• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.61 no.6
• /
• pp.891-898
• /
• 2012

The study for the passenger's comfortableness of vehicles and the arousal of car drivers has been done widely. On the other hand, there are few studies for the locomotive engineers. Human error means that the mistakes made by human, recently it receives attention in the field of safety engineering and human engineering. Comparing the operating condition of train with car, because of the simplification of the visual stimulus, the arousal level on the train goes down easily. The arousal level down makes judgement down, the accident risk from human error is getting bigger. In this study, we measured bio-signals(ECG, EDA, PPG, respiration and EEG) from 6 locomotive engineers to evaluate their arousal state while they operated the train. Also we recorded the 3 axes acceleration signal showing the vibration state of train. Also, the existence of tunnels were simultaneously measured. At the station section where the train speed goes down, the size of vector's sum decreases because of reduced vibration. Beta component in EEG tends to increase at the entering point of each station and tunnel. It is due to the arousal reaction and tension growth. The mean SCR(skin conductance response) was more increased in neutral section. As the button control movement (body movement) increases in the neutral section, it is appeared that SCR increase. RR interval tends to gradually increase during train operation for 1 hour 40 minutes. However, It tends to sharply decrease at the stop station because strong concentration needed to stop train on the exact point. The engineer's arousal reaction can be checked through analysing the bio-signal change during train operation. Therefore, if this analysing result is adopted to the sleepiness prevention caution system, it will be useful for the safety train operation.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.9 no.2
• /
• pp.462-469
• /
• 2008

In this paper, we design the FPGA (Field-Programmable Gate Array) of the KOINONIA WPAN (Wireless Personal Area Network), and implement the SoC (System on Chip). We use the redundant bits to make a constant-amplitude in a modulator part. Additionally, the SNR (Signal to Noise Ratio) performance of the demodulator is improved by using the redundant bits in decoding steps. The four-million FPGA of the KOINONIA WPAN can be operated at 44MHz frequency. The PER (Packet Error Rate) of the designed FPGA with RF (Radio Frequency) module is below 1% at the -86dB MIPLS (Minimum Input Power Level Sensitivity), and the SNR is about 13dB. The SoC is implemented by using Hynix 0.25um CMOS (Complementary Metal Oxide Semiconductor) process. The size of the SoC is $6.52mm{\times}6.92mm$.

• Economic and Environmental Geology
• /
• v.51 no.1
• /
• pp.39-48
• /
• 2018

We carried out the standoff compensation data from 2007 to 2011 into four different density borehole models to find out the most effectiveness of standoff compensation charts. First, we investigated the irregular collapse characteristics of gamma ray and cut the non-ideal gamma response to improve the effectiveness of the standoff compensation error data. Effectiveness of detector combinations, density of borehole, and spine and ribs techniques from the modified standoff compensation data was analyzed. As the result of comparison, LSD-MSD combination has been suitable for standoff compensation more than LSD-SSD combination and it is possible to do standoff compensation for soil or weathered zone under groundwater level without fatal errors. Even though error scales of density transformed spine and ribs techniques were generally large compared to the conventional standoff compensation, standoff compensation for soil and weathered zone under groundwater level were sufficiently effective.

• Journal of Digital Contents Society
• /
• v.19 no.7
• /
• pp.1423-1431
• /
• 2018

IoT(Internet of Things) is applied to technologies such as agriculture and dairy farming, making it possible to cultivate crops easily and easily in cities.In particular, IoT technology that intelligently judge and control the growth environment of cultivated crops in the agricultural field is being developed. In this paper, we propose a method of predicting the growth environment of plants by learning the moisture supply cycle of plants using the intelligent object internet. The proposed system finds the moisture level of the soil moisture by mapping learning and finds the rules that require moisture supply based on the measured moisture level. Based on these rules, we predicted the moisture supply cycle and output it using media, so that it is convenient for users to use. In addition, in order to reduce the error of the value measured by the sensor, the information of each plant is exchanged with each other, so that the accuracy of the prediction is improved while compensating the value when there is an error. In order to evaluate the performance of the growth environment prediction system, the experiment was conducted in summer and winter and it was verified that the accuracy was high.

• Proceedings of the Korean Society of Food Science and Nutrition Conference
• /
• 2001.12a
• /
• pp.52-60
• /
• 2001

Purpose: We performed a randomized, double-blind, placebo-controlled trial in mild to moderate myopia patients to evaluate the benefit of taking a nutrient supplement containing anthocyanoside oligomers for improving nocturnal visiual function and/or clinical symptoms. Methods: The subjects included have refractive error between -lD(Diopters) $\~$-8D in both eyes, symptoms of decreased night vision and asthenopia based on the scoring result of a pre-structured questionnaire, and abnormal results of mesopic contrast sensitivity(MCS) screening test showing abnormal curve of contrast sensitivity in the middle and high frequency level, between 6.0 and 30.0 CPD(Cycles per degree) at mesopic condition(-2$\~$0 log cd/$m^2$). Total 60 people who qualified the criteria above were enrolled and the subjects were instructed to take the investigational product (anthocyanoside or placebo) twice daily for a 4 week period. The enrolled subjects were investigated for nocturnal vision performance by MCS and clinical symptoms at their first visit and re-evaluated at post-intervention (4 weeks later). MCS was measured and improvement of contrast threshold level according to each CPD was calculated by subtracting initial values from final values. Age, refractive error, and MCS were compared between the placebo and anthocyanoside. Results: After 4 weeks of drug administration 22 of the anthocyanoside group showed symptom improvement compared to 1 of the placebo group (p=0.000). Contrast sensitivity levels according to each CPD before and after drug treatment showed significant improvement in the anthocyanoside group but not in the placebo group. Mean MCS change of anthocyanoside group is 2.41$\pm$1.91 which showed significant improvement compared to -0.40$\pm$2.47 of the placebo group(p=0.000). MCS changes of anthocyanoside group showed significant improvement compared to placebo group in all levels of CPD(p<0.05). During our investigation none of the subjects complained of specific side effects related to anthocyanoside use. Conclusion: Our results show that under careful selection of people with significant symptoms and definite MCS abnormalities, anthocyanoside oligomers may improve the subjective symptoms and objective MCS results.

