• Geophysics and Geophysical Exploration
• /
• v.14 no.4
• /
• pp.267-273
• /
• 2011

A cluster of micro-earthquakes in the transition zone between the continental and oceanic crust in the East Sea was relocated using the Joint Hypocenter Determination (JHD) method. In order to increase the number of available earthquakes and to take advantage of the high detection capability of the Korea National Seismic Network (KNSN), continuously recorded seismic data were reviewed to identify 56 micro-earthquakes occurring in a 20 km ${\times}$ 20 km region. The initial earthquake hypocenters were determined using a routine single event location method. Single event locations do not reveal any significant structures in the study area. After relocating the earthquake hypocenters using the JHD technique, the earthquakes were clustered and four potential faults responsible for earthquake generation in the subsurface were delineated. They are defined by two sub-vertical and two steeply south-dipping seismicities located next to each other.

• The Bulletin of The Korean Astronomical Society
• /
• v.35 no.1
• /
• pp.34.1-34.1
• /
• 2010

Solar proton events, whose fluxes are larger than 10 particles cm-2 sec-1 ster-1 for >10 MeV protons, have been observed since 1976. NOAA proton event list from 1997 to 2006 shows that most of the events are related to both flares and CMEs but a few fraction of events (5/93) are only related with CMEs. In this study, we carefully identified the sources of these events. For this, we used LASCO CME catalog and SOHO MDI data. First, we examined the directions of CMEs related with the events and the CMEs are found to eject from the western hemisphere. Second, we searched a major active region in the front solar disk for several days before the proton events occurred by taking into account two facts: (1) The location of the active region is consistent with the position angle of a given CME and (2) there were several flares in the active region or the active region is the largest among several candidates. As a result, we were able to determine active regions which are likely to produce proton events without ambiguity as well as their longitudes at the time of proton events by considering solar rotation rate, $13.2^{\circ}$ per day. From this study, we found that the longitudes of five active regions are all between $90^{\circ}W$ and $120^{\circ}W$. When the flare peak time is assume to be the CME event time, we confirmed that the dependence of their rise times (proton peak time - flare peak time) on longitude are consistent with the previous empirical formula. These results imply that five events should be also associated with flares which were not observed because they occurred from back-side.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.12A
• /
• pp.1171-1180
• /
• 2010

In wireless sensor networks, reliable event detection is one of the most important research issues. For the reliable event detection, previous works usually assume the events are only individual objects such as tanks and soldiers. Recently, many researches focus on detection of continuous objects such as wild fire and bio-chemical material, but they merely aim at methods to reduce communication costs. Hence, we propose a reliable continuous object detection scheme. However, it might not be trivial. Unlike individual objects that could be referred as a point, a continuous object is shown in a dynamic two-dimensional diagram since it may cover a wide area and it could dynamically alter its own shape according to physical environments, e.g. geographical conditions, wind, and so on. Hence, the continuous object detection reliability can not be estimated by the indicator for individual objects. This paper newly defines the reliability indicator for continuous object detection and proposes an error recovery mechanism relying on the estimation result from the new indicator.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.42 no.1
• /
• pp.218-226
• /
• 2017

In this paper, optical transport network in real time monitoring system using smart phone. The existing housing using monitoring was a smart phone of optical transport network access switch about an event with new installation of cognitive system in real time. This paper can this problem to be solved of the invention in real time maintenance using smart phone application and optical cable closure switch. If you want to find optical cable closure fault location, this smart phone web is very useful. Cable tie is isolation of fiber spare board from fiber switch tie occur push message. Housing and access, and an external failures otdr the measurement of the global positioning to be able to easily using the This paper can find event of optical cable closure unauthorized work and fault using smart phone OTDR function. the optical cable fault time reduction and network transport quality by managing real time optical cable section by using the smart phone can be maintained efficiently.

