• Journal of the Korean Magnetics Society
• /
• v.15 no.2
• /
• pp.109-112
• /
• 2005

Electronic and magnetic properties of $Ti_{1-x}M_xO_{2-\delta}$ (M=Co and Fe) thin films grown by sol-gel method have been investigated. Anatase and rutile $Ti_{1-x}Co_xO_{2-\delta}$ films were successfully grown on $Al_2O_3$ (0001) substrates and exhibited p-type electrical conductivity while the undoped films n-type conductivity. Room temperature vibrating sample magnetometry measurements on the anatase and rutile $Ti_{1-x}Co_xO_{2-\delta}$ films with same x ($=4.8 at.{\%}$) showed quite similar magnetic hysteresis curves with the saturation magnetic moment of $\~4 {\mu}_B$ per Co ion despite their differences in structural and electronic properties. Such giant magnetic moment is attributable to the unquenched orbital moment of the $Co^{2+}$ ions substituting the octahedral $Ti^{4+}$ sites. Similar ferromagnetic behavior was observed for $Ti_{1-x}Fe_xO_{2-\delta}$ films that are highly resistive compared to the Co doped samples. Saturation magnetic moment was found to decrease for higher x, i.e., $\~2$ and $\~1.5 {\mu}_B$ per Fe ion for x=2.4 and 5.8 at. $\%$, respectively. Conversion electron $M\ddot{o}ssbauer$ spectroscopy measurements predicted the coexistence of $Fe^{2+}$ and $Fe^{3+}$ ions at the octahedral sites of $Ti_{1-x}Fe_xO_{2-\delta}$.

• Bulletin of the Korean Chemical Society
• /
• v.32 no.1
• /
• pp.191-195
• /
• 2011

This study reports the root cause of the improved rate performance of $LiFePO_4$ after Cr doping. By measuring the chemical diffusion coefficient of lithium ($D_{Li}$) using cyclic voltammetry (CV) and electrochemical impedance spectroscopy (EIS), the correlation between the electrochemical performance of $LiFePO_4$ and Li diffusion is acquired. The diffusion constants for $LiFePO_4$/C and $LiFe_{0.97}Cr_{0.03}PO_4$/C measured from CV are $2.48{\times}10^{-15}$ and $4.02{\times}10^{-15}cm^2s^{-1}$, respectively, indicating significant increases in diffusivity after the modification. The difference in diffusivity is also confirmed by EIS and the $D_{Li}$ values obtained as a function of the lithium content in the cathode. These results suggest that Cr doping facilitates Li ion diffusion during the charge-discharge cycles. The low diffusivity of the $LiFePO_4$/C leads to the considerable capacity decline at high discharge rates, while high diffusivity of the $LiFe_{0.97}Cr_{0.03}PO_4$/C maintains the initial capacity, even at high C-rates.

• Journal of the Korean Magnetics Society
• /
• v.9 no.2
• /
• pp.121-126
• /
• 1999

This paper describes a fabrication of Fe-dispersed hydrophilic magnetic fluid and its application to oil seal in combination with the Nd-permanent magnet. The results are as follows; 1) Using silica coated iron particle of magnetization of 125.5 emu/g (at 10 kOe) and the mean particle size of 100 $\AA$, after multiple adsorption to the surface of silica coated iron particle with oleic acid ion, D.B.S. and T.M.A. ion, hydrophilic Fe-magnetic fluid [70 %(g/∝)Fe, magnetization of 52 emu/g and viscosity of 1450 cp] can be produced by dispersing the iron particle in ethylene glycol solution. 2) The oil seal apparatus consisting of six stages of Nd-permanent magnet (3200 Gauss) and Fe-magnetic fluid [70 %(g/∝) Fe] showed an excellent pressure resistance of 7400 g/$\textrm{cm}^2$ under the gap between shaft and oil seal was 0.2 mm.

