• Journal of Power Electronics
• /
• 제9권6호
• /
• pp.960-968
• /
• 2009

This paper presents a design optimization process for interior permanent magnet synchronous motors (IPMSM) for hybrid electric compressors (HEC) which are applied to hybrid electrical vehicles. A hybrid electric compressor is composed of an electric motor driving section and an engine driving section which is connected to the engine by a pulley belt. A hybrid electric compressor driving motor requires half of the full driving power of a compressor. Even though an engine is not operated at the idling stop mode, the electric motor drives the air-conditioner compressor by itself so that the air conditioning system can produce its minimum cooling capacity. In this paper, the design optimization of an IPMSM for a 42 (V) applied voltage system is studied using the design of experiment (DOE) and response surface method (RSM) of 6sigma. The driving characteristics of this motor drive system are measured and analyzed by experiment.

• 한국자동차공학회논문집
• /
• 제21권1호
• /
• pp.92-98
• /
• 2013

There are lots of studies about hybrid electric vehicles (HEVs) because of the global warming and energy problems. Series and parallel HEVs are the common types of many developing hybrid vehicle types. Series HEV uses engine only as the generator for the battery but parallel HEV utilizes engine for driving and generating of the vehicle. In this paper, backward simulations based on dynamic programming were conducted for the fuel economy analysis of two different types of hybrid transit buses depending on driving cycles. It is shown that there is a relation between the type of HEV and the characteristics of driving cycles. Regarding the aggressiveness, the series hybrid bus is more efficient than the parallel system on highly aggressive driving cycle. On the other hand, the parallel hybrid bus is more efficient than the series system on low aggressive driving cycle. Based on this results of the paper, it is expected to choose more efficient type of the hybrid buses according to the driving cycle.

• 한국자동차공학회논문집
• /
• 제22권7호
• /
• pp.117-126
• /
• 2014

Recently, due to various environmental problems such as global warming, increasing of international oil prices and exhaustion of resource, a paradigm of world automobile market is rapidly changing from vehicles using internal combustion engine to eco-friendly vehicles using electric power such as EV (Electric Vehicle), HEV (Hybrid Electric Vehicle), PHEV (Plug-in Hybrid electric Vehicle) and FCEV (Fuel Cell Electric Vehicle). There are many driving cycles for performance evaluation of conventional vehicles. However there is a lack of researches on driving cycle for EV. This study is composed of part 1 and part 2. In this paper part 1, in order to develop urban driving cycle for performance evaluation of electric vehicles, Gwacheon-city patrol route of police patrol car was selected. Actual driving test was performed using EV. The driving data such as velocity, time, GPS information etc. were recorded. GUDC-EV (Gwacheon-city Urban Driving Cycle for Electric Vehicles) including road gradient was developed through the results of analyzing recorded data. Reliability of the driving cycle development method was substantiated through comparison of electricity performance. In the second part of this study, the developed driving cycle was compared to simulation result of the existing urban driving cycle. Verification of the developed driving cycle for EV performance evaluation was described.

• 한국기계가공학회지
• /
• 제16권4호
• /
• pp.69-75
• /
• 2017

In this study, the performances of five input split type hybrid electric vehicle sub-drivetrains were analyzed. The five sub-drivetrains consist of chain, helical gears and planetary gears. For the analyzing above five sub-drivetrains, the mathematical equations were derived. From the analysis, we found that the sub-drivetrain with chain shows slower acceleration performance and larger energy consumption on the city driving. And, the sub-drivetrain with only helical gear shows smallest energy consumption on the city driving. If the sub-drivetrain can change its gear speed, it shows fastest acceleration performance, but it has largest energy consumption on the city driving due to its additional auxiliary components.

