• Wind and Structures
• /
• v.4 no.2
• /
• pp.101-118
• /
• 2001

This paper reports the field measurements concerning pressure equalization of rainscreen facades carried out at the Technical University of Eindhoven (TUE) in the Netherlands. The field facility including the details of test panel, meteorological tower, instrumentation, data collection and analysis is presented. Results of investigations into cavity response for various leakage and venting configurations are discussed. Frequency domain techniques have been utilized to show the influence of wind as well as facade characteristics on the pressure equalization performance. Further, this paper presents an early attempt to synthesize the experimental results into existing building codes.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.19 no.5
• /
• pp.129-133
• /
• 2019

Frequency resource efficiency is important in satellite communication systems. One of the causes of a waste of frequency resource is bad flatness. In the case, flatness of satellite Tx terminals would be worse by ACI and guard band. In order to overcome this problem, this paper proposes a technique for frequency response equalization in satellite Tx terminals. First of all, a general linear polynomial expression which meets least squares of representative measurement data is calculated to interpolate unmeasured data. And then flatness can be adjusted using the polynomial expression. Simulation results illustrate adjusted data have lower peak to peak and standard deviation than original data, and these show that flatness be improved.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.16 no.5
• /
• pp.413-423
• /
• 1991

Some digital partical response continuous phase modulation signals such as 3RC, 3SRC, 4SRC, and TFM have cconstant envelope characteristics and compact power spectra. However, their bit error rates in fast fading environments are too high when a simple frequency detection is used. This is due to high inter symbol interference resulting from adjacent bits. The improvement of BER performance by using DFE(Decision Feedback Equalization) to cancel the ISI of one adjacent bit is theoretically investigated in this paper. Numerical resuls are presentes to compare the BER performance of frequency detection with and without decision feedback equalization.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.13 no.11
• /
• pp.5394-5409
• /
• 2019

The paper investigates a novel detector receiver with Kalman channel information estimator and iterative channel response equalization for MIMO (multi-input multi-output) OFDM (orthogonal frequency division multiplexing) communication systems in fast multipath fading environments. The performances of the existing linear equalizers (LE) are not good enough over most fast fading multipath channels. The existing adaptive equalizer with decision feedback structure (ADFE) can improve the performance of LE. But error-propagation effect seriously degrades the system performance of the ADFE, especially when operated in fast multipath fading environments. By considering the Kalman channel impulse response estimation for the fast fading multipath channels based on CE-BEM (complex exponential basis expansion) model, the paper proposes the iterative receiver with soft decision feedback equalization (SDFE) structure in the fast multipath fading environments. The proposed SDFE detector receiver combats the error-propagation effect for fast multipath fading channels and outperform the existing LE and ADFE. We demonstrate several simulations to confirm the ability of the proposed iterative receiver over the existing receivers.

• Proceedings of the IEEK Conference
• /
• 1999.06a
• /
• pp.69-72
• /
• 1999

In this paper, an efficient time domain equalization algorithm for discrete wavelet multitone(DWMT) data transmission is developed. In this algorithm, the time domain equalizer(TEQ) consists of two stages, i.e., the channel impulse response shortening equalizer(TEQ-S) in the first stage and the channel frequency flattening equalizer(TEQ-F) in the second stage. TEQ-S reduces the length of transmission channel impulse response to decrease intersymbol interference(ISI) followed by TEQ-F that enhances the channel frequency response characteristics to the level of an ideal channel, hence diminishes the bit error rate. TEQ-S is implemented using the least-squares(LS) method, while TEQ-F is designed by using the least mean-square(LMS) algorithm. Since DWMT system also requires of the frequency domain equalizer in order to further reduce ICI and ISI the hardware complexity is an another concern. However, by adopting an well designed and trained TEQ, the hardware complexity of the whole DWMT system can be greatly reduced.

