• Journal of Ginseng Research
• /
• v.19 no.3
• /
• pp.249-253
• /
• 1995

In the browning reaction of Korean ginseng, it appears that enzymatic and non-enzymatic browning reaction occurred in the initial stage of heating fresh ginseng at low temperature, and then non-enzymatic browning reaction followed in the drying period after heating. Activation energy of the browning reaction for red ginseng was about 9.0 kcal/mol. Browning reaction of red ginseng was accede- rated with an increase in steaming time, and a great extent of browning reaction occurred between 60-90 min of steaming at 10$0^{\circ}C$. Browning pigments of red ginseng were mostly water soluble subset.

• 한국연소학회:학술대회논문집
• /
• 2004.11a
• /
• pp.225-230
• /
• 2004

Volatile organic compounds (VOCs) are low calorific value gases (LCVG) emitted from chemical processes such as painting booth, dye works and drying processes etc. Characteristics of VOCs are low calorific values less than 150 kcal/$m^3$, high activation energy for ignition and low energy output. These characteristics usually make combustion unstable and its treatment processes needs high-energy consumption, The cyclone combustion system is suitable for LCVG burning because it can recirculate energy through a high swirling flow to supply the activation energy for ignition, increases energy density to make a combustion temperature higher than usual swirl combustor and also increases mixing intensity, This research was conducted to develop optimized cyclone combustion system for thermal oxidation of VOCs. This research was executed to establish the effect of swirl number with respect to the combustion temperature and composition of exhausted gas in the specific combustor design.

• Journal of the Korean Society of Tobacco Science
• /
• v.2 no.1
• /
• pp.61-67
• /
• 1980

The greenhouse hulk curing and drying system utilizing the direct solar energy was tested to see how much fuel could be saved for curing flue-cured tobacco at the Daegu Experiment Station, Korea Tobacco Research Institute (North latitute: 35$^{\circ}$49'), in 1979. The structure consists of transparent fiberglass exterior, polyurethan boards covered with galvanized iron as the heat absorbers and insulation boards, air duct in which the air is introduced to the furnace room of bulk curing barn, and gravel heat storage system. All exterior surface of heat absorbers, air duct, and gravels were coated with black paint. The air temperature and total radiation were 20.5 to 35.5$^{\circ}C$ and 1004.2 to 1436.2 cal/$\textrm{cm}^2$ during the 3 replicated curing tests, respectively. The greenhouse bulk curing and drying system was able to cut fuel consumption by 25 percent compared with the conventional bulk curing barn. The maximum temperatures for the top absorber and the inlet air of the system were 89$^{\circ}C$ and 64$^{\circ}C$, respectively, and the average temperature of inlet air was higher than that of conventional one by 18$^{\circ}C$.

• Proceedings of the Korea Society for Energy Engineering kosee Conference
• /
• 2003.05a
• /
• pp.431-435
• /
• 2003

Because the Tissue Bound Tritium of food irradiates the organic tissues of a man during a longer time than the Tissue Free Water Tritium, we found the ratio of labile and bound hydrogen, which is the direct source of TBT concentration, in grain such as rice and barley. Tissue free water was extracted from rice and barley sampled, adjacent to Wolsung nuclear power plants of CANDU type, by freeze-drying. Tissue bound water was taken from some of the dried samples by high-pressure combustion. The other of the samples was washed by tritium-free water for 2-3 hours, and dried again by freeze-drying. Tissue bound water was taken again from some of the second dried samples by the combustion. The extracted tissue free and bound waters were distilled and TFWT and TBT concentrations of them were counted by a liquid scintillation counter. Through alternating washing, drying and combustion until the concentration of TBT would be constant, the tritium concentration existing as bound hydrogen was found. The ratios of labile and bound hydrogen of rice and barley were determined by TR concentration, initial TBT concentration and bound tritium concentration. The ratios of bound hydrogen of rice and barley were 0.55, 0.60 relatively.

• Journal of Power System Engineering
• /
• v.21 no.4
• /
• pp.62-69
• /
• 2017

Because the moist foods like anchovy were appeared lower quality by hot air that occurred the lipid oxidation, the drying system by using the cold air has been used widely. This study has been carried out on the performance improvement according to arrangement angle of baffle and location of air duct in the cold air dryer. The main parameters in this study are the arrangement angles which are without, $0^{\circ}$, $10^{\circ}$, $20^{\circ}$, $30^{\circ}$ and $40^{\circ}$, and the locations of air duct are without, front, center and back. For this study we have conducted the numerical analysis method using fluent in order to obtain the optimal condition of the drying performance. As the arrangement angle of baffle is increased, the relative humidity is proportionally decreased, the value at $40^{\circ}$ is 42.2% that indicate the reduction of about 4% than without it. After the air duct was installed, the decreased relative humidity is showed within 1%, therefore, the effect of air duct for improving the dry capacity is more large than the arrangement angle of baffle. Finally, we have obtained the optimal conditions that the arrangement angle is $40^{\circ}$ with the air duct for a cold air dryer.

