• Journal of Positioning, Navigation, and Timing
• /
• v.7 no.3
• /
• pp.155-163
• /
• 2018

This study examined methods to enhance navigation performance and reduce the divergence of navigation solutions that may occur in the event of global positioning system (GPS) failure by integrating the GPS/inertial navigation system (INS) with the three-dimensional (3D) magnetic vector measurements of a magnetometer. A magnetic heading aiding method that employs a magnetometer has been widely used to enhance the heading performance in low-cost GPS/INS navigation systems with insufficient observability. However, in the case of GPS failure, wrong heading information may further accelerate the divergence of the navigation solution. In this study, a method of integrating the 3D magnetic vector measurements of a magnetometer is proposed as a countermeasure for the case where the GPS fails. As the proposed method does not require attitude information for integration unlike the existing magnetic heading aiding method, it is applicable even in case of GPS failure. In addition, the existing magnetic heading aiding method utilizes only one-dimensional information in the heading direction, whereas the proposed method uses the two-dimensional attitude information of the magnetic vector, thus improving the observability of the system. To confirm the effect of the proposed method, simulation was performed for the normal operation and failure situation of GPS. The result confirmed that the proposed method improved the accuracy of the navigation solution and reduced the divergence speed of the navigation solution in the case of GPS failure, as compared with that of the existing method.

• International Journal of Aeronautical and Space Sciences
• /
• v.13 no.4
• /
• pp.468-473
• /
• 2012

Cost is an important aspect in designing a target drone, however the poor performance of low cost IMU, GPS, and microcontrollers prevents the use of complex algorithms, such as ARS, or INS/GPS to estimate attitude angles. We propose an autopilot which uses rate gyro and GPS only for a target drone to follow a prescribed path for anti-aircraft training. The autopilot consists of an altitude hold, roll hold, and path following controller. The altitude hold controller uses vertical speed output from a GPS to improve phugoid damping. The roll hold controller feeds back yaw rate after filtering the dutch roll oscillation to estimate the roll angle. The path following controller operates as an outer loop of the altitude and roll hold controllers. A 6-DOF simulation showed that the proposed autopilot guides the target drone to follow a prescribed path well from the view point of anti-aircraft gun training.

• Proceedings of the KIEE Conference
• /
• 2006.07d
• /
• pp.1759-1760
• /
• 2006

GPS 수신기에서 항법을 수행하기 위해서 신호탐색, 신호추적, 데이터 동기, 데이터 복조, 측정치 생성 및 위치 계산의 과정을 거쳐야 한다. TTFF(Time To First Fix)는 이러한 시간의 합으로 수신기의 성능을 나타내는 중요 평가지수 중의 하나이다. 일반적인 수신기의 TTFF는 80~90초인 것으로 알려져 있으며, 고속으로 운동하는 항체의 경우, 빠른 TTFF를 필요로 하므로 가장 긴 시간이 소비하는 신호탐색 과정의 시간을 줄여야 한다. 본 논문에서는 고속으로 운동하는 항체에서 GPS 신호의 코드 탐색 시간을 줄이기 위하여 다중 상관기 구조를 가지는 수신기를 설계 하고자한다. 설계한 수신기는 수신된 신호의 코드위상을 여러 개의 상관기에서 동시에 탐색하도록 다중 상관기를 구성하여 코드위상 검색에 소요되는 시간을 단축시킨다. 이를 검증하기 위하여 GPS 모의 신호 발생기를 이용하여 실험을 수행하였다. GPS 신호는 IF 데이터 수집 장치로부터 수집된 신호를 이용하며, 실험 수행 결과 다중 상관기를 이용하였을 때 TTFF가 단축되는 것을 확인하였다.

