• Bulletin of the Korean Chemical Society
• /
• v.21 no.6
• /
• pp.588-594
• /
• 2000

Structural changes of an iron phthalocyanine (FePC) monolayer induced by adsorption and externally applied potential on high area carbon surface have been investigated in situ by iron K-edge X-ray absorption fine structure (XAFS) in 0.5 M $H_2S0_4.$ Fine structures shown in the X-ray absorption near edge structure (XANES) for microcrystalline FePC decreased upon adsorption and further diminished under electrochemical conditions. Fe(II)PC(-2) showed a 1s ${\rightarrow}$ 4p transition as poorly resolved shoulder to the main absorption edge rather than a distinct peak and a weak 1s ${\rightarrow}$ 3d transition. The absorption edge position measured at half maximum was shifted from 7121.8 eV for Fe(lI)PC(-2) to 7124.8 eV for $[Fe(III)PC(-2)]^+$ as well as the 1s ${\rightarrow}$ 3d pre-edge peak being slightly enhanced. However, essentially no absorption edge shift was observed by the 1-electron reduction of Fe(Il)PC(-2), indicating that the species formed is $[Fe(II)PC(-3)]^-$. Structural parameters were obtained by analyzing extended X-ray absorption fine structure (EXAFS) oscillations with theoretical phases and amplitudes calculated from FEFF 6.01 using multiple-scattering theory. When applied to the powder FePC, the average iron-to-phthalocyanine nitrogen distance, d(Fe-$N_p$) and the coordination number were found to be 1.933 $\AA$ and 3.2, respectively, and these values are the same, within experimental error, as those reported ( $1.927\AA$ and 4). Virtually no structural changes were found upon adsorption except for the increased Debye-Wailer factor of $0.005\AA^2$ from $0.003\AA^2.$ Oxidation of Fe(II)PC(-2) to $[Fe(III)PC(-2)]^+$ yielded an increased d(Fe-Np) (1 $.98\AA)$ and Debye-Wailer factor $(0.005\AA^2).$ The formation of $[Fe(II)PC(-3)]^-$, however, produced a shorter d(Fe-$N_p$) of $1.91\AA$ the same as that of crystalline FePC within experimental error, and about the same DebyeWaller $factor(0.006\AA^2)$.

• Proceedings of the Korea Concrete Institute Conference
• /
• 1999.10a
• /
• pp.103-106
• /
• 1999

In this study, the properties of mortar using ceramic wastes as admixtures and fine aggregates are considered experimentally. The main chemical of ceramic wastes is SiO2 and micro structure of ceramic wastes is porous. Absorption of ceramic wastes is higher than that of river sand and specific gravity is lower than that of river sand. Flow value of mortar using ceramic waste admixture and fine aggregates is increased more or less and the strength of mortar using ceramic wastes as fine aggregates is increased.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2006.08a
• /
• pp.842-845
• /
• 2006

We studied for high transmittance panel technology in the FFS mode. We found that fine slit of pixel electrode makes increase of panel transmittance, and at the same time this structure has an issue which is increasing operation voltage (Vop). We analyzed the reason of high Vop in the FFS pixel with fine slit using two-dimensional LC analyses. Finally we suggest the solution which has high transmittance with suitable operating voltage.

• Microbiology and Biotechnology Letters
• /
• v.5 no.3
• /
• pp.133-140
• /
• 1977

The results of electron microscopic studies on the cell fine structure of Nocardia sp the location of tellurite-reducing enzyme and the reduction part of T. T. C. (Triphenyl tetrazonium chloride) were summarized as follows. As the fine structure of the cell, the membrane-like structure with unit membrane was distributed in the cytoplasm. The membrane-like structure had complicate forms: some of membrane-like structure appeared spiral form. As the metal tellurium salt appeared in the cytoplasm, it is obvious that tellurite and tellurate-reducing enzymes are present in the cytoplasm. Reduction of T. T. C. took place in the cell membrane and the intracellular membrane-like structure. Therefore, it was thought that reduction of tellurate and T. T. C. took place in different parts. T. T. C. formazane formed in the cell was reoxidized by osmic acid which was used as a fixation reagent for the electron microscopic specimen preparation. As 95％ T. T. C. formazane was soluble in ethanol and embedding materials and removed out of the cell, an originally formed formazane appeared as electron light part on the electron microscopic image.

