• Structural Engineering and Mechanics
• /
• v.76 no.3
• /
• pp.311-324
• /
• 2020

Until now, a comparative study on fully and partially-connected steel shear walls leading to enhancing strength and stiffness reduction of partially-connected steel plate shear wall structures has not been reported. In this paper a number of 4-story and 8-story steel plate shear walls, are considered with three different connection details of infill plate to surrounding frame. The specimens are modeled using nonlinear finite element method verified excellently with the experimental results and analyzed under monotonic loading. A comparison between initial stiffness and shear strength of models as well as percentage of shear force by model boundary frame and infill plate are performed. Moreover, a comparison between energy dissipation, ductility factor and distribution of Von-Mises stresses of models are presented. According to the results, the initial stiffness, shear resistance, energy dissipation and ductility of the models with beam-only connected infill plates (SSW-BO) is found to be about 53%, 12%, 15% and 48% on average smaller than those of models with fully-connected infill plates (SPSW), respectively. However, performance characteristics of semi-supported steel shear walls (SSSW) containing secondary columns by simultaneously decreasing boundary frame strength and increasing thickness of infill plates are comparable to those of SPSWs. Results show that by using secondary columns as well as increasing thickness of infill plates, the stress demands on boundary frame decreases substantially by as much as 35%. A significant increase in infill plate share on shear capacity by as much as 95% and 72% progress for the 4-story SSW-BO and 8-story SSSW8, respectively, as compared with non-strengthened counterparts. A similar trend is achieved by strengthening secondary columns of 4-story SSSW leading to an increase of 50% in shear force contribution of infill plate.

• Journal of Internet Computing and Services
• /
• v.20 no.6
• /
• pp.129-135
• /
• 2019

Recently, studies have been conducted to improve the m-commerce process in the NFC-based mobile environment and the increase of the number of smart phones built in NFC. Since authentication is important in mobile electronic payment, FIDO(Fast IDentity Online) and 2 Factor electronic payment system are applied. In addition, block-chains using distributed raw materials have emerged as a representative technology of the fourth industry. In this study, for the mobile gallery auction of the traders using NFC embedded terminal (smartphone) in a small gallery auction in which an unspecified minority participates, password-based authentication and biometric authentication technology (fingerprint) were applied to record transaction details and ownership transfer of the auction participants in electronic payment. And, for the cost reduction and data integrity related to gallery auction, the private distributed director block chain was constructed and used. In addition, domestic and foreign cases applying block chain in the auction field were investigated and compared. In the future, the study will also study the implementation of block chain networks and smart contract and the integration of block chain and artificial intelligence to apply the proposed method.

• Geomechanics and Engineering
• /
• v.7 no.5
• /
• pp.495-524
• /
• 2014

To investigate the soil-pile interactive performance under lateral loads, a set of laboratory model tests was conducted on remoulded test bed of soft clay and medium dense sand. Then, a simplified boundary element analysis had been carried out assuming floating pile. In case of soft clay, it has been observed that lateral loads on piles can initiate the formation of a gap, soil heave and the tension crack in the vicinity of the soil surface and the interface, whereas in medium dense sand, a semi-elliptical depression zone can develop. Comparison of test and boundary element results indicates the accuracy of the solution developed. However, in the boundary element analysis, the possible shear stresses likely to be developed at the interface are ignored in order to simplify the existing complex equations. Moreover, it is unable to capture the influence of base restraint in case of a socketed pile. To bridge up this gap and to study the influence of the initial stress state and interface parameters, a field based case-study of laterally-loaded pile in layered soil with socketed tip is explored and modelled using the finite element method. The results of the model have been verified against known field measurements from a case-study. Parametric studies have been conducted to investigate the influence of the coefficient of lateral earth pressure and the interface strength reduction factor on the results of the model.

