• Journal of Energy Engineering
• /
• v.19 no.4
• /
• pp.228-233
• /
• 2010

About 55% of total energy is consumed in the industrial division. The industrial heat pump application will show magnificent energy saving effect as well as higher cost efficiency because of larger energy consuming volume of each facility and longer operation hour and higher stability against seasonal temperature change. Over 90% of dryer for industrial usage has hot wind heat source and hot wind dryer is the representative type covering 68.7% while its 30 ~ 50% lower heat efficiency causes lots of energy loss by exhaust air. Re-usage of exhaust air can improve energy efficiency of dryer because 68% heat energy or 78% of hot air lose in exhaust air. Therefore, high temperature heat pump dryer can be the best alternative. Comparing to the existing dryer with 30% ~ 50% energy efficiency, newly developing high temperature heat pump dryer will enhance energy efficiency up to 60% ~ 80% efficiency. In this paper, heat pump system for high temperature was designed, constructed and tested. The results have shown that system COPh is estimated as 3.3.

• Journal of Environmental Impact Assessment
• /
• v.19 no.5
• /
• pp.475-481
• /
• 2010

Lots of pollutants typically originating from urban transportation are accumulating on the paved surfaces during dry periods and are washed-off directly to the river during a storm. Also, paved surfaces are contributing to increase in peak flows and volume of stormwater flows. These are the main reasons why the water quality of rivers and lakes remain polluted and still below standards. Currently, several management practices are being applied in developed countries but the design standards are still lacking. This research was conducted to develop a treatment technology that can be useful to address the problems concerning runoff quality and quantity. A lab scale infiltration device consisting of a pretreatment tank and media zone was designed and tested for various flow regimes characterizing the low, average and high intensity rainfall. Based on the experiments, the high intensity flow resulted to increase in outflow event mean concentration (EMC) of pollutants, about twice as much as the average outflow EMC. However, 78 to 88% of the total suspended solids were captured and retained in the pretreatment tank because of sedimentation. The removal of heavy metals such as zinc and lead was greatly affected by the vertical placement of woodchip layer prior to the media zone. It was observed that the high carbon content (almost 50%) in the woodchip provided opportunity for enhancing its uptake of metal by adsorption. The findings implied that the reduction of pollutants can be greatly achieved by means of proper pretreatment to allow for settling of particles with a combination of using high carbon source media like woodchip and a geotextile mat to reduce the flow before filtering into the media zone and finally discharging to the drainage system.

• Fire Science and Engineering
• /
• v.31 no.6
• /
• pp.107-111
• /
• 2017

The purpose of this study was to develop a Eco smoking booth that can effectively reduce hazardous pollutants generated during smoking and evaluate the efficiency and effectiveness of removing hazardous pollutants. The design and manufacture of an eco-friendly automatic smoking booth equipped with deodorizing facilities, such as inlet - HEPA filter - electrostatic precipitator (EP) - impregnated activated carbon - exhaust port, etc., and the efficiency of removing hazardous pollutants from inside and outside was measured and evaluated. The complex odor removal efficiency was 95.37% inside the smoking booth, and 97.38% at the exit of the preventive facility. The carbon monoxide removal efficiency was 94.25% in the inside and 98.32% in the outlet. In addition, the removal efficiency of particulate matter, (PM1, PM2.5, and PM10) inside the smoking booth was 98.59%, and 98.85% at the outlet. The total volatile organic compounds (TVOCs) decreased from $26,000{\mu}g/m^3$ to $5,203{\mu}g/m^3$ in the smoking booth, resulting in 79.99% removal efficiency. After the ventilator was operated, the measured effluent concentration was $5,019{\mu}g/m^3$, and the removal efficiency was 80.70%. Therefore, the smoking booth designed and manufactured through this study can be applied to the removal of harmful pollutants even in the small working environment in the future.

• Horticultural Science & Technology
• /
• v.28 no.5
• /
• pp.891-894
• /
• 2010

This study was conducted in order to examine the effects of horticultural therapy on stress in demented elders, and for this purpose, we analyzed stress-related physiological changes in demented elders under the care of an elderly facility who had not taken medication and consented to blood tests. The horticultural therapy program included only flower decoration, which was preferred by the participants, aiming ultimately to reduce stress. First, a one-to-one session was given for forming rapport and the horticultural therapist had many conversations about plants with the elders. Furthermore, the participants were induced to be absorbed into the horticultural activities, though a short while, so that they might forget troubles. Evaluation was made by measuring subjective stress and the blood cortisol hormone concentration before and after the horticultural therapy and examining differences between them. Subjective stress increased from 12.88 to 17.88 in the control group, but decreased significantly from 13.88 before the therapy to 6.38 after in the experimental group (p = 0.007). When the blood cortisol hormone level was measured as a physiological indicator of stress, it decreased significantly from $11.33{\mu}g{\cdot}L^{-1}$ before the horticultural therapy to $9.85{\mu}g{\cdot}L^{-1}$ after (p = 0.037). These results suggest that horticultural therapy reduces the blood cortisol hormone level and is effective in easing stress.

