• Nuclear Engineering and Technology
• /
• v.48 no.1
• /
• pp.175-181
• /
• 2016

This study investigates the dispersibility of carbon in carbon contained ammonium diuranate (C-ADU) gel particles and the characteristics of C-ADU gel liquid droplets produced by the vibrating nozzle and integrated aging-washing-drying equipment. It was noted that the excellent stability of carbon dispersion was only observed in the C-ADU gel particle that contained carbon black named CB 10. ADU gel liquid droplets containing carbon particles with the excellent sphericity of approximately 1,950 mm were then obtained using an 80-100-Hz vibrating nozzle system. Dried C-ADU gel particles obtained by the aging-washing-drying equipment were thermal decomposed until $500^{\circ}C$ at a rate of $1^{\circ}C/min$ in an air or in 4% $H_2$ gas atmosphere. The thermally decomposed C-ADU gel particles showed 24% weight loss and a more complicated profile than that of ADU gel particles.

• New & Renewable Energy
• /
• v.2 no.1 s.5
• /
• pp.46-55
• /
• 2006

The performance enhancement of heat exchanger in the drying system using solar collector with evacuated tubes is analyzed. First, for this analysis, the heat loss from a reversed trapezoidal fin attached at the pipe is calculated as a function of convection characteristic number ratio, fin base length and fin tip length. Also, the optimum heat loss and fin tip length of the fin under certain conditions are presented. The overall surface effectiveness of the cylinder with reversed trapezoidal fins in the heat exchanger are shown as a function of half fin base height, fin lateral slope and fin tip length.

• Journal of the Korean Ceramic Society
• /
• v.17 no.4
• /
• pp.179-187
• /
• 1980

Perovskite-type oxide catalysts in the $\textrm{LaMnO}_3$ family were prepared by both freeze drying and precipitation technique, and their catalytic activities with respect to the oxidation of CO with $O_2$ were measured in the composite gases. Freeze drying is a new technique for the prevention of migration of the solutes during drying. Therefore, the corrugated cordierite monolith fabricated with the Ø 1mm stainless steel bar was directly impregnated with nitrate solutions containing the appropriate cations, freeze dried and calcined. Precipitation was done by using $\textrm{(NH_4)}_2\textrm{CO}_3$ but the precipitated catalysts gave lower catalytic than the freeze dried samples due to, in part, relatively high calcining temperature. In this study, freeze dried composition had high catalytic activity, and their apparent activation energy for oxidation of CO was calculated by the rate plots using the data where the percent conversion of CO was less than 20%.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.26 no.1
• /
• pp.21-25
• /
• 2014

A drying machine for discarded Citrus scrap was developed in this study. The Citrus produced in Jeju Province was treated as wastes (a) after making a beverage, such as drinking juice, and (b) if the size of the product did not fit with its agricultural product criteria. Various types of drying machine were developed in this study, and different kinds of technologies were combined improve the performance. To enhance the performance, the system was maintained in a vacuum state, and a high frequency micro wave was activated to the waste Citrus scrap, to heat up the moisture inside the Citrus kernels. The frequency of the micro-wave was 2.6 GHz, which is the resonant frequency of the molecules. Experiments were conducted with a vacuum of 50, 100, 150, 300, 500, and 700 mbar. The waste Citrus scrap has two types of status : (a) original scrap, and (b) mixed with blender. As results, specimen (a) shows a 0.13 g/sec evaporation rate, while specimen (b) shows a 0.19 g/sec rate, at 50 mbar of environment vacuum condition. For the drying efficiency, specimens (a) and (b) show 0.15 g/W and 0.24 g/W, respectively.

• Korean Journal of Food Science and Technology
• /
• v.21 no.3
• /
• pp.425-429
• /
• 1989

Functional relationships of carotenoid destruction and nonenzymatic browning during red pepper drying were established by the dynamic test using the moisture-temperature-quality history curve in actual drying experiments. The dependence of the rate constants on temperature and moisture content was established and analysed assuming that carotenoid destruction and nonenzymatic browning are the first order and the zero order reaction, respectively. Carotenoid destruction rate constant was high at high moisture and high temperature, and had a minimum value at some intermediate moisture content. As dependence of rate constant on temperature, activation energy of carotenoid decolorization ranged from 7.7 to 27.4 kcal/mol, showing higher value at higher moisture content. Nonenzymatic browning showed higher rate at higher temperature and higher moisture content. Activation energy of browning was in the range of 7.5-20.2 kcal/mol with higher value at higher moisture level.

