• Asian-Australasian Journal of Animal Sciences
• /
• 제13권7호
• /
• pp.948-956
• /
• 2000

The effect of high and low level of feed intakes on nutrient digestibility, nutrient losses through methane, energy and protein utilization by goats fed on alfalfa (Medicago sativa L.) pellets based diets was investigated in this study. Twelve castrated Japanese goats were employed in two subsequent digestion and metabolism trials. The goats were divided into three groups, offered three diets. Diet 1 consisted of 100% alfalfa pellet, Diet 2 was 70% alfalfa pellet and 30% corn, and Diet 3 was 40% alfalfa pellet and 60% corn. The two intake levels were high (1.6 times) and low (0.9 times) the maintenance requirement of total digestible nutrients (TON). Rumen ammonia nitrogen ($NH_3$-N) level of Diet 1 was lower (p<0.001) compared to Diets 2 and 3, but the values were always above the critical level (I50 mg/liter), The pH values of rumen liquor ranged from 6.02 to 7.30. Apparent digestibility of nutrient components did not show differences (p>0.05) between the two intake levels but inclusion of corn significantly altered the nutrient digestibility. Diet 3 had highest (p<0.001) dry matter (DM), organic matter (OM), ether extract (EE) and nitrogen fee extract (NFE) digestibility followed by the Diet 2 and Diet 1. The crude protein (CP) digestibility values among the three diets were in a narrow range (70.1 to 70.8%). Crude fiber (CF) digestibility for Diet 3 was slight higher (p>0.05) than that for other two diets. When alfalfa was replaced by corn, there were highly significant (p<0.001) increases in DM, OM, EE and NFE apparent digestibility and a slight increase in the CF digestibility (p>0.05). There were no differences (p>0.05) in energy losses as methane ($CH_4$) and heat production among the diets but energy loss through urine was higher for the Diet 1. The total energy loss as $CH_4$ and heat production were higher for the high intake level but the energy loss as $CH_4$ per gram DM intake were same (0.305 kcal/g) between the high and low intake level. Retained energy (RE) was higher for Diet 3 and Diet 2. Nitrogen (N) losses through feces and urine were higher (p<0.001) for Diet 1. Consequently, N retention was lower (p>0.05) for Diet 1 and higher in Diets 3 and 2. It is concluded that inclusion of corn with alfalfa increased the metabolizable energy (ME) and RE, and retained N through reducing the energy and N losses. The high level of intake reduced the rate of nutrient losses through feces and urine.

• 대한전기학회논문지
• /
• 제39권7호
• /
• pp.653-667
• /
• 1990

Superconductor is consolidated, for required current capacity, with proper numbers of basic strands which are multifilamentary composites. Althouth superconductors are perfectly loss-free under DC conditions of current and field, AC losses occur under time-varying condition of the current and field. The AC losses are a controllable inherent characteristics of supercondectors. The AC losses dependent on the changing rate of current and field can be reduced by reducing the filament diameter. On the other hand, finer filament results in manufacturing cost increase. Therefore, in this paper optimization technique of superconductor for SMES is proposed from the viewpoint of AC loss reduction and manufacturing cost increase. The case study shows that the technique can be effectively used for the design of superconductor for SMES, appreciating the influence of various parameters related to superconductor itself and operating condition of SMES. As a result of the case study, it is confirmed that the technique is more effective for the design of superconductor for SMES for electric power power system stabilization rather then SMES for energy storage.

• 한국태양에너지학회 논문집
• /
• 제27권2호
• /
• pp.29-35
• /
• 2007

Monitoring system is constructed for evaluating and analyzing performance of installed 50kW grid-connected PV system and have been monitored since October 2005. As climatic and irradiation conditions have been varied through long-term operation, there is necessity for evaluating numerical values of PV(Photovoltaic) system performance to observe the overall effect of environmental conditions on their operation characteristics. This paper presents performance monitoring results and analysis on component perspective(PV array and power conditioning system) and global perspective(yield, losses) of PV system for one year monitoring periods.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2004년도 하계학술대회 논문집 B
• /
• pp.812-814
• /
• 2004

AC loss is one of the important parameters in (High Temperature Superconducting)HTS AC devices. Among the HTS AC power devices, the transformer is the essential part in the electrical power system. But unfortunately, the transformer is the worst HTS device concerning AC loss because of very large magnetization loss due to high magnetic field applied to the HTS wire. We calculated the magnetization losses in HTS pancake windings for transformer according to the operating temperature. Two kinds of arrangement of HTS pancake windings were adopted for calculation of AC losses of a shell type transformer, and the analysis results were presented and discussed.

