• Proceedings of the Materials Research Society of Korea Conference
• /
• 1994.05a
• /
• pp.94-94
• /
• 1994

• Korean Journal of Crystallography
• /
• v.12 no.3
• /
• pp.171-176
• /
• 2001

HgCdTe films were grown on the (100). (111), (211) CdZnTe, and (100) GaAs substrates by metal organic chemical vapor epitaxy. We have investigated the surface morphology, electrical properties, crystalline qualities, and composition of HgCdTe with substrates orientation. Three dimensional facet growth was occurred on (111) CdZnTe substrate. The crystalline quality of HgCdTe on (100) CdZnTe was superior to that of HgCdTe on (100) GaAs. FWHM values of double crystal x-ray diffraction of HgCdTe on (100) CdZnTe and (100) GaAs were 55 and 125arcsec, respectively. HgCdTe on GaAs substrate showed n-type conductivity with high mobility, however, HgCdTe on CdZnTe showed p-type conductivity with carrier concentration of higher than 10/sup 16/㎤.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.4 no.1
• /
• pp.11-20
• /
• 1994

GaAs and AlGaAs epi-layers were grown on semi-insulating (100) GaAs substrate by molecular beam epitaxy (MBE) and their electrical and optical properties have been investigated by several measurements. In undoped GaAs, the p-type GaAs layers with the good surface morphology were obtained under the growth conditions of the substrate temperatures ranging from 570 to $585^{\circ}C$ and the $As_4$/Ga ratios from 17 to 22. In the samples with the growth rates of the ranges of $0.9~1.1 {\mu}m/h$, the impurity concentrations were in the ranges of $1.5{\times}10^{14}~5.6{\times}10^{14}cm^{-3}$ with the Hall mobilities of $590~410cm^2/V-s$. In the Si-doped GaAs, the n-type GaAs layers with low electro trap, only two hole deep levels were observed with uniform doping profiles (<1%). AlGaAs layers with good surface morphology and crystallinity were grown under an optimum condition of the substrate temperature, $600^{\circ}C $. 8 deep level defects were observed between 0.17~0.85eV in undoped AlGaAs layers.

• Journal of Ceramic Processing Research
• /
• v.21 no.5
• /
• pp.609-614
• /
• 2020

Variation of optical properties in a bulk GaN substrate have experimentally investigated with respect to different annealing conditions of 700 - 1,000 ℃. As-annealed GaN was characterized by scanning electron microscopy, photoluminescence, and Raman spectroscopy. The experimental results demonstrated that the crystallinity and internal residual compressive stress of GaN are most effectively improved when heat-treated at 900 oC for three hours. The optical characteristics were also improved by enhancing the quality of the GaN substrate by decreasing both the defect density and the residual stress. It was also confirmed that the effect of the heat treatment was excellent given that impurities were effectively removed by this process.

• Korean Journal of Materials Research
• /
• v.9 no.3
• /
• pp.257-262
• /
• 1999

The selective area growth of GaN by metal organic chemical vapor deposition has been carried out on GaN/ sapphire substrate using $SiO_2$ mask. We investgated the effect of growth parameters such as flow rate of $NH_3$(500­~1300sccm) and the growth temperature(TEX>$950~1060^{\circ}C$) on the growth selectivity and characteristics of GaN using the Scanning Electron Microscopy(SEM). The selectivity of GaN improved as flow rate of NH, and growth temperature in­creased. But the grown GaN shapes on the substrate windows was independent of the flow rate of $NH_3$. On the pattern shapes such as circle, stripe, and radiational pattern(rotate the stripe pattern by $30^{\circ}, 45^{\circ}$), we observed the hexagonal pyramid, the lateral over growth on the mask layer, and the difference of the lateral growth rate depending on growth condition.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.11 no.2
• /
• pp.409-413
• /
• 2010

We fabricated 10 nm-thick cobalt silicide($CoSi_2$) as a buffer layer on a p-type Si(100) substrate to investigate the possibility of GaN epitaxial growth on $CoSi_2/Si(100)$ substrates. We deposited 500 nm-GaN on the cobalt silicide buffer layer at low temperature with a PA-MBE (plasma assisted-molecular beam epitaxy) after the $CoSi_2/Si$ substrates were cleaned by HF solution. An optical microscopy, AFM, TEM, and HR-XRD (high resolution X-ray diffractometer) were employed to determine the GaN epitaxy. For the GaN samples without HF cleaning, they showed no GaN epitaxial growth. For the GaN samples with HF cleaning, they showed $4\;{\mu}m$-thick GaN epitaxial growth due to surface etching of the silicide layers. Through XRD $\omega$-scan of GaN <0002> direction, we confirmed the cyrstallinity of GaN epitaxy is $2.7^{\circ}$ which is comparable with that of sapphire substrate. Our result implied that $CoSi_2/Si(100)$ substrate would be a good buffer and substrate for GaN epitaxial growth.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2002.07a
• /
• pp.330-333
• /
• 2002

