• Journal of The Geomorphological Association of Korea
• /
• v.19 no.3
• /
• pp.37-49
• /
• 2012

The objective of this paper is to propose a methodology for surface sediments classification in tidal flats that can combine ground survey data with high-resolution remote sensing data by multivariate kriging. Unlike conventional methodologies that have classified remote sensing data by using pre-classified sediment components, a new classification methodology presented in this paper first generates sediment component fraction maps and then classifies the sediments on a final stage. For generating sediment component fractions, regression kriging, as one of multivariate kriging algorithms, is applied to integrate ground survey data and remote sensing data. First, trend components of sand, silt, and clay are derived through regression analysis of ground survey data and spectral information from remote sensing data. Then, residuals at sample locations are computed and interpolated to generate residual components in the study area. Finally, the sediment component fractions are computed by adding the residuals to the trend components and are classified on a final stage. A case study at the Baramarae tidal flats with KOMPSAT-2 imagery is carried out to evaluate the classification capability of the proposed classification methodology. Through the case study, the proposed methodology showed the best classification accuracy, compared with the conventional classification methodologies. Especially, much improvement of classification accuracy for fine-grained sediments were also obtained. Therefore, it is expected that the presented classification methodology would be an effective one for surface sediments classification in tidal flats.

• Korean Journal of Soil Science and Fertilizer
• /
• v.48 no.4
• /
• pp.240-245
• /
• 2015

The monitoring of soil fertility changes in orchard is very important for agricultural sustainability. Field monitoring was performed to evaluate the soil chemical properties of 140 orchard (23 sites for sandy loam, 88 sites for loam, 28 sites for silt loam, and 1 site for loamy fine sand) in Gyeongnam province every 4 years from 2002 to 2014. Soil chemical properties such as pH, electrical conductivity, amount of organic matter (OM), available phosphate ($P_2O_5$), lime requirement (LR), exchangeable potassium (K), calcium (Ca), magnesium (Mg), and sodium were analyzed. The amount of OM, exchangeable K, Ca, and Mg were significantly increased as cultivation year increases. The frequency distribution within optimum range of subsoil chemical properties in 2014 was 34.3% for pH, 35.0% for OM, 17.1% for available $P_2O_5$, 22.9% for exchangeable K, 15.7% for exchangeable Ca, and 22.1% for exchangeable Mg. In addition, the available $P_2O_5$ and exchangeable calcium were excess level with portions of 69.3% and 48.6%, respectively. The soil chemical properties in the topsoil and subsoil showed that soil pH was significantly higher in sandy loam soil than those from the loam and silt loam soils. The OM, exchangeable K, Mg, and LR of loam soil were higher than those from the sandy loam soil. These results indicated that a balanced management of soil chemical properties as affected by soil texture can improve the amount of fertilizer applied for sustainable agriculture in orchard field.

• The Journal of Advanced Prosthodontics
• /
• v.11 no.1
• /
• pp.7-15
• /
• 2019

PURPOSE. The aim of this study was to identify the effects of three aesthetic restorative materials on the wear between tooth and restoration by a pin-on-disk manner. MATERIALS AND METHODS. Six aesthetic restorative materials were used to prepare disk specimens for wear test, which were Lava Zirconia as zirconia group, Vintage MP and Cerabien ZR as veneering porcelain group, Gradia Direct microhybrid composite containing prepolymerized fillers, Filtek Z250 microhybrid composite containing zirconia glass and colloidal silica particles, and Filtek Z350 nanocomposite as composite resin group. Vertical loss of the worn cusp, change of the surface roughness of the restoration materials, and the surface topography were investigated after wear test under 9.8-N contact load. RESULTS. The porcelain groups (Vintage MP and Cerabien ZR) caused the largest vertical loss of teeth when compared with those of the composite resin and zirconia groups, and Filtek Z250 microhybrid composite results in the second-largest vertical loss of teeth. The surface of Filtek Z350 nanocomposite was deeply worn out, but visible wear on the surface of the zirconia and Gradia Direct microhybrid composite was not observed. When the zirconia surface was roughened by sand-blasting, vertical loss of teeth considerably increased when compared with that in the case of fine polished zirconia. CONCLUSION. It was identified that microhybrid composite resin containing a prepolymerized filler and zirconia with reduced surface roughness by polishing were the most desirable restorative materials among the tested materials to prevent the two-body wear between aesthetic restorative material and tooth.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.23 no.5
• /
• pp.75-83
• /
• 2019

