• Korean Chemical Engineering Research
• /
• v.52 no.1
• /
• pp.68-74
• /
• 2014

In the spiral wound module of the pressure-retarded osmosis (PRO) system for the salinity gradient power generation, effects of the inlet pressure differences between feed-channel and draw-channel were studied. Fluxes of water and solute through membrane and power were estimated. The water flux through membrane decreased along the x-direction and increased along the y-direction with the increase of inlet pressure differences between two channels. On the other hand, the solute flux through membrane showed the opposite trend. The concentration of flow in the feed-channel increased a lot along the y-direction and that in the draw-channel decreased along the x-direction. In our system, for the inlet pressure differences of 1~11 atm, the flow rate in the feed-channel decreased about 8~13% and that in the draw-channel increased by the same amount. The power density increased and then decreased with the increasing inlet pressure difference.

• Asian-Australasian Journal of Animal Sciences
• /
• v.12 no.8
• /
• pp.1277-1284
• /
• 1999

Eight feeds and their residues left after washing with tap water (water residue) or incubation in the rumen (rumen residues) were treated with hydrochloric acid, neutral detergent solution without EDTA (NDS) or both, and the release or sorption of minerals (Ca, Mg, P, Na, K, Cu and Zn) assessed. Six of the feeds were from Sri Lanka (Panicum maximum ecotype Guinea A, Glyricidia maculate, Artocarpus heterophyllus (jak leaves), untreated and urea-treated rice straw, and rice bran) and two from the Netherlands (maize silage and wheat straw). The initial concentration of mineral elements, the concentration of neutral detergent fibre (NDF) and the type of feed significantly influenced (p<0.01). The proportion of the mineral elements released or sorbed. In general, feeds with high NDF content (straws and guinea grass) sorbed Ca from tap water, or released less in the rumen, and within these feeds the extent of sorption varied with source of fibre. Acid or NDS treatment removed little of the sorbed Ca, but they removed much of the Mg from both water and rumen residues. Fibres of wheat straw and jak leaves showed an affinity for Mg in the rumen. All feeds and their water and rumen residues sorbed P and Na from NDS, and the extent of sorption varied with the initial concentrations of these elements and with the type of fibre. Acid treatment removed part of the sorbed Na, but not the P. The solubility of K was not affected by the content of NDF, the type of fibre or the initial concentration of K. All feeds and their residues, except for the rumen residues of rice bran sorbed Cu from tap water and in the rumen. The recovery of Cu in rumen residues declined from 353% to 147% after NDS treatment, and with some feeds (glyricidia and jak leaves) the recovery was below 100%. Acid treatment removed part of the Zn sorbed by the water and rumen residues, but the capacity of residues to retain Zn varied with the type of feed.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.50 no.3
• /
• pp.257-262
• /
• 2017

This study was conducted to investigate the growth and skin color of red- and white-colored fancy carp Cyprinus carpio var. koi juvenile reared at different water temperatures (21, 24, 27, and $30^{\circ}C$) for eight weeks. Two experimental diets were prepared to contain 10% Arthrospira platensis or 10% Arthrospira pacifica powder. After the feeding trial, survival was 100% in all group. Weight gain of fish reared at 24, 27, and $30^{\circ}C$ was higher than $21^{\circ}C$ group. Feed efficiency was not affected by water temperature and dietary Arthrospira sp. Daily feed intake tended to increase with water temperature. The $a^*$ value of skin coloration was affected by Arthrospira sp., but not by water temperature. Fish fed the diet containing A. pacifica powder reared at $27^{\circ}C$ had the highest $a^*$ value among the groups. Total carotenoids were highest in fish fed the diet containing A. pacifica powder reared at $21^{\circ}C$. Based on the results of this study, we conclude that 24-$30^{\circ}C$ water temperature was the optimal range for growth, and dietary inclusion of A. pacifica improved the skin redness of red- and white-colored fancy carp reared at $27^{\circ}C$.

• Asian-Australasian Journal of Animal Sciences
• /
• v.25 no.6
• /
• pp.861-868
• /
• 2012

During two years, four samples per year were collected in Vietnam from rice bran, cassava residue, brewer's grain, tofu residue, soybean meal, coconut cake, sweet potato vines and water spinach for chemical analysis and assessment of water holding capacity (WHC). The selected feedstuffs represent fibre-rich plant sources and agro-industry co-products commonly used in pig feeding in Vietnam. The content (g/kg DM) of crude protein (CP), ether extract (EE) and non-starch polysaccharides (NSP) varied between feedstuffs and ranged from 21 to 506 for CP, from 14 to 118 for EE and from 197 to 572 for NSP. Cassava residue had a high starch content of 563 g/kg DM, while sweet potato vines, water spinach, coconut cake and soybean meal had a high content of sugars (63-71 g/kg DM). The content of individual neutral sugars varied between feed ingredients, with the highest content of arabinose, galactose and glucose in tofu residue, the highest content of xylose in brewer's grain and the highest content of mannose in coconut cake. The content of uronic acid was high for cassava residue, tofu residue, sweet potato vines and water spinach (57-88 g/kg DM). The content of soluble non-cellulosic polysaccharides (S-NCP) was positively correlated ($r^2$ = 0.82) to the WHC. The content (g/kg DM) of CP, NDF, neutral sugars, total NSP, total NCP, S-NCP and total dietary fibre in tofu residue, water spinach and coconut cake varied (p<0.05) between years. In conclusion, diet formulation to pigs can be improved if the variation in chemical composition of the fibre fraction and in WHC between potential feed ingredients is taken into account.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2009.10a
• /
• pp.1108-1111
• /
• 2009

Auto Pilot is the system which move automatically the vessel through locating operation mode to automatic after entering operating course using a electronic chart or plotter. And water jet is the a propulsion system that make a power to push the vessel through spouting the accelerated water which is absorbed by the hole in the bottom of vessel. The water jet receive the effect of the depth of water lowly, it's acceleration efficiency is higher under high speed and have an advantage on vibrating and floating sound, so it's demand is increasing as new propulsion system. However, the signal systems of auto pilot and water jet are different, we need the system to interface between each system. We designed the interface that efficiently digital feed back control embedded module between auto pilot and water jet system in this paper.

