• Journal of Korean Neurosurgical Society
• /
• v.49 no.6
• /
• pp.351-354
• /
• 2011

Objective : This investigation was conducted to evaluate a new, safe entry point for the C2 pedicle screw, determined using the anatomical landmarks of the C2 lateral mass, the lamina, and the isthmus of the pars interarticularis. Methods : Fifteen patients underwent bilateral C1 lateral mass-C2 pedicle screw fixation, combined with posterior wiring. The C2 pedicle screw was inserted at the entry point determined using the following method : 4 mm lateral to and 4 mm inferior to the transitional point (from the superior end line of the lamina to the isthmus of the pars interarticularis). After a small hole was made with a high-speed drill, the taper was inserted with a 30 degree convergence in the cephalad direction. Other surgical procedures were performed according to Harm's description. Preoperatively, careful evaluation was performed with a cervical X-ray for C1-C2 alignment, magnetic resonance imaging for spinal cord and ligamentous structures, and a contrast-enhanced 3-dimensional computed tomogram (3-D CT) for bony anatomy and the course of the vertebral artery. A 3-D CT was checked postoperatively to evaluate screw placement Results : Bone fusion was achieved in all 15 patients (100%) without screw violation into the spinal canal, vertebral artery injury, or hardware failure. Occipital neuralgia developed in one patient, but this subsided after a C2 ganglion block. Conclusion : C2 transpedicular screw fixation can be easily and safely performed using the entry point of the present study. However, careful preoperative radiographic evaluation, regardless of methods, is mandatory.

• Journal of Trauma and Injury
• /
• v.29 no.4
• /
• pp.129-138
• /
• 2016

Purpose: Due to recent advances in internal fixation techniques, instrumentation and orthopedic implants there is an increasing number of humeral shaft fracture treated operatively. As a consequence, an increased number nonunion after operative fixation are being referred to our center. The aim of this study is to report the common error during osteosynthesis that may have led to nonunion and present a systematic analytical approach for the management of aseptic humeral shaft nonunion. Methods: In between January 2007 to December 2013, 20 patients with humeral shaft nonunion after operative procedure were treated according to our treatment algorithm. We could analysis x-rays of 12 patients from initial treatment to nonunion. In a subgroup of 12 patients the initial operative procedure were analyzed to determine the error that may have caused nonunion. The following questions were used to examine the cases: 1) Was the fracture biology preserved during the procedure? 2) Does the implant construct have enough stability to allow fracture healing? Results: In 19 out of 20 patients have showed radiographic evidence of union on follow up. One patient has to undergo reoperation because of the technical error with bone graft placement but eventually healed. There were 2 cases wherein the treatment algorithm was not followed. All patients had problems with mechanical stability, and in 13 patients had biologic problems. In the analysis of the initial operative fixation, only one of 12 patients had biologic problems. Conclusion: In our analysis, the common preventable error made during operative fixation of humeral shaft fracture is failure to provide adequate stability for bony union to occur. And with these cases we have demonstrated a systematic analytic management approach that may be used to prevent surgeons from reproducing the same fault and reduce the need for bone grafting.

• Korean Journal of Metals and Materials
• /
• v.49 no.12
• /
• pp.983-988
• /
• 2011

Failure analyses of the screws in spinal fixation devices were carried out. The fractured screws were retrieved from a patient who had spinal surgery in the thoracic vertebrae from number 10 to 15. The failure occurred one month after the removal of the braces. Microstructures and fracture surfaces were examined by optical and scanning electron microscopy. The microstructures of the screws corresponded to annealed Ti-6Al-4V bar. However, in the vicinity of the screw surface, there was an insufficient number of fine precipitates. Fracture surfaces showed typical fatigue failure modes. Regarding the fact that no machining defects were detected, fatigue crack initiation might have been caused by the lack of precipitates near the screw surfaces. Only the fourth of five fixed screws was severely stress-concentrated by the action of the spinal bones, while the stress of the 4th screw was decreased to half of its acceptable level when the screw was supplemented by one more, which might have been fixed in the 6th vertebra under the 5th position by the switching of its position. The stress simulation was conducted by ANSYS with 3D CAD of PRO/E in order to understand the stress concentration behavior and to provide an effective spinal surgery guide.