• Journal of the Korean Institute of Intelligent Systems
• /
• v.23 no.2
• /
• pp.184-189
• /
• 2013

In this paper, we propose the injurious moving picture filtering system using certain sounds contained in the injurious moving picture to filter injurious moving picture which is distributed without limitation in internet and internet storage space. For this purpose, the Gaussian Mixture Model which can well represent the characteristics of the sound, is used and frame level likelihood estimation is used to calculate the likelihood between filtering target data and the sound models. Also, the pruning method which can real-time proceed by reducing the comparing number of data, is applied for real-time processing, and MWMR method which showed good performance from existing speaker identification, is applied for the distinguish performance of high precision. In the identification experiment result, in case of the frame rate which is the proportion of total frame to high likelihood frame, is set to 50%, identification error rate is 6.06%, and in case of frame rate is set to 60%, error rate is 3.03%. As the result, the proposed system can distinguish between general and injurious moving picture effectively.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.38 no.1
• /
• pp.69-78
• /
• 2001

This paper presents the design and FPGA implementation of a FLEX PSP(Protocol Signal Processor) for the portable high speed paging system. In this approach, two algorithms are newly proposed for implementing the PSP which provides capabilities of the maximum 6,400bps at speed, high-channel throughput, real time error correction and an effective frame search function. One is an accurate symbol synchronization algorithm which is applied for synchronizing the interleaved 4-level bit symbols which are received at input stage of A/D converter, and the other is a modified fast decoding algorithm which is provided for realizing double error correction of (31,21)BCH signal. The PSP is composed of six functional modules, and each module is modelled in VHDL(VHSIC Hardware Description Language). Both functional simulation and logic synthesis have performed for the proposed PSP through the use of Synopsys$^{TM}$ tools on a Axil-320 Workstation, and where Altera 10K libraries are used for logic synthesis. From logic synthesis, we can see that the number of gates is about 2,631. For FPGA implementation, timing simulation is performed by using Altera MAX+ PLUS II, and its results will be also given. The PSP which is implemented in 6 FPGA devices on a PCB has been verified by means of Logic Analyzer.r.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.26 no.6
• /
• pp.617-624
• /
• 2008

In general, RTK-GPS(Real Time Kinematic GPS) based on the single reference station is able to determinate the high accurate position of rover on the spot using error correction information of transmitted carrier phase from the base station via wireless modem. However, single reference station method has some weak points to decrease positioning accuracy because it must be obtained carrier phase from the each satellite continuously, allowed to transmit without obstacle and limited to short base line distance between base and rover station. This paper aims to attempt network based GPS carrier phase differential positioning using three multi reference stations to overcome the method of single reference station and RTK network is realized by real time monitoring program with Visual C++. The optimum error correction value of three multi reference stations by RTK networking is selected automatically to correct the position of rover station. In this paper, this algorithm is applied to determine sea water level using GPS buoy, and the accuracy results of water level change were analyzed and compared with each other using single and multi reference stations.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.22 no.8
• /
• pp.1790-1802
• /
• 1997

A wavelet transform coding method that fulfills the requirements of HD-VCR(high definition video casstte recorder) for studio applications in proposed. A constant bit rate is achieved by a forward rate control technique whcih determins the quantizer stepsize based on the coding results fo the previous frame. We also propose a two-level coder that consists of both the IDC(independently decodable code) and the DDC(dependently decodable code). To minimize error propagation, the transformed coefficients are restructured into transform blocks which are represented by a tree structure. The result shows thta the proposed coding scheme produces better picture quality with block effects than that of DCT(discrete cosine transform) based coding schemes at the same compression ratio. The proposed method meets most of the requirements of HD-VCR.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.19 no.11
• /
• pp.2751-2757
• /
• 2015

To obtain the system requirement specification in the beginning of the precision guidance and control system development, the effectiveness and reliability analysis for the system are necessary. The main purpose of this research is to obtain the system requirement specification by carrying out the effectiveness analysis using the modeling and simulation(M&S) scheme. M&S model is constructed using 6-DOF dynamic model, environment model, guidanc -navigation & control model. Assume that the navigation sensor is consist of inertial navigation sensor(INS) and doppler velocity log(DVL), and the speed and direction of current is environment parameter. The effectiveness analysis is carried out using circular error probability(CEP) and variance analyze scheme. Also, the effectiveness analysis is utilized for cost-performance analysis considering the cost of commercial INS and DVL sensor. This paper shows the high-level INS and the low-level DVL configure a high price-performance integrated navigation system.