• Title/Summary/Keyword: Fluorescence method

Search Result 1,017, Processing Time 0.028 seconds

Kinetics of Cl Atom Reactions. Anomaluous Fluorescence Behavior of Some Cl Atomic Transitions

  • Kwang-Yul Choo
    • Bulletin of the Korean Chemical Society
    • /
    • v.1 no.1
    • /
    • pp.1-4
    • /
    • 1980
  • During the study of the kinetics of Cl atom reactions by atomic fluorescence method we observed anomalous fluorescence emission for some atomic transitions. Instead of usual decrease of the fluorescence intensity by adding substrate, 1363 A transition $(^2P^{\circ}_{3/2}{\to}^2P_{1/2})$ intensity increased by adding substrate. From the normally behaved fluorescence lines the absolute rate constant for the reaction, Cl + $CH_3Cl{\to}$, was found to be $4.2{\times}10^{-13}$ cc/molecule sec at $20^{\circ}C$.

Determination of Aflatoxins Using High-Performance Liquid Chromatography and Fluorescence or UV Absorbence Detection (HPLC에 의한 aflatoxin 분석법에 관한 연구 형광 및 자외선 흡광 검출의 비교)

  • 김종규;강회양;민경진
    • Journal of Environmental Health Sciences
    • /
    • v.22 no.1
    • /
    • pp.36-44
    • /
    • 1996
  • A comparison was made of two detection methods(UV absorbence detection and fluorescence detection with pre-column derivatization, with trifluoroacetic acid) coupled with HPLC for the simultaneous determination of aflatoxin $B_1, B_2, G_1$ and $G_2$. A good separation of the four aflatoxins was achieved on a reversed-phase $C_{18}$ column (30 cm x 3.9 mm) with methanol-acetonitrile-water(20+20+60) for absorbence detection or acetonitrile-water(25+75) for fluorescence detection at the flow rate of 1.0 ml/min. The calibration graphs were linear over the ranges 100 ppb-1 ppm for $B_1/G_1$ and 30~300 ppb for $B_2/G_1$ with absorbence detection, and 1~500 ppb for $B_1/G_1$ and 0.3~150 ppb for $B_2/G_2$ with fluorescence detection. The correlation coefficients were greater than 0.94 and 0.99 for absorbance detection and for fluorescence detection, respectively. The detection limit was 100 ng for $B_1/G_1$ and 30 ng for $B_2/G_2$ with absorbence detection, and 1 ng for $B_1/G_1$ and 0.3 ng for $B_2/G_2$ with fluorescence detection. Recovery rates of aflatoxin $B_1, B_2, G_1$ and $G_2$ added to yeast-extract sucrose broth medium were 66.6%, 59.4%, 67.5% and 59.2%, respectively, for absorbence detection and 82.9%, 71.5%, 80.0% and 69.3%, respectively, for fluorescence detection. The four aflatoxins in culture medium were quantitatively detected by the two methods. The aflatoxins in the rice sample were not detected the absorbence detection method, but were below 10 ppb using the fluorescence detection method. Analysis of aflatoxins by both the absorbence and fluorescence methods coupled with HPLC showed acceptable linearity and good recovery. The absorbence detection was less timeconsuming and safer for treatment. The fluorescence detection was more elective and sensitive though elevated $B_1$ and $G_1$ contents were determined from the TFA-induced conversion of $B_1$ to $B_{2a}$ and $G_1$ to $G_{2a}$.

  • PDF

Simple Analysis for Interaction between Nanoparticles and Fluorescence Vesicle as a Biomimetic Cell for Toxicological Studies

  • Umh, Ha Nee;Kim, Younghun
    • Bulletin of the Korean Chemical Society
    • /
    • v.33 no.12
    • /
    • pp.3998-4002
    • /
    • 2012
  • With continuing progress of nanotechnologies and various applications of nanoparticles, one needs to develop a quick and fairly standard assessment tool to evaluate cytotoxicity of nanoparticles. However, much cytotoxicity studies on the interpretation of the interaction between nanoparticles and cells are non-mechanistic and time-consuming. Here, we propose a simple screening method for the analysis of the interaction between several AgNPs (5.3 to 64 nm) and fluorescence-dye containing vesicles ($12{\mu}m$) acting as a biomimetic cell-membrane. Fluorescence-dye containing vesicle was prepared using a fluorescence probe (1,6-diphenyl-1,3,5-hexatryene), which was intercalated into the lipid bilayer due to their hydrophobicity. Zeta potential of all materials except for bare-AgNPs (+32.8 mV) was negative (-26 to -54 mV). The morphological change (i.e., rupture and fusion of vesicle, and release of dye) after mixing of the vesicle and AgNPs was observed by fluorescence microscopy, and fluorescence image were different with coating materials and surface charge of x-AgNPs. In the results, we found that the surface charge of nanoparticles is the key factor for vesicle rupture and fusion. This proposed method might be useful for analyzing the cytotoxicity of nanoparticles with cell-membranes instead of in vitro or in vivo cytotoxicity tests.

