• 수산해양기술연구
• /
• 제50권1호
• /
• pp.67-74
• /
• 2014

Most of steam power plants in Korea are using the method of heating the feed water whenever the ambient temperature around the power plant area below $5^{\circ}C$ to prevent freezing water flowing in the pipe in winter time. But this kind of heat supplying system is not useful to save energy. If we take the method that the temperature of the each pipe is controled by direct measure of temperature by attaching sensor on the outside surface of the feed water tubes, then we can expect that a plenty of energy can be saved. In this study, the computer simulation is used to compare the energy consumption loads of both systems. Energy saving rate is calculated for the location of Incheon area in winter season. Four convection heat transfer coefficients for the ambient air and three initial flowing water temperature inside the tube were used. The result shows that the temperature control system using sensor represents more than 95% of energy saving rate in Incheon area. Even in the severe January weather condition, the energy saving rate is almost 75% in two days basis and even 83% in one day basis.

• Asian-Australasian Journal of Animal Sciences
• /
• 제24권6호
• /
• pp.825-833
• /
• 2011

Forty-five Hisex commercial layers and forty-five local Saudi breed layers were used to determine the acceptable limit of short-term water restriction in the late phase of production, when the problem of high feed and water consumption is expected. The experiment was performed under hot and arid environmental conditions when the layers were at fifty weeks of age. Layers from each breed were randomly assigned in groups of five into nine floor pens. The average environmental temperature was 37.2-$38.6^{\circ}C$, and the relative humidity was between 20 to 37%. The trial was divided into 3 periods; control (1 week), water restriction (2 weeks) and rehydration (1 week). During the restriction period, layers from each breed were divided into three groups that received 20, 40, and 0% restriction of drinking water relative to their consumed water during the control period. During the study, feed and water consumption, body weight, changes in body weight, egg production, primary antibody response to SRBC, and rectal temperature were evaluated. Water restriction did not result in any clear effect on feed intake in either breed, however, commercial layers tended to consume less feed compared to the local breed. Body weight declined with water restriction during the first week of restriction in the commercial breed regardless of rate of restriction, but it was delayed until the second week in the local breed. Water restriction of 40% decreased egg production in both breeds but with a delay of 1 week in the local breed. Antibody level to SRBC was not affected by water restriction in the commercial line while it was highly affected in the local breed. A water restriction of 20% is considered to be an acceptable limit under the current experimental conditions without a negative effect on egg production in both breeds and considering the immune status of the local breed. Whereas, 40% restriction had a negative effect on egg production, and varied effects in the other traits in both breeds.

• 한국응용과학기술학회지
• /
• 제22권2호
• /
• pp.168-174
• /
• 2005

Aluminum tri-butoxide was mixed with the water/ethanol solution and then chloroplatinic acid was added to the solution. The solution was dried at $100^{\circ}C$ for 15hrs to remove the solvent and water then it was calcined at $500^{\circ}C$. The catalyst was activated with a gas mixture. During the activation, the temperature was increased from $150^{\circ}C$ to $500^{\circ}C$. The necessary amount of urea was dissolved in 50mL water and injected. Aqueous urea solution was then mixed with the feed gas stream. At low temperatures, nitrogen containing compounds of urea decomposition are used as reductants in the reducton of $NO_X$. However at high temperatures the nitrogen containing compounds are oxidized to NO and $NO_2$ by oxygen instead of being used in the reduction. The activity of the catalyst was dependent on urea concentration in the feed stream when there was not adequate water vapor in the feed. The maximum conversion was shifted from $250^{\circ}C$ to $150^{\circ}C$ when water concentration was increased from 2 to 17%. It seems that the maximum temperature shifts to lower temperatures because the hydrolysis rate of HNCO increases with water, resulting in higher amounts of $NH_3$.

