• Journal of the Korean Geosynthetics Society
• /
• v.18 no.1
• /
• pp.91-101
• /
• 2019

Recently, small-scale excavation like ground cavity restoration and buried pipe replacement works are being carried out in urban area, in order to improve living convenience. This paper describes experiment results on the ground reinforcement method that can reduce the buried pipe damage, when the differential settlement occurred due to poor compaction of ground below the buried pipe. Plate load tests were conducted to evaluate a reinforcement effect of ground using concrete mat and expansion mat in the ground below the buried pipe. The results showed that the stress reduction ratio by concrete mat and expansion mat according to the surcharge load was about 46%~48% and 39%~42%, respectively. Therefore, the differential settlement of the buried pipe and the ground deformation below the buried pipes were reduced by the reinforcement effect of the concrete mat and expansion mat. This means that it is possible to prevent a buried pipe damage due to underground cavity and ground subsidence, if concrete mat and expansion mat are reinforced in the ground below the buried pipe or on the ground between the buried pipes.

• The Korean Journal of Ceramics
• /
• v.2 no.4
• /
• pp.246-250
• /
• 1996

The thermomechanical properties of materials from the system Al2O3-SiO2-TiO2(Tialite-Mullite) were investigated by correlating the thermal expansion anisotroypy, flexural strength and Young's modulus with grain size and atructural microcracking during cooling. Microcracking temperatures were determined by measuring the hysteresis of the thermal expansion anisotropy with dilatometry. Single phase Aluminium Titanate is a low strength material, while composites with more than 10 vol% mullite as second phase enhance the Young's modulus, thermal expansion coefficient and room temperature strength.

• Journal of the Korean Geosynthetics Society
• /
• v.17 no.4
• /
• pp.293-304
• /
• 2018

This paper described a results of field test based on plate bearing test of the restoration material, which was developed to restore the ground cavity due to sewerage damage. The analysis of bearing capacity characteristics on the restoration materials was performed by experimental results. The results showed that the load bearing capacity in the maximum stress condition of the foundation ground is about 66%-70%, when the expansion mat is embedded at the bottom of 0.1 m and 0.2 m from the ground surface. However, The load bearing capacity of expansion mat according to embedded depth was not large. The load bearing capacity of concrete mats was about 82%-90% compared with that of ground surface, and it showed about 50% of the load bearing capacity compared with the expansion mat. As a result of analysis of allowable bearing capacity according to restoration materials, it was confirmed that the allowable bearing capacity of the expansion mat and the concrete was about 130%-150% and about 160% more than the foundation ground, respectively.

• Proceedings of the KSR Conference
• /
• 2003.10b
• /
• pp.552-556
• /
• 2003

Expansion joint is the absorbing structure when the upper structure of bridge have the drying shrinkage and creep from the change of temperature or construction badness. Because it has the fatigue from continuous vehicles traffic. the durability and performance is verified by the static and dynamic loading test In this study. we make the decision that T-MAT type expansion joint is applied in railway bridge and the expansion joint was tested by the criterion of Korea High Speed Rail Construction Authority.

• Korean Journal of Materials Research
• /
• v.8 no.1
• /
• pp.85-91
• /
• 1998

인이 높은 농도로 도핑되어진 LPCVD 다결정 실리콘 박막의 열팽창 계수를 마이크로 게이지법을 이용하여 측정하였다. 기존의 박막의 열팽창 계수 측정 법에서는 박막이 기판에 증착되어진 상태에서 측정이 이루어지므로, 기판의 탄성계수와 열팽창계수를 미리 알고 있어야 한다. 이에 비해 마이크로 게이지법에서는 박막의 열\ulcorner창 계수를 도출하기 위하여 기판의 탄성계수 값과 열팽창 계수 값을 필요로 하지 않는다는 장점이 있다. 마이크로 게이지법에서는 전류를 가할 경우 줄 발열에 의해 발생한 마이크로 게이지에의 변위를 측정하고, 그 때 계산된 마이크로 게이지의 평균 온도의 관계에서 열팽창 계수를 계산한다. 다결정 실리콘 박막의 열팽창 계수는 2.9 x $10^{-6}$$^{\circ}C$로 측정되었으며, 이 값들의 표준편차는 0.24x$10^{-6}$$^{\circ}C$였다.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2002.08a
• /
• pp.795-798
• /
• 2002

Replacing Pb-free glass composition for the dielectric materials is expected in PDP industry. In this study, phosphate glasses, $P_2O_5$- ZnO- SnO (PZS), $P_2O_5$-ZnO-BaO (PZB) were selected for a new transparent dielectric. Thermal properties (Tg, CTE) were measured with differential thermal analyzer and thermal mechanical analyzer. The glass transition of the glasses was ranged at $365{\sim}405^{\circ}C$ for the PZS system and $5.9{\sim}9.5{\times}\;10^{-6}$ of thermal expansion were found. The PZB system showed $445{\sim}470^{\circ}C$ of glass transition. Thus, the glass compositions would be a potential candidate for a transparent dielectric layer in plasma display panel.

