• Wind and Structures
• /
• 제6권4호
• /
• pp.307-324
• /
• 2003

The paper presents results of studies concerning wind-induced aeolian vibration and fatigue of a 110 kV covered conductor overhead line. Self-damping measurement techniques are discussed: power method is found to be the most reliable technique. A method for compensating tension variations during the self-damping test is presented. Generally used empirical self-damping power models are enhanced and the different models are compared with each other. The Energy Balance Analysis (EBR) is used to calculate the aeolian vibration amplitudes, which thereafter are converted to bending stress for the calculation of conductor lifetime estimate. The results of EBA are compared with field measurements, Results indicate that adequate lifetime estimates are produced by EBA as well as field measurements. Generally the EBA gives more conservative lifetime expectancy. This is believed to result from the additional damping existing in true suspension structures not taken into account by EBA. Finally, the correctness of the line design is verified using Cigre's safe design tension approach.

• 한국철도학회:학술대회논문집
• /
• 한국철도학회 2007년도 추계학술대회 논문집
• /
• pp.401-410
• /
• 2007

Form the application of long rail system the non-ballast steel plate bridges, fatigue strength increase and rail noise reduction can be expected. This is mainly form the reduction of the rail impact at the rail joint locations which already made to behave together from welds. In the high speed rail, application of long rail system is essential because without long rail system, the required serviceability level can not be achieved. But even with this long rail systems, the thermal expansion from the girder can not be absorbed in the normal bearing systems, and these expansion cause between girder and rail. Also unexpected rail buckling and fracture through rail thermal tension may happen. It was found through numerical analysis and field measurement that these problems can be avoided by semi-fixed bearing system. In this study, the benefits of non-ballast plate bridge through long rail system, especially at the point of girder stability, girder stiffness increase and bearing maintenance will be reviewed.

• 한국강구조학회 논문집
• /
• 제8권3호통권28호
• /
• pp.117-125
• /
• 1996

The stress patterns of vertical stiffener of plate girder bridge were examined by existing data of actual measurement stress for steel bridges and the structural details of vertical stiffener of plate girder bridge having seeked rationalization and abbreviation were investigated by 1/2 bridge model. As the results, the out-of-plane stress occur in the upper parts of vertical stiffner and fatigue cracks by the action of alternative stress is apt to occur in web plate of lower parts vertical stiffener. Also, the gap between lower parts of vertical stiffner and lower flange of plate girder bridge seeking rationalization and abbreviation is effective to adopt 100mm.

• 한국환경과학회지
• /
• 제21권5호
• /
• pp.605-611
• /
• 2012

The purpose of this study is to analyze psychological and physiological effects accordance with viewing and walking in the forest and urban area. In the result of measurement of physiological reactions in nervous system, viewing of the forest had a calming effect on the nervous system by reducing blood pressure and heart rate. The other hand, viewing and walking in the urban area compared to the forest area raised stress by increasing blood pressure and heart rate. In addition, viewing in forest area was effective in stress relief by noticeable reduction of the amylase concentration. In contrast, walking in the urban area was also confirmed an increase of stress by increasing the concentration of the amylase. A viewing and walking in forest area was effective in alleviating depressed on anxiety, anger, fatigue and confusion.

• 한국복합재료학회:학술대회논문집
• /
• 한국복합재료학회 2003년도 춘계학술발표대회 논문집
• /
• pp.42-45
• /
• 2003

Optical fiber vibrations sensors (OFVSs) and extrinsic Fabry-Perot interferometer (EFPI) were used in damage monitoring of fiber-metal laminates(FML). The optical fiber vibration sensor and EFPI were applied in order to detect and evaluate the strain, damage and failure of FML. Damages in composites, such as matrix cracks, delamination and fiber breakage may occur as a result of excessive load, fatigue and low-velocity impacts. Indentation test was performed with the measurement of optical signal and acoustic emission (AE). The signals of the optical fiber vibration sensor due to damages were quantitatively evaluated by wavelet transform. It was found that damage information of comparable in quality to acoustic emission data could be obtained from the optical fiber vibration sensor signals.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2000년도 추계학술대회논문집A
• /
• pp.470-474
• /
• 2000

