• Journal of the Korean Society of Safety
• /
• v.30 no.6
• /
• pp.48-55
• /
• 2015

A variety of safety issues were investigated for chemical reactors using a toluene solvent in case of a fire at small to middle scale chemical plants. The issues covered the operation of pressure-relieving valves and the subsequent discharges of the toluene to the atmosphere either directly or through an absorber, which represent the current practice at most small chemical plants. It was shown that the safety valve on the reactor may not operate within about twenty minutes after an external fire breaks out, but, once relieved, the toluene vapor released directly to the atmosphere may form a large explosion range on the ground. It was also shown that if the discharge is routed to an existing absorber used for the scrubbing of volatile organic compounds or dusts, the column may not operate normally due to excessive pressure drops or flooding, resulting in the hazardous release of toluene vapors. This study proposed two ways of alleviating these risks. The first is to ruduce the discharge itself from the safety valve by using adequate insulation and protection covers on the reactor and then introduce it into the circulation water at the bottom of the absorber through a dip linet pipe equipped with a ring-shaped sparger. This will enhance the condensation of toluene vapors with the reduced effluent vapors treated in the packing layers above. The second is to install a separate quench drum to condense the routed toluene vapors more effectively than the existing absorber.

• Journal of the Korean Institute of Gas
• /
• v.15 no.2
• /
• pp.57-62
• /
• 2011

DME(Dimethyl Ehther) is considered as an attractive fuel in terms of clean, environmentally friendly form of energy, multi-source and multi-purpose. As the physical properties of DME are almost similar to LPG, DME can be mixed with LPG and DME-LPG mixture fuels seem to be employed without major remodeling of the existing LPG supply infrastructure. However, little attention has been given to the effect of different DME-LPG mixture fuels on consequence analysis to adjacent facilities, buildings and etc. In this work, the consequence analysis by different DME-LPG mixture fuels has been done. The results were discussed in terms of release rate, jet fire, vapor cloud explosions, BLEVEs and etc. It was found that the consequences estimated from fire and explosion scenarios assumed were almost similar for both LPG and DME 20 %.

• Journal of the Korean Institute of Gas
• /
• v.12 no.3
• /
• pp.31-37
• /
• 2008

In this paper, the strength analysis has been presented for the stress and strain by using the finite element method for various shell models of the helmets. The advanced helmet that would provide head protection without causing discomfort to the user when it was worn for long periods of time should be manufactured for increasing the safety and workability of the workers. We need a safe, comfortable and light weight of the helmet shell structure. Thus, the helmets had to stand up to the most rigorous conditions encountered for the fire and gas explosion. The FEM computed results show that when the impulsive force is applied on the summit area of a helmet shell structure, the maximum stress and strain have been occurred around the position of an applied impact force, which may lead to the initial failure on the summit of the helmet shell. Thus, the summit area of the helmet shell should be supported by a bead frame and increased thickness of the bead. But the overall thickness of the helmet is to decrease for the light weight of a helmet.

• Journal of the Society of Disaster Information
• /
• v.12 no.3
• /
• pp.273-278
• /
• 2016

In this study, we set the need, purpose, and the direction of developments in life-saving devices and analyzed the disaster sites where power-assisted devices are to be applied. For this purpose, we classified the disaster in accordance with the Basic Law for on Disaster and Safety Management and analyzed the common disaster sites where power-assisted devices are available. As a result, 13 disaster sites were classified into three categories. Firstly, 8 sites of social disaster accidents, fire(suppression), fire(rescue), collapse, traffic accidents, explosion, CBR(chemical, biological, and radiological), environment pollution, and other safety accidents, were defined. Secondly, 4 disaster accidents, earthquake, flood, typhoon and other natural disasters, were classified. Finally, other disaster sites were taken into account.

• Fire Science and Engineering
• /
• v.18 no.1
• /
• pp.18-23
• /
• 2004

This paper describes the minimum ignition limits for propane-air 5.25 Vol.% mixture gases in low voltage inductive circiuts. The improved effects on the ignition limit are studied by parallel safety components(resistors) for propane-air 5.25 Vol.% mixture gas in low voltage inductive circuits. The experimental devices used in this test are the IEC type spark ignition test apparatus. The minimum ignition limits are controlled by the values of current in inductive circuit. Energy supplied from electric source is first accumulated at the inductance, it's extra energy is working as ignition source of the explosive gas. The improved effects on the ignition limit are respectively obtained as the maximum rising rate of 330% by composing parallel circuits between inductance and resistor as compared with disconnecting inductance with the safety components. The more values of inductance increase the higher improved effects of ignition limit rise. The less values of resistor the higher improved effects of ignition limit rise. It is considered that the result can be used for not only data for researches and development of intrinsically safe explosion-proof machines which are applied equipment and detectors used in dangerous areas but also for datum for its equipment tests.

