• Journal of the Korean Institute of Telematics and Electronics
• /
• v.12 no.3
• /
• pp.26-29
• /
• 1975

In this paper, the input equivalent resistances of the n phase-diode average and envelope detection. circuits for the sinusoidal signal waveforms are analytically derived from the power loss in their load resistances, and the input equivalent resistance of the n phase-diode envelope detection circuits for the arbitrary signal waveforms is also obtained from the same physical conception.

• Journal of Advanced Marine Engineering and Technology
• /
• v.36 no.2
• /
• pp.258-266
• /
• 2012

Recently, Acoustic Emission (AE) technique is widely applied to develop the early fault detection system, and the problem about a signal processing method for AE signal is mainly focused on. In the signal processing method, envelope analysis is a useful method to evaluate the rolling element bearing problems and Wavelet transform is a powerful method to detect faults occurred on gearboxes. However, exact method for AE signal is not developed yet. Therefore, in this paper, two methods, which is Hilbert transforms (HT) and Hilbert-Huang transforms (HHT), will be compared for development a signal processing method for early fault detection system by using AE. AE signals were measured through a fatigue test. HHT has better advantages than HT because HHT can show the time-frequency domain result. But, HHT needs long time to process a signal, which has a lot of data, and has a disadvantage in de-noising filter.

• Journal of the Korean Society of Safety
• /
• v.25 no.3
• /
• pp.1-6
• /
• 2010

Ball bearings are one of main components that support the rotational shaft in high speed rotary machinery. So, it is very important to detect the incipient faults and fault growth of bearing since the damage and failure of bearing can cause a critical failures or accidents of machinery system. In the past, many researchers mainly performed to detect the bearing fault using traditional method such as wavelet, statistics, envelope etc in vibration signals. But study on the detection technique for bearing fault growth has a little been performed. In this paper, we verified the possibility for monitoring of fault growth and detection of fault size in bearing outer-race by using the envelope powerspectrum and probabilistic density function from measured vibration signals.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.9A
• /
• pp.795-802
• /
• 2005

Binary CDMA(B-CDMA) is a new modulation scheme that employs a constant envelope modulation scheme By quantizing the envelope of multi-codes CDMA signal into a small number of levels, the B-CDMA can reduce the peak-to-average power ratio, while preserving the advantages of CDMA signaling such as the soft capacity and robustness to interference. In this paper, we analyze the performance of B-CDMA systems in multi-path channel assuming that the spreading factor is not too small. Finally, the analytic results are verified by computer simulation.

• Current Optics and Photonics
• /
• v.5 no.3
• /
• pp.289-297
• /
• 2021

We describe a comb-mode resolving spectroscopic technique by direct time-domain phase correction of unstable interferograms obtained from loosely locked two femtosecond lasers. A low-cost continuous wave laser and conventional repetition rate stabilization method were exploited for locking carrier and envelope phase of interferograms, respectively. We intentionally set the servo control at low bandwidth, resulting in severe interferograms' fluctuation to demonstrate the capability of the proposed correction method. The envelope phase of each interferogram was estimated by a quadratic fit of carrier peaks to correct timing fluctuation of interferograms in the time domain. After envelope phase correction on individual interferograms, we successfully demonstrated 1 Hz linewidth of RF comb-mode over 200 GHz optical spectral-bandwidth with 10-times signal-to-noise ratio (SNR) enhancement compared to the spectrum without correction. Besides, the group delay difference between two femtosecond pulses is successfully estimated through a linear slope of phase information.

• Journal of Satellite, Information and Communications
• /
• v.12 no.4
• /
• pp.115-119
• /
• 2017

Intermodulation distortion degrades the S/N(signal-to-noise) of the original signal and also affects the adjacent channels. Intermodulation distortion is mainly caused by the nonlinear characteristics of the power amplifier. If the power amplifier with nonlinear characteristics has a memory effect, the intermodulation distortions occurred in the power amplifier are generated in various and complex forms. The predistorter is used as a way to improve intermodulation distortions. In order to efficiently utilize the performance of the predistorter, the memory effect of the power amplifier must be reduced. In this paper, we describe the design method of bias circuit to reduce the memory effect in power amplifiers. To reduce the memory effect, the bias circuit must have a high impedance for the signal and a low impedance for the envelope(modulating signal) and the second harmonic component of the signal. To verify the performance of the bias circuit designed considering the memory effect, a power amplifier operating at 170 ~ 220MHz was designed and implemented. The designed bias circuit has a large impedance in the operating frequency band and low impedance in the envelope signal and the second harmonic of the signal. As a result of the performance measurement, it was found that the asymmetric intermodulation distortion component is improved by 3.7dB.

