• Transactions of the Korean Society of Automotive Engineers
• /
• v.25 no.3
• /
• pp.326-335
• /
• 2017

It is known that diesel engines have the disadvantage of high emission levels of NOx and PM. Therefore, many combustion strategies have been developed to reduce these harmful NOx and PM emissions in a diesel engine. Among these strategies, HCCI(Homogeneous Charge Compression Ignition) and PCCI(Premixed Charge Compression Ignition) are the most popular as these can reduce NOx and PM simultaneously. However, when a single fuel like diesel is applied, it is difficult to control the combustion phase and this can lead to power reduction. In this study, premixed gasoline and pilot diesel were used to overcome the problems of controllability of the combustion phase and harmful emissions. We injected gasoline directly into the combustion chamber and the gasoline/air mixture was ignited with a pilot diesel fuel near the top dead center. The results showed that the combustion and emission characteristics of dual-fuel combustion were comparable to those of conventional diesel combustion. When we applied the dual-fuel PCCI combustion concept, more than 90 % of NOx and PM emission was reduced simultaneously without significant degradation of efficiency compared to conventional diesel combustion.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.21 no.5
• /
• pp.15-24
• /
• 2013

Numerical studies were conducted to investigate the internal flow field and combustion characteristics of DISI engine with methanol blended in gasoline. Dual injection was applied and the characteristics were compared to single injection strategy. The amount of the fuel injection was corresponded to air-fuel ratio of each fuel for complete combustion. The preforming model in this study, software STAR-CD was employed for both modeling and solving. The operating speed condition were at 4000 rpm/WOT (Wide open throttle) where the engine was fully warmed. The results of single injection with M28 showed that the uniformity, equivalence ratio, in-cylinder pressure and temperature increased comparing to gasoline (M0). When dual injection was applied, there was no significant change in uniformity and equivalence ratio but the in-cylinder pressure and temperature increased. When M28 fuel and single injection was applied, the CO (Carbon monoxide) and NO (Nitrogen oxides) emission inside the combustion chamber increased approximately 36%, 9% comparing with benchmarking case in cylinder prior to TWC (Three Way Catalytic converter). When dual stage injection was applied, both CO and NO emission amount increased.

• Progress in Medical Physics
• /
• v.23 no.4
• /
• pp.229-233
• /
• 2012

A small water phantom (dual-window phantom) was developed to improve the output measurement efficiency of medical linacs. This phantom is suitable for determining the quality index and output dose for high-energy photon beams. The phantom has two opposite windows and two independently rotating axes. The two axes measure the tissue phantom ratio (TPR) and the percentage depth dose (PDD) simply without requiring chamber movement by rotating the phantom around its axis. High-energy photon beams from a Co-60 irradiator and a medical linac were used to evaluate the phantom. The measured quality index is in good agreement with the reference values; the measured and reference values are within 0.2% of each other for the Co-60 gamma rays and within 1.4% for 6 and 10 MV X-rays. This phantom is more practical for routine output measurements, resulting in the prevention of potential human errors.

• Journal of the Korean Magnetics Society
• /
• v.23 no.6
• /
• pp.193-199
• /
• 2013

The regional distribution of magnetic isotropy depending on the post annealing condition for the dual-type structure GMR-SV (giant magnetoresistance-spin valve) of NiFe/Cu/NiFe/IrMn/NiFe/Cu/NiFe multilayer was investigated. The rotation of in-plane ferromagnetic layer induced by controlment of the post annealing temperature inside of the vacuum chamber. The magnetoresistive curves of a dual-type IrMn based GMR-SV depending on the direction of the magnetization easy axis of the free layer and the pinned layer are measured by between $0^{\circ}$ and $360^{\circ}$ angles for the applied fields. The optimum annealing temperature having a steady and isotropy magnetic sensitivity of 1.52 %/Oe was $107^{\circ}C$ in the rotational section of $0{\sim}90^{\circ}$. By investigating the switching process of magnetization for an arbitrary measuring direction, the in-plane orthogonal magnetization for the dual-type GMR-SV multilayer can be used by a high sensitive biosensor for detection of magnetized micro-beads.

