• Journal of the Korean Society of Physical Medicine
• /
• v.9 no.3
• /
• pp.279-284
• /
• 2014

PURPOSE: This study intended to verify whether there was actual correlation between weight-bearing asymmetry and a limitation in hip joint rotation range in patients with low back pain. METHODS: Thirty five low back pain patients voluntarily participated this study. For each participant, hip joint medial rotation symmetry rate and the weight-bearing symmetry rate were calculated. The correlation between the two variables was investigated. RESULTS: A decrease in the left hip joint medial rotation range of motion (ROM) was observed more often than a reduction in the right hip joint medial rotation ROM. However, similar number between right and left side was observed in ground reaction force more weighted. The coefficient between the passive hip joint medial rotation symmetry rate and the weight loading symmetry ratio was -0.19 (p < 0.05). CONCLUSION: The present study demonstrated a weak correlation between the hip joint medial rotation ROM and the weight distribution of both feet. Such result suggests that careful evaluation by separating each element is needed in treating patients with low back pain. Future research should take into account asymmetric alignment and abnormal movement in different joints of the body as well as asymmetry in the bilateral hip joint rotation and the unilateral weight supporting posture.

• Journal of Institute of Control, Robotics and Systems
• /
• v.15 no.2
• /
• pp.163-168
• /
• 2009

In this study, we would be developed the fuzzy controlled PGO that controlled the flexion and the extension of each PGO's hip joint using the bio-signal and FSR sensor. The PGO driving system is to couple the right and left sides of the orthosis by specially designed hip joints and pelvic section. This driving system consists of the orthosis, sensor, control system. An air supply system of muscle is composed of an air compressor, 2-way solenoid valve (MAC, USA), accumulator, pressure sensor. Role of this system provide air muscle with the compressed air at hip joint constantly. According to output signal of EMG sensor and foot sensor, air muscles and assists the flexion of hip joint during PGO gait. As a results, the maximum hip flexion angles of RGO's gait and PGO's gait were about $16^{\circ}\;and\;57^{\circ}$ respectively. The maximum angle of flexion/extention in hip joint of the patients during RGO's gait are smaller than normal gait, because of the step length of them shoes a little bit. But maximum angle of flexion/extention in hip joint of the patients during PGO's gait are larger than normal gait.

• Journal of the Korea Furniture Society
• /
• v.28 no.2
• /
• pp.126-134
• /
• 2017

This study explores PyeongSang, a piece of traditional Korean furniture, in order to make people know the details about what the piece is in the first paper. And based on the paper, PyeongSang will be developed as moulded multi-useful beds and sofas adapting the joint and ornament from the structure and pattern of the piece in the next paper. As the result, it appeared as two styles such as bed types mentioned as SalPyeongSang and ttulmaru in Korean. The pieces have been used from the three Kingdoms period in Korean history. The styles appeared as the structure of four parts with the lower fences called as nangan, the seats jointed by thin wood pieces, the wind hole, and the legs of foot types. The parts were beautifully carved with the ornament such as lattice patterns like geokjamun and manjamun, flower patterns like dangchomun, elephant eyes patterns like ansangmun from the Korean tradition. And the legs showed various shapes such as supports transformed from horse foots, tiger legs and bamboo, and board types carved with elephant eyes and geometric patterns. Hence, in the next paper based on this paper, PyeongSang will be developed as moulded multi-useful beds and sofas adapting the joints and ornaments from the structure and patterns of the piece.

• Korean Journal of Applied Biomechanics
• /
• v.23 no.3
• /
• pp.235-243
• /
• 2013

The purpose of this study was to analyse scientific according to period of rehabilitation training of ACL patients. ACL patients seven subjects participated in this study. Gait (1.58 m/sec) analysis was performed by using a 3-D Cinematography, a Zebris system and a electromyograph system. The data were analyzed by paired t-test. The joint angles were recorded from the ankle, knee, hip joints. Peak max dorsi-flexion and peak max plantar-flexion identified significant differences (p<0.05). Another angles were no significant difference. Vertical force (Fz) and max pressure variables improved 6 month RTP better than 3 month RTP. EMG were collected from 4 muscles (rectus femoris, biceps femoris, gastrocnemius, tibialis anterior) with surface electrides in gait system. EMG signals were rectified and smoothed data. EMG signas were no significant difference but they also improved 6 month RTP better than 3 month RTP. More research is necessary to determine exactly what constitutes optimal rehabilitation training period for ACL patients.