• Journal of the Institute of Convergence Signal Processing
• /
• v.2 no.3
• /
• pp.32-38
• /
• 2001

Multi-carrier data transmission system performance is mostly limited by Inter- symbol-interference that is caused by a dispersive characteristic of the transmission channel. In order to enhance the system performance to meet the service requirements of local access, the channel impulse response shortening method incorporated with a channel frequency response compensation method is proposed. For a fast and efficient implementation of the equalizer proposed, Kalman and LMS algorithms are successively used. To verify the channel equalization performance, a set of computer simulation is performed on a filter bank based multitone system operating in a typical high-speed local area data transmission environment. The results showed us a comparable signal-to-interference improvement over the conventional multitone equalization scheme.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.23 no.8
• /
• pp.981-987
• /
• 2019

In this paper, we propose a new SC-FDE (single carrier frequency domain equalization) structure to cope with narrow band interference signals or jammers and reduce pilot overhead. The conventional SC-FDE structure has a problem that the receiver performance degrades severely due to difficulty in time-domain channel estimation when narrow band jammers exist. In addition, the spectral efficiency is lowered by transmitting pilot at every SC-FDE block to estimate channel response. In order to overcome those problems, the proposed structure is devised to estimate frequency domain channel directly without time domain channel estimation. To reduce the pilot overhead, several data blocks are transmitted between two pilots. The channel estimate of each data block is found through linear interpolation of two channel estimates at two pilots. By performing frequency domain channel equalization using this channel estimate, the distortion by the channel is well compensated when narrow band jammers exist. The performance of the proposed structure is confirmed by computer simulation.

• 제어로봇시스템학회:학술대회논문집
• /
• 2003.10a
• /
• pp.1398-1403
• /
• 2003

In this paper, a simple method to design an MIMO sound field control system was proposed. The control system was designed to achieve 1) noise attenuation and 2) sound equalization by utilizing feedback and feedforward controllers. The method was based on partial model matching on frequency domain which only required measured frequency response data, or impulse response data in order to tune parameters of the controller. The proposed method was applied to a normal office room and results of experiment showed effectiveness of the proposed method.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2002.05a
• /
• pp.298-302
• /
• 2002

Equivalent volume estimation of the coupler and two coupled microphones has a key role in standard microphone pressure calibration. The equivalent volume of the microphone is determined by the dynamic characteristics of the diaphragm system and front cavity. Therefore the modal parameters of diaphragm system - natural frequency and damping fatter - should be measured explicitly for the estimation of the equivalent volume. The diaphragm system is composed of the vibrating diaphragm, back slit behind diaphragm, pressure equalization vent, and front cavity which are acoustically coupled. In the measurement, the electrostatic actuator was used to excite the system with the swept sine, and the frequency response was obtained. The close actuator in front of the diaphragm must influence the radiation impedance of the system, and then the modal parameters. From the measured frequency response, the natural frequency and the damping factor could be estimated with the Complex exponential method based on the Prony model and the zero crossing real and imaginary plot.

• ETRI Journal
• /
• v.44 no.1
• /
• pp.125-134
• /
• 2022

Visible light communication (VLC) systems incorporate ambient lighting and wireless data transmission, and the experienced channel in indoor VLC is a major topic that should be examined for reliable communication. In this study, it is realized that multiple transmitters in classical alignment are the forceful factors for channel characteristics. In the frequency band, fluctuations with sudden drops are observed, where the fluctuation shape is related to the source layout and receiver location. These varying frequency-selective channels need solutions, especially for mobile users, because sustained channel estimation and equalization are necessary as the receiver changes its location. It is proven that using light-emitting diodes (LEDs) with highly directional beams as sources or using a detector with a narrow field of view (FOV) in the receiver may help partially alleviate the problem; the frequency selectivity of the channel reduces in some regions of the room. For flat fading channel characteristics all over the room, LEDs should be aligned in hexagonal cellular structure, and detector FOV should be arranged according to the cell dimension outcomes.