• Structural Engineering and Mechanics
• /
• v.36 no.2
• /
• pp.129-147
• /
• 2010

This study deals with the viability of using a designed geometrical model consists of plane, polar coordinates (PC) and span length in the determination of bridges deformation. The data of a Tianjin Yonghe bridge located in the southern part of China as collected by RTK-DGPS technique and Accelerometer were used in the analysis. Kalman filter and fast Fourier transformation (FFT) analyses were used to determine the frequency. The results indicate that the designed plane and PC geometrical model are easy to calculate the long-time structural deformation monitoring. In addition, the observed frequency using GPS with the rate of 20 Hz doesn't give correction natural frequency of the observation structures.

• Journal of Positioning, Navigation, and Timing
• /
• v.7 no.1
• /
• pp.15-24
• /
• 2018

This study analyzed positioning accuracy of the multi-differential global navigation satellite system (DGNSS) algorithm that integrated GPS, GLONASS, and BDS. Prior to the analysis, four sites of which satellite observation environment was different were selected, and satellite observation environments for each site were analyzed. The analysis results of the algorithm performance at each of the survey points showed that high positioning performance was obtained by using DGPS only without integration of satellite navigation systems in the open sky environment but the positioning performance of multi-DGNSS became higher as the satellite observation environments degraded. The comparison results of improved positioning performance of the multi-DGNSS at the poor reception environment compared to differential global positioning system (DGPS) positioning results showed that horizontal accuracy was improved by 78% and vertical accuracy was improved by 65% approximately.

• The Journal of Korea Robotics Society
• /
• v.2 no.3
• /
• pp.221-226
• /
• 2007

A robust position-sensing system is proposed in this paper for ubiquitous mobile robots which move indoor as well as outdoor. The Differential GPS (DGPS) which has position estimation error of less than 5 m is a general solution when the mobile robots are moving outdoor, while an active beacon system (ABS) with embedded ultrasonic sensors is selected as an indoor positioning system. The switching from the outdoor to indoor or vice versa causes unstable measurements on account of the reference and algorithm changes. To minimize the switching time in the position estimation and to stabilize the measurement, a robust position-sensing system is proposed. In the system, to minimize the switching delay, the door positions are stored and updated in a database. The reliability and accuracy of the robust positioning system based on DGPS and ABS are verified through the real experiments using a mobile robot prepared for this research and demonstrated.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2002.05a
• /
• pp.197-200
• /
• 2002

The current Inn technique is many problems that is permission of radio station using RF Wireless Modem, that is influence of geographic obstacle using radio wave, that is frequency interference, that is finiteness of frequency resources. In this paper, we are solved many elements, IM replaces RF Wireless Modem, we suggest transmission technique of correction message using mobile phone, we researched Interface Module development which is linkage of DGPS receiver and mobile phone. IM can transmit correction message passing RS-232 port and modem communication control. IM of base station is initialized RS-232 port and modem to move station for correction message transmission, IM waited response mode. IM of move station is initialized RS-232 port and modem, IM requests hand shaking to base station, completed connection establishment. Users are worked Differential surveying using receiving correction message between mobile phones.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.14 no.4
• /
• pp.824-830
• /
• 2010

In order to prepare for increasing performance requirement for Differential Global Navigation Satellite System (DGNSS) services of International Maritime Organization (IMO) and International Association of Lighthouse Authorities (IALA), this paper focuses on design of network-based Automatic Identification System (AIS) reference station system that can perform the functionality of Differential Global Positioning System (DGPS) reference station in an AIS base station system. AIS base station receives the differential corrections from the DGPS reference station, and it is not a method for transmitting the received differential corrections to onboard AIS units, but it is a method for generating the optimized differential corrections for onboard AIS units in AIS coverage. Therefore this paper proposes an algorithm for generating the differential corrections at AIS reference station, and performs the performance assessment of the proposed algorithm based on DGPS correction data measured from a DGPS reference station. Finally this paper discusses the test results and efficiency of the proposed system.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.20 no.9
• /
• pp.1822-1829
• /
• 2016

DGPS Reference station is established in Korea for improvement of GPS navigation accuracy and needs of integrity. Recently, DGPS stations provide user positioning information on land as well as ocean. However, this paper investigated visibility and interference environment for performance degradation of Chung-ju DGPS reference station. In case of Young-do reference station, visibility and interference environment were satisfied with reference standard. In case of Chung-ju reference station, visibility was satisfied with 7 degree elevation angle. However, interference environment was not satisfied with reference standard of -50dBm. This paper proposed time differential measurement analysis method excluding error of signal noise for analyzing measurement error. Chung-ju reference station measurement analysis result is three times the error than on Young-do in Dec, 2015. In addition, this paper has confirmed measurement performance degradations because of reference station equipment problem. Future study will be carried out performance analysis of 17 DGPS reference station.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• v.2
• /
• pp.471-474
• /
• 2006