• Journal of Genetic Medicine
• /
• v.16 no.1
• /
• pp.15-18
• /
• 2019

SHORT syndrome is an extremely rare congenital condition due to a chromosomal mutation of the PIK3R1 gene found at 5q13.1. SHORT is a mnemonic representing six manifestations of the syndrome: (S) short stature, (H) hyperextensibility of joints and/or inguinal hernia, (O) ocular depression, (R) Rieger anomaly, and (T) teething delay. Other key aspects of this syndrome not found in the mnemonic include lipodystrophy, triangular face with dimpled chin (progeroid facies, commonly referred to as facial gestalt), hearing loss, vision loss, insulin resistance, and intrauterine growth restriction (IUGR). 3q duplication syndrome is rare syndrome that occurs due to a gain of function mutation found at 3q25.31-33 that presents with a wide array of manifestations including internal organ defects, genitourinary malformations, hand and foot deformities, and mental disability. We present a case of a 2 year and 3 month old male with SHORT syndrome and concurrent 3q duplication syndrome. The patient presented at birth with many of the common manifestations of SHORT syndrome such as bossing of frontal bone of skull, triangular shaped face, lipodystrophy, micrognathia, sunken eyes, and thin, wrinkled skin (progeroid appearance). Additionally, he presented with findings associated with 3q duplication syndrome such as cleft palate and cryptorchidism. Although there is no specific treatment for these conditions, pediatricians should focus on referring patients to various specialists in order to treat each individual manifestation.

• Korean Journal of Applied Biomechanics
• /
• v.32 no.2
• /
• pp.37-42
• /
• 2022

Objective: The aim of this study is to analyze the effect of the strength of the ankle support on the walking characteristics and ankle joints when men with flexible flat feet walk. Method: 13 adult male subjects (age: 23.9 ± 2.4 yrs, height: 173.0 ± 5.0 cm, weight: 76.9 ± 13.2 kg, Navicular Drop Test (NDT): 10.2 ± 0.8 mm) participated in this study. Each participant had to walk with the 3 conditions, barefoot, soft arch support and hard arch support, along a walkway while their kinematics was recorded at 100 Hz. Results: Based on the results of this study, it is considered that men with flexible flat feet should use hard arch support rather than bare feet to induce normal arch shape, relieve foot damage caused by excessive ankle joint abnormalities and improve stability. Conclusion: Our results for men with flat flexibility, there was a significant difference in the value of step length when walking was performed using two arch supports with different strengths. The angle of ankle dorsiflexion was significantly increased, and the ankle eversion angle was significantly decreased.

• Korean Journal of Applied Biomechanics
• /
• v.18 no.2
• /
• pp.95-104
• /
• 2008

The purpose of this study was to investigate kinematic coordination and control of lower segments in skill process. For the investigation, we examined the difference of resultant linear velocity of segments and angle vs angle graph. Novice subjects were 9 male middle school students who has never been experienced a taekwondo and expert subjects were 7 university taekwondo players. We analyzed kinematic variables of Dollyochagi motion through videographical analysis and the conclusion were as follows. 1. Examining the graph of novice subjects' maximal resultant linear velocity of the thigh, shank, and foot segment, as it gets closer to the end of the training, the maximal resultant linear velocity in each segment increased. Statistical analysis showed the following results; thigh segment caused the increase of speed, using the trunk segment's momentum in the latter term of learning, while the shank segment utilized the momentum of the adjacent proximal segment at the beginning of learning, and the foot segment in the middle of learning. 2. Until the point where the knee joint angle is minimum, as the novice group learn the skill, the flexion of knee and hip joints has changed into the form of coordination pattern in phase. On the other hand, the expert group showed continual coordination pattern in phase that the movement sequences were smooth. From the knee joint maximal flexion to impact timing, all novice and expert groups showed coordination pattern out of phase. 3. From the knee joint maximal flexion to impact timing, the ankle joint was fixed and the knee joint was extended to all the novice stages and expert subjects.

• Korean Journal of Applied Biomechanics
• /
• v.21 no.1
• /
• pp.31-38
• /
• 2011