• Korean Journal of Environmental Biology
• /
• v.31 no.4
• /
• pp.302-307
• /
• 2013

Microbial fermented cellulose gel, citrus gel (CG), was successfully fabricated to porous foam by radiation treatment and freeze drying. The chemically induced radiation was used to create highly porous foam and further freeze drying of the CG produced tough foams with interconnected open pores for use in tissue engineering. The microstructure of the CG foam was controlled by varying the irradiation dose and quenching temperature with pore size ranging from several microns to a few hundred microns. Tensile strength and Gurley value of the CG foam were influenced by irradiation dose. These radiation induced CG foams are promising scaffolds for tissue engineering.

• Applied Biological Chemistry
• /
• v.32 no.2
• /
• pp.104-108
• /
• 1989

A 2.5 ton scale of solar energy concentration blast-grain circulation dryer (SECD) was developed in order to shorten the drying time without damaged paddy. Comparative experiments were carried out on performance, drying efficiency, consistency in moisture content, milling recovery, grade of milled rice, and energy requirement and cost against all that of in-bin drying and storage (IBDS) method. The experiments were performed using mixture of several rice varieties of Tongil type(Japonica-Indica breeding type) under the autumn weather in Korea. The circulating air temperature inside SECD was $4{\sim}5^{\circ}C$ higher than that of IBDS. The moisture content of the paddy during the drying period in SECD was uniform while substantially varied in upper, middle or bottom layer in IBDS. By SECD, 24% initial moisture content of paddy was reduced to 15% after only 3 days of drying as compared to 14 days at IBDS. The percentage of cracked kernels in upper, middle and bottom layers in IBDS was 6, 6 and 12%, respectively, whereas 7% in all layers in SECD. Both types of dryers did not significantly affect the milling recovery of dried paddy and grade of milled rice. Energy requirement of SECD(28.8Kw/2.5ton) for paddy drying was much less than that of IBDS(108Kw/2.5ton).

• Journal of Biosystems Engineering
• /
• v.21 no.1
• /
• pp.60-71
• /
• 1996

The purposes of this study were to develop a simulation model and to determine minimum specific airflow rate requirements for natural air drying of rough rice in Korea. A simulation model was developed considering energy and mass balances within grain bed, drying and rewetting rates, and hysterisis effect between sorption and desorption isotherms. As the results of validation test, the moisture contents predicted by the model agreed very well with the actual data. The criteria for determining minimum specific airflow rate requirements was that the top loom layer in the bin be dried to a moisture content below 16 percent wet basis with less than 0.5% drymatter decomposition. The minimum specific airflow rate requirements in 13 locations of Korea were presented based on the worst one among the past 7 to 13-year weather data. These requirements were also presented for all the combinations of three harvest dates and four harvest moisture contents. Specific airflow rate requirements seemed to be half by each 2 percent reduction in moisture content from 24 percent. As harvest date was delayed by 10 days from October 1, these requirements were reduced by about 20 to 40 percent.

• 한국전산유체공학회:학술대회논문집
• /
• 2010.05a
• /
• pp.283-288
• /
• 2010

The characteristics of a condenser dryer and a vented dryer that are common types of domestic clothes dryers for home use are predicted and compared in an effort to improve the efficiency and to overcome economical and environmental problems due to its inefficient power consumption. In the present study, a drying system is simplified by assuming the mechanism is composed of several elements such as heater and drum and mathematical models using the mass and energy conservation of moisture and air through each element are defined. Based on this mathematical model, the computational tool is developed to predict temperature, humidity and enthalpy of moisture and air in a drum and remained moisture contents (RMC) in drying materials. The computational results are verified by comparing with experimental results from existing studies. In addition, the efficiency of a dryer is calculated using these predicted results for a given condition and the drying characteristics of a condenser dryer and a vented dryer are compared and analyzed.

• Journal of Biosystems Engineering
• /
• v.29 no.3
• /
• pp.261-266
• /
• 2004

This study was Performed to classify the acoustic emission(AE) signal due to surface cracking and moisture movement in the flat-sawn boards of oak(Quercus Variablilis) during drying using the principal component analysis(PCA) and artificial neural network(ANN). To reduce the multicollinearity among AE parameters such as peak amplitude, ring-down count event duration, ring-down count divided by event duration, energy, rise time, and peak amplitude divided by rise time and to extract the significant AE parameters, correlation analysis was performed. Over 96 of the variance of AE parameters could be accounted for by the first and second principal components. An ANN analysis was successfully used to classify the Af signals into two patterns. The ANN classifier based on PCA appeared to be a promising tool to classify the AE signals from wood drying.