GPS수신기는 항법센서로서 여러 분야에서 널리 사용되고 있다. 단일 안테나 GPS수신기로부터 일반적으로 위치와 속도 및 시간 정보를 얻을 수 있다. 그러나 고정익 항공기의 운동 특성을 고려하여 단일 안테나 GPS수신기의 측정치로부터 무인항공기의 자세를 추정할 수 있다. 이로써 단일안테나 GPS수신기를 이용하여 무인항공기의 자동 제어가 가능함을 이전 논문에서 보인 바 있다. 본 논문에서는 단일 안테나 GPS수신기를 무인항공기의 기본 센서로 사용하여 자동 이착륙이 가능함을 비행실험을 통해 보인다. 무인항공기의 반응속도와 강건성을 향상시키기 위해 rate gyros의 각속도 측정치를 이용한다. 또한 활주로에 자동착륙하기 위해서는 높은 정확도의 위치 정보가 필요하므로 DGPS를 이용하였다. 비행 실험 동안 무인항공기는 이륙에서 착륙까지 모든 과정을 자동 제어로 수행한다. 대부분 비행은 경로 제어로 이루어진다. 비행 실험 결과를 바탕으로 단일안테나 GPS수신기가 General Aviation 항공기나 무인항공기의 백업이나 저가의 제어 시스템을 위한 주 센서로서 사용이 가능할 것으로 판단된다.

• Proceedings of the KIEE Conference
• /
• 2003.07d
• /
• pp.2738-2740
• /
• 2003

임베디드 시스템을 인터넷에 접속할 수 있도록 하는 초소형의 임베디드 웹서버는 산업 현장에서 가정에 이르기까지 널리 활용되고 있다. 본 논문에서는 인터넷을 통해 DGPS 간이 기준국의 보정 정보를 항체에게 제공하기 위한 임베디드 웹서버를 제안하였다. 제안한 간이 기준국용 임베디드 웹서버는 HTTP 1.0과 1.1 표준에서 제시한 구조를 기반으로 설계 가능하다. HTTP 1.0 표준을 기반으로 한 서버는 클라이언트의 요청을 순차적으로 처리하는 반면, HTTP 1.1 표준을 기반으로 한 서버는 클라이언트에 대하여 독립된 프로세스를 할당하여 처리한다. 간이 기준국에 적합한 서버 구조를 결정하기 위하여 각 서버 프로그램의 구조 및 특징을 비교하고 네트워크 인터페이스를 가지는 GPS 수신기에 상용의 실시간 운영체제를 기반으로 구현하였다. PC 내부에 탑재한 상용의 웹브라우저를 통하여 제안한 임베디드 웹서버에 접속하여 DGPS 간이 기준국의 보정 정보를 수신하는 실험을 수행하였다. 실험 결과 제안한 임베디드 웹서버의 구조가 DGPS 간이 기준국에 적합함을 확인하였다.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.8 no.1
• /
• pp.10-17
• /
• 1996

A real time simple DGPS (SDGPS) for coastal survey is developed and in situ tested. While the accuracy of the system is almost the same as that of existing commercially available DGPS, it is very economical compared to the commercial ones. The RMS error of the positions fired by the system is estimated to be less than 2 m within the range of 30 km from the reference station. Even if the coordinates of the reference station are uncertain, they can be fixed, from the continuous GPS observation of one day, with the maximum error less than 1 m. The system is believed to be helpfully utilized to most of coastal surveys despite of some minor defects.

• International Journal of Aeronautical and Space Sciences
• /
• v.2 no.1
• /
• pp.67-77
• /
• 2001

In recent navigation system, the profitable solution is to integrate the GPS and Stapdwon INS (SDINS) system and its integration allows compensation for shortcomings of each system. This paper describes the hardware preparation and presents the test results obtained from the automobile test of the developed system. The automobile tests was conducted with two kinds of inertial sensors and GPS receivers : short range and middle range test, to verify and evaluate the performance of the integrated navigation system. The reference of position is given by the Differential GPS(DGPS) which has cm-level accuracy to compare the accuracy of system. Kalman filtering is used for integrating GPS and SDINS and this filter effectively allows the long-term stability of GPS to correct and decrease the time deviation error of SDINS.