The substrate temperature is an important parameter in thin film deposition process. In this paper the effects of the substrate temperature on the properties of CuIn0.75Ga0.25Se2(CIGS) thin films are reported. Structure, surface morphology and optical properties of CIGS thin films deposited at various substrate temperatures have been investigated using a number of analysis techniques. X-ray diffraction (XRD) analysis shows that CIGS films exhibit a strong <112> preferred orientation. As expected, at higher substrate temperatures the films displayed a higher degree of crystallinity. The <112> peak was also enhanced and other CIGS peaks appeared simultaneously These results were supported by experimental work using Raman spectroscopy. The Raman spectra of the as-grown CIGS thin films show only the Al mode peak. The intensity of this peak was enhanced at higher deposition temperatures. Scanning electron microscopy (SEM) results revealed very small grains in films fabricated at 48$0^{\circ}C$ substrate temperature. When the substrate temperature was increased the average grain size also increased together with a reduction in the number and size of the voids. The deposition temperature also had a significant influence on the transmission spectra.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.2
• /
• pp.91-97
• /
• 2013

Self-heating effects during operation of high current AlGaN/GaN power transistors degrade the current-voltage characteristics. In particular, this problem becomes serious when a low thermal conductivity Si substrate is used. In this work, AlGaN/GaN-on-Si devices were fabricated with various channel widths and Si substrate thicknesses in which the structure dependent self-heating effects were investigated by temperature dependent measurements as well as thermal simulation. Accordingly, a device structure that can effectively dissipate the heat was proposed in order to achieve the maximum current in a multi-channel, large area device. Employing via-holes and common electrodes with a 100 ${\mu}m$ Si substrate thickness improved the current level by 75% reducing the channel temperature by 68%.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.16 no.10
• /
• pp.2273-2279
• /
• 2012

This research is based on fabricating Cu(In,Ga)$Se_2$ thin-film by co-evaporation method. On $1^{st}$ - stage, $In_2Se_3$ phase appeared when the substrate temperature reached to $400^{\circ}C$, however, there was small effect between the substrate temperature and absorbency spectrum on $2^{nd}$, $3^{rd}$ - stage because the average thickness of the thin-film was $1{\mu}m$ or higher. SEM and XRD was measured on $2^{nd}$ and $3^{rd}$ stage and it showed as the substrate temperature increases, the density of the crystal structure increased with the decreament of the vacancy. Furthermore, the formation of Cu(In0.7Ga0.3)$Se_2$ phase showed at $480^{\circ}C$ and $500^{\circ}C$.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2010.08a
• /
• pp.232-232
• /
• 2010

Recently light emitting diodes (LEDs) have been expected as the new generation light sources because of their advantages such as small size, long lifetime and energy-saving. GaN, as a wide band gap material, is widely used as a material of LEDs and GaN nanorods are the one of the most widely investigated nanostructure which has advantages for the light extraction of LEDs and increasing the active area by making the cylindrical core-shell structure. Lately GaN nanorods are fabricated by various techniques, such as selective area growth, vapor-liquid-solid (VLS) technique. But these techniques have some disadvantages. Selective area growth technique is too complicated and expensive to grow the rods. And in the case of VLS technique, GaN nanorods are not vertically aligned well and the metal catalyst may act as the impurity. So we just tried to grow the GaN nanorods on Si substrate without catalyst to get the vertically well aligned nanorods without impurity. First we deposited the AlN buffer layer on Si substrate which shows more vertical growth mode than sapphire substrate. After the buffer growth, we flew trimethylgallium (TMGa) as the III group source and ammonia as the V group source. And during the GaN growth, we kept the ammonia flow stable and periodically changed the flow rate of TMGa to change the growth mode of the nanorods. Finally, as the optimization, we changed the various growth conditions such as the growth temperature, the working pressure, V/III ratio and the doping level. And we are still in the process to reduce the diameter of the nanorods and to extend the length of the nanorods simultaneously. In this study, we focused on the shape changing of GaN nanorods with different growth conditions. So we confirmed the shape of the nanorods by scanning electron microscope (SEM) and carried out the Photoluminescence (PL) measurement and x-ray diffraction (XRD) to examine the crystal quality difference between samples. Detailed results will be discussed.