• Korean Journal of Agricultural Science
• /
• v.49 no.3
• /
• pp.389-396
• /
• 2022

The purpose of this study was to investigate the safety of Houttuynia cordata Thunb extract (HCE) in Institute of Cancer Research (ICR) mice, to determine the effects of the extract on the growth performance and colony count, and to establish the optimal concentration of HCE. In total, 60 five-week-old male ICR mice with an average initial body weight (BW) of 27.24 ± 0.44 g were used in a four-week experiment. Mice were randomly allotted to four treatment groups (five replications per group, three mice per cage): 1) a control (CON) group fed with normal distilled water; 2) treatment group 1 (T1) fed with normal distilled water containing 0.05% HCE; 3) treatment group 3 (T3) fed with normal distilled water containing 0.1% HCE; and 4) treatment group 3 (T3) fed with normal distilled water containing 0.2% HCE. BW, feed intake (FI), and water intake were measured on the first, fourteenth, and eighteenth days. T2 showed a significant improvement (p < 0.05) in the feed conversion ratio (FCR) over the experimental period. However, water intake levels did not show significant differences among the groups. In the large intestine and feces, E. coli and Lactobacillus levels were significantly improved (p < 0.05) in the HCE treated group compared to the CON group. Supplying HCE via the drinking water improved the growth performance and colony count in ICR mice. Based on results of this study, utilizing HCE in livestock species is expected to be safe and feasible.

• Proceedings of the Membrane Society of Korea Conference
• /
• 1996.10a
• /
• pp.22-33
• /
• 1996

With the experience of the 1994 drought, and the shortage of water resources in Japan, it has been re-informed upon us ensure and maintain the stability of water resources. Accordingly, with each plant, a serious appraisal has begun looking at the re-use of waste water. Membrane technology is an important process for waste water recovery. Effluent kom waste water facilities changes the quality of water significantly. The conventional pre-treatment of RO is hard to supply good quality feed water to RO in the waste water recovery system. The microfiltration system as a pre-treatment of RO in the paper overcomes the fouling with the air backwash and is operated in direct flow mode at a low pressure producing a high flux. The paper will focus the waste water recovery using membrane technology and many examples will be given.

• Journal of Korean Society of Water and Wastewater
• /
• v.18 no.4
• /
• pp.486-492
• /
• 2004

CMP (Chemical mechanical polishing) is inevitable process to overcome $0.2{\mu}m$ wire thickness in semiconductor industry. In this study, effect of pressure to separate used CMP slurry into solid and liquid for recycle and reuse by ultrafiltration was investigated. Also, water quality after the ultrafiltration such as turbidity and TDS was evaluated. The material of membrane used in the study was PVDF. The used CMP contained 0.5% of solid content and then concentrated up to 18% by weight. The used CMP can not be concentrated higher than 18% because of viscosity and abrasion of pump. The tested feed pressures were 22.1, 29.4 and 36.8 psi. The results have shown that operating at 36.8 psi has advantages on operation time and total flux. The specific flux showed some variation at 1 to 15 of concentration factor but no difference after 15 of concentration factor. Mass balance of solid at initial stage of the operation showed some unbalance because of deposition of solid on the membrane, which was main reason to reduce flux. Turbidity was very stable at lower than 0.2NTU for 22.1 and 36.8 psi of feed pressure.

• Journal of the Korean Society of Manufacturing Technology Engineers
• /
• v.25 no.1
• /
• pp.83-88
• /
• 2016

Because of the increasing tool cost for cutting hard-to-cut materials, abrasive water jet (AWJ) milling recently has been regarded as a potential alternative machining method. However, it is difficult to control the depth and width of cut in AWJ milling because they vary depending on many AWJ cutting parameters. On 27 conditions within a limited range of pressure, feed rate, and abrasive flow rate, AWJ cutting was conducted on titanium, and depth profiles were measured with a laser sensor. From the depth profile data, depth and width of cut were acquired at each condition. The relationships between depth and parameters and between width and parameters were derived through regression analysis. The former can provide proper cutting conditions and the latter the proper pick feed necessary to generate a milled surface. It is verified that pressure mostly affects depth, whereas abrasive flow rate mostly affects width.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.11 no.2
• /
• pp.614-619
• /
• 2010

We proposed perfect recycling method of sea waste. The sea waste(rotten sea fish, rotten shell fish etc.) have bad smell and generate waste water, so these waste materials must be treated quickly. If we use speedy dryer, these sea waste can be changed to useful feed and liquid composts. Also this study relates to a method for drying a variety of untreated waste materials in a hermetically sealed state, and subsequently carbonizing the dried waste materials under a reduced pressure, thereby achieving a more stable and economical treatment for the waste materials, and an apparatus for performing the method. This effects of preventing generation of contaminants and environmental pollution while reducing fuel costs, and a carbide, obtained via the drying and carbonization of the waste material, are available into feed for poultry. The condensate water can be used to deodorants.