• Journal of the Korean Ceramic Society
• /
• v.30 no.8
• /
• pp.609-614
• /
• 1993

Semiconducting Zn-Ti-Ni-O and Zn-Ti-O system were investigated. The specimens sintered at the temperature between 125$0^{\circ}C$ and 145$0^{\circ}C$ exhibited PTCR effect between -5$0^{\circ}C$ and 35$0^{\circ}C$ with resistivity ration exceeding three decades. Semiconducting Zn-Ti-Ni-O is consisted of two phases, one is n-type ZnO and the other is p-type spinel structure. The mechanism of PTCR effect was explained in relation to the piezoelectric property of ZnO and the residual stress caused by thermal expansion difference between two phases during cooling process.

• The Korean Journal of Ceramics
• /
• v.5 no.4
• /
• pp.414-418
• /
• 1999

The synthesis of polycrystalline $Al_2TiO_5$ ceramics with low thermal expansion by fusion in an electric arc furnance was investigated. The thermal expansion curves of $Al_2TiO_5$ ceramics were lowered because of microcracks caused by the strong thermal expansion anisotropy of the crystal axes and were accompanied by hysteresis curves. These phenomena are explained by the opening and closing of microcracks. The difference in microcracking temperatures of dilatometric cooling curves in the range of 400~$620^{\circ}C$ is caused by the difference in sintering temperature, grain size and stabilization status.

• Mycobiology
• /
• v.46 no.1
• /
• pp.64-71
• /
• 2018

The aim of this study was to investigate the pattern of distribution of mating type (MAT) genes of Tuber indicum in ectomycorhizosphere soils from natural T. indicum-producing areas and cultivated truffle orchards and ascocarp samples from different regions. Quantitative real-time PCR and multiplex PCR were used to weight the copy numbers of MAT1-1-1 and MAT1-2-1 in natural truffle soils and cultivated orchard soils. The effect of limestone on the pattern of truffle MAT genes and the correlation between soil properties and the proportion of MAT genes were also assessed. These results indicated that an uneven and nonrandom distribution of MAT genes was common in truffle-producing areas, cultivated truffle orchards, and ascocarps gleba. The competition between the two mating type genes and the expansion of unbalanced distribution was found to be closely related to truffle fructification. Limestone treatments failed to alter the proportion of the two mating type genes in the soil. The content of available phosphorus in soil was significantly correlated with the value of MAT1-1-1/MAT1-2-1 in cultivated and natural ectomycorhizosphere soils. The application of real-time quantitative PCR can provide reference for monitoring the dynamic changes of mating type genes in soil. This study investigates the distributional pattern of T. indicum MAT genes in the ectomycorhizosphere soil and ascocarp gleba from different regions, which may provide a foundation for the cultivation of T. indicum.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.56 no.3
• /
• pp.31-38
• /
• 2014

Four actual cultivations were prepared and a variety of soybean was cultivated. A H-flume, an automatic water level gauge and an automatic water sampler were installed at the outlet of each plot equipped for the measurement of flow rate and its water quality. The amount of rainfall of the study area in 2013 was measured as 975.6 mm which was much lower than the annual average rainfall of 1,271.8 mm, resulting in less occurrences in rainfall-runoff events. Rainfall-runoff events were occurred three times during the rainfall event of 4~5 July, 23 and 24 August. The characteristics of NPS pollution discharge of the plots and the reduction effect of the selected BMPs were analyzed during these events. The reduction effect of straw mat and soil amendments (Polyacrylamide (PAM) and Gypsum) on runoff ratio ranged between 38.2 and 92.9% (average 71.6%). The NPS pollution load reduced between 27.7 and 95.1% (average 70.0%) by the application of rice straw mat and soil conditioner when compared with that of control plot. Soybean yield (2,133.3 kg/ha) of the straw mat covered plots increased by 14.3% when compared with control (1,866.7 kg/ha). The effect of straw mat on the yield was not economically viable if the material and accompanying labor costs were considered. The data collected and analyzed on different soil textures and crops in this study are expected to be a fundamental reference for the expansion of the results to the application nationwide and the development of NPS pollution management policies.