• Korean Journal of Soil Science and Fertilizer
• /
• v.42 no.3
• /
• pp.214-221
• /
• 2009

Denitrification efficiency associated with incorporation of the diffrent carbon substrates with the anaerobic sludge was investigated. For this each kinetic constant such as methane reaction and specific denitrification rate (SDNR) were determined in each treated sludge. In the pure methanogenesis, the specific methanogenesis activity (SMA) value was the highest at $0.76COD/g\;VSS{\cdot}day$ when the acetate was incorporated with the anaerobic sludge which has already been adapted at consistent C/N ratio 5 for reatively higher denitrifier population. The anaerobic dinitrificaition and methanogenesis reaction were dependent on both the types of carbon substrate and sludge showing the higher denitrificaition reaction constant at $1.96hr^{-1}$ with incorporation of acetate with the anaerobic sludge at C/N ratio 5 than any other carbon sources examined. When the glucose was introduced as electron donor for the anaerobic sludge adapted with different carbon substrates the SDNR showed the highest value with the sludge adapted to glucose followed by the sludge adapted to piggery sludge and acetate.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.38 no.2
• /
• pp.114-121
• /
• 2001

A circuit model for active-controlled field emitter array(ACFEA) as an electron source of active-controlled field emission display(ACFED) has been proposed. The ACFEA with hydrogenated amorphous silicon thin-film transistor(a-Si:H TFT) and Spindt-type molibdenum tips (Spindt-Mo FEA) has been fabricated monolithically on the same glass. A-Si:H TFT is used as a control device of field emitters, resulting in stabilizing emission current and lowering driving voltage. The basic model parameters extracted from the electrical characteristics of the fabricated a-Si:H TFT and Spindt-Mo FEA were implemented into the ACFEA model with a circuit simulator SPICE. The accuracy of the equivalent circuit model was verified by comparing the simulated results with the measured one through DC analysis of the ACFEA. The transient analysis of the ACFEA showed that the gate capacitance of FEA along with the drivability of TFT strongly affected the response time. With the fabricated ACFEA, we obtained a response time of 15$mutextrm{s}$, which was enough to make 4bit/color gray scale with the pulse width modulation (PWM).

• Journal of the Korean Ceramic Society
• /
• v.31 no.12
• /
• pp.1577-1587
• /
• 1994

TiO2 thin films with the substitution of oxygen with nitrogen were deposited on silicon substrate by metalorganic chemical vapor deposition (MOCVD) using Ti(OCH(CH3)2)4 (titanium tetraisopropoxide, TTIP) and N2O as source materials. X-ray diffraction (XRD) results indicated that the crystal structure of the deposited thin films was anatase TiO2 with only (101) plane observed at the deposition temperatures of 36$0^{\circ}C$ and 38$0^{\circ}C$, and with (101) and (200) plane at above 40$0^{\circ}C$. Raman spectroscopic results indicated that the crystal structure was anatase TiO2 in accordance with the XRD results without any rutile, fcc TiN, or hcp TiN structure. No fundamental difference was observed with temperature increase, but the peak intensity at 194.5 cm-1 increased with strong intensity at 143.0 cm-1 for all samples. The crystalline size of the films varied from 49.2 nm to 63.9 nm with increasing temperature as determined by slow-scan XRD experiments. The refractive index of the films increased from 2.40 to 2.55 as temperature increased. X-ray photoelectron spectroscopy (XPS) study showed only Ti 2s, Ti 2p, C 1s, O 1s and O 2s peaks at the surface of the film. The composition of the surface was estimated to be TiO1.98 from the quatitative analysis. In the bulk of the film Ti 2s, Ti 2p, O 1s, O 2s, N 1s and N 2s were detected, and Ti-N bonding was observed due to the substitution of oxygen with nitrogen. A satellite structure was observed in the Ti 2p due to the Ti-N bonding, and the composition of titanium nitride was determined to be about TiN1.0 from the position of the binding energy of Ti-N 2p3/2 and the quatitative analysis. The spectrum of Ti 2p energy level could be the sum of a 4, 5, or 6 Gaussian curve reconstruction, and the case of the sum of the 6 Gaussian curve reconstruction was physically most meaningful. From the results of Auger electron spectroscopy (AES), it was known that the composition was not varied significantly throughout the whole thickness of the film, and silicon oxide was not observed at the interface between the film and the substrate. The composition of the film was possible (TiO2)1-x.(TiN)x or TiO2-2xNx and in this experimental condition x was found to be about 0.21-0.16.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.3 no.1
• /
• pp.18-25
• /
• 1978