• Journal of Astronomy and Space Sciences
• /
• v.34 no.4
• /
• pp.315-330
• /
• 2017

Halo coronal mass ejections (CMEs) originating from solar activities give rise to geomagnetic storms when they reach the Earth. Variations in the geomagnetic field during a geomagnetic storm can damage satellites, communication systems, electrical power grids, and power systems, and induce currents. Therefore, automated techniques for detecting and analyzing halo CMEs have been eliciting increasing attention for the monitoring and prediction of the space weather environment. In this study, we developed an algorithm to sense and detect halo CMEs using large angle and spectrometric coronagraph (LASCO) C3 coronagraph images from the solar and heliospheric observatory (SOHO) satellite. In addition, we developed an image processing technique to derive the morphological and dynamical characteristics of halo CMEs, namely, the source location, width, actual CME speed, and arrival time at a 21.5 solar radius. The proposed halo CME automatic analysis model was validated using a model of the past three halo CME events. As a result, a solar event that occurred at 03:38 UT on Mar. 23, 2014 was predicted to arrive at Earth at 23:00 UT on Mar. 25, whereas the actual arrival time was at 04:30 UT on Mar. 26, which is a difference of 5 hr and 30 min. In addition, a solar event that occurred at 12:55 UT on Apr. 18, 2014 was estimated to arrive at Earth at 16:00 UT on Apr. 20, which is 4 hr ahead of the actual arrival time of 20:00 UT on the same day. However, the estimation error was reduced significantly compared to the ENLIL model. As a further study, the model will be applied to many more events for validation and testing, and after such tests are completed, on-line service will be provided at the Korean Space Weather Center to detect halo CMEs and derive the model parameters.

• KIPS Transactions on Software and Data Engineering
• /
• v.3 no.9
• /
• pp.341-348
• /
• 2014

The advance in web accessibility with dissemination of smart phones gives rise to rapid increment of users on social network platforms. Many research projects are in progress to detect events using Twitter because it has a powerful influence on the dissemination of information with its open networks, and it is the representative service which generates more than 500 million Tweets a day in average; however, existing studies to detect events has been used TFIDF algorithm without any consideration of the various conditions of tweets. In addition, some of them detected predefined events. In this paper, we propose the RTFIDF VT algorithm which is a modified algorithm of TFIDF by reflecting features of Twitter. We also verified the optimal section of TF and DF for detecting events through the experiment. Finally, we suggest a system that extracts result-sets of places and related keywords at the given specific time using the RTFIDF VT algorithm and validated section of TF and DF.

• Proceedings of the Earthquake Engineering Society of Korea Conference
• /
• 1998.10a
• /
• pp.421-435
• /
• 1998

An empirical formula for estimating duration magnitude(MD)is determined by analyzing 619 epicentral distance-duration data set, obtained from earthquakes of 1989-1998 recorded at the KMA network. Based on two assumptions: 1) observed signal duration decreases with increasing epicentral distance, and 2) seismographs of KMA are set at low-gain and therefore inclusion of sensitivity correction term in the equation is not necessary, scaling predicted duration at epicenter to Tsuboi's local magnitude yielded the duration magnitude equation: MD =2.0292$\times$log$\tau$＋0.00123Δ-1.4017 for 1/0$\leq$ML$\leq$5.0, where $\tau$is total signal duration(sec)and Δis epicentral distance(km). Event by event comparison of ML values against MD estimates for t152 events shows that for events having a same ML the difference in MD estimates reaches as high as 1.1 magnitude units. So, to test the usefulness of the duration magnitude equation, we have calculated ML-MD relations by which duration magnitude estimates are converted to local magnitudes ("predicted" ML, say) which are then compared with the directly determined local magnitude values. Except for events with stations where duration is anomalously reestimates(predicted ML) which are in an agreement within a 0.2 magnitude units with the corresponding ML values. Although this study could gain some insights into magnitudes of the past events, we still need to re-examine all the observables in order to obtain more reliable and precise information about magnitude and hypocenter location. So we will pursue a new local-magnitude scaling, as well as refinement of the duration magnitude equation, starting soon with re-reading the amplitudes-arrival time records of (and hence relocating) 250+earthquakes of 1979-present recorded at the KMA network. Thus, with more reliable and precise earthquake parameters determined we would better understand the recent seismicity and related tectonic process within and adjacent region to the Korean peninsula.peninsula.