• Transactions on Electrical and Electronic Materials
• /
• v.13 no.3
• /
• pp.121-124
• /
• 2012

Olivine type $LiFePO_4$ cathode material was synthesized by solid-state reaction method including one-step heat treatment. To improve the electrochemical characteristics, graphite nanofiber (GNF) was added into $LiFePO_4$ cathode material. The structure and morphological performance of $LiFePO_4$ were investigated by X-ray diffraction (XRD); and a field emission-scanning electron microscope (FE-SEM). The synthesized $LiFePO_4$ has an olivine structure with no impurity, and the average particle size of $LiFePO_4$ is about 200~300 nm. With graphite nanofiber added, the discharge capacity increased from 113.43 mAh/g to 155.63 mAh/g at a current density of 0.1 $mA/cm^2$. The resistance was also significantly decreased by the added graphite nanofiber.

• Bulletin of the Korean Chemical Society
• /
• v.16 no.3
• /
• pp.261-264
• /
• 1995

A series of samples of the Nd1-x(Ba0.40Mg0.60)1+xFeO4-y (x=0.00, 0.10, 0.20, and 0.30) system has been synthesized at 1450 ℃ under an atmospheric air pressure. The x-ray powder diffraction analysis of the solid solutions assigns the structure of all the compositions to orthorhombic system. Mohr salt analysis shows that τ and y values increase with x value and nonstoichiometric chemical formulas of the system can be formulated from the x, τ, and y values. Oxygen vacancies are distributed along c-axis in the perovskite layer. The magnetic ordering temperature remains unchanged with x value. Electrical conductivity and activation energy depend only on the mixed valence state of Fe ion. Conduction mechanism can be suggested as the hopping of electron between eg orbitals of Fe3+ and Fe4+ ions through Fe3+-O-Fe4+ bonds. Magnetic susceptibility and electrical conductivity are discussed with the nonstoichiometric chemical formulas.

• Resources Recycling
• /
• v.25 no.6
• /
• pp.23-28
• /
• 2016

In this study, leaching process to extract phosphorus from the steelmaking slag was investigated for using the fertilizer resources of agriculture. In general, the phosphorus of steelmaking slag is formed as $C_2S-C_3P$ solid solution, and also, this solid solution is soluble in water more than the other phase in slag, and less than free CaO phase. In the present experiment, the influence of pH on the leaching behavior of various elements from the steelmaking slag was investigated by using multi-component steelmaking slag. When the pH was decreased, the concentration of Ca, Si, P and Fe in solution from the steelmaking slag was increased. Furthermore, at a pH of 3, the concentration of P ion in solution was decreased as leaching time increased. It is considered that the decrement of P was caused from the precipitation reaction between P ion and Fe ion in solution.

• Proceedings of the Korean Vacuum Society Conference
• /
• 1993.07a
• /
• pp.82-82
• /
• 1993

• Proceedings of the Korean Magnestics Society Conference
• /
• 1998.10a
• /
• pp.18-19
• /
• 1998

• Proceedings of the Materials Research Society of Korea Conference
• /
• 1998.11a
• /
• pp.115-115
• /
• 1998

• Journal of Radiation Protection and Research
• /
• v.27 no.1
• /
• pp.27-35
• /
• 2002

Characteristics of Amberlite IRN 77, a cation exchange resin, and the mechanisms of its adsorption equilibria with Co(II), Ni(II), Cr(III) and Fe(III) ions were investigated for the application of the demineralizing process in the primary coolant system of a pressurized water reactor (PWR). The optimum dosage of the resin for removal of the dissolved metal ions at $200mgL^{-1}$ was 0.6 g for 100 mL solution. Most of each metal ion was adsorbed onto the resin in an hour from the start of the reaction. Each metal adsorption onto the resin could be well represented by Langmuir isotherms. However, in the case of Fe(III) adsorption, continuous formation of Fe-oxide or -hydroxide and its subsequent precipitation inhibited the completion of the equilibrium between the metal and the adsorbent Cobalt(II) and Ni(II), which have an equivalent electrovalence, were adsorbed to the resin with a similar adsorption amount when they coexisted in the solution. However, Cr(III) added to the solution competitively replaced Co(II) and Ni(II) which were already adsorbed onto the resin, resulting in desorption of these metals into the solution. The result was likely due to a higher adsorption affinity of Cr(III) than Co(II) and Ni(II). This implies that the interactively competitive adsorption of multi-cations onto the resin should be fully considered for an efficient operation of the demineralizing ion exchange process in the primary coolant system.