• Membrane Journal
• /
• v.25 no.2
• /
• pp.99-106
• /
• 2015

Polysulfone (PSF) hollow fiber membrane was prepared to separate $CO_2$ from the flaring gas. Fabricated PSF membrane system was fulfilled under 1 stage, 2 stage membrane process and simulation in order to confirm the operating condition for 99% of $CH_4$ and 1% of $CO_2$ concentration. Also, $25Nm^3/h$ bench scale $CO_2$ separation membrane system was operated under 1% of $CO_2$ concentration during 100 hr, and $CH_4$ recovery ratio was 98%.

• Membrane Journal
• /
• v.22 no.2
• /
• pp.142-154
• /
• 2012

In order to remove $CO_2$ from the DME plant process, we investigated the composite membrane with rubbery polymers as the separation layer and its separation performance of $CO_2$ and $H_2$. Hollow fiber membranes for supporting layer were prepared by solution spinning method. In case of using PDMS as a separation layer, the composite membranes showed the permeation rates of $CO_2$ were over 300 GPU and minimum $CO_2/H_2$ selectivitties were 4.3 and in case of using PEBAX as a separation layer, the composite membranes showed the permeation rates of $CO_2$ were over 120 GPU and minimum $CO_2/H_2$ selectivities were 5.

• Membrane Journal
• /
• v.29 no.1
• /
• pp.1-10
• /
• 2019

Poly(ether block amide) (PEBA) is one of the commercially important class of block copolymer very much suitable specifically for $CO_2$ separation. Gas separation membrane need to have good mechanical strength as well as high gas permeability. The crystalline polyamide (PA) block provides the mechanical strength while the rubbery polyether (PE) group being $CO_2$-philic facilitate $CO_2$ permeation though the membrane. Composition of thermoplastic and rubbery phase in the polymer are changed to fit into suitable gas separation application. Although PEBA has good permeability, the selectivity of the membrane can be enhanced by incorporating molecular sieve without affection much the gas permeability. Mixed matrix membrane (MMM), a class of composite membrane combine the advantage of polymer matrix with the inorganic fillers. However, there are some disadvantages based on the compatibility of the inorganic fillers and polymeric phase. This review covers both the advantage and limitations of PEBA block copolymer based composite membrane.

• Membrane Journal
• /
• v.10 no.3
• /
• pp.130-138
• /
• 2000

Polyethersulfone (PES) asymmetric membranes for gas separation were prepared by dry/wet phase inversion method and their separation properties for CO$_2$ and N$_2$ gases were investigated. The effects of important variables such as composition of casting solution and evaporation time in preparation of asymmetric gas membrane on membrane morphology and the separation properties were analyzed and the optimum condition of membrane preparation was established. To compensate the defects like pinholes existed on skin layer of the membrane prepared, the membranes were coated with silicone resin. By comparing separation properties after coating with those before coating, we found that the coating of silicone resin was effective to enhance the separation properties. The casting solution mainly used in this study consisted of PES, N-methyl-2-pyrrolidone, acetone, ethanol and distilled water was used as coagulation agent. It was shown that the selectivity for CO$_2$/N$_2$ was getting higher but the permeability decreases, as the contents of PES and volatile organic solvent and evaporation time increased. The selectivity for CO$_2$/N$_2$ and permeability of CO$_2$ of the membrane prepared under the optimum condition were found to be 61 and 21 GPU, respectively.

• Journal of Advanced Marine Engineering and Technology
• /
• v.32 no.6
• /
• pp.915-922
• /
• 2008

The gas separation technology using membrane is widely used to refine various gases in many industry fields and recently is being applying in $CO_2$ recovery technology. In the gas and chemical tanker. nitrogen generators for inerting, purging and padding are on board and most of them have membrane modules of hollow fiber type with long life and vibration resisting properties. Because a membrane module is a key component accounting for 50% of total manufacturing cost of nitrogen generator, adequate selection for it is an important problem. In this paper, the flow performance coefficient based on dimension and specification data of membrane module was relatively selected to compare nitrogen generating capacity of module and various performance tests about the selected PARKER ST6010 membrane module were conducted. As a result, the useful coefficient and basic data in selecting a membrane module were achieved.

