• The Transactions of the Korean Institute of Electrical Engineers B
• /
• v.55 no.5
• /
• pp.250-257
• /
• 2006

It is well known that Grain-oriented electrical steel sheets have two dimensional magnetic properties according to the direction of exciting field such as non-linear phase difference between magnetic flux density and magnetic field intensity vectors, different iron loss and permeability even when an alternating magnetic field is applied. The measurement and application of the two dimensional magnetic properties of the Grain-oriented electrical steel sheets, therefore, are very important for the design and precise performance analysis of electric machines made of them. As the direction of exciting field changes, in this paper, the two dimensional magnetic properties of a Grain-oriented electrical steel sheet, i.e., non-linear B-H curves, phase difference between B and H, and iron loss characteristics, are measured using SST(Single Sheet Tester) which has two axes excitation. The measured results are presented in two ways: using $(B,\theta_B)$ method and using hysteresis loops along rolling and transverse directions, respectively.

• Journal of Environmental Science International
• /
• v.25 no.11
• /
• pp.1521-1530
• /
• 2016

As a result of dividing typhoon that affected Korean Peninsular between 1999 and 2012 into 7 types of path and entering forecast field and analysis field of RDAPS, until 36 hours from the time of forecast, it is reliable to use the forecast field of RDAPS to predict typhoon and for each typhoon path, the difference between the forecast and the analysis shows normal distribution, which is usable for weather forecast until the $36^{th}$ hour. In the $48^{th}$ hour from the time of forecast, the difference of result depending on each typhoon path increased, which was analyzed to be due to errors in the forecast. It was expected that relatively reasonable results should be shown if the $36^{th}$ hour forecast is used to predict the strength and distribution of strong wind. As a result of using Korean RAM and observing the difference of the maximum damage, reliability was secured up to 36 hours and after 48hours, it was expected that the fluctuation of results may become more severe.

• Journal of the Korean Society for Library and Information Science
• /
• v.32 no.2
• /
• pp.77-96
• /
• 1998

Attitude of librarian's Job satisfaction was shown differently by individual characteristic, personality, and cognitive structure in the same circumstance. This means that it is related to the personal psychological difference and subjective thinking. The purpose of this study is to analyze the psychological difference of libraians, especially their Cognitive style and to know what acts the difference and effect in Job satisfaction. The methodology of the study is a suvey of 160 librarians in 11 academic libraries at Pusan. The results are as fellows. In General, they were satisfied with ph than the normal level ane the most dissatisfied with promotion. They had no difference of Cognitive style with a demographic characteristics, had a similar difference with job satisfation, and the older and the higher position peoples were satisfied with thou ph. Cognitive style firly effect at the ph satisfation. Field dependence librarians are more satisfied with their job than field independence librarians. Field independence librarians are oppropriate to technical Services and field dependence librarians are more oppropriate for public services. In conclusion, they demonstrated that it Is very important to consider each psychological difference with cognitive style.

• Journal of Astronomy and Space Sciences
• /
• v.27 no.3
• /
• pp.205-212
• /
• 2010

To better understand the physical processes that maintain the high-latitude lower thermospheric dynamics, we have identified relative contributions of the momentum forcing and the heating to the high-latitude lower thermospheric winds depending on the interplanetary magnetic field (IMF) and altitude. For this study, we performed a term analysis of the potential vorticity equation for the high-latitude neutral wind field in the lower thermosphere during the southern summertime for different IMF conditions, with the aid of the National Center for Atmospheric Research Thermosphere-Ionosphere Electrodynamics General Circulation Model (NCAR-TIEGCM). Difference potential vorticity forcing and heating terms, obtained by subtracting values with zero IMF from those with non-zero IMF, are influenced by the IMF conditions. The difference forcing is more significant for strong IMF $B_y$ condition than for strong IMF $B_z$ condition. For negative or positive $B_y$ conditions, the difference forcings in the polar cap are larger by a factor of about 2 than those in the auroral region. The difference heating is the most significant for negative IMF $B_z$ condition, and the difference heatings in the auroral region are larger by a factor of about 1.5 than those in the polar cap region. The magnitudes of the difference forcing and heating decrease rapidly with descending altitudes. It is confirmed that the contribution of the forcing to the high-latitude lower thermospheric dynamics is stronger than the contribution of the heating to it. Especially, it is obvious that the contribution of the forcing to the dynamics is much larger in the polar cap region than in the auroral region and at higher altitude than at lower altitude. It is evident that when $B_z$ is negative condition the contribution of the forcing is the lowest and the contribution of the heating is the highest among the different IMF conditions.

• Korean Journal of Applied Biomechanics
• /
• v.19 no.2
• /
• pp.323-336
• /
• 2009

The purpose of the current study was to research scientific basis and necessity of supplementary materials for field lesson out of golf swing teaching methods. As the subject of study, skillful tour pro golfers were chosen to reinterpret field lesson results for driver swing from the viewpoint of kinematics. In addition, through precise analysis, this study developed a case to verify the validity and error of field lesson. As a result, field lesson showed a slight difference among qualitative evaluation of kinematical analysis of techniques, subjects of study, and items. Accordingly, there was a little difference between two methods in view of evaluation of errors that 5 subjects of the study have shown. However, there was a significant difference in compensation to prevent causes of error and errors. Based on instructor's experience most errors could be evaluated. Therefore, feedback for error correction based on instructor's experience showed a significant difference from qualitative evaluation of kinematical analysis of techniques. In conclusion, the following are required for correct golf swing lesson; instant feedback through field lesson and qualitative evaluation of kinematical analysis of techniques to determine fundamental causes correctly.