• 한국가금학회지
• /
• 제21권2호
• /
• pp.93-99
• /
• 1994

Chickens subjected to heat stress decrease their heat production by consuming less feed. The lowered feed intake naturally brings about decreased production performance of chicken. The only exception to this is the increased survivability. Birds drink less when they eat less. In hot enviror-mental temperature, chicken need more water for increased heat loss through evaporation an increased urine excretion. Thus, the increased water intake may alleviate the heat stress of chicken. Various electrolytes supplementation to feed or drinking water can alleviate the heat stress of chicken by their effect of increasing water intake. Lasalocid, an ionophorous coccidiostat, was found to have the effect of increasing water consumption of chicken, thereby improving the lowered production performance of heat-stressed chicken. Finally, dietary fiber could be another possible element which can exert beneficial effects on heat-stressed chicken.

• 대한기계학회논문집A
• /
• 제37권6호
• /
• pp.739-745
• /
• 2013

본 연구에서는 급수 순환 시스템 중 동작 유체의 이송을 위해 사용하는 배관을 대상으로 관로 크기 및 고온 급수 환경에 따른 침식-부식 거동과 그 영향을 규명하고자 하였다. 이를 위해 일반적인 관로 소재인 철과 핵심 부식 인자인 산소의 화학반응식을 기반으로 Hayduk 과 Minhas 가 제안한 모델을 이용하여 침식-부식 해석을 실시하였다. 상용 유한요소해석 프로그램인 ABAQUS 를 사용하여 해석을 수행하였으며 배관의 직경 및 급수 온도를 변화시킴에 따른 침식-부식률을 평가할 수 있었다. 결과를 통해 급수 온도가 침식-부식률에 가장 큰 영향을 미치는 요인이 됨을 알 수 있었으며, 특히 $290^{\circ}C$ 급수에 노출된 스테인리스 316 강은 연간 $2.59{\mu}m$의 두께 손실이 발생할 것으로 예상되었다.

• Asian-Australasian Journal of Animal Sciences
• /
• 제14권7호
• /
• pp.1014-1018
• /
• 2001

Pigs respond to extreme temperature (very cold or hot) by physiological and nutritional adjustments. Yet little is known about the effects of different environmental temperature (thermoneutral in the highland area, and hot temperature in the coastal area) where pigs are maintained on the performance of the pigs. Ten pigs each (10 pairs of littermates) were assigned to two treatments (2 locations): highland area (control=CA) or coastal area (hot/heat stress=HS). Experimental design was Paired 't' test. HS pigs had higher average daily water intake (p<0.05) compared to CA pigs (6,05 vs 3.89 kg/d), CA pigs had higher feed intake compared to HS pigs (2.9 vs 1.95 kg/d, p<0,05). CA pigs had higher daily gain compared to HS pigs (0.72 vs 0.58 kg/d, p<0.05). Feed conversion was not significantly different between CA pigs and HS pigs. The digestibility of dry matter, N, Na, K, Mg, CI, Ca and P was not significantly affected by the treatments. High environmental temperature in the coastal area (heat stress) increased water intake, decreased voluntary feed intake and daily gain of the pigs. The results demonstrate that different environmental temperature in the coastal area (heat stress) and highland area (control) had no pronounced effect on digestibility of nutrients.

• 멤브레인
• /
• 제26권1호
• /
• pp.70-75
• /
• 2016

본 연구에서는 하수처리수를 원수로 사용하여 직접 접촉식 막증발법을 적용하여 원수 온도와 원수 유량 변화에 따른 하수처리수의 COD, TN, TP, TOC의 제거율 변화와 여과플럭스의 변화를 측정하였다. 또한 하수처리수에 의한 분리막의 오염 가역성을 평가하기 위해 1차 증류수만을 사용하여 물리세정을 수행한 후 플럭스의 회복률을 측정하였다. 실험결과 원수의 온도 및 유량에 관계없이 원수가 3배 농축될 때까지 여과를 진행하였음에도 불구하고 하수처리수의 주요 오염물질인 COD, TN, TP, TOC에 대한 제거율이 92% 이상으로 높게 나타났다. 또한 비교적 낮은 온도인 $50^{\circ}C$와 $60^{\circ}C$에서 원수의 유량에 따라 최소 13.8 LMH에서 20.3 LMH로 높은 여과플럭스를 나타냈다. 그리고 높은 농축계수까지 여과 실험을 진행했음에도 불구하고 낮은 여과플럭스의 감소를 나타냈으며 1차 증류수를 이용한 짧은 시간 동안의 물리세정만으로 최소 90% 이상의 높은 여과 플럭스 회복율을 나타냈다. 따라서 하수처리수 재이용을 위한 공정으로 막증발법의 적용이 충분히 가능할 것으로 판단된다.