• 제어로봇시스템학회:학술대회논문집
• /
• 제어로봇시스템학회 2005년도 ICCAS
• /
• pp.910-914
• /
• 2005

In this paper an optimal method based on fuzzy logic for controlling parallel hybrid electric vehicles is presented. In parallel hybrid electric vehicles the required torque for deriving and operating the on-board accessories is generated by a combination of internal-combustion engine and an electric motor. The powersharing between the internal combustion engine and the electric motor is the key point for efficient driving. This is a highly nonlinear and time varying plant and its control strategy will be implemented with the use of fuzzy logic controller. The fuzzy logic controller will be designed based on the state of charge of batteries and the desired torque for driving. The output of controller controls the throttle of the combustion engine. The main contribution of this paper is the development of an optimal control based on fuzzy logic, which maximizes the output torque of the vehicle while minimizing fuel consumed by the combustion engine.

• 융복합기술연구소 논문집
• /
• 제5권1호
• /
• pp.23-26
• /
• 2015

The purpose of present study is to analysis the Characteristics of fuel economy and Green house gases due to the driving mode conditions of The hybrid electric vehicle(HEV). HEVs are divided into mild and power types according to the their functions. mild type HEVs are inexpensive because they do not need to implement a pure electric mode. Power type HEVs are more expensive but has also better fuel efficiency. In the present paper, the test results for the gasoline vehicle using FTP-75 mode and HWFET are present.

• 한국군사과학기술학회지
• /
• 제17권2호
• /
• pp.159-166
• /
• 2014

The study is conducted on the subject of optimization of components sizing for series hybrid electric propulsion systems. The components sizing of series type hybrid system is very important because each component of series type is larger than the corresponding component of the parallel type or series-parallel type. If the components sizing is greater or less than what is required to this system, the performance of the system is getting worse. The methodology for the sizing of a driving motor is introduced based on the foundation of determined system configuration and performance target. And the sizing of an engine/generator and a battery is achieved based on simulation results using Dynamic Programming. It is possible to find the optimal sizing of these components by comparing fuel efficiency of hybrid electric propulsion system for 8 driving cycles.

• 한국군사과학기술학회지
• /
• 제15권4호
• /
• pp.366-373
• /
• 2012

In this paper, serious changes in the electromagnetic environment with increasing power and energy capabilities for electric driving and military mission are discussed. Design and control strategies on the Electro-Magnetic Compatibility(EMC) for the series hybrid electric vehicle are proposed to minimize the effects of electromagnetic interferences.

• 한국컴퓨터정보학회논문지
• /
• 제23권3호
• /
• pp.63-70
• /
• 2018

In this work, we analyze the relationship between the accumulated mileage of hybrid electric vehicle(HEV) and the data provided from vehicle parts. Data were collected while traveling over 70,000 Km in various paths. The data collected in seconds are aggregated for 10 minutes and characterized in terms of centrality, variability, normality, and so on. We examined whether the statistical properties of vehicle parts are different for each cumulative mileage interval of a hybrid car. When the cumulative mileage interval is categorized into =< 30,000, <= 50,000, and >50,000, the statistical properties are classified by the mileage interval as 82.3% accuracy. This indicates that if the data of the vehicle parts is collected by operating the hybrid vehicle for 10 minutes, the cumulative mileage interval of the vehicle can be estimated. This makes it possible to detect the abnormality of the vehicle part relative to the accumulated mileage. It can be used to detect abnormal aging of vehicle parts and to inform maintenance necessity.

• 에너지공학
• /
• 제18권1호
• /
• pp.31-36
• /
• 2009

환경친화적인 자동차 제조 방법에는 몇 가지 방법이 있다. 하이브리드 전기자동차는 가장 현실적인 방법일 것이다. 하이브리드 전기자동차는 내연기관과 전기장치의 두 가지 동력을 사용한다. 하이브리드 전기자동차는 연료소비와 배기가스 저감을 위해서 개발되었다. 저자들은 하이브리 전기자동차의 주요 동력원으로 디젤 기관을 선택했다. 테스트는 도심버스주행모드와 고속도로주행모드가 사용되었다. 본 연구는 직렬하이브리드 전기자동차, 병렬하이브리드 전기자동차, 플러그인 직렬 전기자동차와 플러그인 병렬 전기자동차에 따른 중형디젤 하이브리드 자동차의 연료경제성과 배기가스의 시뮬레이션의 결과를 제시하고 있다.