Fluorescence of Tongue Coat - Mechanism of Tongue Coat Fluorescence and Suggestions on Development of Digital Tongue Diagnosis System - (설태의 형광특성 - 설태 형광현상의 발현기전 소개 및 제안 -)

  • Kim, Ji-Hye;Nam, Dong-Hyun
    • The Journal of the Society of Korean Medicine Diagnostics
    • /
    • v.15 no.1
    • /
    • pp.47-54
    • /
    • 2011
  • In traditional Korean medicine, inspection of the tongue is an important method of making medical diagnoses and determining prognosis. We surveyed the fluorescence characteristics of the tongue coat in the ultraviolet light. The tongue coat comprises micro-organisms, blood metabolites, leukocytes from periodontal pockets, large amounts of desquamated epithelial cells released from the oral mucosa and different nutrients. In the ultraviolet light tissues of the oral cavity generally emit weak red or green fluorescence, which is not easily seen by the human eye, but is readily detected. This fluorescence has been proved to be due to the production of porphyrins by oral micro-organisms. While the composition of motile micro-organisms on the dorsum of the tongue is not constant, variations also occur persistingly in the fluorescence characteristics of the tongue coat. But because live bacteria contain a variety of intracellular biomolecules that have specific excitation and emission wavelength spectra characterizing their intrinsic fluorescence, the tongue coat emits fluorescence. the tongue itself, on the other hand, emits very weak or not fluorescence. In conclusion, we suggests that the uncoated tongue area be eliminated from the coated tongue area with the difference between the fluorescence characteristics of the tongue and that of the tongue coat.

Fundamental Study on the Quantitative Analysis of Fluorescent Whitening Agent used for Papermaking (제지용 형광증백제의 정량분석에 대한 기초연구)

  • Lee, Ji-Young;Kim, Chul-Hwan;Lee, Hui-Jin;Gwak, Hye-Joeng
    • Journal of Korea Technical Association of The Pulp and Paper Industry
    • /
    • v.43 no.2
    • /
    • pp.9-15
    • /
    • 2011
  • Fluorescent whitening agent (FWA) is a widely used chemical in paper industry, but a systematic and scientific method on FWA analysis has not been established. We performed the basic researches on the fluorescence analysis of FWA. The fluorescence of FWA was investigated using a spectrofluorometer and a spectrophotometer. When FWA solution was analyzed using the spectrofluorometer, we found that the peak wavelength of the fluorescence emission was about 440 nm and that of the fluorescence excitation was about 370 nm irrespective of FWA types. Papers dyed with an internal FWA were prepared in a laboratory and the reflectance and the fluorescence index were measured using the spectrophotometer. It was confirmed that the optimum peak wavelength of the reflectance was 440 nm and the fluorescence index calculated from the CIE whiteness with and without UV light under a light source D65 was the best indicator to measure the fluorescence of FWAs exiting in papers.

Mixture of dimethylaminobenzaldehyde and cyanoacrylate to develop fingerprints with fluorescence: a preliminary test

  • Lee, Wonyoung;An, Jaeyoung;Yu, Jeseol
    • Analytical Science and Technology
    • /
    • v.35 no.1
    • /
    • pp.1-7
    • /
    • 2022
  • This study suggests a new one-step fluorescent cyanoacylate-fuming method for developing fingerprints by using a CAB mixed with dimethylaminobenzalde (DMAB) and cyanoacylate (CA) in a specific ratio. CAB is prepared by mixing 2.5 % (w/w) DMAB with CA and fumigated at 180 ℃. Under these conditions, developing fingerprints showed the best results. The fuming method using CAB develops latent fingerprints into fluorescence and has a higher sensitivity than CA, and it showed comparable or better contrast to existing fluorescence enhancement methods. It was also applicable on a variety of non-porous surfaces that can be encountered at ordinary times. This method is more useful than conventional fluorescent dyeing methods in that it minimizes damage to fingerprints or samples, makes it easy to manufacture, saves time, and can use existing current equipment as it is.