• Journal of Microbiology and Biotechnology
• /
• v.20 no.7
• /
• pp.1134-1139
• /
• 2010

This study explored the chronic effects of different doses of the triazole fungicide tebuconazole on the growth, and metabolic and enzymatic functions of the filamentous paddy field cyanobacterium, Westiellopsis prolifica Janet. The growth of the cyanobacterium was determined by an estimation of the change in pigment contents. Chlorophyll-a, carotenoids, and accessory pigments such as phycocyanin, allophycocyanin, and phycoerythrin were shown to decline over a 16-day period by a factor of 92%, 93%, 83%, 95%, and 100%, respectively, with increasing doses of the fungicide. Metabolic and enzymatic activities were also adversely affected. Over the 16 days, a gradual rise in total phenol content was recorded when Westiellopsis prolifica Janet was treated with 60 ppm of the fungicide, despite the reduction in carbohydrates, proteins, and amino acids by 96%, 92%, and 90%, respectively. Moreover, the enzymes nitrate reductase (NR), glutamine synthetase (GS), and succinate dehydrogenase (SDH) also registered reductions of 93%, 90%, and 98%, respectively. This study indicates that tebuconazole, although an important fungicide used extensively in rice fields, exhibits an inhibitory effect on the growth and metabolic activities of Westiellopsis prolifica Janet and hence possibly on other varieties as well.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.39 no.spc1
• /
• pp.142-150
• /
• 2006

We examined the effect of predation by observing the changes in macrobenthic communities in a tidal flat at Seonjae, Korea, following the exclusion of large predators such as birds, fishes and crustaceans using protective screens. We conducted two interference experiments in the field from April to November 2004: (1) Experiment 1 was conducted at a mid-tidal flat in the western part of Seonjae-do, Incheon, Korea, (2) Experiment 2 was set up at a low tidal flat in the eastern part of Seonjae-do. predator exclusion showed different effects in the two experiments. Both the number of species and density were reduced by 20% in Experiment 1. Whereas in Experiment 2, they increased by up to 13% and 69%, respectively. In Experiment 1, a high density of brachyuran crabs observed in the treatment may have caused the difference in community composition between the treatment and the control, and this probably resulted from active predation of macrofauna (e.g., small crabs) under protection from megafaunal predators such as birds and fishes. However, in Experiment 2, as typically observed in other predator exclusion experiments, a lower density of benthic predators and the subsequent reduction of over predation probably resulted in a more diverse and abundant benthic community in the treatment. We confirmed that predation was a contributing factor in the formation of the macrobenthic community. We also demonstrated relationships that exist among different trophic groups (large predators, macrobenthic predators and prey) and what effects and responses occur in each component of the tidal flats.

• Journal of Climate Change Research
• /
• v.7 no.4
• /
• pp.443-450
• /
• 2016

The major greenhouse gases (GHGs) in agricultural sector are methane ($CH_4$), nitrous oxide ($N_2O$), carbon dioxide ($CO_2$). GHGs emissions are estimated by pertinent source category in a guideline book from Intergovernmental Panel on Climate Change (IPCC) such as methane from rice paddy, nitrous oxide from agricultural soil and crop residue burning. The methods for estimation GHGs emissions in agricultural sector are based on 1996 and 2006 IPCC guideline, 2000 and 2003 Good Practice Guidance. In general, GHG emissions were calculated by multiplying the activity data by emission factor. The total GHGs emission is $10,863Gg\;CO_2-eq$. from crop cultivation in agricultural sector in 2013. The emission is divided by the ratio of greenhouse gases that methane and nitrous oxide are 64% and 34%, respectively. Each gas emission according to the source categories is $7,000Gg\;CO_2-eq$. from rice paddy field, $3,897Gg\;CO_2-eq$. from agricultural soil, and $21Gg\;CO_2-eq$. from field burning, respectively. The GHGs emission in agricultural sector had been gradually decreased from 1990 to 2013 because of the reduction of cultivation. In order to compare with indirect emissions from agricultural soil, each emission was calculated using IPCC default factors (D) and country specific emission factors (CS). Nitrous oxide emission by CS applied in indirect emission, as nitrogen leaching and run off, was lower about 50% than that by D.

• Journal of the Society of Disaster Information
• /
• v.19 no.3
• /
• pp.719-728
• /
• 2023

Purpose: Mobile cranes are machines that contribute to high mortality, and the High Risk Factor (SIF) information, which analyzed 2,574 accidental deaths in the construction industry in the past 6 years (2016~2021), resulted in a total of 61 mobile crane accidents. Despite safety measures in the field, it is not used properly. In this study, we present standard risk assessment indicators that contribute to accident prevention. Method: Through expert interviews, fatal accident case analysis, field analysis, and literature research, we present the standard risk assessment index method of the 4M risk assessment method. Result: As a result of analyzing the risk assessment of eight sites, it was concluded that it cannot make a significant contribution to disaster prevention and should be applied as an improvement measure of the Standard Risk Assessment Index Law. Conclusion: Switching to the standard risk assessment index method at construction sites has been proposed to make it easier for health and safety personnel and workers to use, contributing to the reduction of accidents.