• Journal of the Korea Society for Simulation
• /
• v.29 no.3
• /
• pp.1-8
• /
• 2020

When enemy drones infiltrate large urban areas, various forms of great republics are deployed in large areas to respond. Due to the characteristics of a large number of government-run aircraft, the residual coal, other than the hit bullet, falls into various sizes of debris after its own explosion. The damage rate was analyzed by dividing the debris into anti-aircraft guns and guided weapons by deriving four factors: critical speed, fragmentation mass, initial speed of debris, and object collision speed, which can cause damage to human life as the debris falls to the ground. In the future, the North is expected to infiltrate the capital city of Seoul by operating unmanned aerial vehicles, which are asymmetric forces, and the damage could be minimized by setting up pre-fatal and fire-restricted zones to minimize casualties between responses.

• Journal of the Society of Disaster Information
• /
• v.18 no.2
• /
• pp.364-373
• /
• 2022

Purpose: The purpose of this paper is to develope smoke detection using AI model for detecting the initial fire in underground utility tunnels using CCTV Method: To improve detection performance of smoke which is high irregular, a deep learning model for fire detection was trained to optimize smoke detection. Also, several approaches such as dataset cleansing and gradient exploding release were applied to enhance model, and compared with results of those. Result: Results show the proposed approaches can improve the model performance, and the final model has good prediction capability according to several indexes such as mAP. However, the final model has low false negative but high false positive capacities. Conclusion: The present model can apply to smoke detection in underground utility tunnel, fixing the defect by linking between the model and the utility tunnel control system.

• Korean Chemical Engineering Research
• /
• v.59 no.3
• /
• pp.359-365
• /
• 2021

We investigated experimentally the ignition characteristic of dust and the hazard evaluating for electrostatic discharge. The ignition energy experiments were performed on sample dusts such as PE(HD), PE(LD), PMMA using the MIKE-3 apparatus. The formation of flame during the ignition of PE(HD) dust clouds occurred after the delay time of about 8 ms, and the flame kernels were not observed in center of ignition occurrence area. The voltage increased with increasing the number of dust dispersions and the increase rate of measured voltage with dust concentration was the highest in the order of PMMA, PE(LD) and PE(HD). For the effect of dispersion condition on the voltage in PE(HD) dust, the results were obtained that the voltage increased as the number of dispersions increased and as the concentration increased under the same dispersion number. The safety voltages to prevent fire and explosions by electrostatic ignition were estimated that PE(HD), PE(LD)-1, PE(LD)-2, and PMMA were 2.58, 44.72, 25.82, and 8.16 kV, respectively. We proposed the method for estimating the minimum ignition energy by using the measured voltage data for efficient investigation of electrostatic ignition hazard.

• Journal of the Korean Society of Safety
• /
• v.38 no.6
• /
• pp.50-59
• /
• 2023

As the diversity of disasters continues to increase, the concept of "complex disasters" has gained prominence in various policies and studies related to disaster management. However, there has been a certain limitation in the availability of the systematic statistics or data in advancing policies and research initiatives related to complex disasters. This study aims to analyze the macro-level characteristics of the complex disasters that have occurred domestically utilizing a 30-year span of a news data. Initially, we categorize the complex disasters into the three types: "Natural disaster-Natural disaster", "Natural disaster-Social disaster", and "Social disaster-Social disaster". As a result, the "natural diaster-social disaster" type is the most prevalent. It is noted that "natual disaster-natural disaster" type has increased significantly in recent 10 years (2011-2020). In terms of specific disaster types, "Storm and Flood", "Collapse", "Traffic Accident", "National Infrastructure Paralysis", and "Fire⋅Explosion" occur the most in conjunction with other disasters in a complex manner. It has been observed that the types of disasters co-ocuuring with others have become more diverse over time. Parcicularly, in recent 10 years (2011-2020), in addition to the aforementioned five types, "Heat Wave", "Heavy Snowfall⋅Cold Wave", "Earthquake", "Chemical Accident", "Infectious Disease", "Forest Fire", "Air Pollution", "Drought", and "Landslide" have been notable for their frequent co-occurrence with other disasters. These findings through the statistical analysis of the complex disasters using long-term news data are expected to serve as crucial data for future policy development and research on complex disaster management.

• Journal of the Korean Institute of Gas
• /
• v.28 no.2
• /
• pp.24-31
• /
• 2024

In the chemical industry, fires and explosions constantly occur due to runaway reactions during the production of various chemical products. To prevent this, much research has been conducted, and the possibility of runaway reactions for each substance is reviewed and interlocking devices are installed to prepare for adverse reactions to prepare for fires and explosions. However, despite legal and technical safety measures, accidents due to runaway reactions still occur every year. Accordingly, in this study, based on cases of fire and explosion accidents in styrene monomer reactors, the discharge capacity during runaway reactions was examined through experiments and graphs. Unlike the commonly calculated fire equation, in the case of a runaway reaction where pressure and temperature increase rapidly, discharge is made in two phases rather than a single phase, so the size of the rupture disk must also increase, and the orientation must be adjusted before the rupture disk is installed at the top of the pressure vessel. It was found that position adjustment was necessary.