• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.8 no.7
• /
• pp.2231-2245
• /
• 2014

Cognitive Radio (CR) has very promising potential to improve spectrum utilization by allowing unlicensed Secondary Users (SUs) to access the spectrum dynamically without disturbing licensed Primary Users (PUs). Mitigating interference is a fundamental problem in CR scenarios. This is particularly problematic for deploying CR in cellular networks, when users are located at the cell edge, as the inter-cell interference mitigation and frequency reuse are critical requirements for both PUs and SUs. Further cellular networks require higher cell edge performance, then SUs will meet more challenges than PUs. To solve the performance decrease for SUs at the cell edge, a novel Dynamic Spectrum Allocation (DSA) scheme based on Game Theory is proposed in this paper. Full frequency reuse can be realized as well as inter-cell interference mitigated according to SUs' sensing, measurement and interaction in this scheme. A joint power/channel allocation algorithm is proposed to improve both cell-edge user experience and network performance through distributed pricing calculation and exchange based on game theory. Analytical proof is presented and simulation results show that the proposed scheme achieves high efficiency of spectrum usage and improvement of cell edge SUs' performance.

• Proceedings of the Korean Environmental Sciences Society Conference
• /
• 2005.05a
• /
• pp.267-271
• /
• 2005

This experiment was carried out at 450"C, which is relatively lower than the temperature for supercritical water oxidation (600-650$^{\circ}C$). In this experiment, the decomposition rates of various incombustible organic substances were very high. In addition, it was confirmed that hetero atoms existed in organic compounds and chlorine was neutralized by sodium(salt formation).However, to raise the decomposition rate, relatively large amount of sodium nitrate(3-4 times the equivalent weight) was required. When complete oxidation is intended as in the case with PCB, the amount of oxidizer and decomposition cost is important. But when vaporization reduction is required as in the case with nuclear wastes, the amount of radioactive wastes increases instead. But as can be seen in the result of XRD measurement, unreacted sodium nitrate remained unchanged. If oxidation reaction of organic substance simply depends on collision frequency, unreacted sodium nitrate can be recovered and reused, then oxidation equivalent weight would be sufficient. In the gas generated, toxic gas was not found. As the supercritical water medium has high reactivity, it is difficult to generate relatively low energy level SO$_{X}$, and NO$_{X}$.

• The Journal of the Korea Contents Association
• /
• v.9 no.1
• /
• pp.167-176
• /
• 2009

Traditional cluster-based routing method is a representative method for increasing the energy efficiencies. In these cluster-based routing methods, the selected cluster head collect/aggregate the information and send the aggregated information to the base station. But they have to solve the unnecessary energy dissipation of frequent information exchange between the cluster head and whole member nodes in cluster. In this paper, we minimize the frequency of the information exchange for reducing the unnecessary transmit/receive frequencies as calculate the overlapped area or number of overlapped member nodes between the selected cluster head and previous cluster head in the setup phase. So, we propose the modified cluster selection protocol method that optimizes the energy dissipation in the setup phase and reuses the saved energy in the steady-state phase efficiently that prolongs the whole wireless sensor network lifetime by uniformly selecting the cluster head.

• Journal of Internet Computing and Services
• /
• v.19 no.4
• /
• pp.95-105
• /
• 2018

As the IT industry has developed, the frequency of mobile communication usage has increased sharply. Mobile communication has many advantages such as improving work performance, communication beyond time and local constraints, and rapid and vast amounts of information exchange. However, mobile communication also allows supervisors to give their subordinates work at any time. Thus, mobile communication may also have a negative impact on workers' stress levels during non-work time. This study examined required time, urgent business, personal engagement, and trivial matters as sub-dimensions of mobile communication messages that workers could receive during non-work time. Further, the nature of the relationship between team leaders and members explains how these messages may increase the stress levels of workers. Supervisors should prohibit the use of such mobile communication, and efforts should be made at the enterprise level. Through this research, we aim to explain the dual nature of mobile communication, and understand how to optimize the usage of this innovative technology

• The KIPS Transactions:PartA
• /
• v.12A no.1 s.91
• /
• pp.7-12
• /
• 2005

Scattered look-ahead(SLA) pipelining method can be efficiently used for high-speed or low-power applications of digital II R filters. Although the pipelined filters are guaranteed to be stable by this method, these filters suffer from large roundoff noise when the poles are crowded within some critical regions. An angle and radius constrained II R fille. design approach using modified Remez exchange algorithm and least squares algorithm is proposed to avoid tight pole-crowding in pipelined filters, resulting in improved frequency responses and reduced coefficient sensitivities. Experimental results demonstrate that our proposed method leads to chip area reduction by $33{\%}$ and low power by $45{\%}$ against the conventional method.

