• Archives of Plastic Surgery
• /
• 제35권3호
• /
• pp.345-348
• /
• 2008

Purpose: Fracture of the frontal sinus accounts for 5-15% of all facial fractures. Only anterior table fracture occupies one third of the frontal sinus fracture. Conventional coronal approach is the standard treatment, but this method is very aggressive, especially in patient with simple, depressed, anterior frontal sinus wall fracture. We introduce new, simple technique for these patients, using small incision and Dual-top screws. Methods: A 27-year-old male patient was introduced to our department under the impression of fracture of frontal sinus, involving only anterior table. Under general anesthesia, 1.5 cm-sized, small incision was made on the suprabrow area. We reduced fractured fragment with two dual-top screws and 25G wires. Fixation was not necessary Results: The operation took about forty minutes, and the patient discharged 2 days after the operation. Postoperative 2 months follow up CT shows maintenance of reduction site. Gross depression of the forehead and visible scar was not observed. Conclusion: Although the indication of this procedure is limited, less aggressive, simple and very effective to the patient with simple. depressed, anterior frontal sinus fracture.

• 대한치과보철학회지
• /
• 제45권6호
• /
• pp.780-786
• /
• 2007

Statement of problem. The performance and maintenance of implant-supported prostheses are primarily dependent upon load transmission both at the bone-to-implant interface and within the implant-abutment-prosthesis complex. The design of the interface between components has been shown to have a profound influence on the stability of screw joints. Purpose. The Purpose of this study was to compare the strength and the fatigue resistance of 1-piece and 2-piece abutment connected to oral implant, utilizing an internal conical interface. Material and methods. Twenty $Implatium^{(R)}$ tapered implants were embedded to the top of the fixture in acrylic resin blocks. Ten $Combi^{(R)}$(1-piece) and $Dual^{(R)}$(2-piece) abutments of the same dimension were assembled to the implant, respectively. The assembled units were mounted in a testing machine. A load was applied perpendicular to the long axis of the assemblies and the loading points was at the distance of 7mm from the block surface. Half of 1-piece and 2-piece abutment-implant units were tested for the evaluation of the bending strength, and the others were cyclically loaded for the evaluation of the fatigue resistance until plastic deformation occurred. Nonparametric statistical analysis was performed for the results. Results. Mean plastic and maximum bending moment were $1,900{\pm}18Nmm,\;3,609{\pm}106Nmm$ for the 1-piece abutment, and $1,250{\pm}31Nmm,\;2,688{\pm}166Nmm$ for the 2-piece abutment, respectively. Mean cycles and standard deviation when implant-abutment joint showed a first plastic deformation were $238,610{\pm}44,891$. cycles for the 1-piece abutment and $9,476{\pm}3,541$ cycles for the 2-piece abutment. A 1-piece abutment showed significantly higher value than a 2-piece abutment in the first plastic bending moment (p<.05), maximum bending moment (p<.05) and fatigue strength (p<.05). Conclusion. Both 1-piece and 2-piece conical abutment had high strength and fatigue resistance and this suggests long-term durability without mechanical complication. However, the 1-piece conical abutment was more stable than the 2-piece conical abutment in the strength and the fatigue resistance.