• Food Science and Preservation
• /
• v.15 no.2
• /
• pp.191-196
• /
• 2008

We examined the effects of four different types of cutting on the quality characteristics of sweet pumpkin. Two hundred grams of each of four samples were packed individually in polypropylene mm and stored at $10^{\circ}C$ for 9 days. Samples were evaluated for weight loss, change in hardness, color change, pH change, water-soluble materials, gas changes, and sensory evaluation. $CO_2$concentration increased during storage, whereas $O_2$ concentration rapidly decreased and then stabilized after 3 days. $C_2H_4$ was detected only after 3 days of storage, and steadily increased thereafter. The rate of weight loss steadily increased Analysis of Lab color space indicated no significant change in the L and b values, but an increase in the a value at the end of storage. Waster-soluble solids increased, but hardness showed no change. All the samples underwent a steady increase in pH. Samples cut into 8 pieces had the highest sensory scores.

• Food Science and Preservation
• /
• v.21 no.3
• /
• pp.381-387
• /
• 2014

Food irradiation is one of the successful modern techniques used to preserve food. However, it needs very careful control. Detection of irradiated food is of prime importance to facilitate global trade and consumer assurance, choice, and protection. This study was performed to evaluate the radiation-induced hydrocarbon content of dried squid and octopus by e-beam irradiation. The samples were collected from supermarkets all over South Korea and irradiated with an e-beam at 0, 1, 3, 5, 7, and 10 kGy doses. Lipids were extracted with soxhelt, and the hydrocarbons induced with irradiation were separated via solid phase extraction (SPE) and identified via gas chromatography mass spectrometry (GC/MS). The major induced hydrocarbons in the irradiated dried squid and octopus were 1-tetradecene and pentadecane derived from palmitic acid and 1-hexadecene and heptadecane from stearic acid. The concentration of hydrocarbons differed from the composition of the fatty acid at the same radiation and increased according to the level of the radiation dose. The hydrocarbons induced by e-beam irradiation, including 1-tetradecene, 1-hexadecene, and heptadecane, were confirmed to have been the irradiation marker compounds. Therefore, they can be used to distinguish the e-beam-irradiated dried squid and octopus from the non-irradiated ones.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.36 no.5
• /
• pp.891-901
• /
• 2016

By comparing test blasting data experimented in three layered-structure polymorphic grounds to a geological profile, influence of blast vibration with respect to uncontrollable ground characteristics was analyzed. Inefficient blast have been performed without sufficient verifications or confirmations because insufficiencies with regard to experiments and data of blasting engineering on the layered structures to be irregularly repeated clinker layer consisted of volcanic clastic zones. It is difficult to quantify N values of clinkers within test blasting region because they have diverse ranges, or coverages. An absolute value of attenuation coefficient N in a field, estimated by blasting vibration predictive equation (SRSD), are lesser than criteria of a design instruction, meaning that vibrations caused by blast can spread far away, and the vibrational characteristics of blasting test No.1, indicating relatively small values, inferred by the geological profile, pressures of gas by the explosion may be lost into a widely distributed clinker layers by penetrating holes resulted from blast into vicinity of clinker layers located in bottom of soft rock layers at the moment of blast. As a result, amounts of spalling rocks are decreased by almost half. Also, ranges of primary frequencies in the fields are identified as similar to those of natural frequency of typical structures.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.2 no.1
• /
• pp.10-19
• /
• 1992

Mn - Zn Ferrite has physical properties of the high initial permeability, saturation magnetic flux density, and low loss factor as a representative magnetic material of soft ferrites, in addition the mechanical property is excellent as a single crystal. Therefore it is important electronic components and used for VTR Head. Mn - Zn Ferrite single crystals with the diameter 8mm were grown in atmosphere mixed with $O_2$ and Ar gas by the Floating Zone(FZ) method that impurities can not be incorporated to the crystals because of not-using the crucible to put in the melt, and the sharp temperature gradient results from making a focus at one point utilizing the infrared ray emitted from the halogen lamp as a heat source. During the crystal growing, the highest temperature of melting area was maintained to be $1650^{\circ}C$, growth rate and rotation rate were 10 mm/hr, 20 rpm respectively. The phases and the growth directions of crystals were determined from the analysis of X RD patterns, Laue, TEM diffraction patterns and etch pit shapes were observed by the optical microscope through the chemical etching. The corelation of optimum conditions for acquiring the better crystals was found out with the growth rate, the length and diameter of melt at the interface according to the diameter of feed rod, and the patterns of growing interface also studied.

