• 한국전자파학회논문지
• /
• 제15권3호
• /
• pp.278-283
• /
• 2004

위성통신에서 있어서 주파수 할당 및 빔 커버리지가 다양해지고 복잡해짐에 따라 주파수상에서 인접하지 않은 여러 개의 채널 신호가 하나의 고출력 증폭기에 의해서 증폭되어져 안테나를 통하여 지상으로 송출되는 경우가 있다. 본 논문에서는, 이러한 위성통신 시스템에 적용이 가능한 두 개의 통과대역을 갖는 위성 중계기용 이중모드 정규(canonical) 구조 필터를 제시하였다. 필터의 무게와 부피를 줄이기 위하여 이중모드 설계기법을 사용하였으며, 최대한 많은 수의 전달영점 구현이 가능한 정규 구조로 필터를 설계하였다. 두 개의 통과대역을 갖는 Ka대역 위성 중계기용(30/20 ㎓) 6차 이중모드 정규 구조 필터의 구현을 통하여 설계기법을 검증하였다.

• 전기학회논문지P
• /
• 제57권3호
• /
• pp.260-264
• /
• 2008

In this paper, a dual mode baseband analog channel selection filter is described which is designed for the Bluetooth and WCDMA wireless communications. Using the presented current-mode integrator, a dual mode channel selection filter is designed. To verify the current-mode integrator circuit, Hspice simulation using 1.8V Hynix $0.18{\mu}m$ standard CMOS technology was performed and achieved $50.0{\sim}4.3dB$ gain, $2.29{\sim}10.3MHz$ unity gain frequency. The described third-order dual mode analog channel selection filter is composed of the current-mode integrator, and used SFG(Signal Flow Graph) method. The simulated results show 0.51, 2.40MHz cutoff frequency which is suitable for the Bluetooth and WCDMA baseband block each.

• 전기전자학회논문지
• /
• 제22권4호
• /
• pp.1088-1092
• /
• 2018

In this paper, we propose a dual-mode frequency tripler using push-push and stacked FET structures. The proposed circuit can operate either in frequency multiplier mode or in amplifier mode. In the frequency multiplier mode, push-push frequency multiplication is achieved by allowing input signals with particular phase shifts. In the amplifier mode, the device operates as a distributed amplifier to obtain high gain. Also both modes were designed using stacked FET structure. The designed circuit showed frequency tripled output power of 9.7 dBm at 2.4 GHz with the input at 800 MHz. On the other hand, in the amplifier mode, the device showed 8.9 dB of gain to generate 19.5 dBm at 800 MHz.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2002년도 하계학술대회 논문집 C
• /
• pp.1527-1529
• /
• 2002

본 논문은 저손실 소형 대역통과 여파기인 기지국용 RF/Microwave 수동소자의 다중 공진 모드(Multi-Mode)에 관한 연구로 한개의 유전체 공진기(Dielectric Resonator)로 두개의 공진 모드(Dual-Mode)를 형성하고 그의 결합량을 조절하여 대역통과 여파기를 설계 및 제작하고, 기지국용 Dual-Mode 대역통과 여파기의 소형화, 경량화를 50%이상 향상시켜 양질의 Dual-Mode 공진 특성을 관찰하였다.

• Advances in Energy Research
• /
• 제8권4호
• /
• pp.213-222
• /
• 2022

Our overdependence on the limited supply of fossil fuel with the burden of emission as a consequence of its utilization has been a major concern. Biodiesel is emerging as a potential diesel substitution for its similar performance, with the additional benefits of emitting lesser emissions. Due to the easy availability of feedstock for Biogas production, Biogas is studied for its use in CI engines. In this study, we considered Linseed Biodiesel and Biogas to run on dual fuel mode in a CI engine. An energy and exergy analysis was conducted to study the rate of fuel energy and exergy transformation to various other processes. Exergy relocation to exhaust gases was observed to be an average of 5% more for dual fuel mode than the diesel mode, whereas exergy relocation to the diesel mode was observed to be more than the dual fuel modes. Also, exergy loss to exhaust gas is observed to be more than the exergy transferred to cooling water or shaft. The exergy efficiency observed for biodiesel-biogas mode is only lesser by 3% compared to diesel-biogas mode, suggesting Biodiesel can be a substitute fuel for diesel.