• Membrane Journal
• /
• v.21 no.2
• /
• pp.177-192
• /
• 2011

Hollow fiber membrane using CTA polymers were prepared by the phase separation method for the separation and purification of biogas and the hollow fiber gas separation membrane modules with the effective surface area of 0.17 $m^2$ were prepared. The pure gas permeation properties of membrane modules for methane, oxygen and carbon dioxide were measured. The permeance of $CO_2$ and $CH_4$were 0.46 GPU and 18.52 GPU, respectively, therefore, the high $CO_2$/$CH_4$ selectivity of 40.4 was obtained. The separation and purification test for 4 different simulated mixed gases were carried out after the pure gas test and the gas concentration and flux of the permeate at the various stage-cut were measured from the 1 stage, 2 stage, and 3 stage cascade of membrane modules. In the 1 stage test, the concentration of $CH_4$ increased as the increase of the stage-cut, while the $CH_4$ recovery efficiency ratio decreased. In the 2 stage test, the $CH_4$ recovery efficiency ratio increased compared to the 1 stage. The 3 stage test was employed to reduce the loss of $CH_4$ in biogas and the result showed less than 5% of $CH_4$ recovery loss.

• Membrane Journal
• /
• v.28 no.5
• /
• pp.351-360
• /
• 2018

In this study, propylene/propane separation mechanism through NaY zeolite membrane was investigated. As permeation temperature increased, both propylene and propane permeances increased, saturated and decreased again, and a maximum selectivity was shown at around 50 to $60^{\circ}C$. Propane permeance in mixed gas experiment was much smaller than that in single gas experiment, and propylene/propane mixed gas selectivity was much larger than single gas permselectivity. As permeation time increased in transient permeation experiment, propylene permeance initially increased and saturated, while propane permeance decreased and saturated. All the experimental results announced that propylene/propane separation through NaY zeolite membrane was from preferentially adsorbed propylene molecules. The adsorbed propylene molecules efficiently prevented propane molecules from permeating through the membrane, and sufae diffused through the membrane. NaY zeolite capillary membrane prepared in the present study showed a high mixed gas selectivity of 12 and high propylene permeance of 497 GPU for a propylene/propane (89 : 11) mixture at $50^{\circ}C$ and 4 bar. Therefore, it was concluded that NaY zeolite membrane is one of promising membrane materials for propylene/propane separation due to the low cost and high separation performance.

• Journal of Industrial and Engineering Chemistry
• /
• v.67
• /
• pp.373-379
• /
• 2018

A transparent, freestanding Porous Aromatic Framework-97 (PAF-97) membrane was successfully synthesized via a one-step acid-catalyzed reaction. Due to the introduction of ether groups, the obtained PAF-97 membrane possesses enhanced structural flexibility, thus increasing the flexibility of the resulting membrane. This is proofed by the fact that the feeding pressure of the membrane reaches as high as 5.5 bar during the separation of gas mixtures. The Young's moduli of the membrane were 6.615 GPa and 11.11 GPa, either in a dry or hydrated state respectively. To be highlighted, under a feeding pressure of 3.6 bar, the PAF-97 membrane rendered the permeance values of $2.90{\times}10^{-7}$, $1.29{\times}10^{-8}mol\;m^{-2}s^{-1}Pa^{-1}$ for $CO_2$ and $CH_4$, respectively, with a $CO_2/CH_4$ permselectivity of 22.48.

• Carbon letters
• /
• v.16 no.3
• /
• pp.183-191
• /
• 2015

Gas transport through graphene-derived membranes has gained much interest recently due to its promising potential in filtration and separation applications. In this work, we explore Kr-85 gas radionuclide sequestration from natural air in nanoporous graphene oxide membranes in which different sizes and geometries of pores were modeled on the graphene oxide sheet. This was done using atomistic simulations considering mean-squared displacement, diffusion coefficient, number of crossed species of gases through nanoporous graphene oxide, and flow through interlayer galleries. The results showed that the gas features have the densest adsorbed zone in nanoporous graphene oxide, compared with a graphene membrane, and that graphene oxide was more favorable than graphene for Kr separation. The aim of this paper is to show that for the well-defined pore size called P-7, it is possible to separate Kr-85 from a gas mixture containing Kr-85, O₂ and N₂. The results would benefit the oil industry among others.

• Proceedings of the Membrane Society of Korea Conference
• /
• 1999.07a
• /
• pp.3-7
• /
• 1999

Government efforts on membrane technology started in early 1980 with Membrane Development Program supported by the Ministry of Science and Technology. Several independent research projects on liquid separation, gas separation, hollow fiber producing program etc. were carried out during the 1980s. The RaCER was commissioned by MOCI for the general management of the project which had its aims in establishing the base for developing membranes, modules and systems for liquid separation in August 1993. More recently, in June 1995, a program for developing membranes for oxygen separation, nitrogen separation and hydrogen separation was initiated. This paper outlines the brief history of membrane technology development in Korea from the introduction of membrane filtration technology during the late 1960s to present.