• Journal of the Korean Society of Hazard Mitigation
• /
• v.10 no.5
• /
• pp.125-133
• /
• 2010

In general, curved bends raises a risk of overtopping due to floods and also threatens a bank safety due to a local flow concentration. This study aims to test the applicability of CCHE2D model for experimental flumes with two different types of bends and then investigate flow characteristics in the sharply-curved bend of a natural channel. The results demonstrated that the percent error of water level was within 4.9% for experimental flume applications and the simulated spatial distribution of velocity matched the observed results very closely. The calibrated model based on the experimental flumes was also applied to analyze the flow characteristics in natural channel bends of the Daeyu reach, located in a downstream of the Youngdam Dam. The results showed that in upstream, the simulated water level by the CCHED was observed at 1.5 m higher than the 1-D numerical model (HEC-RAS) result since the HEC-RAS could not represent the bend geometry effect on streamflow. However, the calculated results by several empirical formula support that the CCHE2D is suitable for the super elevation simulation as well as flood stage and velocity in a natural channel bend.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.33A no.7
• /
• pp.269-277
• /
• 1996

This paper has been presented a design of a POCSAG decoder in RT-level VHDL and implemented in a FPGA chip, and tested. In a single clock of 76.8KHz, the decoder receives all the data of the rate of 512/1200/2400bps and has maximum 2-own frames for service enhancement. To improve decoder performance, the decoder uses a preamble detection cosidering 9% frequency tolerance, a SCW detction and a ICW detection at each 4 bit. The decoder also corrects a address data and a message data up to 2 bits and proposes the PF (preamble frequency) error for saving battery. The decoder increases a battery life owing to turn off RF circuits when the preamble signal is detected with nises. The chip has been designed in RT-level VHdL, synthesized into logic gates using power view$^{TM}$ of viewlogic software. The chip has been implemented in an ALTERA EPF81188GC232-3 FPGA chip with 98% usability, and fully tested in shield room and field room. The chip has been proved that the wrong detection numbers of preamble of noises are significantly reduced in the pager system using PDI 2400 through the real field test. The receiving performance is improved by 20% of aaverage, compared with other existing systems.

• The Journal of the Acoustical Society of Korea
• /
• v.39 no.2
• /
• pp.105-112
• /
• 2020

An analysis model of noise map is proposed to evaluate and reduce the acoustical noise of power plant and its surroundings. The sound powers of many noise sources are estimated by measuring the sound levels of major equipments in the power plant. The analysis of noise has been made by using ENPro that is a commercial program for environmental noise prediction. The proposed model is verified by comparing the results from noise analysis and measurement at several points of the power plant units 1 through 4, and residential areas. It is shown that noise map simulation using the proposed model has a reliability, since the overall noise level approximates within the error of ±2 dB. Furthermore, through noise analysis, the increasing effect of noise due to newly established units 5 and 6 on residential areas is also analyzed. Consequently, the noise barrier is designed to meet an environmental noise standard and satisfy low cost and safety conditions.

• Physical Therapy Korea
• /
• v.19 no.4
• /
• pp.46-54
• /
• 2012

Ely's test is commonly used to assess rectus femoris muscle flexibility. however, a reliability limit of this test was demonstrated by a previous study. In this study, we present an alternative method using an application for a digital horizontal level in a smartphone (DHLS) to complement the reliability limit of Ely's test. The aim of this study was to examine the reliability of Ely's test using DHLS on the pelvis, compared to using visual observation (VO) of pelvic and hip motions. Nineteen patients with lumbar extension-rotation syndrome were recruited for this study. An examiner examined the rectus femoris flexibility (both pass/fail and goniometer scoring) through Ely's test using both DHLS and VO. A retest session was completed two hours later for within-day reliability and seven days later for between-day intra-rater test-retest reliability. Results showed higher Kappa values for pass/fail scoring and higher intraclass correlation coefficient values for goniometer scoring in Ely's test using DHLS, compared to using VO. Measurement error and Bland and Altman plots further demonstrated the degree of intra-rater variance during Ely's test using DHLS in a clinical setting, compared to using VO. These results demonstrated that Ely's test using DHLS showed acceptable reliability compared to using VO. Ely's test using DHLS could be widely used for measuring the rectus femoris muscle flexibility in patients with lumbar extension-rotation syndrome, although the inter-rater reliability needs to be established first.