In order to fulfill the obligation to voluntarily reduce greenhouse gas emissions under the Paris Climate Agreement, the proportion of coal and nuclear power generation is reduced worldwide and national efforts are being made to spread renewable energy including solar power generation. Korea also intends to increase the proportion of renewable energy generation to 30~35% by 2040 by introducing laws and regulations. In addition, while the country is trying to apply solar power generation to sidewalks and roads, there is no research related to it in Korea. Therefore, as a precedent study to develop solar power generation roads, solar power generation concrete blocks applicable to sidewalks and plazas were developed and the applicability was evaluated by constructing them on the site. As a result of indoor experiment, compressive strength was measured by 25.5~35.7MPa and flexural strength was measured by 5.1~10.5MPa, which showed that all domestic standards were satisfied. However, the higher the unit cement amount, the lower the strength was measured according to the mixing of the broken fine aggregate. The absorption rate was 5.7%, which satisfied the domestic standard of 7% or less. As a result of the freeze-thawing test, the reduction rate of the compressive strength after 100 cycles was up to 6.3%. As a result of measuring the settlement amount after construction, the maximum of 2.498mm was measured and irregular settlement occurred in the overall area, which is because the resolution of the sand layer was poor during construction. Maintenance techniques of sidewalk concrete block and solar panel need to be established more efficiently through long-term operation in the further.

• The Journal of Engineering Geology
• /
• v.29 no.1
• /
• pp.23-35
• /
• 2019

Landslides occur due to heavy rainfall in the summer season. Some of water may infiltrate into the ground; it causes a high saturation condition capable of causing a landslide. Soil properties are crucial in estimating slope stability and debris flow occurrence. The main study areas are Gwanaksan, Suraksan and Bukhansan (Mountain) in Seoul. A total of 44 soil samples were taken from the study area; and a series of geotechnical tests were performed. Physical and mechanical properties were obtained and compared based on region. As a result, among well-graded soils, they are classified as a clayey sand. Coarse-grained and fine-grained contents are approximately 95% and 5%, respectively, with very low amount of clay content. Density, liquid limit and dry unit weight are ranged in $2.62{\sim}2.67g/cm^3$, 27.93~38.15% and $1.092{\sim}1.814g/cm^3$. Cohesion and internal friction angle are 4 kPa and $35^{\circ}$ regardless of mountain area. Coefficient of permeability is varied between $3.07{\times}10^{-3}{\sim}4.61{\times}10^{-2}cm/sec$; it means that it results in great seepage. Permeability is inversely proportional to the uniformity coefficient and is proportional to the effective particle size. In the formal case, there was a difference by mountain area, while in the latter, the tendency was almost similar.

• Journal of Wetlands Research
• /
• v.21 no.2
• /
• pp.181-190
• /
• 2019

Recently, Low impact development techniques, a form of nature-based solutions (NBS), were seen cost-efficient alternatives that can be utilized as alternatives for conventional stormwater management practices. This study evaluated the effectiveness of an infiltration trench (IT) and a small constructed wetland (SCW) in treating urban stormwater runoff. Long-term monitoring data were observed to assess the seasonal performance and cite the advantages and disadvantages of utilizing the facilities. Analyses revealed that the IT has reduced performance during the summer season due to higher runoff volumes that exceeded the facility's storage volume capacity and caused the facility to overflow. On the other hand, the pollutant removal efficiency of the SCW was impacted by the winter season as a result of dormant biological activities. Sediment data also indicated that fine and medium sand particles mostly constituted the trapped sediments in the pretreatment and media zones. Sediments in SCW exhibited a lower COD and TN load due to the phytoremediation and microbiological degradation capabilities of the system. This study presented brief comparison LID facilities equipped with pre-treatment zones. The identified factors that can potentially affect the performance of the systems were also beneficial in establishing metrics on the utilization of similar types of nature-based stormwater management practices.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.9 no.3
• /
• pp.383-388
• /
• 2021

In this study, constant head water permeability test was adopted to evaluate self-healing performance of mortars containing inorganic healing materials which consist of blast furnace slag, sodium sulfate and anhydrite. Clinker powder and sand replaced for a part of cement and fine aggregates. On constant head water permeability test for self-healing mortars, unit water flow rate of mortar specimens were measured according to crack width and healing period. As a result of evaluating the healing performance of self-healing mortar, it was confirmed that with the initial crack width of 0.3mm, the healing rate at healing period of 28 days increased by more than 30%p compared to plain mortar, greatly improving the healing performance. Furthermore, the coefficient(α) which was estimated from the relationship between crack width and unit water flow rate was used for calculating equivalent crack width. By analyzing the correlation of healing rate and equivalent crack width, the time and initial crack width attaining healing target crack width were predicted.

