• 한국광학회지
• /
• 제9권1호
• /
• pp.5-8
• /
• 1998

비균일 단축결정(inhomogeneous uniaxal)매질 내에서 빛의 전파를 Berreman의 $4{\times}4$ 행렬을 사용하여 계산할 때, 광원이 단색광일 경우 매질 내의 불연속점에서 발생하는 다중 반사로 인한 Fabry-Perot 간섭효과에 의해, 투과광은 간섭효과가 나타나게 된다. 본 논문에서는 Berreman의 $4{\times}4$ 행렬 연산에서 Fabry-Perot 간섭효과를 제거하기 위한 apodization 방법을 제시하였다. 매질내에 k개의 불연속 경계면이 있을 경우, 새로운 apodization 방법은 최대 (k+1)개의 $4{\times}4$ 행렬을 부가적으로 곱하므로써 전체 전달행렬을 계산할 수 있다. 이를 twisted-nematic(TN) LC cell의 광투과 특성 계산에 적용한 결과 간섭 패턴을 효과적으로 제거할 수 있음을 확인하였다.

• Journal of Magnetics
• /
• 제18권2호
• /
• pp.173-177
• /
• 2013

Cantilever-detected high-frequency electron spin resonance (ESR) is a powerful method of sub-terahertz and terahertz ESR spectroscopy for a tiny magnetic sample at low temperature. In this technique, a small magnetization change associated with ESR transition is detected as deflection of a sample-mounted cantilever. So far, we have succeeded in ESR detection at 370 GHz using a commercial piezoresistive microcantilever. The spin sensitivity was estimated to ${\sim}10^{12}$ spins/gauss. In order to further increase the sensitivity, we adopt a fiber-optic-based detection system using a Fabry-Perot interferometer in place of piezoresistive system. Fabry-Perot cavity is formed between an optical-fiber end and microcantilever surface, and a change in the interference signal, corresponding to the cantilever deflection, is sensitively detected. This system is suitable for low-temperature and high-magnetic-field experiments because of its compact setup and less heat dissipation. In this study, performance of Fabry-Perot interferometer is evaluated, and its application to cantilever-detected ESR measurement is described.

• 한국광학회:학술대회논문집
• /
• 한국광학회 1989년도 제4회 파동 및 레이저 학술발표회 4th Conference on Waves and lasers 논문집 - 한국광학회
• /
• pp.113-118
• /
• 1989

By using the single mode optical fiber, we fabricated Fiber-optic Fabry-Perot interferometer (FFPI). The change over a wide range in the optical path length of a FFPI is observed. The temporal movement of the interference fringes by external condition to P.Z. T) is converted to circular motion on an oscilloscope display and then recorded with a micro-computer. The two output voltages of the D/A converters are applied to X and Y terminals of oscilloscope to display circular motion on oscilloscope. Thus the direction of phase shift can be determined with observing the direction of circular motion. The variation of the optical length can be measured by calculating the angle of spot of circle with an accuracy of λ/90 wave length due to variation of temperature in this system 2.7x10-4$^{\circ}C$.

• 대한전기학회논문지
• /
• 제43권4호
• /
• pp.620-626
• /
• 1994

As the electrostrictive actuator for optic control, PZN-BT-PT ceramics were investigated for the influences of sintering conditions on the structural, electrostrictive properties and the optical properties of Fabry-perot Interferometer using eletrostrictive ceramics. The specimen SS15T, sintered 1hr at 1150$^{\circ}C$, is sutible for eletrostrictive actuator because its piezoelectric constants(dS131T) and strain(XS131T) at dc 10kV/cm had the higest value of 175${\times}$10S0-12TC/N, -255${\times}$10S0-6TΔl/l respectively. As the dc electric field increased, the interference effect of Fabry-Perot Interferometer was increased. The most intense interference fringe and the maximum power of 160${\mu}$W were observed at dc 6kV/cm. Thus it was considered that specimen SS15T could be used as the electrostrictive actuator for optic control.

