• Journal of Korean Society for Geospatial Information Science
• /
• v.22 no.4
• /
• pp.127-133
• /
• 2014

The purpose of this study is to evaluate the accuracy of Network-RTK(VRS) survey for applying to Ground Control Points(GCPs) survey required for mapping aerial photographs. Network-RTK has been serviced by National Geographic Information Institute since 2007. On the basis of the global coordinates system(ITRF2000), the coordinates of GCPs determined by Static GNSS survey with relative positioning techniques were regarded as accurate values. The coordinates of GCPs were also determined by Network-RTK survey using two kinds of receivers, and then they were converted into the global coordinates system(ITRF2000) by applying suitable geoid model and coordinate transformation. These coordinates of GCPs were compared with those from Static GNSS survey. The root mean squares error (RMSE) of coordinate differences between Network-RTK and Static GNSS was ${\pm}2.0cm$ in plane and ${\pm}7.0cm$ in height. Therefore, Network-RTK survey that enables single GNSS receiver to measure positions in short time is a practical alternative in positioning GCPs to either RTK survey that uses more than two sets of GNSS receivers or Static GNSS survey that requires longer observation time.

• Journal of Advanced Navigation Technology
• /
• v.21 no.1
• /
• pp.43-49
• /
• 2017

Generally, loop filter based scalar tracking loops (LF-STL) have been used for global positioning system (GPS) signal tracking algorithm. This paper introduces the accuracy and robustness of linear-quadratic-Gaussian based vector tracking loop (LQG-VTL) algorithm instead of LF-STL. To verify the accuracy of LQG-VTL, we confirm that the measurements estimation errors of the LQG based scalar tracking loops (LQG-STL) are improved by more than 60 % compared to LF-STL. Also, when LQG-VTL is used, measurements estimation errors decrease compared to LQG-STL, and position/velocity estimation errors also decrease as the number of satellites increases. To verify the robustness of LQG-VTL, we confirm that LQG-VTL can estimate position/velocity and measurements successively compared to LF-STL in temporal signal attenuation of 30 dB-Hz during 4 seconds.

• Journal of Advanced Navigation Technology
• /
• v.21 no.2
• /
• pp.171-178
• /
• 2017

In this paper, in order to verify the performance of a localization algorithm using GPS as an auxiliary sensor, the algorithm was applied to a hovering-type autonomous underwater vehicle (AUV) to perform a field test. The applied algorithm is an algorithm to improve the accumulated positional error of dead reckoning using doppler velocity logger(DVL) and tilt-compensated compass module (TCM) mounted on the AUV. GPS when surfaced helps the algorithm to estimate the position and the heading bias error of TCM for geodetic north, which makes it possible to perform dead reckoning on north-east-down (NED) coordinates. As a result of field test performing heading control, it was judged that the algorithm could improve the positional error, enhance the operational capability of AUV and contribute to the research of underwater navigation depending on a magnetic compass.

• Journal of Biosystems Engineering
• /
• v.43 no.3
• /
• pp.247-254
• /
• 2018

Purpose: Although previous studies have performed on-farm evaluations for the control of airborne diseases such as foot-and-mouth disease (FMD) and influenza, disease control during the process of livestock and manure transportation has not been investigated thoroughly. The objective of this study is to predict common patterns of livestock-vehicle movement. Methods: Global positioning system (GPS) data collected during 2012 and 2013 from livestock vehicles on Jeju Island, South Korea, were analyzed. The GPS data included the coordinates of moving vehicles according to the time and date as well as the locations of livestock farms and manure-keeping sites. Data from 2012 were added to Esri software ArcGIS 10.1 and two approaches were adopted for predicting common vehicle-movement patterns, i.e., point-density and Euclidean-distance tools. To compare the predicted patterns with actual patterns for 2013, the same analysis was performed on the actual data. Results: When the manure-keeping sites and livestock farms were the same in both years, the common patterns of 2012 and 2013 were similar; however, differences arose in the patterns when these sites were changed. By using the point-density tool and Euclidean-distance tool, the average similarity between the predicted and actual common patterns for the three vehicles was 80% and 72%, respectively. Conclusions: From this analysis, we can determine common patterns of livestock vehicles using previous year's data. In the future, to obtain more accurate results and to devise a model for predicting patterns of vehicle movement, more dependent and independent variables will be considered.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.25 no.4
• /
• pp.355-363
• /
• 2007

The purpose of this study is to maximize the use of framework data by a method for updating road framework data using a economical, rapid, and accurate Vehicle-based kinematic survey to get the latest road data among "transportation framework data" which was built in 2003. We collected data using a Vehicle-based kinematic survey with DGPS (Differential Global Positioning System) in Daejeon and Pyeongtaek city and verified the accuracy of line and point features between surveying and previous results. The result showed that Daejeon city which is located near GPS CORS (Continuously Operating Reference Station)s and receive a signal well had lower errors than 1/5,000 digital base map, and Pyeongtaek city which is located far from the stations and receive a signal badly had errors beyond the limits. The study showed that postprocessing method or Total Station surveying should be used where signals cannot be detected well after analyzing a receiving rate from GPS CORSs, the stations of other organizations should be shared, and further studies are needed.