Fluorescence Spectroscopic and Time-Dependent Density-Functional Theory Studies of Diphenylsilane

  • Boo, Bong-Hyun;Lee, Jae-Kwang
    • Bulletin of the Korean Chemical Society
    • /
    • v.33 no.3
    • /
    • pp.993-996
    • /
    • 2012
  • We investigated fluorescence and fluorescence excitation of diphenylsilane (DPS) in a solution and molecular beams in combination with the aid of the DFT method. When the molecule was photoexcited at 250 nm in a cyclohexane solution, normal and excimer fluorescences were observed in the ranges of 260-320 and 330-450 nm, respectively. The fluorescence excitation spectrum indicates that the channel leading to the intramolecular excimer formation is not efficient in comparison with the normal fluorescence. Vibrationally resolved fluorescence excitation spectra were measured for the DPS molecules cooled in pulsed supersonic expansion of He in the range 262.2-271.7 nm, in which we can see several electronic excitation spectra exhibiting the electronic band origins. We found that the simulated absorption spectrum based on the time-dependent densityfunctional theory calculations accords well with the absorption spectrum.

Quantitative Vapor Phase Exciplex Fluorescence Measurements at High Ambient Temperature and Pressure

  • Kim, Tongwoo;Jaal B. Ghandhi
    • Journal of Mechanical Science and Technology
    • /
    • v.17 no.1
    • /
    • pp.157-167
    • /
    • 2003
  • The exciplex fluorescence technique with the TMPD (tetamethyl-Ρ-phenylene-diamine) / naphthalene dopant system was applied in a combustion-type constant-volume spray chamber. A detailed set of calibration experiments has been performed in order to quantify the TMPD fluorescence signal. It has been demonstrated that the TMPD fluorescence intensity was directly proportional to concentration, was independent of the chamber pressure, and was not sensitive to quenching by either water vapor or carbon dioxide. Using a dual heated-jet experiment, the temperature dependence of TMPD fluorescence up to 1000 K was measured. The temperature field in the spray images was determined using a simple mixing model, and an iterative solution method was used to determine the concentration and temperature field including the additional effects of the laser sheet extinction. The integrated fuel vapor concentration compared favorably with the measured amount of injected fuel when all of the liquid fuel had evaporated.

Patterned Fluorescence Images with a t-Boc-Protected Coumarin Derivative

  • Min Sung-Jun;Park Bum Jun;Kim Jong-Man
    • Macromolecular Research
    • /
    • v.12 no.6
    • /
    • pp.615-617
    • /
    • 2004
  • We have developed an efficient method for the generation of patterned fluorescence images using a protected precursor molecule. The t-Boc-protecting group of a coumarin derivative was readily removed from a polymer film upon irradiation with UV light in the presence of a photoacid generator to provide the original properties of the coumarin. Fine fluorescence patterns were obtained when using this photolithographic method.

Concentration Range Analysis for Fluorescence Expression of Indocyanine Green (Indocyanine green 형광조영제의 형광발현을 위한 농도 범위 분석)

  • Kim, Yong Jae;Lee, Da Ae;Yoon, Ki-Cheol;Kim, Kwang Gi
    • Journal of Korea Multimedia Society
    • /
    • v.22 no.12
    • /
    • pp.1339-1346
    • /
    • 2019
  • In the characteristic of the brain malignant, the blood vessels and tumors have the same color and shape, and the boundary distinction is not clear, Therefore, it is difficult to observe the naked eye. Because of the high invasiveness, the risk of recurrence is high. Therefore, complete resection of the tumor is essential. The method for distinguishing the boundary between blood vessels and tumors is a fluorescence contrast method using indocyanine green (ICG), a fluorescence contrast agent. In ICG, the concentration range analysis is very important because the fluorescence expression state varies depending on the concentration. However, since the analysis result of the fluorescence expression condition is insufficient according to the current concentration, this paper proposes by analyzing the initial protocol of the concentration range. 780 nm infrared light was irradiated to the ICG sample to observe the fluorescence expression through a near infrared (NIR) camera. The wavelength is measured by using a spectrum instrument (ocean view) to observe the fluorescence expression wavelength of 811nm. As a result of analyzing the mol concentration according to each sample, the fluorescence expression range was found to be 16.15-0.16M and the optimum fluorescence concentration on the brightest part was found to be 3.23-0.81M.