• Journal of the Korean institute of surface engineering
• /
• v.35 no.4
• /
• pp.232-240
• /
• 2002

The composition and the microstructure of the Zn-Cr alloys electroplated in chloride bath with EDTA were studied according to electrolysis conditions. The cathode current efficiency decreased with increasing both Cr/(Cr+Zn) ratio and current density. The Cr content of the alloy deposits increased with Cr/(Cr+Zn) ratio and current density The phase structure of Zn-Cr alloy deposits changed from η-Zn through η-Zn+${\gamma}$'-ZnCr to ${\gamma}$'-ZnCr with increasing Cr content of alloys. The surface morphology of Zn-Cr alloy deposits changed from fine needle shaped crystallites through the mixed structure of needle-shaped and granular one to the colony structure with fine granular crystallites according to the change of phase structure

• Clinical and Experimental Reproductive Medicine
• /
• v.8 no.2
• /
• pp.29-33
• /
• 1981

Vesectomy has been increased as a popular method of birth control because it is simpler than other methods for men. But the vasectomy results in several problems such as relation to effect changes on the structure and function of the reproductive organ. The fate of non-ejaculated spermatozoa is postulated by some authors that those are disappeared by a progress of dissolution and reabsorption in the epididymis, and we have attempted to prove the true state of sperm-acrosome on the fine structure in vasectomized rats. The results were as follows: 1. Apical segments of the acrosome were swollen similar to the shape of club in many spermatozoa. 2. Discontinuities of the outer and inner acrosomal membranes were occasionally noted and there were complete losses of acrosomes in the certain place. 3. There was no evidence of significant changes in the nuclear structure, nor dilatation of the subacrosomal space. 4. Vasectomy might effect destructive changes in the acrosomes of the non-ejaculated spermatozoa in situ.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2021.11a
• /
• pp.76-77
• /
• 2021

compared and reviewed the water repellency and strength characteristics by controlling the surface stamping size and fine aggregate ratio of cement mortar mixed with water repellent as a method to control the ecological imitation surface structure. As a result of measuring the contact angle, the higher the ratio of fine aggregate, the larger the contact angle. The contact angle increased when the surface structure was changed by stamping, and increased as the stamping size became smaller. In the surface stamping of mesh#150, the contact angle was particularly increased.

• Proceedings of the Korean Magnestics Society Conference
• /
• 2007.05a
• /
• pp.326.1-326.1
• /
• 2007

• Proceedings of the Korea Society of Design Studies Conference
• /
• 2004.10a
• /
• pp.208-209
• /
• 2004

• Journal of the Korean Applied Science and Technology
• /
• v.36 no.4
• /
• pp.1281-1289
• /
• 2019

This study was conducted to evaluate the optimal operating condition of ultra-fine bubble washing machine for removing calcium chloride from road concrete structure. The diameter of the ultra-fine bubble was measured to 196.6 ± 100.6 nm and the ultra-fine bubble concentration was measured to 1.36 × 108 cell/ml. As a result of the performance on the spray device of the washing machine, it was confirmed that the washing efficiency of 93% and 91% appeared at 100cm and 150cm of injection distance at 100bar injection pressure. By increasing the ultra-fine bubble generation cycles from 2 to 6, the chloride removal rate increased from 1% to 7%. As the ultra-fine bubble generation air flow was lowered from 4 ml/min to 0.5 ml/min, it was confirmed that the washing efficiency increased up to 30%. The washing efficiency of ultra-fine bubble water was 25% higher than normal water.