• Journal of the Korean Operations Research and Management Science Society
• /
• v.5 no.1
• /
• pp.31-38
• /
• 1980

The purpose of this paper is to exhibit existing replacement models and to develop new replacement models for managing equipments in large organizations, private or public. Some of the models in this paper are well known and in use, and some are not. All these models are classified, depending on main factors which play key roles on the models. One group is the models in which the economic factor plays a key role, and the other is those in which both the economic factor and the effectiveness factor play key roles.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.33 no.4
• /
• pp.105-120
• /
• 1991

This study was performed to investigate the minimum safety factor of embankment in consideration of seismic coefficient by the psuedo-static analysis The variables were cohesion, the internal friction angle, angle of slope, height of seepage, height of embankment, depth of replacement The results obtained were compared with those by Fellenius method, simplified Bishop method and Janbu method. The results were summarized as follows: 1.The increasing rate of the minimum safety factor with the increasing of cohesion appeared larger in Fellenius method and Bishop method than in Janbu method. And that with the increasing of the internal friction angle appeared the lowest value in Janbu method. The minimum safety factor was influenced larger on the internal friction angle than on cohesion. 2.The variation of the minimum safety factor with the height of seepage at 0m and 5 m was nearly similar to Fellenius method, Bishop method and Janbu method. On the other hand, it was decreased suddenly at 25 m. 3.The minimum safety factor with the height of embankment was decreased remarkably under 10 m with the increasing of seismic coefficient. But, it was decreased slowly more than 10 m. As the height of embankment was low, the influence of cohesion appeared larger. 4.In heigher case of the depth of replacement, the phenomenon of reduction of the minimum safety factor appeared remarkably with seismic coefficient increased. And in lower case of the depth of replacement, the minimum safety factor was similar in Fellenius method and Bishop mehtod. But it appeared larger in Bishop method and Janbu method than in Fellenius method with the depth of replacement increased. 5.As the cohesion and the internal friction angle were large, the phenomenon of reduction of the minimum safety factor with the increasing of seismic coefficient appeared remarkably. Also, the influence of seismic coefficient in minimum safety factor appeared larger with the soil parameter increased. 6.When the seismic coefficient was considerated, investigation of the structural body on the slope stability appeared profitably in Fellenius method and Janbu method than in Bishop method.

• PNF and Movement
• /
• v.9 no.1
• /
• pp.39-45
• /
• 2011

Purpose : The purpose of this article was to review the literature on change of knee position sense after total knee replacement intervention in knee rehabilitation. Methods : This review outlines scientific findings regarding different literature data in knee rehabilitation, and discusses proprioceptive change of knee joints after total knee replacement intervention. Result : Severe pain and diminished joint sensation may precipitate degenerative changes of knees joint, and a strong association between decreased proprioception and function has been identified in elderly patients with knee osteoarthritis. Total knee replacement(TKR) of the knee joint are effective surgical procedures in osteoarthritis patients, resulting in decreased pain, and improved physical function and quality of life in patients. After total knee replacement, joint position sensation is partially recovered, which may improve functional stability of the knee, but aspects of physical functioning are not fully restored to preoperative status. Conclusions : Thus, recovery rate in proprioception after TKR also is considered to be important because it may be a significant risk factor in failure of total knee replacement and knee rehabilitation intervention.

• Clinical and Experimental Pediatrics
• /
• v.49 no.8
• /
• pp.821-829
• /
• 2006

Hemophilia is the most common coagulation disorder. It has a long history. Hemophilia A is caused by FVIII gene mutation, and hemophilia B by FIX gene mutation. Those genes are located on X chromosome long arm. Bleedings in hemophiliacs predominantly occur in joints and muscles. Because those site are insufficient in tissue factor to induce hemostasis. Among joints knee, ankle and elbow are most frequently affected because their synovial structure is vulnerable to injury compared to other joints. Hemophilia is diagnosed with factor assay. Severe hemophilia is below 1% of FVIII : C, moderate between 1% and 5%, mild over 5%. Carrier detection and prenatal diagnosis have been conducted with RFLP-based linkage analysis and DNA sequencing. Mainstay of treatment is factor replacement therapy so far. Bleedings can be controlled by infusion of factor concentrates. Hemophilc arthropathy and muscle contracture are representative sequelae. Complications of facotor replacement therapy are inhibitor development and infections. Hemophiliacs with inhibitor should be managed with large dose factor concentrate, bypassing agent, ITI and immunosuppression. Ultimately, hemophilia could be cured by gene therapy.

• Journal of Applied Reliability
• /
• v.16 no.4
• /
• pp.280-286
• /
• 2016

Purpose: Recently, Jiang defines the tradeoff B life to minimize a sum of life lost by preventive maintenance (PM) and corrective maintenance (CM) contribution parts and sets up an optimal replacement age of age replacement policy as this tradeoff life. In this paper, Jiang's model only considering the known lifetime distribution is extended by assigning different weights to two parts of PM and CM in order to reflect the practical maintenance situations in application. Methods: The new age replacement model is formulated and the meaning of a weight factor is expressed with the implied cost of failure under asymptotic expected cost model and also discussed with one-cycle expected cost criterion. Results: The proposed model is applied to Weibull and lognormal lifetime distributions and optimum PM replacement ages are derived with corresponding implied cost of failure. Conclusion: The new age replacement policy to escape the estimation of cost of failure in classical asymptotic expected cost criterion based on the renewal process is provided.