• Proceedings of the Korea Information Processing Society Conference
• /
• 2016.04a
• /
• pp.900-902
• /
• 2016

사물인터넷은 최근 몇 년간 급격한 발전을 이루었으며 발전을 바탕으로 삶의 질 향상과 상업적인 가치가 큰 스마트 환경을 구축하였다. 스마트 환경 구축을 위해서는 각각 사물들이 사용하는 통신 프로토콜 간 통신이 되어야 한다. 그러나 통신 프로토콜 간 서로 다른 통신 규약을 가지기 때문에 통신이 안 되는 이질성 문제가 있으며 이러한 문제를 해결하기 위해서는 DDS(Data Distribution Service) 기반의 어댑터(Adaptor)가 필요하다. 본 논문은 최근 각광받고 있는 BLE(Bluetooth Low Energy)를 사물 인터넷에 적용하기 위해 DDS 기반의 BLE 어댑터를 제안한다. 이러한 BLE 어댑터를 통하여 BLE와 RFID(Radio-Frequency Identification), LTE(Long-Term Evolution), 그리고 지그비(ZigBee) 등 다른 통신 프로토콜 간 이질성 문제를 해결함으로써 서로 다른 데이터를 활용할 수 있다.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.8B
• /
• pp.1012-1020
• /
• 2011

In this paper a design of $\pi$/4-DQPSK baseband receiver for the exchange of digital data and e-mail between shore and ship stations and/or among ship stations in the maritime mobile service VHF channels is described. Due to the permitted relatively big frequency instability of local oscillators at the transmitter and the receiver of maritime communication system, the designed baseband receiver should have the capabilities of correct estimation and compensation of the synchronization parameters, such as symbol timing and frequency offset, from the received signal which might include relatively big frequency error. Simulated BER results show that the designed baseband receiver works less than 0.5dB loss under AWGN channel when the normalized frequency offset of the received signal is more then 20%.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2014.10a
• /
• pp.208-210
• /
• 2014

IOT(Internet of Things) through Radio Frequency Identification (RFID), Wireless Sensors, Global Positioning Systems, Laser Scanners and other information sensing device, according to the agreed protocol keep anything connected to the Internet for information exchange and communication. It's a network what in order to achieve intelligent identify, locate, track, monitor and manage. With the development of IOT technology, data growth will explode once again on the existing basis, which gives data management enormous challenges. This paper described characteristics of data in IOT and analysis existing data management technologies, then proposed a data management framework to conduct the research on the data management of IOT.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.19 no.12
• /
• pp.32-40
• /
• 2018

In order to avoid excessive vibration, it is required to carry out a vibration analysis of heat-exchanger/nuclear-reactor at the design stage. Information of eigen-frequency in the vibration problem is required to evaluate safety of heat-exchange/nuclear reactor. This paper describes a numerical method, Galerkin's method, to solve the eigenvalue problem occurred in a cantilever beam. The beam is restrained with added mass and spring at the free end or a node point of a mode shape. The numerical results of eigen-frequency were compared with simple analytical and experimental results given by simple approach and simple test, respectively. It is found that Galerkin's method is applicable to estimate the eigen-frequency of the cantilever beam. The frequencies become lower with increasing the added mass and the frequencies increase with the spring force. It is shown the heavy added mass has a role of support on the flexible tube. The eigen-frequency of the first mode, for the system with the added mass mounted at the free end, can be calculated by the approximate analytical method existing with more or less accuracy.

• Journal of Fisheries and Marine Sciences Education
• /
• v.25 no.1
• /
• pp.260-273
• /
• 2013

This study aims to reflect experts' opinions in analyzing a design thinking as foundation of multidisciplinary education. For this purpose, a delphi survey was conducted with 20 experts in three sessions from May 1 to June 25, 2012. To analyze the collected data, descriptive statistics, including frequency, percentage, the mean, and standard deviation were implemented, and internal reliability test on the survey instrument was carried out for statistical processing. The main results are as follows : First, the delphi analysis on intuitive thinking of design thinking suggested 7 items(to pursue the possibility of outside, to pursue the possibility of applying new forms of technology, content planning, facing a complex real-world phenomena etc.). Second, the delphi analysis on logical thinking of design thinking suggested 7 items(executed repeatedly, reasoning and verification, artificial intelligence, a decision support system etc.) Third, the delphi analysis on subjective thinking of design thinking suggested 9 items(user experience measuring, user satisfaction ratings, user requirements analysis, user interface design, behavioral responses of the human etc.). Fourth, the delphi analysis on objective information of design thinking suggested 8 items(information management system, simulation, production process, information exchange and sharing etc.). According to the results of the delphi analysis, design thinking can be seen as the foundation of multidisciplinary education. Suggestions were made for discussion about the main results and further researches.