• Journal of Sensor Science and Technology
• /
• v.31 no.1
• /
• pp.64-68
• /
• 2022

Herein, we propose a LoRaWAN-based small draft system that can measure the ocean current flow (speed, direction, and distance) in real time at the request of the Coast Guard to develop a device that can promptly find survivors at sea. This system has been implemented and verified in the early stages of rescue after maritime vessel accidents, which are frequent. GPS signals often transmit considerable errors, so correction algorithms using the improved triangulation method algorithm are required to accurately indicate the direction of currents in real time. This paper is structured in the following manner. The introduction section elucidates rescue activities in the case of a maritime accident. Chapter 2 explains the characteristics and main parameters of the GPS surveying technique and LoRaWAN communication, which are related studies. It explains and expands on the critical distance error correction algorithm for GPS signals and its improvement. Chapter 3 discusses the design and analysis of small draft buoys. Chapter 4 presents the testing and validation of the implemented system in both onshore and offshore environments. Finally, Section 5 concludes the study with the expected impact and effects in the future.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.49 no.11
• /
• pp.159-166
• /
• 2012

There are several ways such as GPS(Global Positioning System) and INS (Inertial Navigation System) to track the location of moving vehicle. The GPS has the advantages of having non-accumulative error even if it brings about errors. In order to obtain the position information, we need to receive at least 3 satellites information. But, the weak point is that GPS is not useful when the 혠 signal is weak or it is in the incommunicable region such as tunnel. In the case of INS, the information of the position and posture of mobile with several Hz~several hundreds Hz data speed is recorded for velocity, direction. INS shows a very precise navigational performance for a short period, but it has the disadvantage of increasing velocity components because of the accumulated error during integration over time. In this paper, sensor fusion algorithm is applied to both of INS and GPS for the position information to overcome the drawbacks. The proposed system gets an accurate position information from experiment using SVD in a non-accessible GPS terrain.

• Ocean and Polar Research
• /
• v.35 no.3
• /
• pp.193-203
• /
• 2013

A GPS-drifter was newly designed to observe the sea surface skin current and to estimate the direct wind effect on the sea surface. After conducting a test to establish and verify the accuracy of the GPS itself in the laboratory, in-situ experimental campaigns at Saemangeum in Gunsan city and Haeundae in Busan city, Korea, were carried out to ascertain the drifter track and to estimate the velocity data set on Oct. 3, 15, 23, 27 and Nov. 25, 2011. The current meters, RCM9 and ADCP, were moored together to remove the background current field, and the wind data were obtained from several marine stations such as towers and buoys in these areas. The drifter-observed velocity show good agreement with the flow obtained by the HF radar in the Saemangeum area. The direction of the wind-driven current extracted from the drifter-observed velocity was completely deflected to the right, however the degree of the angle was different according to the drift types. The average speed of the wind-driven current matched with 2.19~2.81% of the wind speed and the deflection angle was about $8.0{\sim}10.9^{\circ}$ without adjustment for the land-sea effect, and about 2.19~2.84% and $4.1{\sim}6.0^{\circ}$ with the adjustment for the land-sea effect.

• Journal of Fisheries and Marine Sciences Education
• /
• v.25 no.3
• /
• pp.724-732
• /
• 2013

The purpose of this study is to obtain a basic data on layout of the trawlers' bridge equipment. The task activities of bridge workers involved in the navigation and fishing operation were analyzed by link analysis methods. The results are as follows. It was found that the movement pattern and frequency of bridge workers are different accordance with the bridge work (navigation, casting net, towing net and hauling net). The central workstation of movement of the bridge workers was a radar workstation, a steering workstation and a trawl winch workstation in the bridge work. But the radar did not show up as the center of movement during the hauling net. Workstations related deeply to the central workstations of the movement on the bridge were as below. Radar workstation was related to a GPS plotter, a microphone location for external communication with VHF and MF/HF equipment and a steering in the case of the navigation, the steering, the GPS plotter and the net monitor in the case of the fishing operation. Steering workstation was related deeply to the GPS plotter, the radar in the case of the navigation, a speed controller, the GPS plotter, a fish finder, the net monitor and the microphone location in the case of the fishing operation. Trawl winch workstation showed deep relation with the GPS plotter and the speed control during the fishing operation. Through this study, it was found that Workstations related deeply to the central workstation of the movement of the bridge workers in accordance with the bridge work. The results of this study might be utilized as the basic data on the bridge layout to minimize the fatigue degree due to a physical movement of the bridge workers.