• 전기학회논문지
• /
• 제60권9호
• /
• pp.1733-1740
• /
• 2011

In this research, a MEMS vibratory gyroscope with dual-mass system in the sensing mode has been proposed to increase the stability of the device using wide bandwidth. A wide flat region between the two resonance peaks of the dual-mass system removes the need for a frequency matching typically required for single mass vibratory gyroscopes. Bandwidth, mass ratio, spring constant, and frequency response of the dual-mass system have been analyzed with MATLAB and ANSYS simulation. Designed first and second peaks of sensing mode are 5,917 and 8,210Hz, respectively. Driving mode resonance frequency of 7,180Hz was located in the flat region between the two resonance peaks of the sensing mode. The device is fabricated with anodically bonded silicon-on-glass substrate. The chip size is 6mm x 6mm and the thickness of the silicon device layer is $50{\mu}m$. Despite the driving mode resonance frequency decrease of 2.8kHz and frequency shift of 176Hz from the sensing mode due to fabrication imperfections, measured driving frequency was located within the bandwidth of sensing part, which validates the utilized dual-mass concept. Measured bandwidth was 768Hz. Sensitivity calculated with measured displacement of driving and sensing parts was 22.4aF/deg/sec. Measured slope of the sensing point was 0.008dB/Hz.

• 한국인터넷방송통신학회논문지
• /
• 제10권5호
• /
• pp.45-55
• /
• 2010

FDD를 사용하는 영역에서는 LTE-FDD가 "4G" 무선 광대역 엑세스의 강력한 후보기술의 하나로 여겨지는 한편, 최근 LTE-TDD가 TD-SCDMA의 진화 경로 및 일부 경우에는 WiMAX-TDD에 대한 진화 경로로서 떠오르고 있다. 본 논문에서는 LTE-TDD에 관하여 다음의 두 가지 조합의 듀얼모드 구현에 대한 실현가능성을 분석한다: 듀얼모드 LTE-FDD/TDD 및 듀얼모드 WiMAX-TDD/LTE-TDD. LTE-FDD 및 LTE-TDD 사이의 시스템 파라미터, 용어사용 및 프레임 구조에서의 공통성에 따라 듀얼모드 LTE-FDD/TDD가 비용면에서 효율적으로 구현이 가능함을 보인다. 또한, 스케줄링 알고리즘, 제어 메카니즘 및 지원하는 스펙트럼 대역에서의 공통성에 따라 듀얼모드 WiMAX-TDD/LTE-TDD 역시 비용면에서 효율적으로 구현이 가능함을 보인다. 시스템 파라미터 및 프레임 구조에서의 공통성은 칩을 구현하는데 매우 중요한 부분이며, 알고리즘 및 제어 메카니즘에서의 공통성은 구현된 칩이 얼마나 잘 동작하느냐에 매우 중요한 부분임을 주목한다.

• 전자공학회논문지D
• /
• 제34D권10호
• /
• pp.53-59
• /
• 1997

In this paper, we present a 20 GHz low-loss dual-mode channel filter designed by using mode matching method. The performance of dual-mode channel filter mainly depends on iris characteristics. Therefore the exact design of iris is the key point to get good frequncy response of the filter. MOde matching technique is widely used ot design several kinds of waveguide filters because it is simple in theory and can easily calculate the scattering matrices at the discontinuities with simple structure like iris coupled filters. Additionally the effect for finite thickness of the iris in the dual-mode cavity iflter is analyzed by te full-wave method, providing the exact filter implementation without trial and error.

• 한국통신학회논문지
• /
• 제25권7A호
• /
• pp.978-985
• /
• 2000

블라인드 등화기는 학습신호를 이용하지 않고 저송된 데이터의 알려진 특성을 이용해 신호를 복원하며 일반적으로 가장 많이 이용되는 알고리즘은 구현이 간단한 Steepest Gradient Descent 계열의 알고리즘으로서 CMA나 Sato 알고리즘이 여기에 속한다. 본 논문에선, CMA 및 Normalized CMA (NCMA)의 장점과 이중모드 위상복원 알고리즘의 장점을 결합하는 이중모드 NCMA 알고리즘을 제안하고 QAM 시스템에 적용한 컴퓨터 시뮬레이션을 수행하여 제안한 알고리즘이 CMA와 이중모드 CMA 보다 더 빠른 수렴속도와 더 적은 정상상태 잔류에서 특성을 가짐을 확인하다.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1998년도 춘계학술대회 논문집
• /
• pp.41-44
• /
• 1998

Dual mode resonators were fabricated using high temperature superconductor. The deposited material was $Y_1Ba_2Cu_3O_{7-x}$(YBCO) on MgO(100) substrate using pulsed laser deposition. Dual mode resonators were patterned by standard photolithography process and wet etching. At the back-side of the substrate, the ground plane with the metal layer of Ti and Ag was fabricated. The transition temperatures of YBCO films were 85-88 K, and network analyzer was used for testing the performance of the resonators. The input/output feedline angles of each resonator were $60^{\circ}$and $100^{\circ}$. The resonant frequency of resonators was 10 GHz. In this paper, dual mode resonator was fabricated for the application of satellite communication.