• Proceedings of the KIEE Conference
• /
• 2006.07b
• /
• pp.1203-1204
• /
• 2006

Recently, utility network is getting more and more complicated and huge. In addition to, demands of power conversion devices which have non-linear switching devices are getting more and more increased. Consequently, according to the non-linear power semiconductor devices, current harmonics are unavoidable. Those current harmonics flow back to utility network and become one of the reasons which make the voltage distortion. On the other hands, voltage sag from sudden increasing loads is also one of the terrible problems inside of utility network. In order to compensate the current harmonics and voltage sag problem, AF(Active Filter) systems could be a good solution method and SMES(Superconducting Magnetic Energy Storage) system is a very good promising source due to the high response time of charge and discharge. Therefore, the combined system of AF and SMES is a wonderful device to compensate both harmonics current and voltage sag. However, unfortunately SMES needs a superconducting magnetic coil. Because of the introduction of superconducting magnetic coil, quench problem caused by unexpected reasons is always existed. In case of discharge operation, quench is a significantly harmful factor according as it decreases the energy capacity of SMES. Therefore, this paper presents a decision method of the specification of the AF-SMES system considering internal fault condition. Especially, authors analyzed the change of the original energy capacity of SMES regarding to the size of resistance caused by quench of superconducting magnetic coil. Finally, based on this simulation, authors manufactured actual Active Filter System using DSP.

• Korean Journal of Materials Research
• /
• v.21 no.10
• /
• pp.546-549
• /
• 2011

Nano-sized $SnO_2$ thick films were prepared by a screen-printing method onto $Al_2O_3$ substrates. The sensing characteristics were investigated by measuring the electrical resistance of each sensor in a test box as a function of the detection gas. The nano-sized $SnO_2$ thick film sensors were treated in a $N_2$ atmosphere. The structural properties of the nano $SnO_2$with a rutile structure according to XRD showed a (110) dominant $SnO_2$ peak. The particle size of $SnO_2$:Ni nano powders at Ni 8 wt% was about 45 nm, and the $SnO_2$ particles were found to contain many pores according to the SEM analysis. The sensitivity of the nano $SnO_2$-based sensors was measured for 5 ppm $CH_4$ gas and $CH_3CH_2CH_3$ gas at room temperature by comparing the resistance in air with that in the target gases. The results showed that the best sensitivity of $SnO_2$:Ni and $SnO_2$:Co sensors for $CH_4$ gas and $CH_3CH_2CH_3$ gas at room temperature was observed in $SnO_2$:Ni sensors doped with 8 wt% Ni. The response time of the $SnO_2$:Ni gas sensors was 10 seconds and recovery time was 15 seconds for the $CH_4$ and $CH_3CH_2CH_3$ gases.

• Polymer(Korea)
• /
• v.31 no.3
• /
• pp.194-200
• /
• 2007

The resistive-type polymeric humidity sensors were prepared from the copolymers of [2- [(methacryloyloxy)ethyl] dimethyl] propylammonium bromide(MEPAB), [2- [(methacryloyloxy)ethyl]-2-hydroxyethyl]dimethylmonium bromide (MEHDAB), n-butyl methylacrylate(MBA), 2-hydroxyethyl methylacrylate(HEMA) and styrene. Four kinds of copolymers, ie, MEPAB/styrene/MEHDAB MEHDAB/BMA/HEMA, MEPAB/BMA/MEHDAB, and MEPAB/styrene/HEMA crosslinked with blocked-isocyanate on the Ag/Pd electrode/alumina substrate showed good durability at high humidities. The various electrical properties such as frequency dependency, temperature dependency, hysteresis, response time and water durability were examined. In the case of copolymer MEPAB/BMA/MEHDAB= 3/6/1, the resistance was varied from $2.9 M{\Omega}$ to $1.84k{\Omega}$ at $25^{\circ}C$ in the range of $30{\sim}90%RH$ and this copolymers showed a good linearity and low hysteresis.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2013.02a
• /
• pp.208-208
• /
• 2013

Graphene has emerged as a fascinating material for next-generation nanoelectronics due to its outstanding electronic properties. In particular, graphene-based field effect transistors (GFETs) have been a promising research subject due to their superior response times, which are due to extremely high electron mobility at room temperature. The biggest challenges in GFET applications are control of carrier concentration and opening the bandgap of graphene. To overcome these problems, three approaches to doping graphene have been developed. Here we demonstrate the decoration of Ni nanoparticles (NPs) on graphene films by simple annealing for p-type doping of graphene. Ni NPs/graphene films were fabricated by coating a $NiCl2{\cdot}6H2O$ solution onto graphene followedby annealing. Scanning electron microscopy and atomic force microscopy revealed that high-density, uniformly sized Ni NPs were formed on the graphene films and the density of the Ni NPs increased gradually with increasing $NiCl2{\cdot}6H2O$ concentration. The formation of Ni NPs on graphene films was explained by heat-driven dechlorination and subsequent particlization, as investigated by X-ray photoelectron spectroscopy. The doping effect of Ni NPs onto graphene films was verified by Raman spectroscopy and electrical transport measurements.