The 1/f noise spectrum of short-circuited output drain current due to the Shockley-Read-Hal] recombination centers with a single lifetime in homogeneous nondegenerate MOS-field effcte transtors with n-type channel is calculated under the assumptions that the quasi-Fermi level for the carriers in each energy band can not be defined if we include the fluctuation for time varying quantities. and so 1/f noise is a majority carrier effect. Under these assumptions the derived 1/f noise in this paper show some essential features of the 1/f noise in MOS-field effect transistors. That is, it has no lowfrequency plateau and is proportionnal to the channel cross area A and to the driain bias voltage Vd and inversely proportional to the channel length L3 in MOS field effect transistors. This model can explain the discrepancy between the transition frequency of the noise spectrum from 1/f- response to 1/f2 and the frequency corresponding to the relaxation time related to the surface centers in p-n junction diodes. In this paper the results show that the functional form of noise spectrum is greatly influenced by the functional forms of the electron capture probability cn (E) and the relaxation time r (E) for scattering and the case of lattice scattering show to be responsible for the 4 noise in MOS fold effect transistors. So we canconclude that the source of 1/f noise is due to lattice scattering.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.33 no.1
• /
• pp.152-157
• /
• 2004

Physicochemical characteristics of rice milled by newly designed abrasive milling machine were studied. Crude protein and crude lipid contents were 7.81∼8.50% and 1.07∼0.95%, respectively, and they showed a tendency to decrease with milling times. However, they showed higher values than that of polished rice. Major fatty acids of crude lipid were palmitic acid, oleic acid, and linoleic acid. Whiteness of tested samples was higher than brown rice but lower than polished rice. The remain rate of rice germ of four pass-through and polished one time sample (FPS) was 39.33%, and it was higher than that of polished rice (4.00%). One thousand grain weight of samples over than three pass-through was significantly different from brown rice (p<0.05). FPS had smooth surface similar to polished rice and it showed some residual rice germ by scanning electron microscopy. Sensory evaluation showed that the taste of three pass-through rice, four pass-through rice, and FPS was not significantly different from polished rice, whereas their color, odor, texture, and overall acceptability had lower score than polished rice but higher than brown rice. Therefore, we estimate that rice ground over three pass-through by newly designed abrasive milling machine might be a good source having nutritive value.

• Korean Chemical Engineering Research
• /
• v.49 no.2
• /
• pp.250-255
• /
• 2011

In this study, by using the polymeric membrane separation process, the $CO_{2}/CH_{4}$ separation and $H_{2}S$ removal from biogas were performed in order to $CH_{4}$ purification and enrichment for the fuel cell energy source application. Fibers were spun by dry/wet phase inversion method. The module was manufactured by fabricating fibers after surface coating with silicone elastomer. The scanning electron microscopy(SEM) studies showed that the produced fibers typically had an asymmetric structure; a dense top layer supported by a porous, sponge substructure. The permeance of $CO_{2}$ and $CO_{2}/CH_{4}$ selectivity increased with pressure and temperature. Mixture gas with increasing pressure and temperature, removal efficiency of the $CO_{2}$ and $H_{2}S$ were decreased while concentration of $CH_{4}$ was increased up to 100%. When retentate flow rate was increased with the decreasing of pressure and temperature the $CH_{4}$ recovery ratio in retentate side was increased while the $CH_{4}$ purity in retentate side was decreased.

• Journal of Radiation Protection and Research
• /
• v.4 no.1
• /
• pp.14-20
• /
• 1979

