• 방재기술
• /
• 통권52호
• /
• pp.12-18
• /
• 2012

• Steel and Composite Structures
• /
• 제8권3호
• /
• pp.231-242
• /
• 2008

This paper presents results of fire tests on corrugated sheets used as load bearing structure of roofs of industrial buildings. Additional tests of bolted sheet connections to the supporting structure at ambient and elevated temperatures are described. Three connection types were tested and their resistance, stiffness and deformation capacity was evaluated. Finite element simulations of the corrugated sheet based on the experimental observations are briefly described and design models are presented.

• 한국화재소방학회논문지
• /
• 제34권4호
• /
• pp.87-95
• /
• 2020

본 연구는 건물형 전통시장의 화재 시뮬레이션을 통해 실내온도를 도출하여 온도구배를 이용하여 주요구조부의 온도를 산출하여 구조체 한계온도에 도달하는 시간과, 피난 시뮬레이션을 이용하여 도출 된 피난완료시간을 비교하여 피난안전성을 평가하였다. 피난안전성이 확보되지 않는 건축물의 주요구조부재에 내화보강을 0.01~0.035 m 두께로 실시하는 것을 개선안으로 제시하여 피난안전성을 확보하고자 하였다. 소형과 중형은 내화보강이 0.025 m 이상일 때, 중대형과 대형은 0.035 m 이상 보강시 안전성이 확보되는 것으로 나타났다. 이에 피난안전성의 확보하기 위해선 내화 보강이 적용되어야 할 것으로 판단된다.

• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2023년도 봄 학술논문 발표대회
• /
• pp.301-302
• /
• 2023

In this study, we aimed to identify changes in fire resistance according to the type of sleeves used for pipe penetrations and to examine their accreditation of fire resistance performance and use them as basic data. The test results of fire resistance according to the type of sleeve used in non-metallic pipe facilities showed that the temperature on the support side was higher for sleeves with higher thermal conductivity. For the temperature on the surface of the pipes, in the case of galvanized steel plates, steel pipes, and structures without sleeves, the highest temperature was observed after the expansion of the firestop material for 46 to 53 minutes and then decreased. PVC sleeves showed a steady increase in temperature until 53 minutes, after which the temperature did not increase further. In addition, for non-metallic pipes, the effect of the type of sleeve on fire resistance is considered to be insignificant because the lower part (heating direction of the furnace) under the support structure is cut off to block the heat during the two-hour fire resistance test.

• Advances in Computational Design
• /
• 제1권1호
• /
• pp.105-117
• /
• 2016

The objective of this work is to study the restraining effect in fire resistance of framed structures and to evaluate the global response of reinforced concrete frames when exposed to fire based on advanced finite element method. To study the response a single portal frame is analyzed. The effect of floor slab on this frame is studied by modeling a beam-column-slab assembly. The evolution of temperature distribution, internal stresses and deformations of the frame subjected to ISO 834 standard fire curve for both the frames are studied. The thermal and structural responses are evaluated and a comparison of results of individual members and entire structure is done. From the study it can be seen that restraining forces has significant influence on both stresses and deflection and overall response of the structure when compared to individual structural member. Among the various structural elements, columns are the critical members in fire and failure of column causes the failure of entire structure. The fire rating of various structural elements of the frame is determined by various failure criteria and is compared with IS456 2000 tabulated fire rating.