• Proceedings of the Korean Society of Medical Physics Conference
• /
• 2002.09a
• /
• pp.235-236
• /
• 2002

A Klystron powered dual photon energy electron linear accelerator 2300 C/D from Varian Associates has been installed in our center. From the radiological safety view as well as treatment planning, the output (contamination) of Bremsstrahlung Radiation with electron beam energy determined accurately. It has been found 0.5% to 4.7% with increasing the electron beam energy which is the clinically not much significant in the treatment of the malignant diseases with the treatment of electron beam.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.1 no.1
• /
• pp.33-36
• /
• 2000

Auto DOME-reversing system had been installed in a vacuum coating chamber which decreased the coating time, the electric energy spending and the contamination by rotating and revilving substance. Auto multi coating with dual electron beam was accomplished and effective coating area was increased. The coating duration was decreased with 30%. the production efficiency were increased with 50%. Also the surface conductivity the coated film uniformity and anti-reflection capablity were also improved.

• Journal of ILASS-Korea
• /
• v.23 no.4
• /
• pp.159-168
• /
• 2018

Thrust throttling in a liquid rocket engine can be implemented via several ways such as high pressure drop injector, dual manifold, multiple chamber, pintle injector, and gas injection. Thrust throttling using gas injection controls thrust by usually injecting inert gas into propellant through an aerator to reduce the propellant's bulk density. In this study, the outside-in aerator was used in the propellant line to create two phase flow. Closed-type, open-type, and screw-type bi-swirl coaxial injectors were utilized for investigating throttling characteristics such as pressure drop, mixture density, and discharge coefficient according to gas-liquid mass ratio.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2006.11a
• /
• pp.24-25
• /
• 2006

SmBCO coated conductors were successfully fabricated using EDDC (Evaporation using Drum in Dual Chambers) deposition system that is a bath type co-evaporation system for fabrication of superconducting tape and divided into two chambers named evaporation chamber and reaction chamber. To obtain long and high quality superconducting coated conductor, it is very important to secure the uniformity of all the deposition parameters m the deposition system such as deposition temperature, oxygen partial pressure, compositional ratios and so on. Therefore, we investigated the distribution of the parameters along the axis of the drum m EDDC on which tapes were wound helically. When the temperature on the middle point of deposition zone was $700^{\circ}C$, that on the edge of deposition zone was $675^{\circ}C$. When the thickness of SmBCO layer on the middle point of deposition zone was 1063 nm, that on the edge of deposition zone was 899 nm. The partial pressure of oxygen was 5 mTorr in the reaction chamber while that was $7{\times}10^{-5}$Torr in the evaporation chamber. The composition ratio of Sm:Ba:Cu, that was measured by EDX, was very uniform along the axis of the drum. Under these deposition conditions, critical current distribution along the drum axis was 175 A/cm, 190A/cm, 217.5 A/cm, 182.5 A/cm, 175 A/cm with the interval of 9 cm between samples. It means that the EDDC system has the potential of fabricating (100m, 200A) class coated conductor.

• Korean Journal of Heritage: History & Science
• /
• v.50 no.4
• /
• pp.168-197
• /
• 2017

