• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.18 no.6 s.121
• /
• pp.639-647
• /
• 2007

This paper proposed the novel method that can realize the parallel coupled line(PCL) band-pass filter with directly coupled feeding structure by means of transforming the first and last PCL sections of the conventional PCL band-pass filter into K-inverters, then substituting T-type equivalence for K-inverter. The proposed method supplies simple design formulae and can considerably reduce time and efforts needed to optimize filter performance when compared to reported methods using external Q or equivalent parameters. On the basis of the proposed method, the band-pass filter using directly coupled feeding structure and having 18% fractional bandwidth was designed and fabricated. The validity of proposed method was proven by the measured result.

• The Sea:JOURNAL OF THE KOREAN SOCIETY OF OCEANOGRAPHY
• /
• v.24 no.1
• /
• pp.128-138
• /
• 2019

Effects of feeding type and food resource availability on community structure of mollusks inhabiting hard-bottom subtidal areas were investigated. By following guidance from several references, mollusks observed in this study were divided into 5 groups according to feeding type - 1) grazing, 2) filter feeding, 3) deposit feeding, 4) omnivorous and 5) predation. The results showed that both grazing and filter feeders were the most numerous, explaining grazing type in the East Sea accounting for 47.9%, 32.6% in the South Sea and 29.6% for filter feeding, and filter feeding as a dominant feeding type in Yellow Sea accounting for 42.3%. Results of this study showed distinctive difference in community structure depending on mechanism of feeding type and geographical areas where sampling took place. With the results, attempts were made to understand whether community structure could be affected by feeding type or feeding availability and found out that community structure depended heavily on food resource availability. In the East Sea where marine algal density was high, the algal community in the forms of thick-leathery and sheet often occurred in water column with high transparency which provides proper environment for growth. In the South Sea where grazing and filter feeding types were predominated similarly, the algal density was high, but had the relative highest phytoplankton density. Whereas in the Yellow Sea showing the lowest algal biomass compared to the one in the East and the South Sea, and phytoplankton density was similar to those. It might be a adequate environment for filter feeders than grazers. This study concluded that community structure of mollusks showing high abundance was present where food resource availability with types and quantity was high.

• Journal of Ecology and Environment
• /
• v.46 no.4
• /
• pp.304-315
• /
• 2022

Background: Filter-feeding zooplankton has limited food resources owing to their habitat. Consequently, it is crucial for them to acquire all essential compounds, such as fatty acids (FAs) and amino acids, from confined diets. To elucidate the trophic transfer of FAs to filter feeders, the primary consumers in freshwater ecosystems, we compared the FA accumulation patterns of two species of filter-feeding zooplankton, Daphnia magna and Branchinella kugenumaensis, in a laboratory experiment. Experimental neonates and nauplii preyed on a single phytoplankton species (Selenastrum capricornutum) for three days after hatching prior to diet switching. Five replicates per feeding group in each species were fed on six different types of mixed phytoplankton diet for 10 days after diet switching. Subsequently, the consumers and diets were harvested and FAs were extracted. Results: Principal component analysis showed that the FA profiles of zooplankton were well-grouped by species and diet. Although diet affects the FA profiles of consumers, they exhibit different FA accumulation patterns. D. magna had a higher 18C-ω3 content and ω3/ω6 ratio than did B. kugenumaensis. In contrast, B. kugenumaensis had higher contents of 18:1ω7 and 20:5ω3 (eicosapentaenoic acid), 22:6ω3 (docosahexaenoic acid), and a higher ratio of ∑18C monounsaturated FAs to ∑18C-ω3 polyunsaturated FAs than did D. magna. Conclusions: This study showed that two primary consumers, D. magna and B. kugenumaensis, fed the same diet had different assimilation patterns of FAs under controlled environments. Specific FA accumulation patterns in filter feeders can provide information on the transfer process of various FAs to high-trophic organisms.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.40 no.2
• /
• pp.73-78
• /
• 2007

The suitability of a flexible fiber filter for removing suspended solid (SS) in a recirculating aquaculture system was evaluated. This study focused on variation in the performance with a change in filtering time, influent water quality, and filtering mode duration. The particle distribution diagram of the filter effluent showed that the number of particles bigger than $5-8{\mu}m$ decreased dramatically, and the removal efficiency exceeded 80%. Although the removal efficiencies of SS and chemical oxygen demand (COD) were dependent on the quality of the influent, the SS and COD concentrations of the effluent were not affected by the influent concentrations. This was despite the deterioration if water quality after feeding in the rearing tank. The performance of the filter was not affected by the filtering mode duration, feeding conditions, or filtering time. The SS concentration and turbidity of the recirculating-type rearing tank were 30% and 50% lower, respectively, than of the a non-recirculating-type rearing tank under the same operating conditions. The flexible fiber filter was applicable to a recirculating aquaculture system that uses plenty of seawater, based on its low filtering resistance $(2kg_f/cm^2)$, high flux $(330m^3/m^2/hr)$, and high fine particle removal efficiency (80%, $5-8{\mu}m$).

