• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.22 no.5
• /
• pp.213-217
• /
• 2012

Carbon coils could be synthesized on nickel catalyst layer-deposited silicon oxide substrate using $C_2H_2$ and $H_2$ as source gases under thermal chemical vapor deposition system. By the incorporation of $SF_6$ additive in cyclic modulation manner, the dominant formation of the nanosized carbon coils could be achieved with maintaining the minimized sulfur additive amount. The geometry variation of the as-grown carbon coils, such as linear type, microsized coil type, wavelike nanosized coil type, and nanosized coil type, were investigated according to the different cyclic modulation manner of $SF_6$ flow. $SF_6$ gas incorporation develops the coil-type geometry. Furthermore, the higher flow rate of $SF_6$ gas increased the amount of the nanosized carbon coils. The slightly increased etching ability by $SF_6$ addition seems to be the cause for these results.

• Transactions of Materials Processing
• /
• v.4 no.3
• /
• pp.257-266
• /
• 1995

A simulation method based on upper bound method is developed in order to characterize forging characters in forging of spur gears. In this paper, utilizing a kinematically admissible velocity field and applying it to investigate the effect of inner diameter of holow billet. In the analysis, to predict the variation of inner diameter of hollw billet, neutral surface has been introduced. The neutral surface of each step is assumed as a circle and determined in order to have minimum forging energy by golden section method. By this method, the variation of inner diameter of billet during spur gear forging is successfully predicted. As a result, the selection of inner diameter of initial billet is very important to reduce the forging load.

• 한국신재생에너지학회:학술대회논문집
• /
• 2009.11a
• /
• pp.478-481
• /
• 2009

As a first step for aerodynamic analysis of vertical axis wind turbine, dynamic stall characteristics of airfoil was investigated. Dynamic stall of wind turbine airfoil is caused by severe variation of angle of attack and relative velocity of flow around airfoil. Angle of attack and relative velocity can be expressed with tip speed ratio. Variation of angle of attack is strongly dependent on the tip speed ratio. For tip speed ratio, 1.4 and free stream velocity, 15m/s, dynamic stall characteristics of wind turbine airfoil is compared with those of oscillating airfoil having same angle of attack variation.

• International Journal of Aeronautical and Space Sciences
• /
• v.17 no.2
• /
• pp.175-183
• /
• 2016

A poroelastic composite material, containing different material phases and filled with fluids, serves as a model to formulate the overall ablative behaviors of such materials. This article deals with the assessment of variation in nondeterministic poroelastic properties of two-phase composite materials using micromechanical representative volume element (RVE) models. Considering the configuration and arrangement of pores in a matrix phase, various RVEs are modeled and analyzed according to their porosity. In order to quantitatively investigate the effects of microstructure, changes in effective elastic moduli and poroelastic parameters are measured via finite element (FE) analysis. The poroelastic parameters are calculated from the effective elastic moduli and the pore-pressure-induced strains. The reliability of the numerical results is verified through image-based FE models with the actual shape of pores in carbon-phenolic ablative materials. Additionally, the variation of strain energy density is measured, which can possibly be used to evaluate microstress concentrations.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.10 no.2
• /
• pp.100-106
• /
• 2010

The impact of surface quantization on device parameters of a Si metal oxide semiconductor (MOS) capacitor has been analyzed in the present work. Variation of conduction band bending, position of discrete energy states, variation of surface potential, and the variation of inversion carrier concentration at charge centroid have been analyzed for different gate voltages, substrate doping concentrations and oxide thicknesses. Oxide thickness calculated from the experimental C-V data of a MOS capacitor is different from the actual oxide thickness, since such data include the effect of surface quantization. A correction factor has been developed considering the effect of charge centroid in presence of surface quantization at strong inversion and it has been observed that the correction due to surface quantization is crucial for highly doped substrate with thinner gate oxide.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.25 no.8
• /
• pp.82-87
• /
• 2011

Induction motor is most widely used as the driving power in the industrial site. Induction motor current is composed of two parts, magnetizing current and load current. Load current uses energy what is doing the work. Load current varies with load variance but magnetizing current is constant, regardless of load variation. Magnetizing current needs for establishing the rotating magnetic field of induction motor and lags behind the voltage. Generally capacitor is used for power-factor compensation of inductive load. Self-excitation occurs when the capacitive reactive current from the capacitor is greater than the magnetizing current of the induction motor. When this occurs, excessive voltages can result on the terminals of the motor. This excessive voltage can cause insulation degradation and ultimately result in motor insulation failure. In this paper, we analyzed that how the magnetizing current and condenser current is operating at the allowable limit by the load variation. Condenser current is below allowable limit of magnetizing current but magnetizing current is above allowable limit at the lower load operation condition.

• 한국신재생에너지학회:학술대회논문집
• /
• 2006.06a
• /
• pp.206-209
• /
• 2006

In this paper, I try to measure the electrical characteristics of PV cell for lanterns with solar simulator and simulated with PC1D software. I keep my eye on the characteristics variation of PV cell as a temperature change. Therefore, I try to increase a temperature of controlled block from $10^{\circ}C$ to $50^[\circ}C$ while measuring the FV cell. As a result, A variation caused by voltage have an effect on the efficacy of PV cell. Hence it is an important variable when a designer plan to make a solar cell for lanterns.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.26 no.6
• /
• pp.1215-1220
• /
• 1997

This study was undertaken to estimate heath status, meal management, and seasonal variation of nutrient intake of rural women. The study was carried out in three seasons ; farming season(June), harvest season(October), nonfarming season(February). General characteristics, health status, and meal management of subjects were assessed using questionnaire and interview. Nutrient intake was measured by 24hr recall. Only 39.5% of subjects felt healthy. 21.1% of subjects often skipped meal each day. In farming & harvest seasons 92.1% of subjects participated in agriculture but 78.9% of subjects had the same or less appetite and 63.2% of subjects ate the same or less than usual. The mean intakes of energy and riboflavin in all seasons, calcium in June & February, and protein, vitamin A, and thiamin in February were below Recommended Dietary Allowances(RDA) for Koreans. All nutrient intake was significantly low in February but was not significantly different between in June and October.

• Structural Engineering and Mechanics
• /
• v.76 no.5
• /
• pp.591-598
• /
• 2020

Ultrasonic waves provide a non-destructive and sensitive way to monitor the concrete hydration. However, limited works are reported to monitor the evolution of the mechanical parameter at early ages. In this study, modified piezoelectric aggregates are embedded inside a concrete beam to excite and receive primary waves. A hydration index, namely, the variation of ultrasonic waveform (VUW) is developed to characterize the variation of the transmitted waves during the hydration process. The recorded hydration indices are compared with the compressive strength measured by destructive test at different ages. The results show that the VUW is closer to the compressive strength than the other two traditional hydration indices, ultrasonic velocity and wave packet energy. The proposed VUW provides a simple and accurate way to monitor the concrete hydration at early ages.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2003.03a
• /
• pp.647-654
• /
• 2003

This study investigated the effect of ultrasound on the permeability of the filter paper The investigation involves laboratory experiments, and the laboratory tests were conducted under abroad range of conditions Including energy levels of ultrasonic waves, time for treatment, and temperature. The results of the study show that sonication enhances the permeability of the filter paper significantly. The degree of enhancement varies with sonication power and duration of application. The effect of sonication on permeability with temperature variation and concentration of the test specimens seems not to be significant.