• Journal of the Korean Society of Food Science and Nutrition
• /
• v.39 no.4
• /
• pp.631-636
• /
• 2010

To develop a natural antioxidant from three Chrysanthemum species, flower and shoot extracts of Chrysanthemum frutescens, Chrysanthemum morifolium and Chrysanthemum zawadskii ssp. naktongense were obtained and their phenolic compound contents, scavenging effects on DPPH and ABTS radicals, ferrous ion chelating effects and inhibition activity on lipid peroxidation of linoleic acid were studied. Shoots of C. morifolium showed the highest levels in all above mentioned analyses. Especially, shoot extract of C. morifolium had high scavenging activities on ABTS radicals, similar to ascorbic acid or BHT. Ferrous ion chelating effect was the lowest in a C. morifolium shoot extract, but the highest in a C. morifolium flower extract. Inhibition activity on lipid peroxidation of linoleic acid was the highest with C. frutescens and C. morifolium shoots, but activity was lower than BHT. From present study, a shoot extract of C. morifolium is demonstrated as a valuable source for the development of a natural antioxidant. However, due to its low levels of ferrous ion chelating effects and inhibition activity on lipid peroxidation, a combination of other antioxidants with C. morifolium extract is recommended for the development of a new antioxidant.

• Journal of the Korean institute of surface engineering
• /
• v.40 no.6
• /
• pp.254-257
• /
• 2007

TiN coating on tool steel has been widely used for the improvement of durability of tools. In this work, radical nitriding(RN) is carried out on SKD61 at $450^{\circ}C$ for 5 hours in the ammonia gas pressure $2.7{\times}10^3\;Pa$. The TiN coating is carried out by arc ion plating(AIP) with the process parameters: arc power 150 A, bias voltage -50V, coating time 40 minutes and nitrogen gas pressure $4{\times}10^3\;Pa$. Hardness, elastic modulus, friction coefficient and adhesion of TiN coating on substrates of both TiN/SKD61 and TiN/RN SKD61 coatings are investigated comparatively. The primary crystalline faces of TiN surface are(200) and(111) for TiN/SKD61 and TiN/RN SKD61 respectively. In addition to the primary phase, Fe phase exists in TiN/SKD61 coating, but not in TIN/RN SKD61. The hardness of TiN/RN SKD61 is about 700 Hv, 250 Hv(56%) higher than that of TiN/SKD61 at the near interface of TiN and substrates. At the TiN surface, hardness of TiN/RN SKD61 is 2,149 Hv, 71 Hv(3%) higher than that of TiN/SKD61. The elastic modulus of TiN coating is improved to 26.7 GPa(6%) by radical nitriding. The adhesion is improved by the RN coating showing no spalling. buckling and chipping on the scratch test track which are shown on the non-RN TiN/SKD61.

• Journal of Environmental Science International
• /
• v.2 no.1
• /
• pp.61-72
• /
• 1993

Result of this study indicate that two criteria must be met in order to have effective macrocycle-mediated transport in these emulsionsystem. First, one must effective extraction of the post transition metals, $Cd^{2+}$. $Pb^{2+}$ and $Hg^{2+}$ , into toluene membrane. The effectiveness of this extraction is greatest if log K values for the metal-macrocycle interaction is large. Second, the ratio of the log K values for the metal ion-receiving phase to the metal ion-macrocycle interaction must be large enough to ensure quantitative stripping of the metal ion at the toluene phase interface. Control of the first step can be obtained by appropriate selection of macrocycle donor atom, substituents, and cavity radius. The second step can be controlled by selecting the proper complexing agent for inclusion in the receiving phase. The order of the transport, when using the several $A^-$ species such as $SCN^-$, $1^-$, $Br^-$ and $Cl^-$ is the order of the changing degree of solvation for $A^-$ and the transport of the metals is also affected by the control of concentration for receiving species because of solubility-differences. In this study, we can seperate each single metal ion from the mixture of $Cd^{2+}$, $Pb^{2+}$, and $Hg^{2+}$ ions by using the toluene membranes controlled by optimized conditions. Transport of the single metal is also very good, and alkaline and alkaline earth metals as interferences ions did not affect the seperation of the metals in this macrocycle-liquid membrances but transition metal ions were partially affected as interferences for the post transition metal ions.

