• Journal of ILASS-Korea
• /
• v.23 no.3
• /
• pp.128-135
• /
• 2018

In this study, the following conclusions could be obtained from the analysis of emissions contribution rates and features for contaminated emissions by 13,456 gasoline vehicles passed in the vehicle load test (ASM-idle) under the inspection year 2013 to 2017. It was confirmed that the contamination of the CO, HC, NOx by the displacement is reduced on over 3L engine. As a result of comparing the exhaust gas in the low speed idle mode and the AS2525 mode, the exhaust gas in the low speed idle mode was measured high. It is estimated that if ISG function is applied, emissions from idle condition will be reduced. NOx emissions were reduced when the engine power was above 200HP. It has been confirmed that the amount of exhaust emissions are significantly reduced for vehicles manufactured after 2004. As a result of analyzing the exhaust gas according to the season, it is judged that there is a correlation between HC and NOx according to the ambient temperature. The concentration of exhaust emission in vehicles with high accumulated distance increases, which is considered to be the result of aging of the vehicle.

• 한국연소학회:학술대회논문집
• /
• 2001.11a
• /
• pp.51-56
• /
• 2001

An experiment using preheated air in the coaxial diffusion flame burner was carried out in order to decrease NOx emission and improve the thermal efficiency. Preheated air combustion generally produces high NOx emissions but it was known very well to reduce NOx emission by diluting the combustion air with inert gas in preheated air combustion. In our study, $N_2$ gas was used for diluent and propane was utilized for fuel. We set the combustion air temperature on 300K, 500K, 700K, 900K and dilution level from 21% to 10% in terms of oxygen concentration. NOx emission increased along increment of combustion air temperature and decreased along increment of dilution level(lowering of oxygen concentration in combustion air). Flame-off limit with dilution level enhanced, flame length became longer and the location of maximum flame temperature became lower with increasing of combustion air temperature.

• Korean Management Science Review
• /
• v.29 no.2
• /
• pp.157-165
• /
• 2012

This paper researches on the effective and efficient logistics policy for the parcel express company. The paper derives new policy by considering the number of used vehicles, carbon emission amount, delivery completion time, etc. The maximum waiting of delivery is considered as the time limit T day. To verify the effectiveness of the derived policy, the data of 30 days is generated, and it was shown that the derived policy is very effective compared with the conventional one.

• Journal of the Korean Institute of Navigation
• /
• v.23 no.2
• /
• pp.61-66
• /
• 1999

It is being more and more difficult to suppress emissions from electronic products using PCB(Printed Circuit Board) to the limit. Therefore, the exact evaluation of the emission from PCB has been more important to reduce the required time and the cost at the design phase of the products, especially on board ship's equipments. This research has evaluated the emission radiated from PCB based on the theoretical approach of SDA(Spectral Domain Analysis), which is available to analyze microwave stripline, coplanar line, patch antenna, etc. According to the theoretical results, it has been clearly shown that the emission radiated from PCB is reduced as the thickness of PCB is thinner, the permittivity of PCB is higher, the length of stripline is shorter, and the frequency is lower.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2008.04a
• /
• pp.529-533
• /
• 2008

Recently in Korea, noise is one of the most important social issues because the living standard becomes more higher. Railway noise is also annoying one in our society, although railway has very positive role in our country. The major measures for mitigation of railway noise in Korea are rail welding and installation of noise barrier on the noisy area. But these measures have its own limit for the calm and comfortable living environment. In Europe the railway noise problem has been treated more systematically and aggressively, there has been emission noise standard for Trans-European rail network. In this paper, the trend of noise standard for railway vehicles will be reported and the check point for our country will be discussed.

• Analytical Science and Technology
• /
• v.5 no.3
• /
• pp.263-268
• /
• 1992

A plasma source with cylindrical microwave cavity was used as atomic emission detector for gas chromatography. Detection limits of several elements were determined for this system. Detection limits for bromine and sulfur were 0.46 pg/s and 0.51 ng/s, respectively. The plasma was stable at the range of flow rate of 10 to 20mL/min.

