• 대한임베디드공학회논문지
• /
• 제8권1호
• /
• pp.43-50
• /
• 2013

The narrow dynamic range of most smart phone cameras is severely limited. It usually is narrower than the dynamic range of most scenes. So we proposes a illuminance dynamic range expansion using multi-point knee for smart phone camera. Such as logarithmic functions the proposed method compress the image sensor output signal. Additionally, the proposed method was merged into the gamma that is essential circuit for any cameras. To justifying multi-point knee effectiveness, we configure the control and quality evaluation system for smart phone camera module. Experimental results show that the lost information by cut off and saturated affectively reconstructed in darker and in brighter areas. Finally this methods have advantage to implement without any changing hardware for conventional smart phones.

• 한국소성가공학회:학술대회논문집
• /
• 한국소성가공학회 2008년도 춘계학술대회 논문집
• /
• pp.491-492
• /
• 2008

The effect of B on the hot ductility of Fe-29Ni-17Co Kovar alloy and the mechanism of high temperature deformation behavior were investigated. Hot-tensile test was carried out at the temperature range of $900^{\circ}C-1200^{\circ}C$. Optical microscopy and scanning electron microscopy were used to investigate the microstructure and fracture during hot deformation. The hot ductility of Kovar alloy was drastically increased with the addition of Boron. The improvement of hot ductility results from the grain boundary migration mainly due to the dynamic recrystallization at lower temperature range($900^{\circ}C$).

• 한국전자파학회논문지
• /
• 제29권12호
• /
• pp.986-991
• /
• 2018

본 논문은 광대역 디지털 수신기의 동적 범위 개선을 위한 A/D 변환 모듈을 설계 및 제작하였다. 동적 범위 확장을 위한 A/D 변환 모듈은 입력신호 레벨에 따라 정상 경로와 증폭 경로로 신호를 분기하여 디지털 신호로 변환하는 방식이다. 제작 및 측정 결과, A/D 변환 모듈의 정상 경로는 입력 레벨 -57 dBm~-12 dBm 신호를 디지털 신호로 변환하고, 증폭 경로는 입력 레벨 -30 dBm~+12 dBm 신호를 왜곡 없이 디지털 신호로 변환하여 69 dB의 입력 동적 범위 특성을 나타내었다. 또한 순시 대역폭 100 MHz에서 일정한 출력 특성을 나타내고 있음을 확인하였다.

• 한국컴퓨터정보학회논문지
• /
• 제20권12호
• /
• pp.45-52
• /
• 2015

We propose a hybrid prefix caching scheme to enable high speed IP address lookup. All prefixes loaded in a prefix cache should not be overlapped in address range for correct IP lookup. So, every non-leaf prefix needs to be expanded not so as to be overlapped. The shorter expanded prefix is more preferable because it can cover wider address range just as an single entry in a prefix cache. We exploits advantages of two dynamic prefix expansion techniques, bounded prefix expansion technique and bitmap-based prefix expansion technique. The proposed scheme uses dual bound values whereas just one bound value is used in bounded prefix expansion. Our elaborated technique make the dual bound values be associated with several subtries flexibly using bitmap information, rather than with fixed subtries. We evaluate the performance of the proposed scheme in terms of the average length of the expanded prefixes and cache miss ratio. The experiment results show the proposed scheme has lower cache miss ratio than other previous schemes including both bounded prefix expansion and bitmap-based expansion irrespective of the cache size.

• 한국광학회:학술대회논문집
• /
• 한국광학회 2009년도 동계학술발표회 논문집
• /
• pp.471-472
• /
• 2009

• 한국광학회:학술대회논문집
• /
• 한국광학회 2008년도 하계학술발표회 논문집
• /
• pp.395-396
• /
• 2008

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2013년도 추계학술대회 논문집
• /
• pp.815-824
• /
• 2013

Pneumatic exciters can be good replacements of electrodynamic, piezoelectric and hydraulic exciters owing to simple structure and large exciting force. One problem to be solved is a slow response caused by compressibility of air. Desirable frequency response characteristics of exciter are constant magnitude and zero degree phase, because users want no time delay between input signal and output force. For this reason, frequency range of pneumatic exciters is limited about 0~1 Hz. Therefore, expansion of frequency range is an important issue when designing the pneumatic exciter. In this paper, the pneumatic exciter which has same structure with active pneumatic isolator is dealt with. The dynamic characteristics are presented, and its limitation of expanding frequency range is shown based on analytical studies. Then the pneumatic exciter with dual-chamber is suggested to overcome this problem. Based on simulation study, a design method is presented.

• 방송공학회논문지
• /
• 제22권1호
• /
• pp.42-50
• /
• 2017

비트의 심도 확장은 영상을 표현하는 비트 수를 확장하는 방법이다. HDR(High Dynamic Range) 디스플레이의 발전과 디스플레이의 해상도가 높아짐에 따라서, 디스플레이에서 영상을 표현하는 휘도가 증가하고 표현력도 상승한다. 이러한 디스플레이에 대응하기 위해서는 영상을 표현하는 비트수도 확장되어야 하기 때문에 비트의 심도 확장의 중요성은 높아지고 있다. 본 논문에서는, 높은 비트 심도(10bit)를 가지는 디스플레이에 기존의 영상(8bit)을 자연스럽게 표현하기 위한 비트 심도 확장 방법을 소개한다. 정량적인 결과와 정성적인 결과 및 연산량의 비교를 통해서 제안된 알고리즘이 기존의 비트 심도 확장 방법과 비교해서 우수함을 검증하였다. 제안된 방법은 기존의 최신 비트 심도 확장 방법과 비교해서, 40배 더 빠른 연산속도와 평균 1db이상 높은 성능 향상 결과를 보여준다.

• 설비공학논문집
• /
• 제19권2호
• /
• pp.183-190
• /
• 2007

Controlling superheat of indoor units associated with a multi-type heat pump is one of difficult tasks to be addressed. This study suggests a dynamic model of an evaporator based on heat and mass balance. Thermodynamic properties are calculated by a commercial software, Refprop. The model is programmed in MFC Visual C++ for controller interface in real-time mode. The simulation results shows that PI control works for a narrow range of superheat. Beyond the range, the temperature behavior of the refrigerant is quite nonlinear mainly due to phase change. Thus, it is concluded that PI control of superheat has to be supplemented by nonlinear control ideas to avoid saturation and excessive superheat.

• 디지털융복합연구
• /
• 제9권1호
• /
• pp.13-24
• /
• 2011

IT is the core industry in Korea which has the most international competitiveness and counts for 35% of the total exports of Korea. Nevertheless, it tends to be concentrated in small range of items, a few countries and mostly large companies. Therefore, it is needed for small and medium-sized enterprises which can have prompt decision making processes and various changes to export wide range of items and to diverse countries. This study will introduce 'the fleet-type expansion strategy of overseas export' that is about large and small enterprises perform the appropriate role based on their own character, thus they produce the mutual benefit. This strategy will contribute to improve the export structure of Korea and perform the major role for Korea's IT industry to become the dynamic force for growth in the future.