Cold expansion of fastener holes is a mechanical process widely used in the aerospace industry. This treatment leads to an improvement of fatigue behavior due to the developed compressive residual stresses on the hole surface. The residual stress profile depends on the parameters of cold expansion, which are, expanding rate, inserting direction of mandrel, material properties etc. and the method to confirm this profile is only measurement by X-ray diffractometer. Despite its importance to aerospace industries, little attention has been devoted to the accurate modelling of the process. In this paper, Two-dimensional axisymmetric finite element simulations have been conducted for the cold expansion in an aluminium plate in order to predict the magnitude and distribution of the residual stress and plastic deformation. Maximum compressive residual stress could be increase about 7 percent using the 2-step cold expansion method.

• 한국정보통신학회:학술대회논문집
• /
• 한국정보통신학회 2013년도 춘계학술대회
• /
• pp.125-128
• /
• 2013

3D-TV 시청시 눈에 피로를 주는 원인은 시청자의 안간 거리와 시청거리에 상관없이 고정된 disparity 의 좌/우 영상이 재생되기 때문이다. 본 논문은 TV 단말의 양쪽에 카메라 모듈을 이용하여 시청자의 위치와 눈동자 간격을 알아내어 3D TV 영상재생에 그 정보를 반영하는 방법을 제안한다.

• 대한의용생체공학회:의공학회지
• /
• 제11권2호
• /
• pp.243-248
• /
• 1990

EMG (eleltromyographic) signals are generated by contracting muscle and detected in and out side of muscle in the form of random signals. In the measurement of muscle fatigue, the mean frequency of EMG signals using spectrum analysis is an important parameter in diagonosis of muscle disease and in sports medicine fields. In this study, the degree of spectral transfer to lower frequency caused by accumulation of Latic acid inside the muscle is estimated. The new spectral analysis method using 2"d order hAaximum Entropy Method was applied to estimate the mean frequency and we confirmed that this new method yields fast and reliable estimation.tion.

• 한국정밀공학회:학술대회논문집
• /
• 한국정밀공학회 1995년도 춘계학술대회 논문집
• /
• pp.510-514
• /
• 1995

설계 초기 단계에서 자동차 샤시 부품의 내구강도를 평가하는 것은 대단히 중요하므로 실제 전산수치해석을 통하여 예측도 행하고 있지만 양산 적용여부는 차량제작 후 실차 내구시험을 시행 후 결정되고 있다. 본 연구에서는 컴퓨터의 잇점을 적극 활용하여, 차량의 주요부품인 Lower Arm과 Rear Axle Housing 등의 내구시험에서 부품의 변형을 탐지하기 위한 자동 측정 프로그램을 개발하고자 한다. 사용한 프로그램은 IBM-PC 호환기종(80286, 80386, 80486)에 사용되는 Turbo-C 언어를, 한글입력을 위해서 한글 라이브러리 <한>을 사용하였다. 그리고사용자가 임의로 시스템 각 요소의 모듈(module)을 대치할 수 있도록 각 함수별로 서브루틴(subroutine)화 하였다.

• 감성과학
• /
• 제3권1호
• /
• pp.1-6
• /
• 2000

단조 작업에 의한 정신적 피로도의 평가를 위하여 피험자에게 1자릿수 숫자 3개를 더하는 연산 작업을 수행하게 하였다. 주관적 평가를 통해 단조작업임이 확인된 task를 사용하여 작업 시간이 증가함에 따라 단조감이 증가하도록 실험과정을 설계하고 생리신호를 측정하였다. 측정된 생리신호 중 심전도, 피부온도, 호흡을 분석하였다. 단조 작업을 수행함에 따라 피부온도의 증가 경향이 나타났으며, 심박 변화율의 전력스펙트럽 분석결과 고주파성분의 감소와 Power spectrum balance가 증가하였다. 특히 power spectrum balance와 주관적 평가치의 상관관계가 높게 나타났다. 또한 상관관계가 높은 생리신호를 사용하여 정신피로를 예측한 결과 (R=0.945)가 정신피로를 잘 나타낼 수 있음을 알 수 있었다.