For accurate and easily shielding irregular shaped organ, its minimized penumbra region and a low melting point alloy 'Lead Y' and synchronizing instrument have been developed. The 'Lead Y' is the quaternary eutectic alloy and it is composed of Lead 30.0% Tin 11.5% Bismuth 48 5% Cadmium 10.0% The density of its at $22^{\circ}C$ is $9.8g/cm^3$ and the melting temperature has $40^{\circ}C\;to\;68^{\circ}C$. The thickness of 'Lead Y' for perfect shielding of Co-60 gamma ray and LINAC 10MeV x-ray is 6cm and 7cm respectively. The 'Lead Y' shielding block is casted directly on the styrofoam from which is cut with hot wire of synchronizer device. The special features and advantages of the Lead Y shielding block could be summarized as follows; 1. The shielding block for radiotherapy is rapidly processed only with boiling water and styrofoam. 2. It is not injure one's health and not danger of a fire, because of not generating of any metals vapor and evil smelling. 3. It is very effective to minimize secondary penumbra for the protection of healthy tissue from unnecessary ionizing radiation regardless of the magnification source to skin distance. 4. The HVL of the Lead Y is 1.2cm for Co-60 gamma ray and it's shielding effect is almost same as the pure lead block. 5. The hardness of Lead Y is 1.5 times higher than lead block. 6. It's reavailability is higher than lead block and then one block of Lead Y is reavailable about 30 to 40 times. 7. It is usefull for shielding of x-ray, gamma ray, beta-ray, electron and neutron radiation. 8. The materials for Lead Y are easy to acquire with reasonable price and tractable.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.36 no.12
• /
• pp.1491-1496
• /
• 2007

As an oriental medicinal plant, wild grape (WG, Vitis coignetiae) has been known to contain abundant nutrients compared to grape (Vitis vinifera L.) and as a source of stilbenes, a kind of polyphenol. This study was performed to investigate the antioxidative activity of WG extracts by measuring electron donating ability (EDA), nitrite scavenging ability (NSA), super oxide dismutase (SOD)-like activity and total polyphenol content (TPC). The extracts were obtained using microwave-assisted extraction (microwave power: 90 W, extraction time: 5 min, extractant: water, 50 and 100% ethanol). EDAs, SOD-like activities and TPCs were the highest at 50% ethanol extracts while conversely lowest at 100% ethanol extracts. EDAs of 50% and 100% ethanol extracts at 1.6 g/dL concentration, $97.70{\pm}0.55\;and\;98.05{\pm}0.36%$, were higher than those of 0.1 and 1% L-ascorbic acids, $101.44{\pm}0.98%\;and\;99.43{\pm}0.78%$, respectively. At the concentration of 1.6 g/dL, 50% ethanol extract showed lower NSA (pH 1.2) than water extract unlike EDA, TPC and SOD-like activity. Regarding TPCs of WG extracts, the activities were the highest at 50% ethanol extracts (1.6 g/dL: $38.76{\pm}0.23$ mM gallic acid equiv.) followed by water and 100% ethanol extracts. The results suggest the usefulness of developing functional foods using antioxidative active compounds of WG with high polyphenol contents.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.35 no.6
• /
• pp.585-592
• /
• 2011

The enhancement of the cold-start capability of polymer electrolyte fuel cells is of great importance in terms of the durability and reliability of fuel-cell vehicles. In this study, vanadium oxide films deposited onto the flat surface of metallic bipolar plates were synthesized to investigate the feasibility of their use as an efficient self-heating source to expedite the temperature rise during startup at subzero temperatures. Samples were prepared through the dip-coating technique using the hydrolytic sol-gel route, and the chemical compositions and microstructures of the films were characterized by X-ray diffraction, X-ray photoelectron spectroscopy, and field-emission scanning electron microscopy. In addition, the electrical resistance hysteresis loop of the films was measured over a temperature range from -20 to $80^{\circ}C$ using a four-terminal technique. Experimentally, it was found that the thermal energy (Joule heating) resulting from self-heating of the films was sufficient to provide the substantial amount of energy required for thawing at subzero temperatures.

• Korean Journal of Food Science and Technology
• /
• v.38 no.5
• /
• pp.684-690
• /
• 2006

Eriobotrya japonica has been used as a folk medicine for treatment of skin diseases, inflammation, coughing, phlegm, and ulcers in Korea and other Asian countries. In a search for possible bioactive agents from natural sources, we found that the methanolic extracts from various parts of E. japonica showed moderate antioxidative and antimicrobial activities in several in vitro bioassay systems. Additionally, the respective parts of E. japonica were irradiated at 20 kGy to investigate the effects of irradiation. Gamma irradiation of E. japonica extracts removed the deep greenish color without affecting its natural biological activities such as its antioxidative and antimicrobial properties. Based on these findings, the methanolic extracts of this plant source may be not affected by gamma irradiation as its bioactive constituents may be insensitive to this irradiation. Moreover, the methanolic extract of E. japonica may serve as a good natural resource for beneficial functions in food and other related industries.