• Journal of the Korea Safety Management & Science
• /
• v.26 no.3
• /
• pp.71-82
• /
• 2024

In modern society, buildings are becoming more complex, and the population is becoming more densely populated. Such large buildings require a variety of evacuation measures, as there is a high possibility of large-scale human casualties due to increased evacuation distance and evacuation time in the event of a fire. Strobe light and exit sign light are used as important evacuation equipment to provide early warning and evacuation directions. In this thesis, we conducted a fire simulation assuming that a fire occurrence point notification function and a strobe light function were added to equipment such as visual alarms and evacuation guidance, and compared and analyzed the difference in evacuation completion time with existing equipment. The scenarios for the simulation were divided into "general fire situations" and "fire location and evacuation exit guidance situation" and the differences in evacuation completion time in the event of a fire were compared and analyzed for each floor from the 1st floor to the 3rd floor. The maximum travel distance to complete evacuation in the case of a fire on the first floor decreased by 80.6 m and the evacuation completion time decreased by 329.4 seconds, and the maximum travel distance to complete evacuation in the case of a second-floor fire decreased by 28.5 m and the evacuation completion time by 438.8 seconds. During the fire on the third floor, the maximum distance decreased until evacuation was completed to 3.4 m, and the evacuation completion time was reduced by 355.6 seconds. It is expected that if the congestion level of evacuation routes is reduced by utilizing the congestion level of evacuation exits when fire alarm systems and evacuation equipment are activated, the evacuation completion time will be further shortened and evacuations will be carried out quickly and safely.

• Journal of the Korean association of regional geographers
• /
• v.11 no.5
• /
• pp.349-367
• /
• 2005

The purpose of this paper is to establish three themes of regional instruction based on new regional geography and to examine explanation of space, understanding of place and judgement of environmental values for the Jinju regional instruction. Under the premise that region is the representation of space, place, and environmental perception, we reviewed location and space, event and place, development and environmental values in Jinju area. The results of the study are as follows: Owing to locational conditions, commercial agriculture, industrial and agroindustrial park, bio industry have been developed in Jinju. There are however some tasks that have to be solved such as rural investment, industrial park relocation and economic reconstruction. The Jinju castle combat, Farmers' resistance in 1862, Human right campaign for butchers in 1923, and educational conflict all occurred in the Jinju community. These events resulted in the integration and separation of the stratified citizens. They were represented as a variety of semiotics and landscape in the place. Citizens who live in Jinju are confronted with judging the environmental values. They ask whether inviting companies to town will ensure environmentally sound and sustainable development. The regional characteristics of knowledge, culture and environment in Jinju have been reproduced through the economic activity, place understanding, place marketing, and citizens' campaign.

• Korean Journal of Cognitive Science
• /
• v.21 no.2
• /
• pp.359-386
• /
• 2010

In order to evaluate the domain-specific model and process-specific model of spatial and nonspatial working memory (WM), this study manipulated the memory load of the delayed response task and examined how the neural correlates of memory load effect was influenced by the stimulus domain (face and location) at the maintenance stage of WM using an event-related fMRI experiment. One or three face stimuli were presented as target stimuli and participants were asked to maintain the face itself (face WM) or the location of face stimuli (spatial WM). The results of recognition judgment accuracy showed no difference between face WM and spatial WM, and showed equivalent memory load effects of both WM. As a result of brian image analysis, memory load effect at maintenance stage showed that inferior, middle, and superior PFC were recruited by both face WM and spatial WM, and showed that VLPFC was the commonly activated area by both WM, supporting functional specialization of PFC by process components of WM. This study provides evidence for process-specific model in which maintenance of WM is associated with VLPFC.