• 한국정보통신학회논문지
• /
• 제16권11호
• /
• pp.2569-2574
• /
• 2012

초계함(천안함급)에 탑재 된 HMS(Hull Mount Sonar) 장비는 능동모드에 적합하도록 설계 되어 있다. 이에 센서 및 시스템 특성이 어뢰 탐지 주파수 대역에 적당하도록 구성되어 있지는 않다. 이에 초계함에 장착 된 기존 HMS 장비를 이용한 어뢰탐지 기능 구현을 위하여, 초계함 함 별 입력 특성을 분석하고, 입력 주파수 신호에 대한 역보상 회로 설계, 입력 신호 크기에 따른 AGC(Auto Gain Control) 기능 구현 및 함별 신호특성에 따른 대역설정 기능을 통하여 함정 별 특성 및 운용환경 특성에 맞는 어뢰방어시스템을 구현하였다.

• 한국지능시스템학회:학술대회논문집
• /
• 한국퍼지및지능시스템학회 2004년도 춘계학술대회 학술발표 논문집 제14권 제1호
• /
• pp.153-156
• /
• 2004

This Paper deals with speed control of DC servo motor using a Fuzzy-Sliding observer. Speed sensor detect a speed of rotor continuously. But It have a limit as a driving speed to detect speed precisely. So it is problem to improve the performance of the driving system To solve the problem, it is studied to detect a speed of DC motor without sensor In particular, study on the method to estimate the speed using the observer is performed a lot. In this parer, the gain of the observer is properly set up using the fuzzy control and sliding observer that have a superior transient characteristic and is easy to implement compared the exist ing method is designed. It estimate the derivative of the armature current directly using the armature current measured in the DC motor. It estimate the speed of the rotor using the differentiation. It is Proposed speed sensor less control method using the estimated speed. Optimal gain of Luenberger observer is set up using the fuzzy control and adapted speed control of DC servo motor. It is proved excellence and feasibility of the presented observer from the comparison tested a case with a speed sensor and a case without a speed sensor which used a highly efficient drive and 200W DC servo motor start ing system.

• 한국전자파학회논문지
• /
• 제23권6호
• /
• pp.661-668
• /
• 2012

본 논문에서는 이중 급전 방식을 적용하여 높은 격리 특성을 갖는 초소형 ICS(Interference Cancellation System) 중계기용 안테나를 설계하고, 제작 및 측정을 통하여 이를 검증하였다. 대역폭과 이득은 주방사 패치 및 전력분배기 근처의 스터브 길이, 그리고 기생 패치의 크기를 조정하여 최적하였다. 제작된 안테나는 3G 이동 통신 주파수인 1,920~2,170 MHz 대역에서 VSWR 2:1 미만, 이득은 7 dBi 이상, 격리도는 -65 dB 미만의 특성을 나타내었다.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2003년도 춘계전력전자학술대회 논문집(2)
• /
• pp.663-666
• /
• 2003

This paper presents a speed controller method based on the disturbance torque observer of high performance brushless DC (BLDC) motor drives. In case of the speed control of robot arms and tracking applications with lower stiffness, we cannot design the speed controller gain to be very large from tile viewpoint of the system stability. Thus, the feedforward compensator using disturbance torque observer was proposed. This method can improve the speed characteristic without increasing the speed controller gain. The enhanced speed control performance can be achieved and the speed response against the disturbance torque can be Improved for high-performance BLDC motor drive systems in which the bandwidth of tile speed controller cannot be made large enough. Consequently, speed control for high-performance BLDC motor drives become improved. The simulation results for BLDC motor drive systems confirm the validity of the proposed method.

• ETRI Journal
• /
• 제27권6호
• /
• pp.685-690
• /
• 2005

DC and RF characteristics of $0.15{\mu}m$ GaAs power metamorphic high electron mobility transistors (MHEMT) have been investigated. The $0.15{\mu}m{\times}100{\mu}m$ MHEMT device shows a drain saturation current of 480 mA/mm, an extrinsic transconductance of 830 mS/mm, and a threshold voltage of -0.65 V. Uniformities of the threshold voltage and the maximum extrinsic transconductance across a 4-inch wafer were 8.3% and 5.1%, respectively. The obtained cut-off frequency and maximum frequency of oscillation are 141 GHz and 243 GHz, respectively. The $8{\times}50{\mu}m$ MHEMT device shows 33.2% power-added efficiency, an 18.1 dB power gain, and a 28.2 mW output power. A very low minimum noise figure of 0.79 dB and an associated gain of 10.56 dB at 26 GHz are obtained for the power MHEMT with an indium content of 53% in the InGaAs channel. This excellent noise characteristic is attributed to the drastic reduction of gate resistance by the T-shaped gate with a wide head and improved device performance. This power MHEMT technology can be used toward 77 GHz band applications.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2004년도 ICEIC The International Conference on Electronics Informations and Communications
• /
• pp.181-184
• /
• 2004