• 한국가구학회지
• /
• 제21권6호
• /
• pp.469-478
• /
• 2010

본 연구에서는 두 개의 주요 구조부분으로 구성된 새로운 하이브리드 목조 벽체의 내화성능을 평가하였다. 수직하중을 전적으로 담당하는 기둥-보 형태의 기본 골조에 두 가지 형태의 벽체가 채워졌을 때 이 전체를 내력 벽체로 가정하고 그 내화성능을 평가하고자 하였다. 하이브리드 벽체의 기본 개념은 뼈대를 갖는 전형적인 가구의 구조로부터 채용되었다. 기본이 되는 기둥-보 골조는 국산 낙엽송 소재로서, 기둥은 $180mm{\times}180mm$, 보는 $180mm{\times}240mm$ 단면의 부재가 사용되었다. 기둥-보 골조의 내부에 채워지는 벽체는 두 종류로서, 하나는 블러킹이 사용된 일반적인 경골목구조 벽체이고, 또 하나는 구조용 패널 사이에 스티로폼 단열재가 채워져 일체화된 구조를 이루는 구조용 단열 패널 벽체이다. 내화성능 시험에 사용된 모든 벽체는 2겹의 방화석고보드를 화염 노출면에 부착하였다. 모든 벽체는 우선 기둥-보 골조가 없는 상태에서 표준화염 조건에서 내화성능 시험을 수행하였고 다시 기둥-보 골조와 결합된 형태로 내화성능 시험을 수행하였다. 시험에 적용된 화염조건은 KS F 2257의 조건을 적용하였고 시험 중 구조체 내부 각 부위의 온도변화도 측정하였다. 본 연구를 통해 기둥-보 골조의 보강이 목구조 벽체의 내화성능 향상에 상당히 기여하는 것으로 확인되었다.

• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2008년도 춘계 학술논문 발표대회
• /
• pp.21-25
• /
• 2008

It is the aim of this study to investigate the fire resistance design Guidelines for high-strength concrete structure for example compressive strength more than 40Mpa. It is well know that explosive spalling due to fire attack of high strength concrete is related to concrete failure. so, the purpose of this study introduce the fire A Studty on the Fire Resistance Design Guidelines for High-Strength Concrete Structures of AIK for the response of explosive spalling of high strength concrete.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 2005년도 추계 학술발표회 제17권2호
• /
• pp.749-752
• /
• 2005

Normally, the degradation of concrete member exposed to fire is largely dependent on the fire scale and fire condition. With all ensuring the fire resistance structure as a method of setting the required cover thickness to fire, the RC is significantly affected from the standpoint of its structural stability that the compressive strength and elastic modulus is reduced by fire. Thus, this study is concerned with experimentally investigating fire resistance of high strength-light weight concrete. From the test result, high strength-light weight concrete is happened explosive spalling. The decrease of cross section caused by explosive spalling made sharp increasing gradient of inner temperature.

• 대한건축학회논문집:구조계
• /
• 제33권12호
• /
• pp.19-27
• /
• 2017

This paper is a study to improve the fire-resistance capacity of reinforced concrete (RC) members strengthened by fiber-reinforced-polymer (FRP). The fire resistance of the RC members strengthened by FRP was evaluated through high temperature exposure test. In order to improve the fire resistance of the FRP reinforcing method, a fire-proof board was attached to the reinforced FRP surface and then the high temperature exposure test was carried out to evaluate the improvement of the fire resistance performance. It was confirmed that the resistance to high temperature of NSMR could be improved somewhat compared with that of EBR from the experiment that exposed to high temperature under the load corresponding to 40% of nominal strength. When 30 mm thick fire-resistance (FR) board is attached to the FRP surface, the surface of the reinforced FRP does not reach $65^{\circ}C$, which is the glass transition temperature (GTT) of the epoxy until the external temperature reaches $480^{\circ}C$. In particular, when a high performance fire-proof mortar was first applied prior to FR board attachment, the FRP portion did not reach the epoxy glass transition temperature until the external temperature reached $600^{\circ}C$.

• 한국화재소방학회논문지
• /
• 제24권3호
• /
• pp.20-24
• /
• 2010

건축물의 화재발생 시 건축물 붕괴방지 및 인명의 피난시간 확보를 위하여 내화구조(내화피복재)를 시공하도록 하고 있으나 실제 규모와 가까운 내화시험의 특성으로 건축물 시공현장에서 내화구조(내화피복재)의 품질을 확인할 수 있는 현장품질방법이 부재하다. 따라서 근-적외선분광분석을 통하여 현장에서 적용할 수 있는 일치성 분석기법 연구를 통해 정확하고 간편한 과학적 내화구조현장관리 시험방법을 제시하고자 함.