• Journal of the Korean GEO-environmental Society
• /
• v.13 no.7
• /
• pp.5-12
• /
• 2012

Recently the installation of reinforced earth retaining walls in the domestic construction site has increased, surpassing conventional RC walls. These reinforced walls have various types depending on the reinforcing material, installation method and the form of face panel. However, there are difficulties in design and construction management due to the unproved safety of construction method. In case of reinforcing materials, despite the fact that they come in all different sizes and types produced by small businesses or partially imported with cheap price and low quality, no proper standards for designing the walls have been suggested. In order to apply reinforced retaining wall system to broad cases and design the walls effectively considering site conditions, specific design and construction guidelines for efficient construction management are needed. In conclusion, this study verified that reduction factors can be greatly affected by grain sizes and stiffness of backfill materials and granularity range, therefore in case of relatively large construction site, it is required to redesign the reinforced retaining wall by evaluating site installation resistance test, applying respective reduction factors to each backfill material and select the right geogrid depending on the usage of retaining wall so as to enhance the safety of reinforced earth retaining walls with efficiency.

• Journal of the Korean Society of Safety
• /
• v.31 no.3
• /
• pp.143-155
• /
• 2016

Recently, a massive loss of life and property is occurring in Korea due to traffic accidents, with the rapid increase in cars. For improvement of traffic safety, the Korea Transportation Safety Authority intensively analyzes accident data in local governments with low traffic safety index, performs a field investigation to extract problems and offers local governments improvements for problems, by conducting the 'Special Survey of Actual Conditions of Traffic Safety' each year, starting 2008. But local governments cannot strongly push forward the improvement projects due to the limited budget and the uncertainty of the improvement plan effects. Therefore, this study suggested a model which applied the Utility concept to the AHP theory, in order to efficiently decide a priority of the improvement plans in accident black spots in consideration of the limited budget of local governments. The number of accidents in each spot for improvement and accident severity, traffic volume, pedestrian volume, the improvement project cost and the accident reduction effect were chosen as evaluation factors for deciding a priority, and data about the improvement plan costs and the accident reduction effects, traffic accidents and traffic volume in the spots to undergo the special research on the real condition of traffic accident in the past were collected from the existing studies. Then, regression analysis was carried out and the Utility Curve of each evaluation factor was computed. Based on the AHP analysis findings, this study devised a priority decision method which calculated the weight and the utility function of each evaluation factor and compared the total utility values. The AHP analysis findings showed that among the evaluation factors, accident severity had the biggest importance and it was followed by the improvement plan cost, the number of accidents, the improvement effect, traffic volume and pedestrian volume. The calculated utility function shows a rise in utility, as the variables of the 5 evaluation factors; the number of accidents, accident severity, the improvement plan effect, traffic volume and pedestrian volume increase and a fall in utility, as the variables of the improvement plan cost increase, since the improvement plan cost is included in the budget spent by a local government.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.13 no.10
• /
• pp.4917-4926
• /
• 2012

This study was designed to assess the factor of influence to occupational stress who work in the field of firefighters and questionnaire was uesd to analyse the stress scores and find the primary factors influence to occupational stress. The number of respondents were 408 who received the refresher training and period of investigation was august 2011 through october 2011. A structured questionnaire was employed to evaluate the participants' socio-demographics, job-related factors, health-related behaviors, occupational stress, reaction factor (fatigue, job satisfaction) and buffer factor (social support). Occupational stress and fatigue were assessed using the Korean Occupational Stress Scale-Short Form (KOSS-SF) and the Multidimensional Fatigue Scale (MFS), respectively. The analysis showed that we found a strong correlation between fatigue, job satisfaction and occupational stress. Occupational stress was associated with an increased risk of fatigue and decreased the job satisfaction. In the multiple regression analysis(stepwise), main factor that influence to occupational stress were job satisfaction, gender, age, processing number for a day, exercise. In logistic regression analyses, a higher occupational stress was associated with higher odds of fatigue(High) and the odds was down by 15.0% after adjustment for job satisfaction, gender, age, processing number for a day, exercise. Thus, a job satisfaction promote program for the reduction of occupational stress and the promotion of firefighters's health is strongly recommended.