• Journal of the Ergonomics Society of Korea
• /
• v.30 no.6
• /
• pp.689-694
• /
• 2011

Objective: The aim of this study is to evaluate the fluctuation of signal amplitude during repetitive dynamic contraction based on surface electromyography(EMG). Background: The most previous studies were considered isometric muscle contraction and they were difference to smoothing window length by moving average filter. In practical, the human movement is dynamic state. Dynamic EMG signal which indicated as the nonstationary pattern should be analyzed differently compared with the static EMG signal. Method: Ten male subjects participated in this experiment, and EMG signal was recorded by biceps brachii, anterior/posterior deltoid, and upper/lower trapezius muscles. The subject was performed to repetitive right horizontal lifting task during ten cycles. This study was considered three independent variables(muscle, amplitude processing technique, and smoothing window length) as the within-subject experimental design. This study was estimated muscular activation by means of the linear envelope technique(LE). The dependent variable was set coefficient of variation(CV) of LE for each cycle. Results: The ANOVA results showed that the main and interaction effects between the amplitude processing technique and smoothing window length were significant difference. The CV value of peak LE was higher than mean LE. According to increase the smoothing window length, this study shows that the CV trend of peak LE was decreased. However, the CV of mean LE was analyzed constant fluctuation trend regardless of the smoothing window length. Conclusion: Based on these results, we expected that using the mean LE and 300ms window length increased reproducibility and signal noise ratio during repetitive dynamic muscle contraction. Application: These results can be used to provide fundamental information for repetitive dynamic EMG signal processing.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.12 no.7
• /
• pp.1086-1093
• /
• 2001

A new linearization technique for RF high-power amplifiers(HPAs) using n-th order error signal generator (ESGn) is proposed. The n-th order ESG generates an error signal based on the complex envelope transfer characteristics of the HPA, which is combined at the output of the HPA. Therefore, the higher-order nonlinearlities are not affected by the ESG$\_$n/ and the stability of the linearized system is guaranteed due to the inherent open-loop configuration. Moreover, the output delay loss can be avoided, because the error signal is generated with the input signal of the HPA. The IMD(intermodulation distortion) improvement obtained applying the ESG$\_$7/ to 5 W class A HPA in cellular band demonstrates the feasibility of the proposed postdistortion system.

• Structural Monitoring and Maintenance
• /
• v.4 no.2
• /
• pp.115-131
• /
• 2017

Classical flutter of wind turbine blades indicates a type of aeroelastic instability with fully attached boundary layer where a torsional blade mode couples to a flapwise bending mode, resulting in a mutual rapid growth of the amplitudes. In this paper the monitoring problem of onset of flutter is investigated from a detection point of view. The criterion is stated in terms of the exceeding of a defined envelope process of a specific maximum torsional vibration threshold. At a certain instant of time, a limited part of the previously measured torsional vibration signal at the tip of blade is decomposed through the Empirical Mode Decomposition (EMD) method, and the 1st Intrinsic Mode Function (IMF) is assumed to represent the response in the flutter mode. Next, an envelope time series of the indicated modal response is obtained in terms of a Hilbert transform. Finally, a flutter onset criterion is proposed, based on the indicated envelope process. The proposed online flutter monitoring method provided a practical and direct way to detect onset of flutter during operation. The algorithm has been illustrated by a 907-DOFs aeroelastic model for wind turbines, where the tower and the drive train is modelled by 7 DOFs, and each blade by means of 50 3-D Bernoulli-Euler beam elements.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.10 no.1
• /
• pp.49-56
• /
• 2006

In this paper, to overcome the effect of nonlinear power amplifier, CE-CPSK(Constant Envelope Continuous Phase Shift Keying)modulation method which has the constant envelope and continuous phase characteristics is proposed. The code acquisition performances of the CE-CPSK modulated system and BPSK system are analyzed. And the performance is evaluated in terms of mean acquisition time and detection probability with the output backoff of the amplifier in multiuser environment. Results performed in a channel having a high degree of AM nonlinearity(AM-to-AM conversion), have shown that the CE-CPSK signal, when passed through class C-nonlinear Amplifier, has a spectrum with greatly reduced sidelobes compared to the conventional BPSK signal. The code acquisition performance of a CE-CPSK modulation system is better than that of BPSK system with nonlinear amplified multiuser environments.