• Journal of Mechanical Science and Technology
• /
• 제17권8호
• /
• pp.1185-1195
• /
• 2003

Heat losses from the receivers of a dish-type solar energy collecting system at the Korea Institute of Energy Research (KIER) are numerically investigated. It is assumed that a number of flat square mirrors are arranged on the parabolic dish structure to serve as a reflector. Two different types of receivers, which have conical and dome shapes, are considered for the system, and several modes of heat losses from the receivers are thoroughly studied. Using the Stine and McDonald model convective heat loss from a receiver is estimated. The Net Radiation Method is used to calculate the radiation heat transfer rate by emission from the inside surface of the cavity receiver to the environment. The Monte-Carlo Method is used to predict the radiation heat transfer rate from the reflector to the receiver. Tracing the photons generated, the reflection loss from the receivers can be estimated. The radiative heat flux distribution produced by a multifaceted parabolic concentrator on the focal plane is estimated using the cone optics method. Also, the solar radiation spillage around the aperture is calculated. Based on the results of the analysis, the performances of two different receivers with multifaceted parabolic solar energy collectors are evaluated.

• 한국환경과학회지
• /
• 제12권9호
• /
• pp.911-919
• /
• 2003

When the city water was heated for the optimum use of unused energy, the energy flows and losses were calculated and evaluated to improve the value of heated water systems at dwelling side. To obtain this purpose, it was simulated on heat flows under two conditions like with heat pumps or not and calculated the energy sayings. Furthermore, recycling water system was suggested for enhancing the value of heated water system. From this results, the energy flows without heat pumps showed that it was 3-4 percents of heat losses from pipes, 62 percents of energy savings from hot water uses and 34 percents of unutilized heat. When the heated water system adopt the recycling water system at dwelling side, it was improved 12 percents of total energy sayings.

• 전기학회논문지
• /
• 제59권1호
• /
• pp.40-45
• /
• 2010

In order to establish the electric distribution system economically and operate efficiently, it becomes important to calculate energy losses of the system more accurately. This importance is not only related for the engineering of utilities' power network but also for the consumers' electric system. The Distribution Loss Factor (DLF) is the fundamental element of calculating the energy losses occurred through the electric system including the electric lines and equipments. Up to now, the DLF is calculated by empirical formulas using the correlation between the DLF itself and Load Factor. However, these methods have some limitations to reflect the various characteristics of the system and the load. In this regard, the novel method proposed here is developed to yield more accurate result of DLF which actively interacting with the characteristics and load patterns of the system. The improvement of accuracy is very significant according to the results of verification presented at the end of this paper.

• 한국방재학회:학술대회논문집
• /
• 한국방재학회 2008년도 정기총회 및 학술발표대회
• /
• pp.401-404
• /
• 2008

The vegetation in the surrounding area of river is a primary factor to increase water level during flood. The influence of vegetation on the river flow in a bank has been investigated by using a hydraulic experiment. For a hydraulic experiment square-shaped piers are used as a model of unsubmerged rigid vegetation in a open channel. For fully developed uniform flows, the water elevation of the experiment was measured as varying the interval of piers and the porosity which presents the fraction of water flowing area in the cross-sectional area. The Manning's roughness coefficient, which implicates energy losses due to the vegetation, was obtained by using the experimental data. As a result, the energy losses were varied when the distance of piers and the porosity of area were changed, and the Manning's coefficient increased nonlinearly when a water elevation increased.

• International Journal of Air-Conditioning and Refrigeration
• /
• 제6권
• /
• pp.80-92
• /
• 1998

A third-order simulation model of a Vuilleumier{VM) heat pump has been developed. This model takes into account the major losses such as the heat conduction losses through regenerators and displacers, the pumping losses and the wall-to-gas heat transfer losses in active volumes, in addition to the heat exchanger and regenerator losses. The working volume was divided into 12 control volumes and the conservation equations of mass and energy were applied to each control volume. Pressure drops were considered in regenerators only. Thermodynamic behavior of the working gas in a VM heat pump was investigated and effects of the major losses and operating conditions on the performance of a VM heat pump were shown.

• KEPCO Journal on Electric Power and Energy
• /
• 제4권2호
• /
• pp.47-53
• /
• 2018

VSC technology is now well established in HVDC and is, in many respects, complementary to the older Line Commutated Converter (LCC) technology. Despite the various advantages of VSC technology, VSC HVDC stations have higher power losses than LCC stations. Although the relative advantages and disadvantages are well known within the industry, there have been very few attempts to quantify these factors on an objective basis. This paper describes methods to determine the operating losses of every component in the valve of VSC-HVDC system. The losses of the valve, including both conduction losses and switching losses, are treated in detail.