• 제어로봇시스템학회논문지
• /
• 제10권5호
• /
• pp.402-410
• /
• 2004

To obtain a good tracking performance in an optical disk drive servo system, it is essential to attenuate periodic disturbances caused by eccentric rotation of the disk. As an effective control scheme for enhancing disturbance attenuation performance, disturbance observers (DOBs) have been successfully applied to the track-following servo system of optical disk drives. In disk drive systems, the improvement of data transfer rate has been achieved mainly by the increase of disk rotational speed, which leads to the increase of the disturbance frequency. Conventional DOBs are no longer effective in disk drive systems with a high-speed rotation mechanism because the performance of conventional DOBs is severely degraded as the disk rotational frequency increases. This paper proposes a new DOB structure for effective rejection of the disturbance in optical disk drives with a very high rotation speed. Asymptotic disturbance rejection is achieved by adopting a band-pass filter in the DOB structure, which is tuned based on the information on the disturbance frequency. In addition, performance sensitivity of the proposed DOB to changes in disk rotational frequency is analyzed. The effectiveness of the proposed DOB is verified through simulations and experiments using a DVD-ROM drive.

• 전자공학회논문지S
• /
• 제34S권7호
• /
• pp.28-38
• /
• 1997

Previously, we have proposed the M-BECM(Modified-Band Edge Component Maximization), which is a symbol synchronization algorithm based on spectral line method for all-digital high speed digital communications. However, Until now, the characteristics of the timing detector based on the spectral line method including M-BECM was not analyzed, particularly the effect of a timing offset at the optimal convergence pont. In this paper, we analyze the timing dtector's characteristics of the M-BECM and present optimal design value. First, the expression for the timing detector's mean value(often called its S-Curver) as a function of the normalized symbol timing offset is derived. Next, the P $D_{bias}$, the value for compensating the timing offset at an optimal convergence point, and the bandwidth of bandpass filter in the timing detector are calculated. It is also shown and analyzed that the P $D_{bias}$ is affected by varuous factors such as the excess bandwidth of input signal, frequency offsets, noise and particularly, the excess bandwidth of input signal is a major parameter to decide P $D_{bias}$. Finally, analytic resutls are compared to simulation results.

• 한국인터넷방송통신학회논문지
• /
• 제14권4호
• /
• pp.85-90
• /
• 2014

ZigBee를 이용한 개인영역망으로 구성된 무선 다중 통합 레이저 교전 시스템을 구현하였다. 무선 레이저 검출기는 아날로그 신호처리, 해독 및 무선통신 기능을 갖추어야하는 반면 병사의 신체에 부착될 수 있도록 저전력소모, 소형 및 경량화 되어야한다. 소형 및 경량화를 위해 해독기는 소프트웨어적으로 구현하였고, 협대역 광학 필터를 이용하여 시스템의 부하를 줄여줌으로써 저전력화를 꽤하였다. 제작된 무선 레이저 검출기는 광잡음 환경에서도 정상 작동하였다. 무선 개인영역망을 통한 PU(Player Unit)와의 통신은 무선 레이저 검출기의 부착 위치에 따라 다소 차이가 있었으나 -40.2dBm이상의 출력으로 송신할 경우 100%의 수신율을 확보할 수 있었다.

• Journal of the Optical Society of Korea
• /
• 제19권4호
• /
• pp.346-350
• /
• 2015

We report a measurement of the effective refractive index of a nematic liquid crystal (NLC) inside a Fabry-Perot (FP) etalon according to the applied electric fields. The effective refractive index of the NLC depends on the intensity of the applied electric field. A wavelength-swept laser with a polygon-scanner-based wavelength filter is used as a wide-band optical source to measure the effective refractive index of the NLC. The bandwidth of the optical source is greater than 90 nm around 1300 nm. The fabricated NLC FP etalon consists of glass substrates, gold layers as the electrodes with highly reflective surfaces, polyimide layers as the planar alignment layers, and an LC layer. Furthermore, we measured the Freedericksz transition voltages for three types of NLC FP etalons having thicknesses of $30.6{\mu}m$, $55.4{\mu}m$, and $108.8{\mu}m$. The Freedericksz transition voltages in the three cases are nearly equal. The measured effective refractive indices in the three cases decreased from 1.67 to 1.51 as the applied electric field intensity was increased. Beyond the threshold electric field, the effective refractive indices quickly decreased and eventually saturated at a value of 1.51 for all cases.

• 한국운동역학회지
• /
• 제17권2호
• /
• pp.41-50
• /
• 2007

The purpose of this study was to examine the effects of Task-oriented training on the balance, lapse time and MVC(Maximum Voluntary Contraction) of CVA(cerebral vascular accident) patients. The active balance equipment was used to measure of the static balance, lapse time and task-oriented training. The EMG technique was used to record muscle activitie of affected side of gluteus medius and vastus medialis. The raw EMG data were filtered with band pass filter (60Hz) to remove artifacts and then low pass filtered (20Hz) to find the linear envelope which resemble muscle tension curve. The experiment had been conducted at the department of physical therapy in J hospital in M city during 8weeks. The thirty patients experienced the stroke were participated: training group (15), control group (15). They were ambulatory with or without an assistive device. They were assessed on central perturbation(mm) in the static balance, lapse time(s) and MVC test(mV). The data were analyzed using repeated measured ANOVA. The results were as follows: After Task-oriented training, central perturbation and lapse time was significantly differences in both groups(p<.001), and MVC in gluteus medius were no significant differences in both groups, but vastus medialis was significant differences in both groups (p<.001).