• Asian-Australasian Journal of Animal Sciences
• /
• 제22권5호
• /
• pp.694-699
• /
• 2009

The present study was conducted to evaluate the effect of chilled drinking water on the productivity of laying hens under constant high ambient temperature. A total of seventy-two, 123-day-old Hy-line brown layers was divided into two equal groups. The first group (UDWG) was given unchilled water ($23.0{\pm}2.5^{\circ}C$) as a control, and the second group (CDWG) was given chilled water ($16.0{\pm}0.5^{\circ}C$). The laying hens were kept at $30^{\circ}C$ constant temperature with 50% relative humidity and were exposed to 17 h of light per day. Feed intake, egg production, egg quality (egg weight, shell weight, shell thickness, egg color, yolk color, and Haugh unit), and blood samples were collected and analyzed. The results showed that the feed intake of CDWG laying hens was significantly higher (11.64%) than the UDWG counterparts (p<0.01). Egg production of CDWG was also significantly higher (11.27%) than the UDWG counterparts (p<0.001). Furthermore, we observed that the CDWG laying hens had significantly higher (11.72%) levels (p<0.10) of blood calcium, with a corresponding value of 21.92 mg/dl compared to the UDWG hens (19.62 mg/dl). The higher calcium concentration in the CDWG animals may contribute to increased egg production. The CDWG laying hens also contained higher (12.53%) phosphorus concentrations in blood compared to the UDWG (4.22 mg/dl vs. 3.75 mg/dl), although not statistically different (p>0.10). Egg weight and egg quality were not affected by chilled drinking water. In conclusion, providing chilled drinking for laying hens under high ambient temperature improved feed intake and egg production.

• 한국수산과학회지
• /
• 제45권5호
• /
• pp.430-437
• /
• 2012

The effects of low temperature and starvation on the physiochemical characteristics of the muscle of the olive flounder Paralichthys olivaceus, were examined. Fish were deprived of feed for 28 days at 2, 4, 6, 8, 10, 12, and $20^{\circ}C$ in order to establish suitable conditions for live fish transportation. Throughout most of the 4 weeks of feed restriction, the physiochemical characteristics of the muscle of olive flounder were found to be dependent on the acclimation temperature. The breaking strength of muscle did not show a significant reduction during feed restriction at 2 and $4^{\circ}C$. With increasing temperatures, however, the breaking strength of muscle differed significantly according to the individual and feed restriction period (P<0.05). The moisture content in muscle acclimated at 10, 12, and $20^{\circ}C$ increased steadily over the feed-restriction period, while the crude lipid content decreased during the same period (P<0.05). At water temperatures above $2-8^{\circ}C$, no significant differences were shown during the same period. After it reached 6, 8, 10, 12, and $20^{\circ}C$, the muscle had an accumulation of lactate, and a loss of ATP. There was no change in the lactate or ATP content during the feed restriction period at 2 and $4^{\circ}C$, although there were differences among the water temperature groups. These results clearly show that temperature can have an important influence on the of muscle of physiochemical characteristics of muscle during live fish transportation.

• 한국압력기기공학회 논문집
• /
• 제11권1호
• /
• pp.74-78
• /
• 2015

Nuclear power plant steam generator that is one of the main component has several thousands of thin tubes. And the steam generator tube is subject to damage because of the severe operation conditions such as the high temperature and pressure. Therefore periodic inspections are conducted to ensure the integrity of steam generator component. Hanul unit 3 also has been inspected in accordance with in-service inspection program and is scheduled to be replaced for exceeding the plugging rate which was recommended by manufacturer. During the steam generator replacement activity, we found several clustered porosity on inner surface of main feed water pipe. Additionally crack-like indications were found at weld interface between base material and weld of main feed water pipe. This paper describes the field experience and visual testing results for inner surface of main feed water pipes. The destructive test result had shown that these indications were porosities which were caused by manufacturing process not by operation service.