• International Commerce and Information Review
• /
• v.15 no.2
• /
• pp.3-23
• /
• 2013

In 1997, 180 countries signed the Kyoto Protocol in Kyoto, Japan. The Kyoto Protocol came into force in February 2005. The agreement calls for industrialized nations to cut greenhouse gas emissions by 5 percent from 1990 levels by 2008 to 2012. One of those polices is a modal shift that change from road freight to sea, inland waterway and railroad transportation that is eco-friendly. The increase of road freight brings road congestion, accidents, logistic costs, air pollution and greenhouse gases. Railroads are superior than the other modes of transportation in mass transportability, high speed, timeliness, safety and environmental-friendliness, but the railway industry has been pushed behind in competition. Korean railroads were used by passengers and freight transport popularly until the middle of 20th century, however, by the sudden change of logistics environments, a shaving time efficiency being most important, railroad logistic lost its competitive power against the transportation by truck. From the research which sees consequently investigated a various policy, a system and a law about Chinese logistics industry and present condition of the Chinese goods enterprise and instance analysis of the large Chinese corporation that branch out to undeveloped markets led and a Chinese logistics industry and problem point escape hereafter the heightening of competitiveness plan which is rational under prsenting boil.

• Korean journal of applied entomology
• /
• v.45 no.1 s.142
• /
• pp.25-30
• /
• 2006

The female sex pheromone of the peach leafminer, Lyonetia clerkella Linne (Lepidoptera: Lyonetiidae), was analyzed by coupled gas chromatographic-electroantennographic detector (GC-EAD). GC-EAD analyses of pheromone gland extract revealed a single compound that elicited responses from male antennae. Retention time on DB-1 column of EAD-active compound was identical to that of synthetic (145)-14-Methyl-1-octadecene (14Sme-1-18Hy). In field tests, sticky traps baited with synthetic 14Sme-1-18Hy alone were highly attractive to male. Traps with 0.1 mg dose showed the lowest catches, but there were no significant difference in the numbers of moth caught in traps baited with doses of 0.5 and 1.0 mg. The results of the field assays for longevity of pheromone traps showed that effectiveness of lures maintained for at least 8 weeks under field condition. The attractiveness of 14Sme-1-18Hy was not affected by the addition of butylated hydroxytoluene (BHT) in lures as an antioxidant. Traps baited with 0.5 mg 14Sme-1-18Hy were successfully used to monitor L. clerkella male flights. Analysis of seasonal trap catches over two years showed that moth flight activity in peach orchards occurred over a period of seven months with six generations in Suwon.

• Clean Technology
• /
• v.4 no.2
• /
• pp.41-53
• /
• 1998

Most of flame furnace with uncontrolled atmosphere forms oxidation scales in the surface during heat treatment. In this case, shot blasting and pickling are commonly used for reduction of oxidation scales. These processes have many disadvantages, such as long process time, high operating cost and environmental problems due to polishing dust, etc. Hence, this study aimed to develop the advanced heat treating equipment which could make a controlled atmosphere using a heatresisting structure into the flame furnace. The analysis result with SEM, EPMA, and EDX revealed that the amount of scales formed is much less than that with the conventional flame furnace. A brightness of the sample treated with the advanced process is similar compared to the treatment with vacuum furnace. In the present work, it was recommended that the inside structure of the furnace and gas line system could made up of SBB410 and STS310, respectively. The operating cost with the advanced heat treatment system could be reduced annually by forty million won. As a result of this study, it may be possible to reduce the oxidation scales. The fundamental information obtained in this study will be useful not only for improving the heat treatment process(reduction of shot blast and cleaning process), but for promoting the manufacture of bright products.