• Journal of Korea Water Resources Association
• /
• v.50 no.12
• /
• pp.803-813
• /
• 2017

Recently, various studies have been conducted to optimize the pump operation scheduling and/or the pump/tank size minimizing the system cost of water distribution network. Prior to that, it is important to understand the sensitivity of pump/tank size on the system cost and overall water quality. Here, we have performed the sensitivity analysis to investigate the effect of pump/tank size on the economic cost (construction and operation) and water quality (water age). The analysis was applied on a real, large-scale water transmission network currently operating in South Korea. The results revealed that the pump/tank size has a strong influence on system construction/operation costs. Especially, the tank size has a significant effect on the system-wide water quality. In the case of applied networks, the operating cost decreases as the capacity of the facility increases, but the design cost increases. Using a sensitivity analysis, a suitable range of pump/tank size could be suggested to minimize costs and stabilize the water quality at the same time prior to a system design.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2018.10a
• /
• pp.292-294
• /
• 2018

Recently, damage caused by natural disasters such as fire, earthquake, heavy rains and heavy snow is increasing. In addition, traffic accidents due to freezing, fog and fire in tunnels and bridges are frequently occurring. In such a disaster situation, it is very important to take prompt action by the person in charge of managing the facility and area.To this end, a disaster broadcasting system is used, but in the existing system, the broadcasting room and the speaker are connected by a wired connection. Also, the person in charge has to be in the broadcasting room to broadcast, which has a problem of delaying the time. In this paper, we design a disaster broadcasting system using LTE modem. The designed system enables a broadcasting person to make a call to a broadcasting system from anywhere using a cellular phone and a public telephone. Broadcasting via telephone is possible only with the telephone number pre-registered in the system and can be registered / deleted by the administrator. The registered telephone number, incoming voice file, and announcement voice for automatic broadcasting are stored in the system internal SD memory for convenient management. This disaster broadcasting system is expected to contribute to quick and convenient disaster broadcasting.

• The Journal of Sustainable Design and Educational Environment Research
• /
• v.15 no.1
• /
• pp.1-10
• /
• 2016

School facilities are one of the important educational requirements, and it is necessary to maintain safe and sustainable for the ongoing educational environment. For this reason, educational government department have an effort to produce school facilities that have become safe, comfort, convenient and high-quality. There are many methods to improve existing buildings and build new schools by energy efficient technology. Even though educational environment of school facilities are improved by the efforts, the energy consumption has a huge increase. Energy is a major budget item for schools. The accurate estimation of energy cost is critical for effective budgeting and financing for the school facility maintenance. Accurate energy cost estimation also allow for a anticipatable LCC (Life Cycle Cost) of new school facilities. In this study, in order to produce a basic information about the present energy usage status in domestic school facilities, energy usage quantity is regionally analysed according to physical characteristics of elementary, middle, and high school facilities. Those results will give a chance to see deeply the pros and cons of energy usage each regional school facilities.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• v.9 no.1
• /
• pp.171-174
• /
• 2005

According as marine leisure industry has developed and the demand of leisure culture has increased rapidly, a desire about service which supply marine safety and connect marine information is enlarging. The performance of personal mobile device has improved and been evolved by composition terminal. So, it became possible that storage and expression of multimedia information as well as simple communication facility. Domestic wireless internet has given development strain to developer and contents Provider(CP) because of different platform. And this has become hindrance factor of wireless internet activation. But, recently, the use of WIPI(Wireless Internet Platform for Interoperability), the wireless internet standard platform, could use different wireless application programs and also guarantee the independency for hardware. We wish to develop contents of download form that supply geographic information of Electronic Navigational Chart(ENC) in the marine that is digitalized to carrying along terminal of WIPI base and various informations for marine leisure. For this, DB that offer ENC and additional information should be constructed. Also, we need server (CPS; Contents provider Server) that offer required contents. In this paper, we design web retrieval agent which store request information to database. When consumer required necessary information through personal mobile device, CPS can inform that by real time. So, we wish to develop agent component that parse informations in various World Wide Webs, and store to database.

• Journal of the Society of Disaster Information
• /
• v.15 no.4
• /
• pp.570-577
• /
• 2019

Purpose: The purpose of this study is to develop a system that enables quick on-site response using real-time decision-making by sharing the results of measurement and management performed in the field for safe temporary construction. Method: It is possible to take preemptive responses during construction by identifying the safety factors of construction conditions from measurement results and determining the risk factors such as soil properties and variability of climate change that can occur during construction by simultaneously using the back analysis method reflected in the measurement system and structural review. Result: we developed a back analysis algorithm of the SUNEX program to cope with the discrepancies between the design results and measured results due to inconsistency between site conditions and design properties, unexpected loads, and outdoor environment. The process of matching the measurement result with the analysis result can be confirmed in the safety management system. Conclusion: Gateway was used to communicate with real-time measurement results and safety management system program. It was made possible to preemptively respond to risk factors that may occur in the field.

• Journal of Navigation and Port Research
• /
• v.42 no.1
• /
• pp.9-16
• /
• 2018

The development of limited petroleum resources for use with mankind inevitably explores and seeks to develop oil fields in the deep sea area, under the rise of the oil prices market situation. The use of Oceanic Thermal Energy Conversion (OTEC) technology, which operates the power generation facility using the temperature differences between the deep water and the surface water, is progressing actively as a trend to follow. In this study, the application of the Discharged Thermal Energy Conversion (DTEC) was designed and analyzed under the condition that the supply condition of seawater used in the FPSO installed in the deep sea area is changed up to 400m depth. In this case, it was confirmed that the design of the system that can generate more electric power according to the depth of water is confirmed, by thus applying the DTEC system by taking the cooling water at a deeper water depth than the existing design water depth. The FPSO considers the similarity of the OTEC power generation facilities, and will apply the DTEC system to FPSO in the deep sea area to accumulate technology and the conversion to further utilize the OTEC power generation facilities after the end of life cycle of oil production, which could be a solution to two important issues, namely, resource development and sustainable development.