• Journal of National Security and Military Science
• /
• s.13
• /
• pp.1-41
• /
• 2016

US 8th Army in the attack on the Western Front was a situation that was frustrated by the 13th Corps Communist army. To this time support this, goals that have been granted to the US 1st Marine Division that initiated the attack in Mupyonri direction, lack the potential to achieve was not decisive. It was a operation specific erroneous judgment that occurred because there was no one accurately grasp the battlefield of the situation the wrong UN Forces Command. Tactical victory can be to maximize the operation outcomes. However, there is no possible failure of the operation is to expand the tactical success. This is because the failure of the operation, because directly linked to the success or failure of the war. Tactical victory can be to maximize the operation outcomes. However, operation specific failure is not it possible to expand the tactical victory. Therefore tactical success of the US 1st Marine Division, can not compensate for operation specific failure of the United Nations Forces Command. However, Chinese Communist Army 9th Corps is obsessed only victory of tactics to annihilate the US 1st Marine Division, by being fixation to the Chosin whole area, it was not possible to run a operational operation. Therefore tactical success df the US 1st Marine Division, Chinese Communist Army 9th Corps is to extinguish the ability to increase the number of the 13th Corps of the Western Front, 8th Army US have contributed to have escaped the crisis. In addition, the US 10th Corps while maintaining the combat force, by an important role to withdraw through the sea, was able to complement the misjudgment of the operation.

• Journal of Korean Foot and Ankle Society
• /
• v.16 no.2
• /
• pp.94-100
• /
• 2012

Purpose: The purpose of this study is to analyze the clinical features of distal tibia fractures and to evaluate the treatment outcomes of minimally invasive plate osteosynthesis (MIPO). Materials and Methods: From January 2004 to December 2009, 84 cases of 81 patients treated with plate fixation for distal tibia fracture were enrolled in this retrospective review. We investigated age, sex, injury mechanism, fracture patterns, and complications, and the clinical features were analyzed. To evaluate the treatment outcomes of MIPO, we divided into two groups. MIPO group consisted of 55 patients were treated with MIPO technique and conventional group consisted of 18 patients were treated with open reduction and internal fixation with conventional anterolateral plating. The results were compared between two groups by assessing bony union time, operation time, amount of blood loss, range of ankle motion, clinical score by American Orthopaedic Foot and Ankle Society (AOFAS) score, and post-operative complications. Results: The mean age of 81 patients with distal tibia fracture was 54.8 years. According to AO classification, A1:2:3 were 16, 20, 16 patients, B1:2:3 were 2, 8, 7, C1:2:3 were 1, 3, 11 patients. According to injury mechanism, slip down injury was patients, traffic accident was 26, fall from height injury was 14 patients respectively. The type A fractures were lower energy trauma and more older patients. The type C fractures were higher energy trauma and younger patients. MIPO group was better than conventional group in operative time, blood loss, bony union time, and ankle joint motion. In complications, MIPO group showed no nonunion and infection, one malunion, one skin necrosis, nine skin irritations, and one screw breakage. Conventional group showed two nonunion, four infections, two skin necrosis, and one metal failure. Conclusion: Distal tibial fractures caused by low energy trauma were on the increase. Minimal invasive plate osteosynthesis was shorter bony union time and operation time, less blood loss, and larger ankle motions than conventional open reduction and plate fixation.

• Clinics in Shoulder and Elbow
• /
• v.9 no.2
• /
• pp.189-195
• /
• 2006

Purpose: To analyze the result of the accurate open reduction of acromioclavicular (AC) joint and pin fixation, coracoclavicular (CC) screw fixation without CC ligament repair for AC joint injuries. Materials and Methods: Between January 2000 and December 2003, seventeen cases with at least one year follow-up among twenty-one cases underwent operation for AC-CC ligament injuries. A transverse incision approximately 5 cm in length was made over the clavicle, and the AC joint was reduced accurately. Under the image intensifier, a cannulated screw and washer were inserted for the CC ligament. Two Steinman pins were inserted for the AC joint and the AC ligament was repaired with nonabsorbable suture. Gentle passive range of motion was begun postoperative 2 weeks. The pins were removed at $6{\sim}8$ weeks and the screw was removed at $10{\sim}12$ weeks. The results were evaluated by a distance between AC and CC joints on plain films and ASES score at last follow-up. Results: At the last follow-up, there was no limitation of motion and average ASES score was 96($86{\sim}100$ points). There was no failure showing over 5 mm difference of distance compared to opposite side on the plain films. Seven cases had the skin damages and local infection due to pin migration and three cases showed the loosening of CC screw. Conclusion: We could have satisfactory results by accurate reduction of AC joint and simple pins and screw fixation for AC-CC ligament injuries.