• Journal of Korea Water Resources Association
• /
• v.56 no.9
• /
• pp.553-562
• /
• 2023

The Gobiobotia naktongensis is a species endemic to Korea, and it has recently been designated as a class I endangered species of freshwater fish. Naeseong Stream, one of the tributaries of the Nakdong River, where the Gobiobotia naktongensis was first discovered, provided an optimal habitat for the Gobiobotia naktongensis in the past with fine sand beds and riffle. Currently, due to the construction of Yeongju Dam and the excessive dredging of river channels by the local government, the riverbed armoring in the downstream area of the dam is undergoing rapid changes, and as a result, the habitat environment of the Gobiobotia naktongensis is deteriorating. In this study, the variations of the habitat suitability of the Gobiobotia naktongensis due to the change in the riverbed grain size of the Naeseong Stream were analyzed based on the WUA (weight usable area) using the physical habitat model, River2D. The study domain is the reach from Seoktap Bridge to Hoeryong Bridge downstream of Yeongju Dam. The change in riverbed grain size was analyzed using D50 acquired in 2010 and 2020, respectively. The substrate grain size of Naeseong Stream in 2020 was thicker than that in 2010, and the riverbed coarsening phenomenon was evident overall. As a result of the River2D analysis, the area in which the Gobiobotia naktongensis could inhabit was only about 0.75% in 2010 compared to the entire area of the flow, and even this decreased to 0.55% in 2020 due to riverbed armoring.

• Journal of the Korean Geotechnical Society
• /
• v.22 no.9
• /
• pp.61-68
• /
• 2006

Recently the large scale civil engineering projects are being implemented by reclaiming the sea or utilizing seashore and river embankment areas. The reclaimed land and utilized seashore are mostly soft ground that doesn't have sufficient bearing capacity. This soft ground consists of fine-grained soil such as clayey and silty soils or large void soil like peat or loose sand. It has high ground water table and it may cause the failure and crock of building foundation by uplift pressure and ground water leakage. In this study, the permittivity and the transmissivity were evaluated with the applied normal pressure in the laboratory. The laboratory model tests were conducted by utilizing geocomposite drainage system for draining the water out to release the uplift pressure. The soil used in the laboratory drainage test was dredged soil from the reclaimed land where uplift pressure problems can arise in soil condition. Geocomposite drainage system was installed at the bottom of apparatus and dredged soil was layered with compaction. Subsequently the water pressure was supplied from the top of specimen and the quantities of drainage and the pore water pressure were measured at each step water pressure. The results of laboratory measurements were compared with theoretical values. For the evaluation of propriety of laboratory drainage test, 2-D finite elements analysis that can analyze the distribution and the transferring of pore water pressure was conducted and compared with laboratory test results.

• The Sea:JOURNAL OF THE KOREAN SOCIETY OF OCEANOGRAPHY
• /
• v.14 no.1
• /
• pp.10-21
• /
• 2009

Muan Bay has extensively undertaken artificial influences through a series of construction of dams and dykes nearby resulting in a substantial increase in highest high water level. To unravel sedimentary responses to the water level rise, we collected a number of surface sediment samples and hydrodynamic data from in-situ observations of tidal currents in Muan Bay in 1998 and 2007. Comparison of the data between 1998 and 2007 shows that the relative content of coarse fractions, sand and gravel, in the sediment samples has increased with a decreased mean size, on average, from 6.2 to 5.8${\phi}$ at the expense of silt contents. Such a coarsening trend, which is more evident around high water level, particularly on the tidal flats of Dongam-ri, Guro-ri and Aphae-do, is most likely attributable to rising water level. On the other hand, an increase of fine fractions locally in the western entrance of the bay can be explained with changes in characteristics of tidal currents imposed by construction of bridges therein, such as decreased velocities and varied direction and phase of the tidal currents.