• Korean Journal of Remote Sensing
• /
• v.30 no.6
• /
• pp.797-807
• /
• 2014

The Sea Surface Temperature (SST) is one of the most important oceanic environmental factors in determining the change of marine environments and ecological activities. Satellite thermal infrared images can be effective for understanding the global trend of sea surface temperature due to large scale. However, their low spatial resolution caused some limitations in some areas where complicated and refined coastal shapes due to many islands are present as in the Korean Peninsula. The coastal ocean is also very important because human activities interact with the environmental change of coastal area and most aqua farming is distributed in the coastal ocean. Thus, low-cost airborne thermal infrared remote sensing with high resolution capability is considered for verifying its possibility to extract SST and to monitor the changes of coastal environment. In this study, an airborne thermal infrared system was implemented using a low-cost and ground-based thermal infrared camera (FLIR), and more than 8 airborne acquisitions were carried out in the western coast of the Korean Peninsula during the periods between May 23, 2012 and December 7, 2013. The acquired thermal infrared images were radiometrically calibrated using an atmospheric radiative transfer model with a support from a temperature-humidity sensor, and geometrically calibrated using GPS and IMU sensors. In particular, the airborne sea surface temperature acquired in June 25, 2013 was compared and verified with satellite SST as well as ship-borne thermal infrared and in-situ SST data. As a result, the airborne thermal infrared sensor extracted SST with an accuracy of $1^{\circ}C$.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.28 no.8A
• /
• pp.633-643
• /
• 2003

UWB impulse radio signals have an very short duration, extremely wide bandwidth and share the same frequency spectrum with other existing systems. It was determined by the Federal Communications Commission (FCC) that UWB systems could cause interference with other systems, such as Global Positioning System (GPS) for example. Therefore, at present. the FCC has restricted the use of UWB systems to frequencies above 3.1㎓. In this paper, We evaluated performance of UWB system using proposed pulses in ［1］［2］ that are strictly limited in time to remove interference while, at the same time, contain their power distribution to a frequency band from 3.1㎓ to 10.6㎓. In particular, We evaluated the BER Performance in relation to system parameters such as pulse duration. $\delta$, the number of users. Nu. and the number of symbols, M. We found the optimal pulse duration $\delta$ through computer simulation using developed UWB pulses in ［1］［2］. It is shown that performance evaluation between the UWB communication system using these UWB pulses ［1］［2］and the Gaussian monocycle pulse in M-ary PPM and BPSK schemes. These results can be contributed to construct M-ary PPM UWB communication system in terms of multiuser parameters and pulse duration.

• Journal of Ocean Engineering and Technology
• /
• v.33 no.5
• /
• pp.470-478
• /
• 2019

Because the global positioning system (GPS) is not available in underwater environments, an inertial navigation system (INS)/doppler velocity log (DVL) integrated navigation system is generally implemented. In general, an INS/DVL integrated system adopts a loosely coupled method. However, in this loosely coupled method, although the measurement equation for the filter design is simple, the velocity of the body frame cannot be accurately measured if even one of the DVL transducer signals is not received. In contrast, even if only one or two velocities are measured by the DVL transducers, the tightly coupled method can utilize them as measurements and suppress the error increase of the INS. In this paper, a filter was designed to regenerate the measurements of failed transducers by taking advantage of the tightly coupled method. The regenerated measurements were the normal DVL transducer measurements and the estimated velocity in RPM. In order to effectively estimate the velocity in RPM, a filter was designed considering the effects of the tide. The proposed filter does not switch all of the measurements to RPM if the DVL transducer fails, but only switches information from the failed transducer. In this case, the filter has the advantage of being able to be used as a measurement while continuously estimating the RPM error state. A Monte Carlo simulation was used to determine the performance of the proposed filters, and the scope of the analysis was shown by the standard deviation ($1{\sigma}$, 68%). Finally, the performance of the proposed filter was verified by comparison with the conventional tightly coupled method.

• Geophysics and Geophysical Exploration
• /
• v.23 no.4
• /
• pp.243-252
• /
• 2020

To share an understanding of trajectory measurement in surveys using borehole, this tutorial summarizes the relevant mathematical principles of the borehole deviation survey based on coordinate transform. For uncased or open holes, calculations of the azimuth-deviation-tool face rotation using three-component accelerometer and magnetometer measurements are summarized. For the steel-cased holes, calculations are based on the time-derivative formula of the coordinate transform matrix; yaw-pitch-roll angles through time are mathematically determined by integrating the threecomponent angular velocity measurements from the gyroscope while also removing the Earth's rotation effect. Sensor and data fusion to increase the accuracy of borehole deviation survey is explained with an example of the method. These principles of borehole deviation surveys can be adapted for attitude estimation in air-borne surveys or for positioning in tunnels where global positioning system (GPS) signals cannot be accessed. Information on the optimization filter that must be incorporated in sensor fusion is introduced to help future research.

• Journal of Korea Society of Industrial Information Systems
• /
• v.19 no.4
• /
• pp.53-63
• /
• 2014

Moving context determination is an important issue to be resolved in a mobile computing environment. This paper presents a method for recognizing and classifying a mobile user's moving context by Euclidean distance similarity. In the proposed method, basic data are gathered using Global Positioning System (GPS) and accelerometer sensors, and by using the data, the system decides which moving situation the user is in. The decided situation is one of the four categories: stop, walking, run, and moved by a car. In order to evaluate the effectiveness and feasibility of the proposed scheme, we have implemented applications using several variations of Euclidean distance similarity on the Android system, and measured the accuracies. Experimental results show that the proposed system achieves more than 90% accuracy.