In this paper, we propose the dual band(2.4GHz and 5GHz) antenna for access point of WLAN(Wireless Local Area Network) which has similar radiation patterns for each band. Simulation results by using HFSS(High Frequency Structure Simulator) for the proposed antenna are presented. The electrical characteristics of the proposed antenna are measured with HP 8510C network analyzer and included. And radiation patterns are measured with rectangular anechoic far field antenna chamber. Measured results show that $S_{11}$ is less than - 14dB and VSWR(Voltage Standing Wave Ratio) is less than 1.5 for all frequency bands of interest. The measured maximum gain for elevation pattern at 2.40GHz is about 2.46dBi at $theta=-78^{\circ}$ and maximum gain for 5.825GHz is about 2.70dBi at $theta=-80^{\circ}.$ And the implemented antenna has good radiation pattern characteristic, therefore, we expect that the implemented dual band antenna is applicable for access point of WLAN.

• JSTS:Journal of Semiconductor Technology and Science
• /
• 제2권1호
• /
• pp.30-40
• /
• 2002

A 2.45GHz double-balanced modified Gilbert-type CMOS up-conversion mixer design is introduced, where the PMOS current-reuse bleeding technique is demonstrated to be efficient in improving conversion gain, linearity, and noise performance. An LO buffer is included in the mixer design to perform single-ended to differential conversion of the LO signal on chip. Simulation results of the design based on careful modeling of all active and passive components are examined to explain in detail about the characteristic improvement and degradation provided by the proposed design. Two kinds of chips were fabricated using a standard $0.35\mu\textrm$ CMOS process, one of which is the mixer chip without the LO buffer and the other is the one with it. The measured characteristics of the fabricated chips are quite excellent in terms of conversion gain, linearity, and noise, and they are in close match to the simulation results, which demonstrates the adequacy of the modeling approach based on the macro models for all the active and passive devices used in the design. Above all the benefits provided by the current-reuse bleeding technique, the improvement in noise performance seems most valuable.

• 대한전자공학회논문지TC
• /
• 제44권1호
• /
• pp.18-23
• /
• 2007

본 연구에서는 DTV 전파환경 및 수신환경 측정용 기준 안테나를 LPDA 안테나를 이용하여 개발하였다. 안테나의 재질은 측정 장치 구성 및 해체 시의 기구적 견고성을 확보하고 가벼운 시스템 구성이 가능하도록 Element 및 본체를 두랄루민으로 제작하였으며, 동작 주파수 $450\;{\sim}\;850$ MHz에서 안테나 이득은 FCC 규정치인 10 dBd 이상이 되도록 설계하였다. 개발된 안테나는 전 대역에서 10 dBd 이상 (평균 11.7dBd)의 이득 특성과 ${\pm}1.5$ dB의 우수한 통과특성을 지녀 수신환경 측정용 표준안테나로 적합하다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2000년도 하계학술대회 논문집 D
• /
• pp.3124-3126
• /
• 2000

The application of IR(Infrared) communication is very wide and IR receiver has become a standard of home entertainment. A preamplifier with single 5V supply was designed for IR receiver IC. To operate at long distance, receiver IC should have high gain and low noise characteristic. To provide constant output signal magnitude, independent of transciever distance, gain limiting stage is needed. And to cut-off DC noise component effectively, large resistance and capacitance are required. Transimpedance type preamplifier, and diode limiting amplifier, and current limiting amplifier were designed. It is another function of current limiting amplifier that transforms single input signal to differential output signal. Using AMS BiCMOS model, both BJT version and MOS version was designed. Total power consumption is O.lmW, and IC size is $0.3mm^2$

• Journal of Electrical Engineering and Technology
• /
• 제13권5호
• /
• pp.2004-2010
• /
• 2018

We propose a small active antenna to receive Global Navigation Satellite System (GNSS) signals, i.e., Global Positioning System (GPS) L1 (1,575MHz) and Russian Global Navigation Satellite System (GLONASS) L1 (1,600 MHz) signals. A two-stage low-noise amplifier (LNA) with more than 27 dB gain is implemented in the bottom layer of a three-layer antenna package. In addition, a hybrid coupler is used to combine signals from pair of proximately coupled orthogonal feeds with $90^{\circ}$ phase difference to achieve the circular polarization (CP) characteristic. Three layers of high permittivity (${\varepsilon}_r=10$) substrates are stacked and effectively integrated to have a small dimension of $64mm{\times}64mm{\times}7.42mm$ (including both circuit and antenna). The reflection coefficient of the fabricated antenna at the target frequency is below -10 dB, the measured antenna gain is above 26 dBic and the measured noise figure is less than 1.4 dB.