• 환경위생공학
• /
• 제18권3호통권49호
• /
• pp.43-47
• /
• 2003

The desorption characteristics of NaY zeolite, of which Si/Al ratio is 2.36, was measured at 25${\circ}$C and 150${\circ}$C so as to be used practically as a adsorbent for separation of sulfur oxides from flue gas, for which adsorption and desorption cycles at 25${\circ}$C were repeated four times and that at 150${\circ}$C was done one time. As a result it took 30.8 at 150${\circ}$C and 164.1 minutes in average at 25${\circ}$C to reach equilibrium condition. It means that regeneration of the NaY zeolite can be done below 150${\circ}$C so that zeolite can be used for flue gas desulfurization.

• 에너지공학
• /
• 제12권2호
• /
• pp.65-73
• /
• 2003

국내의 HAPs(Hazardous Air Pollutants)중 수은은 아직까지 관심의 대상이 아니지만 머지않아 문제가 될 것으로 예측된다. 본 논문에서는 현재 국내외의 배가스 수은 배출현황과 처리기술에 대해 요약하였다. 미국을 중심으로 구미 각국에서는 대기분야의 연구개발이 수은에 집중되고 있다. 수은 제어 프로그램은 크게 두 가지로 방향을 잡고 있다. 하나는 기존의 WFGD(Wet Flue Gas Desulfurization)를 이용하여 수은을 산화시켜 제거하는 방법이며 다른 하나는 수은 제거효율이 높은 활성탄 또는 다른 novel sorbent (low-cost sorbent)를 사용하는 방법이다. 선진국에서는 2007년에 발전소 수은 제거설비 설치가 의무화 될 것이다. 본 논문에서 제공하는 자료는 국내에서 발전소 수은 규제가 시작될 때 효과적으로 적용될 수 있을 것이다.

• 한국입자에어로졸학회지
• /
• 제15권2호
• /
• pp.57-65
• /
• 2019

Recently, there has been much research on the effect of fine dust on human body with increasing interest in the fine dust. Thermal power plant, which is considered as one of the main sources of fine dust, is reported to be responsible for 14% of the total amount of domestic fine dust in the Republic of Korea. Therefore, dust collecting devices in the thermal power plant need to be improved. In this study, the electrostatic precipitator (ESP) was considered to substitute for a mist eliminator used in flue gas desulfurization facility. By considering real situation in the flue gas desulfurization facility, the collection efficiency of the ESP was evaluated by using the sprayed limestone slurry particles. The collection efficiency of the ESP was higher than that of the mist eliminator, showing the possibility of replacing the mist eliminator with the ESP in flue gas desulfurization facility.

• 대한기계학회논문집B
• /
• 제34권8호
• /
• pp.775-782
• /
• 2010

본 연구는 대형 석탄 화력 발전소 탈황설비 내 흡수탑의 성능향상을 위하여 Tray 설치 가능성을 검토하기 위한 연구로 전산 유체역학(CFD) 기법을 이용하여 탈황설비 내 흡수탑의 내부유동을 전산해석 하였다. 흡수탑 내의 Gas와 Slurry의 거동에 대한 사실적 묘사를 위해 Euler-Lagrangian 기법을 이용한 전산해석을 수행하였다. 기존 흡수탑 내에 Tray를 설치함에 따라 탈황설비 내에서 Slurry의 체공시간 증가로 인한 펌프동력 절감과 압력강하 증가로 인한 Fan의 소요동력 증가에 대하여 중점적으로 비교 및 고찰하였다. 그 결과 Tray를 설치함에 따라 흡수탑 내에 Slurry의 체공시간과 배기가스의 압력강하가 증가되는 것을 확인할 수 있었다. 체공시간 증가로 인하여 절약된 동력이 압력강하에 의한 동력 소모량 증가보다 더 큰 것으로 확인되었다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1998년도 하계학술대회 논문집 B
• /
• pp.825-827
• /
• 1998

Air pollution is one of the most important global issues of the environmental concerns. Some advanced foreign countries have developed the air pollution control technology. KEPCO has been researching on the air pollution control technology and developed the FGD(Flue Gas Desulfurization) system for 200MW thermal power plant. In this paper, we describe the major control loops implemented to the domestic FGD system. The major control loops are to be classified into booster fan control, absorber PH control and limestone density control. The control loops were applied to the actual desulfurization processes and proved to their performance.

• 한국환경보건학회지
• /
• 제27권4호
• /
• pp.9-14
• /
• 2001

This study was performed to develop the modified FGD(Flue Gas Desulfurization) process which can eliminate the possibility of generating secondary pollutants. Limestone was regenerated by adding ammonium hydroxide and carbon dioxide, and reusing it as a absorbent in FGD gypsum Process. A series of the new or modified FGD process which include desulfurization and regeneration limestone from CaSO$_3$. 1/2H20 and CaSO4 . 2H2O, were carried out under various experimental conditions. The results showed that the optimum injection ratio for regeneration of limestone was 0.3 ml/min of CO2 flow rate, 2 ml of NH4OH per 0.01 M of regent grade CaSO4 . 2H20O and the optimum regeneration temperature was 50. The increaser was the number of times of limestone regeneration, the faster was the breakthrough point of desulfurization at the desulfurination process which the regenerated limestone was used. Then the efficiency of desulrurization was decreased. This study can be confirmed the possibility for reuse of regenerated limestone due to the similarity of desulfurization characteries both reagent grade calcium carbonate and regenerated calcium carbonate. Finally, it appeared that the new technology using regenerated 1imestone can be applied to the FGD process.

