• 한국지하수토양환경학회지:지하수토양환경
• /
• 제20권6호
• /
• pp.95-102
• /
• 2015

The purpose of this study is to compare the degradation characteristics by subcritical water of RDX contaminated soil using batch mode and dynamic mode devices. First, upon application of RDX contaminated soil, RDX treatment efficiency was increased with increasing the temperature in both modes. At 150℃, the treatment efficiency was 99.9%. RDX degradation efficiency got higher with lower ratio of solid to liquid. However, the treatment efficiency in the dynamic mode tended to be decreased at a certain ratio of solid to liquid or lower. The treatment efficiency was increased when it took longer time for the reactions in both modes. As the results of analysis on concentration of treated water after subcritical water degradation, the RDX recovery rate of dynamic and batch modes at 150℃ was 10.5% and 1.5%, respectively. However, both modes showed very similar recovery rates at 175℃ or higher. RDX degradation products were analyzed in treated water after it was treated with subcritical water. According to the results, RDX degradation mechanism was mostly oxidation reaction and reduction reaction was partially involved. Therefore, it suggested that most of RDX in soil was degraded by oxidation of subcritical water upon extraction. According to this result, it was found that both batch and dynamic modes were very effectively applied in the treatment of explosive contaminated soil.

• Journal of Electrical Engineering and Technology
• /
• 제13권1호
• /
• pp.60-67
• /
• 2018

The presence of induction motor loads in a power system may cause the phenomenon of delayed voltage recovery after the occurrence of a severe fault. A high proportion of induction motor loads in the power system can be a significant influence on the voltage stability of the system. This problem referred to as FIDVR(Fault Induced Delayed Voltage Recovery) is commonly caused by stall of small HVAC unit(Heating, Ventilation, and Air Conditioner) after transmission or distribution system failure. This delayed voltage recovery arises from the dynamic characteristics associated with the kinetic energy of the induction motor load. This paper proposes the UVLS (Under Voltage Load Shedding) control strategy for dealing with FIDVR. UVLS based schemes prevent voltage instability by shedding the load and can help avoid major economic losses due to wide-ranging cascading outages. This paper review recent topic about under voltage load shedding and compare decentralized load shedding scheme with conventional load shedding scheme. The load shedding strategy is applied to an actual system in order to verify the proposed FIDVR mitigation solution. Simulations demonstrate the effectiveness of the proposed method in resolving the problem of delayed voltage recovery in the Korean Power System.

• 한국소성가공학회:학술대회논문집
• /
• 한국소성가공학회 2008년도 추계학술대회 논문집
• /
• pp.288-291
• /
• 2008

Physics based Cellular Automata model is developed and implemented into FEM code. CA model can predict microstructure evolution based on physical phenomena, such as hardening, recovery and recrystallization. This paper outlines the methodology to determine the materials constants for these different phenomena from simpler measurements.

• 한국섬유공학회:학술대회논문집
• /
• 한국섬유공학회 2001년도 가을 학술발표회 논문집
• /
• pp.175-178
• /
• 2001

일반적으로 점탄성 거동을 나타내는 고분자 액체의 전단유동특성(shear flow properties)을 평가하기 위하여 정상전단(steady shear), 동적전단(dynamic shear), 응력완화(stress relaxation) 그리고 크리프(creep) 및 크리프 회복(creep recovery) 실험 등이 활용되고 있다[1], 이때 영전단점도(zero shear viscosity)와 정상상태 회복 컴플라이언스(steady-state recoverable compliance)는 정상상태(steady state)에서 얻어지는 물리량으로, 각 실험방법으로부터 직접적 또는 간접적으로 측정이 가능하다. (중략)

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2014년도 춘계학술대회 논문집
• /
• pp.577-578
• /
• 2014

• 제어로봇시스템학회:학술대회논문집
• /
• 제어로봇시스템학회 1997년도 한국자동제어학술회의논문집; 한국전력공사 서울연수원; 17-18 Oct. 1997
• /
• pp.1520-1523
• /
• 1997

A rigorous dynamic simulation was performed in binary gas mixture H$_{2}$/CO (70:30 vol.%) to determinate start-up operating conditions of PSA(Pressure Swing Adsorption) processes. The rigorous dynamic model for the PSA process contains an Ergun equation for expressing the pressure drop in a bed, and valve equations to compute the boundary pressure change of the bed. As the result of the continuous dynamic simulation of 100 operating cyles in various initial conditions, the unsteady-state appeared in the early period and the cyclic steady-state came out about 20th cycle in feed condition and vaccum condition, and 30th cycle in pure H$_{2}$ condition. As time goes by valve equations made change the pressure at each end of the bed in ressurization, countercurrunt-depressurization and pressure equalization steps. The H$_{2}$ purity and the recovery is 99.99% and 86.73% respectively, which is slightly higher than the experimental data. Main contributiion of this study includes supplying fundamental technologies of handling combined variables PSA processes by developing rigorous models.

• 한국주조공학회지
• /
• 제22권1호
• /
• pp.11-16
• /
• 2002

Hot deformation behavior of GCD-50 cast iron has been investigated by employing the compressive test. Phenomenological deformation behaviors, which were modeled based on the dynamic materials model and the kinetic model, have been correlated with the microstructural change taken place during compression. Microstructural investigation revealed that the adiabatic shear band caused by the locallized deformation was taken place in low temperature and high strain rate. On the other hand, the wavy and curved grain boundaries, which repersent the occurrence of dynamic microstructure change such as dynamic recovery and dynamic recrystallization, were observed in high temperature and low strain rate. Deformation model based on hyperbolic sine law has also been suggested.

• 대한임베디드공학회논문지
• /
• 제8권5호
• /
• pp.243-248
• /
• 2013

Reliability evaluation is important task in embedded system. It can avoid potential failures and manage the vulnerable components of embedded system effectively. Dynamic fault tree analysis is one of the reliability evaluation methods. It can represent dynamic characteristics of a system such as fault & error recovery, sequence-dependent failures. In this paper, the steering system, which is embedded system in vehicles, is represented using dynamic fault tree. We evaluate the steering system using approximation algorithm based on Simpson's rule. A set of simulation results shows that proposed method overcomes the low accuracy of classic approximation method without requiring no excessive calculation time of the Markov chain method.

• 전기의세계
• /
• 제31권4호
• /
• pp.281-287
• /
• 1982

PASCAL has a recursive nested structure and uses deep binding of identifiers. This paper studies the problems and techniques in storage management for PASCAL on the IBM 370 system, and presents run-time storage administration algorithms which use stack scheme and heap efficiently on the view of storage. The stack-scheme was used to implement the feature of recursive nested structure and the heap was used to implement the feature of the dynamic allocation procedure and pointer variable, allowing an additional dynamic storage recovery procedure.

• 정보처리학회논문지C
• /
• 제12C권5호
• /
• pp.733-740
• /
• 2005

IPv6 네트워크에서 SCTP를 기반으로 하여 트랜스포트 계층에서 이동성을 지원하는 방안을 제안하였다. 제안하는 방안에서는 단말의 이동에 따라 SCTP 연결에 매핑되는 종단 주소를 변경하기 위한 적절한 시점을 판단하는 기준을 제안하였고, 핸드오버에 효율적으로 대처하는 오류 복구 메커니즘을 제안하였다. 또한, 수치적 분석을 통해 기존 SCTP에 비하여 제안하는 방안이 핸드오버 지연과 손실복구시간을 줄임을 보였다.