• Computers and Concrete
• /
• v.21 no.5
• /
• pp.531-538
• /
• 2018

The slag through sieve #4 replaced the natural fine aggregate in different proportions (0-50%) to make ready-mixed soil and slag (RMSAS). The fresh properties studied, and the concrete specimens were produced to test the hardened properties at different ages. Results showed that the workability of RMSAS decreases when the replacement increases. The unit weight increases with the replacement. The setting time extends when the replacement decreases and shortens when the replacement increases. The compressive strength, ultrasonic pulse velocity and hammer rebound value increase with the replacement. However, the high-replacement results decrease because of the expansion factor at late age. Resistivity is close and less than $20k{\Omega}-cm$. After the industrial of steelmaking by-products are processed properly, they can be used in civil engineering, not only as a substitute for natural resources and to reduce costs, but also to provide environmental protection.

• Journal of Korean Society of Water and Wastewater
• /
• v.16 no.6
• /
• pp.710-716
• /
• 2002

A General Pipe Break Prediction Model that incorporates linear and exponential models in its form is developed. The model is capable of fitting pipe break trends that have linear, exponential or in between of linear and exponential trend by using a weighting factor. The weighting factor is adjusted to obtain a best model that minimizes the sum of squared errors of the model. The model essentially plots a best curve (or a line) passing through "cumulative number of pipe breaks" versus "break times since installation of a pipe" data points. Therefore, it prevents over-predicting future number of pipe breaks compared to the conventional exponential model. The optimal replacement time equation is derived by using the Threshold Break Rate equation by Loganathan et al. (2002).

• International Journal of Concrete Structures and Materials
• /
• v.7 no.3
• /
• pp.239-249
• /
• 2013

In the present scenario to fulfill the demands of sustainable construction, concrete made with multi-blended cement system of OPC and different mineral admixtures, is the judicious choice for the construction industry. Silica fume (SF) and fly ash (FA) are the most commonly used mineral admixtures in ternary blend cement systems. Synergy between the contributions of both on the mechanical properties of the concrete is an important factor. This study reports the effect of replacement of OPC by fly ash (20, 30, 40 and 50 % replacement of OPC) and/or silica fume (7 and 10 %) on the mechanical properties of concrete like compressive strength and split tensile strength, with three different w/b ratio of 0.3, 0.4 and 0.45. The results indicate that, as the total replacement level of OPC in concrete using ternary blend of OPC + FA + SF increases, the strength with respect to control mix increases up to certain replacement level and thereafter decreases. If the cement content of control mixes at each w/b ratio is kept constant, then as w/b ratio decreases, higher percentage of OPC can be replaced with FA + SF to get 28 days strength comparable to the control mix. A new method was proposed to find the efficiency factor of SF and FA individually in ternary blend cement system, based on principle of modified Bolomey's equation for predicting compressive strength of concrete using binary blend cement system. Efficiency factor for SF and FA were always higher in ternary blend cement system than their respective binary blend cement system. Split tensile strength of concrete using binary and ternary cement system were higher than OPC for a given compressive strength level.

• Clinical and Experimental Pediatrics
• /
• v.53 no.10
• /
• pp.913-916
• /
• 2010

Congenital factor VII deficiency is a rare autosomal-recessive bleeding disorder. Bleeding manifestations and clinical findings vary widely, ranging from asymptomatic subjects to patients with hemorrhages that may cause significant handicaps. Treatment has traditionally involved factor VII(FVII) replacement therapy using fresh frozen plasma, prothrombin complex concentrates or plasma-derived FVII concentrates. Recombinant activated FVII ($NovoSeven^{(R)}$) is currently considered the first-line treatment for replacement therapy of FVII deficiency. Here we present a case of severe intracerebral and intraventricular hemorrhage in a neonate with congenital FVII deficiency.

• Journal of the East Asian Society of Dietary Life
• /
• v.27 no.4
• /
• pp.420-430
• /
• 2017

This study investigated the status of Korean food consumption and the need for home meal replacement of Korean food for Chinese and Japanese in order to export Korean food to China and Japan. In total, 78.2% of Chinese and 33.0% of Japanese showed significant differences in their experiences of visiting Korea. The most common place to consume Korean food was a Korean restaurant for Chinese (55.8%), whereas Japanese (44.9%) consumed Korean food at Korean restaurants in Japan. In the purchasing experience of Korean home meal replacement, 59.2% of Chinese and 40.5% of Japanese responded that they had 'purchase experience', and the reason for purchasing was 'delicious' (32.5%) for Chinese and 'convenience' (34.8 %) for Japanese. The place to purchase Korean home meal replacement was large marts in both countries. Most Chinese (92.2%) and Japanese (62.1%) respondents said they were willing to buy Korean home meal replacement. Both Chinese (54.8 %) and Japanese (48.0%) said that 'taste' was the most important factor to consider when developing Korean home meal replacement. The favorite tastes were 'spicy' (35.3%) for Chinese and 'savory' (38.8%) for Japanese. For the taste of Korean home meal replacement, Chinese answered that the product should be developed by maintaining 'Korean traditional taste as it is' (57.7%), whereas Japanese responded 'change according to the taste of Japanese' (65.2%). For the preferred packaging form of home meal replacement, Chinese preferred 'vacuum' package while the Japanese preferred 'frozen'. The results of this study can be used as basic data for domestic food companies to establish marketing strategies to enter the Chinese and Japanese home meal replacement markets.