• Clean Technology
• /
• v.17 no.2
• /
• pp.166-174
• /
• 2011

The xAl-yCe oxide catalysts with different mol ratios of Al/(Al+Ce) were prepared by a co-precipitation method and Pt supported on xAl-yCe oxide catalysts were synthesized by an incipient wetness impregnation method. The catalysts were characterized by X-ray Diffraction (XRD), $N_2$ sorption, and $H_2$/CO-temperature programmed reduction ($H_2$/CO-TPR) to correlate with catalytic activities in co oxidation. Among the catalysts studied here, Pt/1Al-9Ce oxide catalyst showed the highest activity in dry and wet reaction conditions and the catalytic activity showed a typical volcano-shape curve with respect to Al/(Al+Ce) mol ratio. When the presence of 5% water vapor in the feed, the temperature of $T_{50%}$ was shifted ca. $30^{\circ}C$ to lower temperature region than that in dry condition. From CO-TPR, the desorption peak of $CO_2$ on Pt/1Al-9Ce oxide catalyst showed the highest value and well correlated the catalytic performance. It indicates that the Pt/1Al-9Ce oxide catalyst has a large amount of active sites which can be adsorbed by co and easy to supplies the needed oxygen. In addition, the amount of pentacoordinated $Al^{3+}$ sites obtained through $^{27}Al$ NMR analysis is well correlated the catalytic performance.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.40 no.6
• /
• pp.397-402
• /
• 2016

To produce adequate electricity in nuclear and thermal power plants, an optimal amount of steam should be supplied to a generator connected to high- and low-pressure steam turbines. A turbine output control device, which is a special steam valve employed to supply or interrupt the steam to the turbine, is operated using a hydraulic servo actuator. In power plants, the performance of servo actuators is degraded by the air generated from the hydraulic system, or causes frequent failures owing to an increase in the wear of the seal. This is due to the seal being burnt as generated heat using the produced compressed air. Some power plants have exhausted air using a fixed orifice, and thus they encounter power loss due to mass flow exhaust. Failures are generated in hydraulic pumps, electric motors, and valves, which are frequently operated. In this study, we perform modeling and analysis of the load-sensing air-exhaust valves, which can be passed through very fine flow under normal use conditions, and exhaust mass flow air at the beginning stage as with existing fixed orifices. Then, we propose a method to prevent failures due to the compressed air, and to ensure the control accuracy of hydraulic servo actuators.

• Applied Chemistry for Engineering
• /
• v.8 no.3
• /
• pp.430-437
• /
• 1997

Uranyl-peroxide compound was prepared by the reaction of excess hydrogen peroxide solution and trace uranium in filtrate from nuclear fuel conversion plant. The $CO_3{^{2-}}$ in filtrate was removed first by heating more than $98^{\circ}C$, because uranyl-peroxide compound could not be precipitated by $CO_3{^{2-}}$ remaining in filtrate. The optimum condition for uranyl-peroxide compound was ageing for 1 hr after controling the pH with $NH_3$ gas and adding the excess $H_2O_2$ of 10ml/lit.-filtrate. Uranium concentration in the filtrate was appeared to 3 ppm after the precipitation of uranyl-peroxide compound, and the chemical composition of this compound was analyzed to $UO_4{\cdot}2NH_4F$ with FT-IR, X-ray diffractometry, TG and chemical analysis. Also, this fine particle, about $1{\sim}2{\mu}m$, could be grown up to $4{\mu}m$ at pH 9.5 and $60^{\circ}C$. The separation efficiency of precipitate from mother liquor was increased with increase of pH and reaction temperature. Otherwise, the crystal form of this particle showed octahedral by SEM and XRD, and $U_3O_8$ powder was obtained by thermal decomposition at $650^{\circ}C$ in air atmosphere.