• Nuclear Engineering and Technology
• /
• v.49 no.5
• /
• pp.920-927
• /
• 2017

With ever-advancing computer technology, the Monte Carlo (MC) neutron transport calculation is expanding its application area to nuclear reactor transient analysis. Dynamic MC (DMC) neutron tracking for transient analysis requires efficient algorithms for delayed neutron generation, neutron population control, and initial condition modeling. In this paper, a new MC steady-state simulation method based on time-dependent MC neutron tracking is proposed for steady-state initial condition modeling; during this process, prompt neutron sources and delayed neutron precursors for the DMC transient simulation can easily be sampled. The DMC method, including the proposed time-dependent DMC steady-state simulation method, has been implemented in McCARD and applied for two-dimensional core kinetics problems in the time-dependent neutron transport benchmark C5G7-TD. The McCARD DMC calculation results show good agreement with results of a deterministic transport analysis code, nTRACER.

• Atmosphere
• /
• v.26 no.4
• /
• pp.541-551
• /
• 2016

A real-time quality control algorithm for $PM_{10}$ concentration measured by Continuous Ambient Particulate Monitor (FH62C14, Thermo Fisher Scientific Inc.) has been developed. The quality control algorithm for $PM_{10}$ data consists of five main procedures. The first step is valid value check. The values should be within the acceptable range limit. Upper ($5,000{\mu}g\;m^{-3}$) and lower ($0{\mu}g\;m^{-3}$) values of instrument detectable limit have to be eliminated as being unrealistic. The second step is valid error check. Whenever unusual condition occurs, the instrument will save error code. Value having an error code is eliminated. The third step is persistence check. This step checks on a minimum required variability of data during a certain period. If the $PM_{10}$ data do not vary over the past 60 minutes by more than the specific limit ($0{\mu}g\;m^{-3}$) then the current 5-minute value fails the check. The fourth step is time continuity check, which is checked to eliminate gross outlier. The last step is spike check. The spikes in the time series are checked. The outlier detection is based on the double-difference time series, using the median. Flags indicating normal and abnormal are added to the raw data after quality control procedure. The quality control algorithm is applied to $PM_{10}$ data for Asian dust and non-Asian dust case at Seoul site and dataset for the period 2013~2014 at 26 sites in Korea.

• Korean Journal of Community Nutrition
• /
• v.25 no.2
• /
• pp.150-158
• /
• 2020

Objectives: This study was conducted to estimate usual meat intake distribution, which may have been over/underestimated when estimations were made using only the third food codes of the Korea National Health and Nutrition Examination Survey (KNHANES). Methods: For this purpose, 24-hour recall data from the 2009 Korea National Health and Nutrition Examination Survey, which conducted a partial 2-day survey of food intake, were used. The Multiple Source Method (MSM) was used to estimate the distribution of the usual intake of red and processed meats. Results: The results of this study show that the mean intake of red meat was 45.07 g while that of processed meat was 4.33 g. These results are slightly higher than the consumption calculated using only tertiary food code, and the difference was statistically significant. Furthermore, characteristics of the estimated usual intake distribution were a smaller standard deviation, increased lower percentiles, and decreased upper percentiles compared to the 2-day mean intake distribution for both red and processed meats. The proportion of individuals not consuming red meat decreased substantially from approximately 37% to 0.7%. The proportion of consumption that exceeded 90 g, which is the upper limit of red meat intake recommended by the National Health Service (NHS), was only approximately 10% in the distribution of usual intake. Conclusions: As the consumption of processed foods is expected to continuously increase, caution is needed regarding the processes used to calculate food (group) intake to avoid over/underestimation. Moreover, use of KNHANES data to calculate the proportion of the population at risk of insufficiency or excess intake of certain nutrients or food (group), based on one day intake that does not address within-individual variation, may lead to biased estimates.

• Journal of Radiation Protection and Research
• /
• v.41 no.4
• /
• pp.378-383
• /
• 2016

Background: Radiation dose rates in PRIDE facility is evaluated quantitatively for assessing radiation safety of workers because of large amounts of depleted uranium being handled in PRIDE facility. Even if direct radiation from depleted uranium is very low and will not expose a worker to significant amounts of external radiation. Materials and Methods: ORIGEN-ARP code was used for calculating the neutron and gamma source term being generated from depleted uranium (DU), and the MCNP5 code was used for calculating the neutron and gamma fluxes and dose rates. Results and Discussion: The neutron and gamma fluxes and dose rates due to DU on spherical surface of 30 cm radius were calculated with the variation of DU mass and density. In this calculation, an imaginary case in which DU density is zero was added to check the self-shielding effect of DU. In this case, the DU sphere was modeled as a point. In case of DU mixed with molten salt of 50-250 g, the neutron and gamma fluxes were calculated respectively. It was found that the molten salt contents in DU had little effect on the neutron and the gamma fluxes. The neutron and the gamma fluxes, under the respective conditions of 1 and 5 kg mass of DU, and 5 and $19.1g{\cdot}cm^{-3}$ density of DU, were calculated with the molten salt (LiCl+KCl) of 50 g fixed, and compared with the source term. As the results, similar tendency was found in neutron and gamma fluxes with the variation of DU mass and density when compared with source spectra, except their magnitudes. Conclusion: In the case of the DU mass over 5 kg, the dose rate was shown to be higher than the environmental dose rate. From these results, it is concluded that if a worker would do an experiment with DU having over 5 kg of mass, the worker should be careful in order not to be exposed to the radiation.