• Journal of Korean Public Health Nursing
• /
• v.10 no.2
• /
• pp.37-50
• /
• 1996

To analyze the roles by abilities between manpower through the analysis of industrial health service agency personnel, 115 industrial health service agency personnel in 19 Industrial Health Service Agency personnel scattered in Seoul and Kyungki areas have been investigated according to the questionnaires formulated in line with the Likert 5-point scale from September 1 through October 30, 1995 and the following significant result has been obtained: 1. The job abilities by fields. 1) In the field of health care, the level of medical personnel's job ability was 3.30 on average and that of industrial hygienists' was 2.54 on average, which showed that the level of medical personnel's job ability was higher. 2) In the field of health management, there was a difference between the level of medical personnel's job ability and that of industrial hygienists' only in the health education but there was not so much difference between manpower' which showed that it was 3.00 on average. 3) In the field of working environment management. the level of industrial hygienists' job ability was 4.03 on average and that of medical personnel's was 2.62, which showed that the level of industrial hygienists' job ability was higher than that of medical personnel's. 2. The job abilities by manpower. As for the job ability by manpower. on the health care the medical personnel's ability was more excellent than the industrial hygienists' and on the working environment management the latter's{industrial hygienists') ability was more excellent than the former's(the medical personnel's). However. the field that a difference between both manpower as mentioned above was not recognized was the health management. 3. As for the difference of potential factors between manpower. in Factor '1' the industrial hygienists' 80.7 points by percentage was higher than the medical personnel's 52.5 points and in Factor '2' the latter's(medical personnels's) 72.6 points by percentage was higher than the former's{industrial hygienists') 50.6 points in the level of job abilities. The above result shows that the industrial health service agency personnel can be classified into the job with a difference between manpower and that without any difference manpower. Therefore, the following issues: First: The field of health care shall be defined as the medical personnel's exclusive job. Second: The field of working environment management shall be defined as the industrial hygienists' exclusive job. Third: The field of health management shall be defined as a common job to lead the limits of time and space in the collective group occupational health management to be controlled effectively.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.17 no.5
• /
• pp.1055-1063
• /
• 2013

CTL cell that is one of the standard electromagnetic generation equipment can measure the characteristic of the electromagnetic susceptibility and the electromagnetic interference. In case of being input the same magnitude signal with the phase difference of 0o or the phase difference of 180o at two input ports of CTL cell to be the fundamental resonant frequency(TE011) of 2.20GHz, the characteristics of the electric field and the magnetic field at the uniform area were measured. And, it measured the electric field characteristic due to the variation of the input power, the test position and the input frequency under the dominant E-field and the dominant H-field of CTL cell. Using these mesuremed data, it examined the operation characteristic and the available frequency band of CTL cell.

• Journal of Advanced Marine Engineering and Technology
• /
• v.24 no.1
• /
• pp.88-93
• /
• 2000

In this study, the mixing process of two-phase flow generated by two jets with height difference is analyzed. The primary jet is jetted on the condition of the state mixed pulverized solid particles with air. The height difference between the main jet and the secondary jet is changed into three kinds(0, 32.5, 47.5mm). The velocity vector field, concentration field and turbulent properties of solid particles are measured by using 3-Dimensional Particles Dynamics Analyzer. As the height difference of two jets through the two nozzles increases, the solid particle recirculation zone and the dense zone in the combustion chamber become large. The solid particle concentration at the center of the combustion chamber gets dense because the particle velocity remains slow due to the existence of the solid particle recirculation zone. The particle concentration in the combustion chamber can also be influenced by the hight difference of two jets.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.25 no.2
• /
• pp.159-164
• /
• 2012

In this paper, it tried to develop the core sensor for detection of micro magnetic field in electric wires. The sensor is non contact type and is consisted of ferrite core for low price. To investigate their properties for variations of current, it changed the number of winding and the length of sample core, it examined, to check the live wire situation in built-in wires, electrical characteristics due to difference between electric wires and core sensor. As the results, it verified live wire situation at the number of winding(5,000) and within length of 6[cm]. Also, it obtained magnetic field magnitude decreased inverse proportion ratio to a square about difference between electric wires and core sensor.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.7 no.1
• /
• pp.27-40
• /
• 1997

The heat in Czochralski method is transfered by all transport mechanisms such as convection, conduction and radiation and convection is caused by the temperature difference in the molden pool, the rotations of crystal or crucible and the difference of surface tension. This study delvelops the simulation model of Czochralski growth by using the finite difference method with fixed grids combined with new latent heat treatment model. The radiative heat transfer occured in the surfce of the system is treated by calculating the view factors among surface elements. The model shows that the flow is turbulent, therefore, turbulent modeling must be used to simulate the transport phenomena in the real system applied to 8" Si single crystal growth process. The effects of a cusp magnetic field imposed on the Czochralski silicon melt are studied by numerical analysis. The cusp magnetic field reduces the natural and forced convection due to the rotation of crystal and crucible very effectively. It is shown that the oxygen concentration distribution on the melt/crystal interface is sensitively controlled by the change of the magnetic field intensity. This provides an interesting way to tune the desired O concentration in the crystal during the crystal growing.