• 한국전자파학회논문지
• /
• 제19권11호
• /
• pp.1248-1253
• /
• 2008

본 논문은 접지가 있는 비대칭 CPW(Coplanar Waveguide) 선로를 conformal mapping 방법을 사용하여 해석하였다. 이 방법으로 선로의 준정전계 특성 파라미터인 특성 임피던스와 유효 유전율을 계산하였다. 계산된 결과는 상용 프로그램인 IE3D의 결과와 기존 실험값과 비교했으며, 거의 일치함을 보였다. 그리고 본 논문에 해석한 접지가 있는 비대칭 CPW(MCS: Micro Coplanr Strip) 선로를 이용하여 스텝 임피던스 저역 필터에 적용하였다. 제작된 스텝 임피던스 저역 필터는 일반 마이크로스트립 선로로 구현된 저역 필터 특성과 비교하였다. 제작된 필터의 실험 결과를 모의실험과 비교하여 잘 일치함을 확인하였다.

• 한국의학물리학회지:의학물리
• /
• 제5권1호
• /
• pp.25-39
• /
• 1994

심장 벽의 운동속도와 혈관내 혈구의 유속을 측정하기 위해, 단일 채널 3.1MHz 펄스 도플러 속도계를 제작하였다. 도플러 속도계에 사용된 초음파 펄스의 폭과 펄스 반복주파수(PRF)는 각각 1$\mu$s과 6kHz이고, 후방 산란된 반향신호의 도플러 편이는 완전간섭성(coherent) 복조방식을 이용하여 위상 측정기에 감지된다. 위상 측정기의 출력신호로부터 레인지 게이트와 샘플 홀더, 대역여파기를 이용하여 작은 영역내에 있는 초음파 산란체의 평균속도에 해당하는 도플러 신호가 얻어진다. 도플러 신호의 평균 주파수는 영점교차의 카운터에 의해 측정되며 시간의 함수로 산란체의 순간 속도를 디스플레이한다. 채널 수와 거리 분해능을 증가시키면 혈관내의 혈류속도 분포도와 총 유량 그리고 혈류가속도를 측정할 수 있다.

• 한국세라믹학회지
• /
• 제40권4호
• /
• pp.393-397
• /
• 2003

To investigate the effect of AIN c-axis orientation on the resonance performance of film bulk acoustic wave resonators, solidly mounted resonators with crybtallographically different AIN piezoelectric films were prepared by changing only the bottom electrode surface conditions. As increasing the degree of c-axis texturing, the effective electromechanical coupling coefficient ($\kappa$$\_$eff/)$^2$ in resonators increased gradually. The least 4 degree of full width at half maximum in an AIN(002) rocking curve, which corresponds to $\kappa$$^2$$\_$eff/ of above 5%, was measured to be necessary for band pass filter applications in wireless communication system. The longitudinal acoustic wave velocity of AIN films varied with the degree of c-axis texturing. The velocity of highly c-axis textured AIN film was extracted to be about 10200 n/s by mathematical analysis using Matlab.

• International Journal of Fuzzy Logic and Intelligent Systems
• /
• 제13권1호
• /
• pp.12-18
• /
• 2013

Motor imagery classification in electroencephalography (EEG)-based brain-computer interface (BCI) systems is an important research area. To simplify the complexity of the classification, selected power bands and electrode channels have been widely used to extract and select features from raw EEG signals, but there is still a loss in classification accuracy in the state-of- the-art approaches. To solve this problem, we propose a discriminative feature extraction algorithm based on power bands with principle component analysis (PCA). First, the raw EEG signals from the motor cortex area were filtered using a bandpass filter with ${\mu}$ and ${\beta}$ bands. This research considered the power bands within a 0.4 second epoch to select the optimal feature space region. Next, the total feature dimensions were reduced by PCA and transformed into a final feature vector set. The selected features were classified by applying a support vector machine (SVM). The proposed method was compared with a state-of-art power band feature and shown to improve classification accuracy.

• 천문학회보
• /
• 제38권2호
• /
• pp.83.2-83.2
• /
• 2013

Camera for QUasars in EArly uNiverse (CQUEAN) is an optical CCD camera developed by the Center for the Exploration of the Origin of the Universe (CEOU). In 2010 August, CQUEAN was attached on the 2.1m Otto Struve Telescope at the McDonald Observatory in Texas, USA. As the main purpose of CQUEAN is detecting the Lyman breaks of redshift ~5 quasars, it is sensitive to near-infrared wavelengths (0.7-1.0 ${\mu}m$). For the auto-guiding system, it is using a rotating guide arm to find guide stars on the Cassegrain off-axis focus of the telescope. We plan to upgrade a new filter wheel system consists of a series of narrow band filters. We will install this independent auto-guiding units on the finder scope, which makes rooms on the Cassegrain focal plane of the main telescope. In this presentation we present the system architecture of the CQUEAN Auto-guiding Package (CAP).