• The Korean Journal of Physiology and Pharmacology
• /
• v.3 no.3
• /
• pp.237-244
• /
• 1999

Magnesium ion is known to selectively block the N-methyl-D-aspartate (NMDA)-induced responses and to have anticonvulsive action, neuroprotective effect and antinociceptive action in the behavioral test. In this study, we investigated the effect of $Mg^{2+}$ on the responses of dorsal horn neurons to cutaneous thermal stimulation and graded electrical stimulation of afferent nerves as well as to excitatory amino acids and also elucidated whether the actions of $Ca^{2+}$ and $Mg^{2+}$ are additive or antagonistic. $Mg^{2+}$ suppressed the thermal and C-fiber responses of wide dynamic range (WDR) cell without any effect on the A-fiber responses. When $Mg^{2+}$ was directly applied onto the spinal cord, its inhibitory effect was dependent on the concentration of $Mg^{2+}$ and duration of application. The NMDA- and kainate-induced responses of WDR cell were suppressed by $Mg^{2+}$, the NMDA-induced responses being inhibited more strongly. $Ca^{2+}$ also inhibited the NMDA-induced responses current-dependently. Both inhibitory actions of $Mg^{2+}$ and $Ca^{2+}$ were additive, while $Mg^{2+}$ suppressed the EGTA-induced augmentation of WDR cell responses to NMDA and C-fiber stimulation. Magnesium had dual effects on the spontaneous activities of WDR cell. These experimental findings suggest that $Mg^{2+}$ is implicated in the modulation of pain in the rat spinal cord by inhibiting the responses of WDR cell to noxious stimuli more strongly than innocuous stimuli.

• Journal of KIISE:Computer Systems and Theory
• /
• v.28 no.12
• /
• pp.674-684
• /
• 2001

This paper presents the SIC(Size-Interval-Count) prefetching scheme that can record the file access patterns of applications within a relatively small space of memory based on the repetitiveness of the file access patterns. Several knowledge-based prefetching methods were recently introduced, which includes high correctness in predicting future accesses of applications. They records the access patterns of applications and uses recorded access pattern information to predict which blocks will be requested next. Yet, these methods require to much memory space. Accordingly, the proposed method then uses the recorded file access patterns, referred to as "SIC access pattern information", to correctly predict the future accesses of the applications. The proposed prefetching method improved the response time by about 40% compared to the general file system and showed remarkable memory efficiency compared to the previously knowledge-based prefetching methods.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.37 no.8
• /
• pp.42-47
• /
• 2000

Long-wavelength infrared (LWIR) detectors made of self-assembled quantum dots embedded in the channel region of high electron mobility transistor (HEMT) is demonstrated. Above 180 K, the detector shows low dark currents due to strong confinement effect of electrons in InAs quantum dots and exhibits the broad spectral response ranging from 7 mm to 11 mm. The peak detectivity ($D^*$) of $1.93{\times}10^{10}cmHz^{1/2}/W$ is obtained at 9.4 mm. The photocurrent characteristics as a function of applied bias are similar to that of normal FETs, while the photocurrent decreases as the applied electric field exceeds $2{\times}10^3V/cm$ because of the increased dark current.

• Journal of the Korean Institute of Telematics and Electronics S
• /
• v.35S no.10
• /
• pp.175-185
• /
• 1998

In this paper, we studied some design methodologies of typical FIR filters based on the peak-error constrained least square criterion which was first introducedd by Adams in 1991. This method is a mixed type of the classical least squared error method(LSM) and the so-called min-max error method (MMM). And by considering both the least squared error as well as the maximum error, the solution, i.e. the impulse response of the filter, can be found only when the restrictions on maximum gain, transition bandwidth, and the squared error are satisfied simultaneously under some trade-off conditions. We used the multiple exchange algorithms for optimization procedure and applied the design methodology to the cases of the multiband filter, the differentiator, and the Hilbert transformer by taking the balance of two design criteria into account. The results show that the peak-error constrained least weighted square error design method(PLEM) is superior in performance to the existing LSM and MMM from both the squared error and the maximum error standpoints. And it is verified that PLEM can be applied to not only the case of simple low pass filter, but also to various types of FIR filters.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.53 no.1
• /
• pp.29-35
• /
• 2016

We have demonstrated a $Ti:LiNbO_3$ electro-optic electric-field sensors utilizing a $1{\times}2$ Y-fed balanced-bridge Mach-Zehnder interferometric (YBB-MZI) modulator which uses a 3-dB directional coupler at the output and dipole patch antenna. The operation and design were proved by the BPM simulation. A dc switching voltage of ~16.6 V and an extinction ratio of ~14.7 dB are observed at a wavelength of $1.3{\mu}m$. For a 20 dBm rf power, the minimum detectable electric-fields are ~1.12 V/m and ~3.3 V/m corresponding to a dynamic range of about ~22 dB and ~18 dB at frequencies 10 MHz and 50 MHz, respectively. The sensors exhibit almost linear response for the applied electric-field intensity from 0.29 V/m to 29.8 V/m.

• Journal of Korean Society of Industrial and Systems Engineering
• /
• v.40 no.4
• /
• pp.10-20
• /
• 2017

The proportion of software in the automotive industry is steadily increasing due to the rapid technological development of automobile E/E parts. Because the automotive E/E technology is now on the basis of intelligent automobile and advanced safety automobile technology. The purpose of this study is to investigate the effect of organizational capability (organizational resource capability and management capability), process capability (process capability, customer Requirement management capability), performance dimension (motivation, participation level). In this study, we conducted questionnaires and statistical analysis on engineers (members of the Korea Advanced Automotive Technology Association) who perform research and development activities in the R&D organization of the automotive E/E part in South Korea. ANOVA is applied for the verification of the difference in performance measured by organizational capability, process maturity, and motivation participation level according to company characteristics (level of processing : supply chain configuration, annual sales, total SW development ratio). According to the results of this study, in order to improve the performance of ASPICE or ISO 26262-related consulting project, a different consulting approach strategy considering the characteristics of organization and personnel is needed. In summary, the analysis results for the three main treatment levels are as follows. The difference in organizational capacity, process capability and performance was found to be statistically significant according to supply chain configuration and annual sales, but it was found that the difference of response according to the proportion of total SW was not significant.