• Tribology and Lubricants
• /
• v.15 no.4
• /
• pp.328-334
• /
• 1999

Acoustic emission (AE) sensor was used to evaluate the wear-life of CrN-coated steel disks with 1 $\mu\textrm{m}$ and 4 $\mu\textrm{m}$ coating thickness. The relationship between Af and friction signal from scratch test and sliding test was investigated. The first spatting of CrN film was detected by AR signals in the early stage of coating failures, and overall failures by friction signals. Therefore, the conservative design for coating-life should be done using the results of AE signals. Using the percent contact load, the ratio of sliding normal load to the critical scratch load and the number of cycles to failure was measured to predict the wear-life of CrN film. On the wear-life dia-gram the percent contact loads and the number of cycles to failure showed a good linear relationship on the log coordinate. As the load percentage was decreased, the diagram showed that the wear-limits, at which the coated steels survived more than 35,000 cycles, were about 4∼5% of the critical scratch loads.

• Journal of the korean Society of Automotive Engineers
• /
• v.8 no.1
• /
• pp.29-39
• /
• 1986

The purpose of this study is to develop an exhaust gas recirculation valve for reduction of the NOx emission of the gasoline engine. In this study the back pressure modulated(BPM) EGR system was developed and tested for the 1.6$\ell$ gasoline engine. By this system 50% of NOx emission was reduced at 7% EGR rate. Fuel consumption and CO emission were not affected by EGR but HC was increased up to the level of allowable limit. Overall operation was satisfactory. As a result of this study, the technics for developing EGR valve and adjusting the engine for EGR have been established.

• Journal of Korean Society for Atmospheric Environment
• /
• v.28 no.4
• /
• pp.396-410
• /
• 2012

The purpose of this study is to quantify the contribution of high emitting vehicles to mobile emission inventories. Analyzed emission data include $NO_x$, HC, and CO results, which were measured through the vehicle Inspection and Maintenance (I/M) program in Seoul metropolitan area. The high emitting vehicles were identified as the top 5% worst polluting cars of the fleet. We estimated that 5% of the gasoline passenger car fleet, which is high emitters, generated 25.5% of $NO_x$, 34.5% of HC, and 66.1% of CO emissions of total inventories for gasoline passenger car fleet in year 2010. In the study, we identified that the older vehicles (older than ten years) and high mileage vehicles (more than 120,000 km driven) comprised high emitter fleet with 70.9% and 71.2%, respectively. The emission contribution of high emitters became larger in younger fleet than in the older fleet. This is due to the reduced emission rates in newly manufactured vehicles, which were developed under the more stringent emission regulation limits. This analysis implies that high emitters could be responsible for an even larger fraction of total vehicular emissions as more advanced technology vehicles are being incorporated into the current vehicle fleet. The findings suggested that the high emitting vehicles should be primarily considered for in-use vehicle emission management program, such as I/M, accelerated vehicle retirement, or catalytic converter replacement, in order to enhance the effectiveness of selected program.

• Korean Journal of Agricultural and Forest Meteorology
• /
• v.24 no.4
• /
• pp.285-294
• /
• 2022

In order to accurately calculate greenhouse gas emissions in the agricultural field, Korea has been developing national-specific emission factors through direct measurement of gas fluxes using the closed-chamber method. In the rice paddy, only national-specific emission factors for methane (CH₄) have been developed. It is thus necessary to develop those for nitrous oxide (N₂O) affected by the application of nitrogen fertilizer. However, since the concentration of N₂O emission from rice cultivation is very low, the QA/QC methods such as method detection and practical quantification limits are important. In this study, N₂O emission from a rice paddy was evaluated affected by the amount of nitrogen fertilizer, by taking into account both method detection and practical quantification limits for N₂O concentration. The N₂O emission from a rice paddy soils affected by the nitrogen fertilizer application was estimated in the following order. The method detection limit (MDL) of N₂O concentration was calculated at 95% confidence level based on the pooled standard deviation of concentration data sets using a standard gas with 98 nmol mol^-1 N₂O 10 times for 3 days. The practical quantification limit (PQL) of the N₂O concentration is estimated by multiplying 10 to the pooled standard deviation. For the N₂O flux data measured during the rice cultivation period in 2021, the MDL and PQL of N₂O concentration were 18 nmol mol^-1 and 87 nmol mol^-1, respectively. The measured values above the PQL were merely about 12% of the total data. The cumulative N₂O emission estimated based on the MDL and PQL was higher than the cumulative emission without nitrogen fertilizer application. This research would contribute to improving the reliability in quantification of the N₂O flux data for accurate estimates of greenhouse gas emissions and uncertainties.