• 한국컴퓨터정보학회논문지
• /
• 제19권2호
• /
• pp.161-171
• /
• 2014

본 논문에서는 CFDRC 사의 상용 CFD 소프트웨어인 CFD-ACE+로 전산유체역학 기법을 적용하여 수치 해석을 수행하여 배연탈황 설비에서 Induced Draft Fan(I.D.Fan) 출구부터 Booster Up Fan(B.U.Fan) 입구까지 난류 유동장과 연소 유동 문제를 모사하여 배기가스 계통 설비의 유동 특성을 해석하였다. 배기가스가 I.D.Fan 출구 ~ B.U.Fan 입구 구간을 적정속도로 균일하게 유동하여 B.U.Fan로 균일하게 유입되도록 하며 압력손실이 적게 발생하도록 설계기준 보일러 부하와 최대연속 정격유량의 보일러 부하에서 이 구간의 안내깃을 검토하였다. 검토한 결과에 대해 CFD 해석을 수행하여 I.D.Fan 출구에서 안내깃을 제거하고 B.U.Fan 입구 전에 안내깃을 보강할 수 있도록 설계를 변경하였다. 배기가스 계통에 변경된 설계를 적용하여 수치모사한 결과에서 배연탈황 설비 내부의 배기가스 압력손실이 줄어들고 유속과 유선이 균일하게 유동할 수 있어 배연탈황 시스템의 효율이 향상한 것을 확인하였다.

• 플랜트 저널
• /
• 제15권1호
• /
• pp.38-44
• /
• 2019

본 연구에서는 1,000 MW급 석탄화력발전소용 탈황흡수탑을 대상으로 대기환경보전법 및 발전소 자체 배출규제치를 준수하면서 운전할 때, 석회석 슬러리 투입량을 조절하여 흡수탑 내부 슬러리 pH의 적정 범위를 찾고자 하였다. 배기가스 유량, 발전기 출력, 흡수탑 압력강하, 산화용 공기량을 고정한 상태에서 흡수탑 유입가스에 포함된 이산화황의 평균 농도, ${\bar{C\;in}}$ [ppm]을 500 ppm, 550 ppm, 600 ppm 그리고 635 ppm으로 변동시키며 운전하였을 때, 흡수탑 내부 적정슬러리 pH, 는 5.0, 5.2, 5.3 그리고 5.4였다. 이러한 결과로부터 흡수탑 유입가스에 포함된 이산화황의 평균 농도가 500~635 ppm의 범위일 때 상관관계식 을 이용하여 적정슬러리 pH를 산출하여 운전하는 것이 추천된다.

• 한국정밀공학회지
• /
• 제19권1호
• /
• pp.204-211
• /
• 2002

Today\`s industrialized plants are required to reduce SOx emitted from stacks at factories, utility power stations, etc. For this purpose, flue gas desulfurization(FGD) system is installed in thermal power plant and gas-gas heater(GGH) is used to play a vital role to reheat the wet treated gas from FGD. The sector plates are located at cold and hot sides of gas-gas heater. They serve as sealing to prevent mixing treated and untreated gases. Therefore, the deformation of the sector plate due to its dead weight and gas pressure should be considered as major factor for the sector plate design. And finite element analysis(FEA) for rotor part in GGH is performed with original model and two weight-reduced models with different diaphragm thickness, respectively. Stress concentrations at rotor diaphragm happen due to the dead weight, pressure difference between treated and untreated gas, and thermal distribution in the rotor. As the thickness of diaphragm is decreased, the stress level is increased. The direction of treated gas and untreated gas flow may affect the stress level.

• 한국수자원학회:학술대회논문집
• /
• 한국수자원학회 2007년도 학술발표회 논문집
• /
• pp.46-52
• /
• 2007

As flue gas desulfurization (FGD) wastewater contains high concentrations of nitrate and is very low in organic carbon, the feasibility of nitrate removal by autotrophic denitrification using Thiobacillus denitrificans was studied. This autotrophic bacteria oxidizes elemental sulfur to sulfate while reducing nitrate to elemental nitrogen gas, thereby eliminating the need for addition of organic compounds such as methanol. Owing to the unusually high concentrations of dissolved salts $(Ca^{2+},\;Mg^{2+},\;Na^+,\;K^+,\;B^+,\;SO_4^{2-},\;Cl^-,\;F^-,)$ in the FGD wastewater, extensive laboratory-scale and pilot-scale tests were carried out in sulfur-limestone reactors (1) to determine the effect of salinity on autotrophic denitrification, (2) to evaluate the use of limestone for pH control and as source of inorganic carbon for microbial growth, and, (3) to find the optimum environmental and operational conditions for autotrophic denitrification of FGD wastewater. The experimental results demonstrated that (1) autotrophic denitrification is not inhibited up to 1.8 mol total dissolved salt content; (2) inorganic carbon and inorganic phosphorus must be present in sufficiently high concentrations; (3) limestone can supply effective buffering capacity and inorganic carbon; (4) the high calcium concentration may interfere with pH control, phosphorus solubility and limestone dissolution, hence requiring pretreatment of the FGD wastewater; and, 5) under optimum conditions, complete autotrophic denitrification of FGD wastewater was obtained in a sulfur-limestone packed bed reactor with a sulfur:limestone volume ratio of 2:1 for volumetric loading rates up to 400g $NO_{3^-}N/m^3.d$. The interesting interactions between autotrophic denitrification, pH, alkalinity, and the unusually high calcium and boron content of the FGD wastewater are highlighted. The engineering significance of the results is discussed.