• Journal of Korea Society of Digital Industry and Information Management
• /
• v.10 no.3
• /
• pp.127-141
• /
• 2014

A Vehicle Tracking System consists of GPS tracking device which fits into the vehicle and captures the GPS location information at regular intervals to a central GIS server, and GIS tracking server providing three major responsibilities: receiving data from the GPS tracking unit, securely storing it, and serving this information on demand of the user. GPS based tracking systems supporting a multi-session processing among RMA, RM, and RCP can make a quick response to various services including other vehicle information between RSU and OBU on demand of the user. In this paper we design RSU lower layers and RCP applications in OBU for a multisession processing simulation and test message processing transactions among RMA-RM and RM-RCP. Furthermore, we implement the additional functions of handling access commands simultaneously on multiple service resources which are appropriate for the experimental testing conditions. In order to make a multi-session processing test, it reads 30 resource data,0002/0001 ~ 0002/0030, in total and then occurs 30 session data transmissions simultaneously. We insert a sequence number field into a special header of dummy data as a corresponding response to check that the messages are received correctly. Thus, we find that GIS service system with a multi-session processing is able to provide additional 30 services in a same speed of screen presentation loading while identifying the number of session processing of Web GIS service, the number of OBU service, and the speed of screen presentation loading by comparing a single session and a multi-session of GIS service system.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.31 no.1
• /
• pp.84-92
• /
• 1995

The methods by turning circle test and maneuvering indices have been used to study and evaluate the maneuverability of a ship. However recently many studies utilizing the GPS are made on the measurement of the turning circle and in the fishery and hydrographic survey. In this paper, the author carried out the turning circle test using the differential GPS and dumb card together, and compared the data measured by them and analyzed the accuracies of them to obtain the utility basic ones on the measurement of the turning circle by the DGPS. The main results area s follows : 1) To check the accuracies of the GPS, the circling experiments of 50m radius by the DGPS were made on the ground. The accuracies of turning circle measured by the DGPS were found to be very high as the errors of 1.5m. 2) the turning circle by the DGPS could be measured very accurately, by the seed, rudder angle, starboard and port respectively. 3) The turning circle measured by the dumb card was found to be measured accurately as much as the DGPS, when using large rudder angle, the turning circle was large, the turning circle by the dumb car could not be measured accurately on account of large error of bearing of compass. 4) The tactical diameters by the DGPS in case of the rudder angle 35。~5。, were found to be 2.6。15.0 times the Lpp of S.T HAELIM-3 at her slow speed 2.8~16.6 times her Lpp at her half speed, 3.1~17.4 times her Lpp at her full speed. The tactical diameter by the dumb card was found to be 2.4~9.5 times, 2.6~9.6 times, 3.2~12.2 times her Lpp respectively, in the above case and speed.

• Journal of Korean Society for Geospatial Information Science
• /
• v.21 no.3
• /
• pp.55-62
• /
• 2013

This paper aims to detect Speed Bump by using Omni-directional Camera and to suggest Real-time update scheme of Speed Bump through Vision Based Approach. In order to detect Speed Bump from sequence of camera images, noise should be removed as well as spot estimated as shape and pattern for speed bump should be detected first. Now that speed bump has a regular form of white and yellow area, we extracted speed bump on the road by applying erosion and dilation morphological operations and by using the HSV color model. By collecting huge panoramic images from the camera, we are able to detect the target object and to calculate the distance through GPS log data. Last but not least, we evaluated accuracy of obtained result and detection algorithm by implementing SLAMS (Simultaneous Localization and Mapping system).