• Geotechnical Engineering
• /
• v.14 no.4
• /
• pp.33-46
• /
• 1998

Anisotropy of stiffness, from extremely small strains to post-failure strains, of isotropically consolidated air-pluviated sands in plane strain compression was studied by using the newly developed instrumentation for small strain measurements. Seven types of sand of the world-wide origins were tested, which have been extensively used for research purposes. Stress-strain at the specimen boundaries. It was found that the maximum Young's modulus $E_{max}$ was irrespective of the angle $\delta$ of the $\delta_1$ direction relative to the bedding plane. However, the normalized$ E_{max}$ was varied with the types of sand. Furthermore, the dependency of the strain and stress level on the stiffness was increased as $\delta$ decreased.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.15 no.3 s.96
• /
• pp.320-328
• /
• 2005

Last target of architectural acoustics is that people wish to convey voice effectively from the space adaptively in use purpose in building. But, how exactly through space sound (sound source) that wish to deliver from indoor can be passed method to do quantification and evaluate quantity of sound by method to serve indoor architectural acoustics estimation summer period and methods to estimate definition propose. This Study searches special quality of sound source about MLS signal that is occurred short-answer sound source (pistol sound source) and nondirectional speaker among indoor sound estimation method, and measure and analyzed reverberation time (RT60), definition (C80, D50) by regulation of each ISO 3382 in age place (classroom, hall, gymnasium). Analysis result and sound factor among could know that d of two sound sources converges in measurement error extent about reverberation time (RT60) of analysis incidental and sound factors and value shows change irregularly about sound factor of D50, C80, pistol sound source judged there is problem. Also, could know that problem is happened in deflection except reverberation time is in deflection analysis with wave that measure each in fixed distance in branch. Finally, when differ size of sound source and measure about change of sound pressure level in case measure sound pressure level giving difference about 10 dB, sound factor could know that there is no different effect.

• The Journal of the Acoustical Society of Korea
• /
• v.14 no.5
• /
• pp.74-82
• /
• 1995

This paper is study on the voice dialing using HMM and post processing of the connected digits. HMM algorithm is widely used in the speech recognition with a good result. But, the maximum likelihood estimation of HMM(Hidden Markov Model) training in the speech recognition does not lead to values which maximize recognition rate. To solve the problem, we applied the post processing to segmental K-means procedure are in the recognition experiment. Korea connected digits are influenced by the prolongation more than English connected digits. To decrease the segmentation error in the level building algorithm some word models which can be produced by the prolongation are added. Some rules for the added models are applied to the recognition result and it is updated. The recognition system was implemented with DSP board having a TMS320C30 processor and IBM PC. The reference patterns were made by 3 male speakers in the noisy laboratory. The recognition experiment was performed for 21 sort of telephone number, 252 data. The recognition rate was $6\%$ in the speaker dependent, and $80.5\%$ in the speaker independent recognition test.

• The Korean Journal of Applied Statistics
• /
• v.17 no.1
• /
• pp.61-73
• /
• 2004

Rotation sampling designs may be classified into two categories. The first type uses the same sample unit for the entire life of the survey. The second type uses the sample unit only for a fixed number of times. In both type of designs, the entire sample is partitioned into a finite number(=G) of rotation groups. This paper is generalization of the first type designs. Since the generalized design can be identified by only G rotation groups and recall level 1, we denote this rotation system as l/G rotation design. Under l/G rotation design, variance and mean squared error (MSE) of generalized composite estimator are derived, incorporating two type of biases and exponentially decaying correlation pattern. Compromising MSE's of some selected l/G designs, we investigate design efficiency, design gap effect, ans the effects of correlation and bias.

• The Korean Journal of Applied Statistics
• /
• v.21 no.4
• /
• pp.615-620
• /
• 2008

In engineering experiments, 'Sometimes Pooling Rules' to remove insignificant terms from the model has been implemented to increase the power of detecting the small size of main effects when the preliminary test of higher order interaction effects declare to be insignificant. In this note, we review the sometimes pooling rules in the literature and also study the probability of the length of 95% confidence interval of ${\mu}_1-{\mu}_2$ of the comparison of two independent samples being shorter than that of the paired comparison at the various level of significance ${\alpha}_1$ of the preliminary test and the insufficient number of blocks n in [2,13], given the block effects being pooled to the error term. This study supports that the sometimes pooling results in the power improvement of the main effects.

• Journal of the Korean Institute of Telematics and Electronics B
• /
• v.33B no.1
• /
• pp.144-152
• /
• 1996

In this paper, a pulse-mode digital multilayer neural network with a massively parallel yet compact and flexible network architecture is presented. Algebraicneural operations are replaced by stochastic processes using pseudo-random pulse sequences and simple logic gates are used as basic computing elements. The distributions of the results from the stochastic processes are approximated using the hypergeometric distribution. A statistical model of the noise(error) is developed to estimate the relative accuracy associated with stochastic computing in terms of mean and variance. Numerical character recognition problems are applied to the network to evaluate the network performance and to justify the validity of analytic results based on the developed statistical model. The network architectures are modeled in VHDL using the mixed descriptions of gate-level and register transfer level (RTL). Experiments show that the statistical model successfully predicts the accuracy of the operations performed in the network and that the character classification rate of the network is competitive to that of ordinary Back-Propagation networks.