• Clean Technology
• /
• v.15 no.1
• /
• pp.60-66
• /
• 2009

Adsorptive removal of tetrahydrothiophene (THT) and tert-butylmercaptan (TBM) that were widely used sulfur odorants in pipeline natural gas was studied using various ion-exchanged NaY zeolites at ambient temperature and atmospheric pressure. In order to improve the adsorption ability, ion exchange was performed on NaY zeolites with alkali metal cations of $Li^+,\;Na^+,\;K^+$ and transition metal cations of $Cu^{2+},\;Ni^{2+},\;Co^{2+},\;Ag^+$. Among the adsorbents tested, Cu-NaY and Ag-NaY showed good adsorption capacities for THT and TBM. These good behaviors of removal of sulfur compound for Cu-NaY and Ag-NaY zeolites probably was influenced by their acidity. The adsorption capacity for THT and TBM on the best adsorbent Cu-NaY-0.5, which was ion exchanged with 0.5 M copper nitrate solution, was 1.85 and 0.78 mmol-S/g at breakthrough, respectively. It was the best sulfur capacity so far in removing organic sulfur compounds from fuel gas by adsorption on zeolites. While the desorption activation energy of TBM on the Cu-NaY-0.5 was higher than NaY zeolite, the difference of THT desorption activation energy between two zeolites was comparatively small.

• Korean Journal of Medicinal Crop Science
• /
• v.14 no.3
• /
• pp.173-177
• /
• 2006

Terminal buds and young leaves of Kalopanax pictus are in a great demand as a edible vegetable. Its bark of stems and roots have been used as the resources of folk medicine in Korea. Recently, attempts to cultivate the plant have being tried in farms and mountain villages. This study was conducted to determine effect of inorganic elements on seedlings growth of K. pictus. Levels of inorganic elements in the leaves were variable based on macro and micro inorganic elements. Among the inorganic elements in the leaves of K. pictus seedlings, level of N was high, while other ions were low in the order of K, Ca, P, Mg, Mn, Fe and Zn. A highly significant correlations between the seedling growth and the level of N, P, K, and Na in the leaves, while a low positive significant correlations between the growth and the level of either Mg or Mn and no significant correlations between the growth and the level of Ca, Fe, Cu, and Zn. The most affecting inorganic ion on the seedling growth was N, and followed by the order of K, P, Mg, Mn and Na.

• Journal of the Korean Ceramic Society
• /
• v.40 no.4
• /
• pp.323-327
• /
• 2003

Microwave dielectric properties of (P $b_{0.4}$C $a_{0.6}$)[($Fe_{\frac{1}{2}}$N $b_{\frac{1}{2}}$)$_{1-x}$ (M $g_{1}$ 3/N $b_{2}$ 3/)x] $O_3$ (PCFMN) ceramics were investigated as a function of (M $g_{1}$ 3/N $b_{2}$ 3/)$^{4+}$ content (0.1$\leq$x$\leq$0.8). A single perovskite phase with the cubic structure was obtained through the given composition range. The unit cell volume was increased with (M $g_{1}$ 3/N $b_{2}$ 3/)$^{4+}$, due to the larger average ionic size of (M $g_{1}$ 3/N $b_{2}$ 3/)$^{4+}$ than that of ($Fe_{\frac{1}{2}}$N $b_{\frac{1}{2}}$)$^{4+}$ for B-site ion. Dielectric constant (K) and Temperature Coefficient of Resonant Frequency(TCF) of PCFMN ceramics were dependent on (M $g_{1}$ 3/N $b_{2}$ 3/)$^{4+}$ content due to the decrease of ionic polarizability and B-site bond valence, respectively. Qf value was decreased with (M $g_{1}$ 3/N $b_{2}$ 3/)$^{4+}$ content due to the decrease of grain size. Typically, K of 73.56, Qf of 5,074 GHz and TCF of -6.45 ppm/$^{\circ}C$ were obtained for the specimens with x=0.4 sintered at 125$0^{\circ}C$ for 3 h.125$0^{\circ}C$ for 3 h.