• Current Optics and Photonics
• /
• 제5권6호
• /
• pp.652-659
• /
• 2021

The theoretical analysis and optimization of extrinsic Fabry-Perot interferometer (EFPI) opticalfiber humidity sensors are deeply investigated. For a typical dual-cavity structure composed of an optical fiber and a humidity-sensitive membrane (HSM), the changes in refractive index (RI) and initial length are discussed for polymer materials and porous oxide materials when relative humidity (RH) increases. The typical interference spectrum is simulated at different RH using MATLAB. The spectral change caused by changing HSM RI and initial length are simulated simutineously, showing different influences on humidity response. To deeply investigate the influence on RH sensitivity, the typical response sensitivity curves for different HSM lengths and air-cavity lengths are simulated. The results show that the HSM is the vital factor. Short HSM length can improve the sensitivity, but for HSM RI and length the influences on sensitivity are opposite, because of the opposite spectral-shift trend. Deep discussion and an optimization method are provided to solve this problem. According to analysis, an opaque HSM is helpful to improve sensitivity. Furthermore, if using an opaque HSM, a short air cavity and long HSM length can improve the sensor's sensitivity These results provide deep understanding and some ideas for designing and optimizing highly sensitive EFPI fiber humidity sensors.

• 센서학회지
• /
• 제23권2호
• /
• pp.110-113
• /
• 2014

In this paper, we propose and demonstrate a Fabry-Perot interferometer (FPI) optical fiber tip sensor fabricated by a blade-sawing technique using a fiber optic patch cord for high-resolution temperature measurement. The sensor head consists of a short air FP cavity near the tip of a single-mode fiber patch cord tip. The temperature which we can measure is determined through a phase variation of the interference fringes in the reflective spectrum of the sensor. The fiber optic FPI sensor in this work can monitor the environmental temperature very accurately from 40 to $120^{\circ}C$. As a result, the temperature sensitivity is obtained as $38.2pm/^{\circ}C$.

• 한국광학회지
• /
• 제7권3호
• /
• pp.287-294
• /
• 1996

MOCVD(metal-organic chemical vapour deposition)방법으로 성장시킨 이중 이종접합구조 GaAs/AlGaAs 웨이퍼를 이용하여 광위상변조기를 제작하였다. 제작과정에서 도파로와 절연층의 형성시 동일 포토레지스트 패턴을 이용하는 자기종렬공정을 개발하여 그 효용성을 입증하였다. Fabry-Perot 간섭법을 이용하여 변조기의 위상변조효율을 측정하였으며 1.31.mu.m파장에서 TE 편광의 경우 22.5.deg./Vmm의 위상변조특성을 얻었다.

• 한국광학회지
• /
• 제10권3호
• /
• pp.254-258
• /
• 1999

전계흡수형 반도체 광도파로에서 흡수된 빛에 의해 발생된 광전류는 전파되는 파장에 따라 Fabry-Perot 모드의 간섭패턴을 나타냄을 보이고, 이로부터 인가전압에 따른 흡수계수의 변화를 측정할 수 있는 방법을 제시하였다. 광전류 신호는 파장에 따라 공명 반공명을 반복해서 나타내며 그 진폭은 흡수계수의 크기에 의존하므로 전계에 따른 흡수계수의 변화량을 측정 할 수 있었고, 1.55 $\mu\textrm{m}$ 파장에서 역전압 1.5V 인가시 bulk in GaAsP의 흡수계수 변화는 대략 157cm-1임을 알 수 있었다.

• 한국초전도학회:학술대회논문집
• /
• 한국초전도학회 2009년도 Korea Superconductivity Society Meeting 2009
• /
• pp.78-78
• /
• 2009

• 대한기계학회논문집A
• /
• 제25권10호
• /
• pp.1551-1558
• /
• 2001

Recently, a number of underground pipelines have been drastically increased. The integrity of these buried pipelines, especially gas transmitting pipelines, is of importance due to an explosive characteristic of natural gas. The third party damage is known as one of the most critical factor which causes fatal accidents. For this reason, a number of systems detecting third party damage are under development. The major concern in the development of third party damage detection system is to transmit vibration signals out of accelerometer to signal conditioner and data acquisition system without any interference caused by noise. The objective of this paper is to develope a fiber optic accelerometer applicable to third party damage detection system. A fiber optic accelerometer was developed by use of combining principles of one degree of freedom vibration model and an extrinsic Fabry-Perot interferometer. The developed fiber optic accelerometer was designed to perform with a sensitivity of 0.06mVg, a frequency range of less than 6kHz and an amplitude range of -200g to 200g. The developed, accelerometer was compared with a piezoelectric accelerometer and calibrated. In order to verify the developed accelerometer, the field experiment was performed. From the field experiment, vibration signals and the location of impact were successfully detected. The developed accelerometer is expected to be used for the third party damage detection system which requires long distance transmission of signals.