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.65 no.6
• /
• pp.1108-1114
• /
• 2016

The cause of failure in the AT feeding system is divided into grounding, short-circuit of feeding circuit and internal faults of the railway substation. Since the fault current is very high, real-time current is detected and the failure must be immediately removed. In this paper, a new DC offset elimination filter that can remove component to decrease in the form of exponential function using low-pass filter was proposed in order to extract the fundamental wave from distorted fault current. In order to confirm the performance of the proposed filter method, AT feeder system was modelled by simulation tool and simulations were performed under various conditions such as fault location, fault resistance and fault voltage phase angle in case of trolley-rail short-circuit fault. When applying the proposed DC-offset removal method, it can be seen that the phase delay and gain error did not appear.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2007.04a
• /
• pp.34-37
• /
• 2007

Propellant filling and holding test was carried out using liquid oxygen as a working fluid. The feeding line system has a filter at propellant tank outlet. Vaporization of liquid oxygen during holding after completion of filling and effect of vaporization to recirculation performance in this system was observed. Filling rate and pressure of tank ullage had the effect on state of liquid oxygen in feeding line. There was no geysering in feeding line during holding because of the position of filter.

• Proceedings of the Korean Institute of Intelligent Systems Conference
• /
• 2001.12a
• /
• pp.19-22
• /
• 2001

In this paper, Streaming Current Monitor (SCM), Pilot Filter (PF) and Coagulant Feeding System(CFS) for fuzzy neural network are used as a coagulation control method in WTP and the results are compared. Several parameters such as coagulant dosage, pH, and turbidity have been changed to find the response characteristic of each equipment. SCM, PF and CFS responded for certain parameters but the range of sensitivity was different each other. It is demonstrated that WTP will be operated more efficiently when SCM, PF and CFS are used as coagulation control strategy.

• Journal of Navigation and Port Research
• /
• v.31 no.5 s.121
• /
• pp.415-420
• /
• 2007

In this paper, we have designed and fabricated a new type of bandpass-filter that used rectangular ring and interdigital capacitive feeding-structure. The filter is applied the modified rectangular ring and interdigital capacitive feeding-structure in patch, which reduce rho size of filter and IEEE 802. 11 correspond to wireless LAN domain(2.45GHz and 5.2GHz) for operating. As a result, the design and fabrication process of the filter become simple and the size of it is reduced more than 60% compared with RF filter are available conventional PEMBF(Parallel Edge-coupled Microstrip Bandpass Filter) of accounted circuit by minimum stage, measurement result of fabricated filter, center frequence is down 2.408GHz and 5.075GHz. input return loss is -39.169dB at 2.408GHz, -40.922dB at 5.075GHz. insertion loss is -0.437dB at 2.408GHz, -1.669dB at 5.075GHz.

• KSBB Journal
• /
• v.9 no.2
• /
• pp.230-237
• /
• 1994

Spin-filters are used as cell separation devices for achieving high cell density and high productivity in animal cell culture. We have proposed a model for the cell growth in a spin-filter perfusion culture and examined the effects on cell growth by several parameters including ammonia inhibition, specific growth rate, specific feeding rate, and cell retention. Results from computer simulation and sensitivity analysis indicate that the cell retention affects the cell growth mostly while there is a significant inhibition on cell growth by the ammonia accumulated during the culture. The specific feeding rate has minimal effects on cell growth, which is consistant with the fact that the cell growth with a step feeding is quite similar to that with a continuous feeding.

• Journal of Korean Society for Atmospheric Environment
• /
• v.20 no.3
• /
• pp.361-369
• /
• 2004

A metal fiber bed has seldom been applied to the practical filtration process despite its excellent mechanical and chemical stability. The filter-bed used in this work was highly porous with open structure, of which apparent porosity was 80 ∼ 90%. Although pressure loss across the filter-bed was very low, separation efficiency was found to be quite high. This paper focuses on the basic filtration mechanisms of a metal filter-bed and a thin ceramic filter from fly ash for reference. The experimental parameters were face velocity, dust loading and porosity of filter-bed. Pressure drop increased with increasing face velocity and dust feeding load for both filters. It also showed that dust particles deposited in the deep flow path, finally resulting in clogging the pore channels. It thereby indicates that the dominating mechanism of the metal filter-bed would be depth filtration. Meanwhile, the thin fly ash composite filters trapped the aerated dust mainly on the surface of the filter medium, so that the instantaneously formed dust layer might cause a steep increase of pressure drop across the filtration system.