• Journal of the Korean Orthopaedic Association
• /
• v.56 no.1
• /
• pp.14-25
• /
• 2021

Several factors need to be considered for a successful anterior cruciate ligament (ACL) reconstruction, such as preoperative planning, operation technique, and postoperative rehabilitation. Graft choice, fixation, preparation method, maturation, incorporation to host bone, and graft tension should also be considered to achieve a good outcome after an ACL reconstruction. Factors to consider when selecting a graft are the graft strength, graft fixation, fixation site healing, and donor site morbidity, as well as the effects of initial strength, size, surface area, and origin of the graft on its potential for weakening during healing. There are two types of graft for an ACL reconstruction, autograft or allograft. Several autografts have been introduced, including the bone-patellar tendon-bone, hamstring tendon, and quadriceps tendon-bone. On the other hand, each has its advantages and disadvantages. The recent increased use of allografts for an ACL reconstruction is the lack of donor site morbidity, decreased surgical time, diminished postoperative pain, and good availability of source. Despite this, there are no reports suggesting that an allograft may have a better long-term outcome than an autograft. Allografts have inherent disadvantages, including a longer and less complete course of incorporation, remodeling, biomechanically inferiority to autograft, the potential risk of an immunogenic reaction and disease transmission. Higher long-term failure rates and poorer graft maturation scores were reported for allografts compared to autografts. An autograft in an ACL reconstruction should remain the gold standard, although the allograft is a reasonable alternative. If adequate length and diameter of autograft can be obtained for an ACL reconstruction, an autograft with adequate graft fixation and postoperative rehabilitation should be chosen instead of an allograft to achieve better results.

• Journal of Yeungnam Medical Science
• /
• v.7 no.1
• /
• pp.81-93
• /
• 1990

The author fractographically analyized the cause of metal failure(the first time this procedure has been used for this metal failure)and also analyized it clinically. In this study, I selected eight cases which have been analyized fractographically. In all these cases, the analysis was done after treatment of metal failure of implants internally fixed to femur shaft fractures at the Department of Orthopedic Surgery, Yeung-Nam University Hospital during the six year period from May 1983 to September 1989. 1. Metal failure occured in five dynamic-compression plates, one Jewett nail, one screw in Rowe plate, and one interlocking nail. 2. The clinical cause of metal failure was deficiency of medial butress in five cases, incorrect position of implant in one case, and incorrect selection of implant in two cases. 3. The time interval between internal fixation and metal failure was four months in one case, between five months to twelve months in six cases, three years in one case. 4. The fractographically analytical cause of metal failure was ; first, impact failure, one case, second, fatigue failure, six cases, machining mark(stress liser), four cases type : low consistent cyclic fatigue failure irregular cyclic fatigue failure third, stress corrosion crack, one case. 5. 316L Stainless Steel has good resistance to corrosion. However, when its peculiar surface film is destroyed by fretting, it shows pitting corrosion. This is, perhaps, the main cause of metal failure. 6. It is possible that mechanical injury occured in implants during the manufacturing of implants or that making a screw hole is the main cause of metal failure.

• Journal of Korean Orthopaedic Sports Medicine
• /
• v.2 no.1
• /
• pp.15-19
• /
• 2003

Although the number of anterior cruciate ligament reconstruction is increasing, complications after primary ACL reconstruction are more difficult to determine. Intraoperative and postoperative complications can lead to ultimate failure of a primary reconstructive procedure. Therefore, surgical success in ACL reconstruction requires detailed knowledge and technical advancements about ACL reconstruction. Preoperatively surgeon must pay attention to selection of grafts and methods of fixation, and intraoperatively, attention to the harvest of graft, passage of graft, intraarticuar placement of the graft, notchplasty, proper tensioning of the graft, and others. Postoperative complications must be detected early, including infection, abnormal healing responses, arthrofibrosis, graft rejection, and reflex sympathetic dystrophy. Careful patient selection, appropriate surgical timing, careful surgical technique, and supervised preoperative and postoperative rehabilitation can minimize postoperative complications.

• Journal of Korean Foot and Ankle Society
• /
• v.6 no.1
• /
• pp.92-95
• /
• 2002

Traumatic ruptures of tibialis posterior tendon are much less common and consequently have received little attention. A tibialis posterior tendon rupture associated with a closed medial malleolar fracture occured in a 32 years old man due to slip down. The tendon rupture was not diagnosed before surgery but was recognized at the time of open operation. The treatment was open reduction and internal fixation at the bony fragments with primary repair of the tendon. This tendon injury, although rare, should be considered in the management of ankle fracture because the tendon rupture could easily have been overlooked and failure to recognize this at the time of injury may result in poor long - term ankle function despite a well- healed fracture.