• Journal of the Korean Wood Science and Technology
• /
• v.31 no.4
• /
• pp.57-62
• /
• 2003

The Mechanical and drying characteristics of Pinus densiflora wood, which was damaged by forest fire, and sound wood were examined. There were no significant differences in axial compressive properties, shearing strength and impact bending absorbed energy between damaged and sound woods. But the bending properties of damaged wood were slightly higher than those of sound wood. The green moisture content of sapwood in damaged wood was lower than that in sound wood, but oven-drying rate was similar in both woods. Number of initial check in damaged wood was smaller than that in sound wood, and inner check in damaged and sound woods was not observed. Consequently, it is considered that mostly damaged wood by forest fire can be used for wood material after removing the bark.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.47 no.4
• /
• pp.160-167
• /
• 2015

The reduction of energy consumption in papermaking process has been considered as one of the major issue in the paper technology. The energy efficiency of paper mill becomes more significant for the mill which manufacture the board grade products such as linerboard with recycled paper such as OCC. The application of lignocellulose spacer to the board grade paper stock would be the feasible solution by increasing the paper bulk and the drying efficiency. The major defects originated from the application of the lignocellulose spacer could be the loss of strength properties. In this study, the ways for improving the strength properties of the spacer-added linerboard were suggested and evaluated. The effects of the addition of various types polyelectrolytes were tested and the different methods of polyelectrolytes were applied for finding the efficient way. The pretreatments of lignocellulose spacer with the polyelectrolytes during wood spacer hydration resulted in the higher strength properties than the typical application method such as the addition to the mixed stock. Multilayer treatments of the spacer with polyelectrolytes were also evaluated and leaded to the higher strength properties with the similar bulk improvement.

• Transactions of the Korean hydrogen and new energy society
• /
• v.26 no.6
• /
• pp.547-553
• /
• 2015

For commercialization of fuel cell electric vehicles, one of the key objectives is to reduce cost of full stack assembly. Regarding Membrane Electrode Assembly, the major issue is to improve fuel cell activation process in the initial Hydrogen Oxidation Reaction and Oxygen Reduction Reaction. In this research, the VD (Vacuum Drying) process has been developed for improvement of activation process. The VD condition is developed by controlling the temperature and degree of vacuum to remove the remaining solvent of electrode. Consequently, the electrode applied to VD process showed the low characteristics such as 3.5% of remaining solvent content and the improved efficiency such as 15% of activation process speed.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.46 no.6
• /
• pp.8-15
• /
• 2014

The increase of wet web solid content in wet pressing will save drying energy greatly. We applied wood flours as spacers to increase the old corrugated container (OCC) solid contents in wet pressing. The mixed furnish of OCC and wood flours of 3-5% (wt/wt) increased bulk and drainage rate, and by increasing wet pressing pressure, its solid content started to be higher than 100% OCC furnish at more than 50% solid content level. Addition of cationic starch and drainage aid to the mixed furnish increased solid content further up to around 2%. Cationic starch addition compensated or exceeded the loss of tensile and compressive strength caused by the addition of wood flour, but drainage aid did not. Cationic starch also improved the stretch of the OCC, which could mitigate cracking at folding in boxboard.

• Korean Journal of Medicinal Crop Science
• /
• v.23 no.6
• /
• pp.468-472
• /
• 2015

Background : Chinese matrimony vine (Lycium chinense Mill.) is a deciduous shrub belonging to the Solanaceae. The leaves are used as an alternative raw material replacing dried fruits associated with high production costs in many industires. The aim of this experiment was to determine the effect of drying temperature on the leaves used in the manufacture of functional products. Methods and Results : The leaves of Chinese matrimony vine were harvested when the plant height reached 60 - 70 cm in the spring and treated at four different temperatures ($40^{\circ}C$, $50^{\circ}C$, $60^{\circ}C$ and $70^{\circ}C$). The time to reach the desiccation state of 20% was 63 h at $40^{\circ}C$, 37 h at $50^{\circ}C$, 17 h at $60^{\circ}C$ and 11 h at $70^{\circ}C$. The drying rate per hour was 1.28% at $40^{\circ}C$, 2.25% at $50^{\circ}C$, 4.94% at $60^{\circ}C$ and 7.60% at $70^{\circ}C$. No significant difference were observed in ash, crude fat, polyphenol or rutin content of treated samples. Crude protein and betaine content decreased with higher dry temperatures. Nitrogen free extract of the treated samples increased with higher drying temperatures. Conclusions : Taking into consideration drying time, drying rate, color value, energy consumption and functional ingredients is advantageous to dry the leaves of the Chinese matrimony vine at $60^{\circ}C$ using a hot air agricultural dryer.