This study aimed to determine the effects of the blockage of visual feedback on joint dynamics of the lower extremity. Fifteen healthy male subjects(age: $24.1{\pm}2.3\;yr$, height: $178.7{\pm}5.2\;cm$, weight: $73.6{\pm}6.6\;kg$) participated in this study. Each subject performed single-legged landing from a 45 cm-platform with the eyes open or closed. During the landing performance, three-dimensional kinematics of the lower extremity and ground reaction force(GRF) were recorded using a 8 infrared camera motion analysis system (Vicon MX-F20, Oxford Metric Ltd, Oxford, UK) with a force platform(ORG-6, AMTI, Watertown, MA). The results showed that at 50 ms prior to foot contact and at the time of foot contact, ankle plantar-flexion angle was smaller(p<.05) but the knee joint valgus and the hip flexion angles were greater with the eyes closed as compared to with the eyes open(p<.05). An increase in anterior GRF was observed during single-legged landing with the eyes closed as compared to with the eyes open(p<.05). Time to peak GRF in the medial, vertical and posterior directions occurred significantly earlier when the eyes were closed as compared to when the eyes were open(p<.05). Landing with the eyes closed resulted in a higher peak vertical loading rate(p<.05). In addition, the shock-absorbing power decreased at the ankle joint(p<.05) but increased at the hip joints when landing with the eyes closed(p<.05). When the eyes were closed, landing could be characterized by a less plantarflexed ankle joint and more flexed hip joint, with a faster time to peak GRF. These results imply that subjects are able to adapt the control of landing to different feedback conditions. Therefore, we suggest that training programs be introduced to reduce these injury risk factors.

• Korean Journal of Applied Biomechanics
• /
• v.15 no.3
• /
• pp.95-104
• /
• 2005

To know the proper setup posture for the various clubs, changes of setup variables according to the change of golf club length was investigated. Swing motions of three male low handicappers including a professional were taken using two high-speed videocameras. Four clubs iron 7, iron 5, iron 3 and driver (wood 1) were selected for this experiment. Three dimensional motion analysis techniques were used to get the kinematical variables. Mathcad and Kwon3D motion analysis program were used to analyze the position, distance and angle data in three dimensions. The variables divided into three categories 1) position and width of anterior-posterior direction 2) position and width of lateral direction 3) angles and evaluated based on the theories of many good golf teachers. Major findings of this study were as follows. 1.The stance (distance between ankle joints) was increased as the length of the club increased but the increasing width was not large. It ranges from 5cm to 10cm and professional player showed small changes. 2. Forward lean angle of trunk was decreased (more erected) as the length of the club increased. It ranges from 30 degrees for iron7 to 25 degrees for driver. 3. Angle between horizontal and right shoulder were increased as the length of the club increased. It ranges from 10 degrees to 20 degrees and professional player showed small changes. 4. Anterior-posterior position of the shoulders were located in front of the foot for all clubs and the difference between the shoulder and knee position was decreased as the length of the club increased. 5. Anterior-posterior position of grip (hand) was located almost beneath the shoulders (2.5cm front) for iron7, but it increased to 10cm for the driver. This grip adjustment makes the height of the posture increased only 5cm from iron7 to driver. 6. Lateral position of grip located at 5cm left for the face of iron7, but it located at the right side (behind) for the face of driver. 7. Lateral position of the ball located at the 40%(15cm) of stance from left ankle for iron7 and located at the 10% (5cm) of stance for driver. 8. Head always located at the right side of the stance and the midpoint of the eyes located at the 37% of stance from the right ankle for all clubs. This means that the axis of swing always maintained consistently for all clubs. 9. Left foot opened to the target for all subject and clubs. The maximum open angle was 25 degrees. Overall result shows that the changes of the setup variables vary only small ranges from iron7 to driver. Paradoxically it could be concluded that the failure of swing result from the excessive changes of setup not from the incorrect changes. These findings will be useful for evaluating the setup motion of golf swing and helpful to most golfers.

• Anatomy & Biological Anthropology
• /
• v.30 no.2
• /
• pp.61-65
• /
• 2017

This report describes a variation of the tendinous slip of the flexor digitorum longus (FDL) for the great toe. In addition, compositions of the long flexor tendons for all five toes were examined. The tendons of the FDL in the foot were investigated in 66 specimens of embalmed Korean adult cadavers. The tendons of the flexor hallucis longus (FHL) and the FDL with the lumbrical muscles were cut at the calcaneus and the metatarsophalangeal joints and were removed en bloc specifically to observe the FDL and the FHL tendons of the great toe. The tendinous slip of the FDL for the great toe was found bilaterally in the foot of a 52-year-old male. Its prevalence was two of 66 specimens (3.0%). The tendinous slip of the FDL for the great toe passed forward the great toe, and it constituted the superficial portion of the long flexor tendon for the great toe. The tendon of the FHL passed forward to constitute the deep portion of the long flexor tendon for the great toe. Thus, both the tendinous slip of the FDL and the tendon of the FHL composed the long flexor tendon for the great toe. The tendinous slip of the FDL and the tendon of the FHL for the great toe were similar in thickness; thus, each tendinous slip of the FDL and the tendon of the FHL were approximately one-half of the long flexor tendon for the great toe in thickness. The present study demonstrated an anatomical variation of the interconnection between the FHL and the FDL tendons, which will be useful for various surgeries and biomechanical research.