• Journal of Convergence Society for SMB
• /
• v.6 no.3
• /
• pp.21-27
• /
• 2016

In this paper, we introduce the PB/MC-CDMA (Partial Block/Multi-Carrier-Code Division Multiple Access) system to mitigate inter-cell interference (ICI) and enhance user capacity in the small cell environment. In 5G mobile communications, the number of devices connected to the network is expected to increase exponentially with the expansion of the IoT (Internet of Things) services. In addition, each device is expected to be required by the various data rates by their content types. In LTE/LTE-A, there are some limitations that large scale connectivity and supporting various data rates. Therefore, we introduce a PB/MC-CDMA physical layer system which is suitable for the small cell environment, and evaluate the performance in the multi cell environment which is affected by ICI. Through computer simulation results, we demonstrate the effectiveness of PB/MC-CDMA for the small cell environment.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.1A
• /
• pp.115-124
• /
• 2007

In this paper, the I/Q mismatch problem between the transmission line and antenna switch is solved by a new CPW matching circuit for a VoWLAN terminal with 54 Mbps communication speed through the IEEE 802.11 b/g CCK/OFDM. I/Q performances with the new matching circuit are analyzed and improved by the output spectrum mask, the characteristics of the EVM(Error Vector Magnitude) due to the nonlinear CCK/OFDM demodulation data, and receiver's sensitivity.

• Journal of the Korean Institute of Intelligent Systems
• /
• v.23 no.5
• /
• pp.379-384
• /
• 2013

For effective ship management in VTS(Vessel Traffic Service), it needs to assess the external force acting on ship. Big data in maritime traffic can be roughly categorized into two groups. One is the traffic information including ship's particulars. The other is the external force information e.g., wind, sea wave, tidal current. This paper proposes the method to assess the external force acting on ship using big data in maritime traffic. To approach Big data in maritime traffic, we propose the Waterway External Force Code(WEF code) which consist of wind, wave, tidal and current information, Speed Over the Water(SOW) of each ship, weather information. As a results, the external force acting a navigating ship is estimated.

• Computational Structural Engineering
• /
• v.8 no.3
• /
• pp.113-122
• /
• 1995

The purpose of this study is to evaluate performance and safety of structures designed according to current seismic code or provisions (e.g., Uniform Building Code(UBC), NEHRP provisions, etc.) during lifetime of structures. The performance is represented in terns of reliability in this paper. To perform reliability analyses, a large number of time history response analyses for a given structure are usually required. In this study, to perform reliability analyses ground motions are generated based on nonstationary random process and structures are designed based on UBC. In this paper, responses of structures under a given earthquake is evaluated using dynamic nonlinear time history analyses and also an equivalent nonlinear system (ENS) with response scaling factors. The ENS system is described in the companion paper. Therefore, this paper evaluates the seismic performance of structures and also verify the accuracy of ENS.

• The Transactions of the Korea Information Processing Society
• /
• v.1 no.3
• /
• pp.299-310
• /
• 1994

Re-engineering tools can substantially increase software maintenance productivity and the quality of maintenance work. Re-engineering usually involves changing the form(e.g.changining objects names and definitions, restructuring process logic) of a program. In this paper, we describe the design and implementation of InMaC＋＋ that is a software tool oriented towards maintenance of C＋＋ object oriented programs. With InMaC＋＋, programms can be displayed and edited in two forms : as the code and as the diagram InMaC＋＋ also contains transformations in both directions, i,e. from code to diagram and from diagram to skeletons of code. Hence, it is suitable for re-engineering and maintenance of existing code. Specially designed browsers implement the graphical interface. InMaC＋＋ contains a database that is based on a simple but effective data model of InMaC＋＋ programs. The model contains only four object classes and three relations, which makes the tool small, and easy to implement and use. A simple query language allows browsing through the database.

• Herbal Formula Science
• /
• v.30 no.1
• /
• pp.19-25
• /
• 2022

Objectives : Huangqintang(⿈芩湯) is a famous herbal prescription in the Traditional Korean Medicine (e.g. Shanghanlun) to treat various chronic disease such as neurological disease and digestive system disease. Its components include Scutellariae Radix(⿈芩), Paeonia lactiflora(芍藥), Glycyrrhizae Radix et Rhizoma(⽢草), Zizyphi Fructus(⼤棗). Methods : In this study, we standardize the name, composition and medical uses of Huangqintang by literature studying and paper searching. Based on the comparison between oriental medicine and modern medicine pharmacology, we linked the medical uses of Huangqintang to Korean Standard Classification of Diseases (KCD). Results and Conclusion : The name of the prescription is unified into "Huangqintang", and its composition ratio between Scutellariae Radix, Paeonia lactiflora, Glycyrrhizae Radix et Rhizoma, and Zizyphi Fructus is 3:2:2:3. Huangqintang is used for enteritis diseases due to its antipyretic and antinflammatory effects. Its medical application was relatied with 'A'code, 'C'code, and 'K'code as indicated by KCD. By standardizing the mixed conceptions of Huangqintang, this review will facilitate the coding of Huangqintang prescription. Therefore, it will make Huangqintang prescription more useful in clinics.