• Tribology and Lubricants
• /
• 제18권2호
• /
• pp.133-137
• /
• 2002

This paper reports on the effect of fuel additive friction modifier on the engine friction and fuel consumption. The test of engine friction and fuel consumption is performed for the each oils and fuels. The TFA4724 friction modifier is added in test oil and fuel. The test results show that total engine friction is a decrease of 0.7-2.0% compared with base fuel, and fuel consumption is improved by 0.3%. The amount of friction reduction corresponds to that of boundary friction loss term in ring-pack friction losses. From the results, it is thought that the additive friction modifier in the fuel is effective to reduce the boundary friction in ring-pack.

• Journal of Biosystems Engineering
• /
• 제35권1호
• /
• pp.1-9
• /
• 2010

A mathematical model was developed to predict the fuel consumption rate consumed by agricultural tractors under arbitrary loaded conditions. The model utilizes the measured data on the fuel consumptions at the full load and at the rated engine speed with partial loads, which can easily be obtained from the official OECD tractor test reports. It was found from the analysis of the measured fuel consumption data that the fuel consumptions at two different speeds does not change with power. The model was developed based on this fact and validated with the measured data of the 159 tractor test reports. The fuel consumptions predicted by the model were compared with those measured under the partially loaded conditions specified in the official OECD tractor test code II. The percent errors of the predicted fuel consumptions were in a range from 0.36 to 2.86% which assured that the developed fuel consumption model can be used practically to predict the fuel consumptions at any speed and power combinations. It was also shown that the developed model predicts the fuel consumption rate better than the Grisso's model.

• 한국산업융합학회 논문집
• /
• 제23권6_2호
• /
• pp.949-956
• /
• 2020

It's important to measure fuel consumption of vehicles. It's possible to monitor green house gas from vehicles for various traffic conditions with the measured data. It's effective to eco-drive for drivers with fuel consumption data also. There's a display of fuel consumption in the modern vehicles, but it's not useful to get the data from the display. An estimating method for fuel consumption of a vehicle is suggested in the study. It's a simple but an effective method using GPS data. The GPS data(speed, acceleration, road slope) and vehicle data(weight, frontal area, model year, certified fuel economy) is necessary to estimate the fuel consumption for the method. It calculates driving resistance force to estimate engine power. Then it estimates the necessary fuel consumption to maintain the engine power with fuel-power conversion factor. The conversion factor is corrected with certified fuel economy, model year and rated power. The precision of the methods is checked with road test data. The test driving data was measured with GPS and OBD. The error of the estimated fuel consumption for the measured one is about 1.8%. But the error is large for the 1000 and 100 data number from the total data number of about 10,000. The error is from the larger change range of the GPS data than the one of the measured fuel consumption data. But the proposed estimating method is useful to percept the fuel consumption change for better fuel economy with simple gadget like smart phone or other GPS instruments.

• 한국ITS학회 논문지
• /
• 제13권4호
• /
• pp.48-56
• /
• 2014

유류소모량 산정 모형 개발을 위해서는 차종, 도로의 경사, 포장상태, 포장종류 등 다양한 변수들을 고려해야 하지만 현재 사용하고 있는 국토교통부의 투자평가지침에도 차종으로만 구분이 되어 있을 뿐 다양한 요인들을 고려하지 못하고 있는 실정이다. 본 연구에서는 도로의 경사도가 승용차의 유류소모량에 미치는 영향을 분석하기 위해 실제 주행실험을 통해 얻은 데이터를 기반으로 유류소모량 산정 모형을 개발하고 적용성을 검증하는 것을 목적으로 한다. 경사도에 따른 유류소모량 모형 개발을 위해 GPS 장비와 연비측정장비를 이용하여 실제 주행실험을 통해 유류소모량을 초(sec)단위로 측정하였다. 평지(${\pm}0{\sim}2%$), 오르막(+2~5%), 내리막(-2~5%)의 세 가지 경사도로 구분하였으며 차량의 속도와 유류소모량을 변수로 하는 회귀모형을 이용하여 모형을 개발하였다. 승용차의 유류소모량은 내리막, 평지, 오르막 순으로 커지는 것을 확인할 수 있었다.

• 한국기후변화학회지
• /
• 제7권2호
• /
• pp.177-184
• /
• 2016

Recently, the need for technology development of commercial vehicle fuel consumption has emerged. Fuel economy improvement of transport equipment and transportation efficiency, and increasing attention to the logistics cost reduction measures. Increasing attention to the logistics cost reduction measures by fuel economy improvement of transport equipment and transportation efficiency. In this study, we have installed aerodynamic reduction device (side skirt, boat tail) to 14.5 ton cargo trucks and 45 ft tractor-trailers. And the fuel consumption was compared installed before and after. Fuel economy assessment for the aerodynamic reduction value device was tested by modifying the SAE J1321 Joint TMC/SAE Fuel Consumption Test Procedure - Type II test in according domestic situation. Greenhouse gas reductions were calculated in accordance with the scenario, including fuel consumption test results. When the 14.5 ton cargo trucks has been equipped with side skirts and boat tail, it confirmed the improvement in fuel efficiency of 4.72%. One Heavy-duty truck's the annual greenhouse gas reductions value are $6.86ton\;CO_2\;eq$. And if applying the technology to more than 50% of registered 15 ton trucks, greenhouse gas reductions are calculated as $686,826ton\;CO_2\;eq./yr$.