This paper considers two aspects of the wooden chamber tombs with stone mound that were constructed in Wolseong North Burial Ground, in Gyeongju: tomb form and the group tomb complex. The basic unit of a wooden chamber tomb with stone mound consisted of a single round mound, covered with an additional earthen layer and surrounded by a circle of protective stones, within which a single wooden chamber was located. The form of a wooden chamber tomb with stone mound could therefore 1) be round, consisting of a single tomb unit, 2) consist of two or more attached tomb units, 3) or consist of multiple attached chambers in a single mound. The single tomb contained the burial of a single individual, and the attached tomb contained two or more individuals who were blood relations or connected by marriage. Multiple attached chambers tombs usually consisted of wooden chamber burials of the lowest rank, and have only been identified in the royal burial area of Wolseong North Burial Ground. At the Jjoksaem Area of Wolseong North Burial Ground, which is currently, under investigation, tombs have been found in small clusters along the slightly raised ground. This is likely the result of small groups of kin relations, upon selecting points along the slightly raised ground as their burial area, having constructed midsized and large single tombs and attached tombs along the axis of the slightly raised ground, which were then surrounded by smaller 'satellite' tombs. It is through this process that the tomb complex of the different groups came to be formed. The tombs of the royal burial area of Wolseong North Burial Ground, including the Daereungwon Tomb Complex, also formed group tomb complexes. Forming the centers of the group tomb complexes of the royal tomb area were huge individual round tombs where the Maripgan rulers were laid to rest or a gourd-shaped dual mound tomb, which was the final resting place of the king and his queen consort. These central tombs were surrounded by large and smaller tombs. Of the individuals that were buried in the group tomb complexes, there would have been individuals that were of equal status or social position, such as husbands and wives or blood relations, but it is unlikely that all of the buried individuals were related by blood, given the significant difference in the sizes of the tombs. It is likely that the individuals buried in the lower ranked tombs included in the group tomb complexes were 'dependents' of the deceased of the central tomb and his or her direct family who maintained a subservient relationship. Such tomb forms and group tomb complexes that can be observed amongst the wooden chamber tombs with stone mounds of Wolseong North Burial Ground provide insights into the nature of the social groups of the Silla center during the Maripgan Period. It is hoped that future studies undertaking a more detailed analysis of the data may make further contributions to unveiling the various aspects of Silla society.

• Journal of Physiology & Pathology in Korean Medicine
• /
• v.24 no.5
• /
• pp.727-736
• /
• 2010

This study is about researching mechanistic pattern identification of disease for DongEuiBoGam NaeGyungPyen by analysing with pattern identification of modern Traditional Korean medical patholgy as more logical, systematic and standardized theory. Disease pattern mechanisms of uterine, urine and excrements parts of DongEuiBoGam NaeGyun gPyen in NaeGyungPyen of DongEuiBoGam are these. Menstrual irregularities in DongEuiBoGam can be classified flui d-humor depletion, blood deficiency, qi deficiency, qi stagnation, qi stagnation complicated by heat, blood stasis, blood deficiency complicated by heat, syndrome of heat entering blood chamber, syndrome of cold entering blood chamber. The disease pattern of abdominal pain after menstruation in DongEuiBoGam is blood deficiency complicated by heat, and a dysmenorrhea represents blood stasis with heat, fluid-humor deficiency. Advanced menstruation represent dual heat of the qi and blood, delayed menstruation is blood deficiency. The disease pattern of inhibited urination in DongEuiBoGam can be classified deficiency heat pattern of kidney yin deficiency(yin deficiency with effulgent fire), kidney qi deficiency, yin deficiency with yang hyperactivity, fluid-humor depletion, spleen-stomach dual deficiency, and excess he at pattern of bladder excess heat. The disease pattern of urinary incontinence in DongEuiBoGam can be classified deficiency pattern of kidney-bladder qi deficiency, consumptive disease, lung qi deficiency, kidney yin deficiency(yin deficiency with effulgent fire), kidney yang deficiency and excess pattern of lower energizer blood amassment, bladder excess heat. And most of them are deficiency from deficiency-excess Pattern Identification. The disease pattern of diarrhea in DongEuiBoGam can be classified deficiency pattern of qi deficiency, qi fall, spleen yang deficiency, kidney yang deficiency and so on and excess pattern of wind-cold-summerheat-dampness-fire, phlegm-fluid retention, dietary irregularities, qi movement stagnation. And most of them are deficiency from deficiency-excess Pattern Identification. Like these, this study identify pattern of disease in DongEuiBoGam by mechanism of disease theory.