• Journal of the Korean GEO-environmental Society
• /
• v.15 no.12
• /
• pp.25-34
• /
• 2014

The objective of this study was to investigate the removal characteristics and the elimination mechanism of heavy metals in Acid Mine Drainage (AMD) using spherical-type porous Zeolite-StarFish ceramics (porous ZSF ceramics) packed in a continuous column reactor system. The average removal efficiencies of heavy metals in AMD were Al 98.7, As 98.7, Cd 96.0, Cu 89.1, Fe 99.5, Mn 94.4, Pb 96.3 and Zn 80.8 % during 110 days of operation time. The average removal capacity of porous ZSF ceramics for heavy metals were measured to be Al 21.76, As 1.52, Cd 1.27, Cu 3.41, Fe 44.83, Mn 3.48, Pb 2.36 and Zn $3.76mg/kg{\cdot}day$. The analysis results of mechanism using SEM, EDS and XRD exhibited that the porous ZSF ceramics could act as a multi-functional ceramics for the removal of heavy metals in AMD through the reactions of precipitation, adsorption and ion-exchange. The experimental results of column reactor system displayed that the porous ZSF ceramics would be a consistently efficient agent for the removal of heavy metals in AMD for a long term.

• Journal of the Korean Electrochemical Society
• /
• v.15 no.4
• /
• pp.222-229
• /
• 2012

We studied the electrochemical phenomena and increase of capacity according to the polymer composite electrode of two different polymeric materials with different the voltage range and capacity. Polyaniline (PANI) with relatively high voltage and small capacity and poly [1,2] bis-thio[1,8]-naphthylidine (PTND) with slightly low voltage and large capacity were used as polymer composite electrode materials. After PTND was synthesized, PANI was synthesized on the surface of PTND. The synthesis and the fine structure were analyzed by FT-IR, XPS, FE-SEM, and FE-TEM. Charge/discharge capacity and cyclic voltammetry measurements were carried out for the electrochemical performance as a polymer cathode active material for lithium secondary batteries. The discharge capacities of PANI/PTND after 1,5, and 10 cycles at 1.3~4.0 V voltage range and room temperature 167 mAh/g, 90 mAh/g, and 81 mAh/g. When we compared with PANI (80, 67, and 62 mAh/g), the discharge capacity after 10 cycles was improved about 30%. After 50 cycles, the discharge capacity of PANI/PTND was 67 mAh/g.

• Journal of the Korean Chemical Society
• /
• v.46 no.6
• /
• pp.515-522
• /
• 2002

Solid beta-dicalcium silicate hydrate $(\beta-C_2SH)$ synthesized under hydrothermal conditions at $240^{\circ}C$ and Ca/Si=2 molar ratio shows cation exchange properties towards divalent metal cations such as Fe, Cu, Zn, Cd, or Pb. The ability of metal cation uptake by the solid was found to be in the order: $Fe^{2+}$〉$Cu^{2+}$〉$Zn^{2+}$〉$Cd^{2+}$ = $Pb^{2+}$. Cesium selectivity of the solid was demonstrated in the presence of univalent cation such as $Li^+$, $Na^+$ and $K^+$ and divalent cations such as $Ca^{2+}$, $Mg^{2+}$ and $Ba^{2+}$, which are one hundred times more concentrated than the $Cs^+$. The uptake of $Cs^+$ is maximum in the presence of $Mg^{2+}$ whereas it is minimum in the presence of $K^+$. The different affinities of ${\beta}-C_2SH$ towards divalent metal cations can be used for the separation of those ions. Due to its selectivity for cesium it can be used in partitioning of radioactive Cs+ from nuclear wastes containing numerous cations. The mechanism of the metal cation exchange and cesium selectivity reactions by the solid is studied.

• Journal of the Korean Ceramic Society
• /
• v.39 no.8
• /
• pp.728-734
• /
• 2002

Stabilization behavior of Cr, Cd, Cu, Pb, Fe and Zn heavy metals in the EAF dust was investigated by adding EAF dust to clay or white clay, respectively, up to 50 wt% with 10 wt% intervals and sintering at temperatures between 200 and $1200^{\circ}C$ with $200^{\circ}C$ intervals with an aid of ICP-AES followed by TCLP test to evaluate heavy metal cation exchange capacity of the clay or the white clay. The clay or the white clay had a better Cr ion exchange capacity than that of zeolite. The TCLP leaching test for the sintered specimens showed that Cr and Fe were rarely detected for all the specimens and the concentration of Cd and Zn decreased with increasing sintering temperature and decreasing EAF dust contents respectively. When the clay or the white clay were mixed with EAF dust, cation exchange may occur between the clay and the EAF dust so that the first stabilization of the mixtures containing semistabilized heavy metals may happen. Stabilization of heavy metals in the ceramic bodies was further completed probably due to the eutectic reaction caused by the sintering of semi-stabilized mixtures. It was conceivable that the white clay rather than the clay may be a better stabilizer for the EAF dust containing heavy metals.