• 한국수소및신에너지학회논문집
• /
• 제21권3호
• /
• pp.207-213
• /
• 2010

Fuel consumption measurement of hydrogen fuel cell vehicle is considerably different from internal combustion engine vehicle such as carbon balance method. A practical method of fuel consumption measurement has been developed for hydrogen fuel cell vehicles. There are three method of hydrogen fuel consumption testing, gravimetric, PVT (pressure, volume and temperature), and mass flow, all of which necessitate physical measurements of the fuel supply. The purpose of this research is to measure the fuel consumption of hydrogen fuel cell vehicles on chassis-dynamometer and to give information when the research is intended to develop test method to measure hydrogen fuel economy.

• 한국신재생에너지학회:학술대회논문집
• /
• 한국신재생에너지학회 2007년도 추계학술대회 논문집
• /
• pp.152-155
• /
• 2007

Fuel cell electric vehicles (FCEVs) using hydrogen gas are zero emission vehicles, thus emission measurement for combustion vehicles is not applicable. The hydrogen gas consumption for fuel economy will be measured by the stabilized pressure/temperature method, mass flow method and electrical current method, etc. In this research, weight method with a newly manufactured test equipment is applied to measure the hydrogen consumption because above 3-methods have a deviation. The hydrogen consumption is directly calculated by the weight differences of the external hydrogen tank before and after the chassis dynamometer test. Ultimately the fuel economy for FCEVs is obtained with a deviation less than 1% in all chassis dynamometer tests.

• 오토저널
• /
• 제6권4호
• /
• pp.36-45
• /
• 1984

The relationship between vehicle driving pattern and fuel consumption in urban area was studied in Seoul along three representative routes using a test car equipped with all the instruments required for recording modes of traffic and measuring fuel consumption. Correlation with idle speed, fuel consumption and CO concentration of car in use was also measured. The average vehicle speed in Seoul was 31.4 km/h and the time spent in different modes was 23.0% in idle mode, 22.5% in acceleration mode, 32.4% in cruising mode and 22.3% in deceleration mode, respectively. Hence, traffic flow was suggested to be relatively smooth. Fuel consumption per unit distance, .phi. was closely related with trip time spent per unit distance, t, and correlation coefficient obtained from the test car was 0.925, and the relationship between .phi. and t was also obtained from the linear regression with the following equation. .phi.=42.87+0.38 t. Idle speed of vehicle in use was mostly adjusted low and cars which were over the permissible standard of CO concentration (4.5%) were 50% or more. As the idle speed decreased, the fuel consumption was decreased, while the CO concentration was increased. Therefore, the decrease of fuel consumption can not be expected with only a decrease in idle speed.

• 한국추진공학회:학술대회논문집
• /
• 한국추진공학회 2011년도 제37회 추계학술대회논문집
• /
• pp.908-911
• /
• 2011

항공기에 사용되는 보조동력장치는 주연료(JP-8) 뿐 아니라 비상시 운용을 위하여 규정된 비상연료를 사용하여 운용이 가능하여야 한다. 이러한 요구조건을 입증하기 위하여 상용 디젤유에 대하여 비상연료 시험을 수행하였다. 디젤유의 경우, 시험 전, 후 부하조건에 따른 비연료소모율의 차이는 3.5%~7.8%로 요구조건을 만족하였다. 주연료와 비교하여 디젤유 적용에 따른 시동특성은 유사하였다. 비연료소모율은 부하조건의 변화에 따라 주연료 대비 2.0%~3.4%의 차이가 발생하였다.

• 한국자동차공학회논문집
• /
• 제23권3호
• /
• pp.326-335
• /
• 2015

In this paper, is a study that analyzed the fuel consumption of hybrid tractor. Testing and analysis in order to evaluate the fuel consumption was performed. Analysis model was developed by using the SimulationX that is a commercial software. Also, map of the analysis model was modeled on the basis of test data. Test was performed using a dynamo device. The engine was tested the fuel consumption in accordance with the conditions on the load and throttle opening. The battery was tested the discharge and charge in accordance with the current amount. We verified the reliability of the analysis model by comparing the analysis results with the rest results. After considering the reliability of each analysis model was extended to the entire hybrid tractor system. To evaluate the efficiency using the analysis model, compared the fuel consumption of general tractor with hybrid tractor in the same load conditions.