• 한국윤활학회:학술대회논문집
• /
• 한국윤활학회 1999년도 제30회 추계학술대회
• /
• pp.42-48
• /
• 1999

An experimental study was performed to discover the effect of environment on the tribological behavior of Si-incorporated diamond-like carbon(Si-DLC) film slid on a steel ball. The films were deposited on Si(100) wafers from radio-frequency glow discharge of mixtures of benzene and dilute silane gases. Experiments using a ball-on-disk test-rig was performed under vacuum, dry air and ambient air conditions. It was observed that coefficient of friction was decreased as the environmental condition changes from vacuum, to dry air. It was also observed that the coefficient of friction decreased with increasing silicon concentration in the film. Chemical analyses of debris suggested that the low and stable friction coefficient is closely related to the silicon rich oxide debris and the rolling action.

• 한국의류학회지
• /
• 제28권7호
• /
• pp.1029-1036
• /
• 2004

The fragrant fabrics were prepared by treatment with eucalyptus microcapsules. 100% cotton fabric, 100% polyester fabric and 100% wool fabric were used as test specimens. Using pad-dry-cure method, microcapsules were attached on each specimen by acrylic binder under conditions of varying concentration. Surface property, stiffness, and air permeability of fragrant fabrics were evaluated. As increasing concentration of binder, add-on yield was increased. Add-on yield was decreased with increasing laundering cycle, especially in polyester fabric. As the concentration of binder was increased, the properties of stiffness and air permeability were decreased. Also it fumed out that pad-dry-cure method was not suitable to polyester fabric.

• 한국태양에너지학회 논문집
• /
• 제25권2호
• /
• pp.45-51
• /
• 2005

The solar shading height for the cultivation of plants is a very important factor because it has an effect on the variations of the solar energy. In this study, the solar shadings were built in Daegu region to investigate the optimum thermal conditions for the cultivation of plants and to provide the basic data. The thermal environment factors (dry bulb temperature, relative humidity, air velocity) were then measured and analyzed. It is found that the heights of the solar shadings have an uniform effect on the thermal environment for the cultivation of plants: the higher the heights of the solar shadings the higher temperature was obtained. But surprisingly this trend was not found for the relative humidity and the air velocity.

• 설비공학논문집
• /
• 제14권10호
• /
• pp.781-785
• /
• 2002

The effects of different surfaces on dry and wet frosting test were experimentally investigated. The results of experiment were compared by the performance evaluation coefficient (PEC). Results showed that the air-side pressure drop of lacquer coated evaporator increased by 5% as compared to the plasma treated one. It was also found that the Plasma coated evaporator is lower than lacquer coated one in the PEC ratio.

• 한국대기환경학회지
• /
• 제13권3호
• /
• pp.231-241
• /
• 1997

A tracer model was applied in the Far East Asia to investigate the dry deposition rates of air pollutants on Korean Peninsula originated from different countries including China and Japan. Wind direction was chosen to predict the maximum deposition rates and SO$_2$ was chosen as a tracer to estimate the source strength. Model simulation shows that inflow, deposition and airborne ratios of China-originated SO$_2$ were 50%, 8% and 30%, respectively, at most. Also it was found that deposition, outbounded and airborne ratios of Korea-originated SO$_2$ were 15~77%, 8~75%, and 3~30%, respectively Model simulation also shows that inflow, deposition and airborne ratios of Kyushu-originated SO$_2$ were, 30~45%, 8~14％ and 20~25%, respectively. This study shows that tracer model can be applied on the estimation of air pollutants partitioning in regional scale and that more sophisticated modules and schemes can be developed and applied to better predict the transboundary amounts of air pollutants in this region.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 2006년도 추계 학술발표회 논문집
• /
• pp.757-760
• /
• 2006

This study aims to manufacture ultra fine cement(UFC) with a multi air-classifier of the dry-type. The classifier employed and devised for materials refining was a cyclone type fitted with an air suction device. This study also investigates the basic physical properties and quality of UFC and evaluates its utilizable possibility as a construction material. The basic properties of the UFC containing granulated blast furnace slag were analyzed and examined through recovery ratio, particle size distribution, scanning electron microscopy and compressive strength. Results obtained from the analysis of ultra fine cement have shown that there are possibilities for manufacturing UFC, which could compensate the weak properties of ordinary Portland cement.

• Tribology and Lubricants
• /
• 제16권3호
• /
• pp.188-193
• /
• 2000

An experimental study was performed to discover the effect of environment on the tribological behavior of Si-incorporated diamond-like carbon(Si-DLC) film slid on a steel ball. The films were deposited on Si(100) wafers by a radio-frequency glow discharge of mixtures of benzene and dilute silane gases. Experiments using a ball-on-disk test-rig was performed in vacuum, dry air and ambient air conditions. It was observed that coefficient of friction decreased as the environment changed from vacuum, to dry air. Chemical analyses of debris suggested that low and stable friction is closely related to the formation of silicon-rich oxide debris and the rolling action.

• 설비공학논문집
• /
• 제20권5호
• /
• pp.327-333
• /
• 2008

The purpose of this study is to develop a paddle-type dryer and to commercialize the dryer, in which mixing and drying can be done simultaneously. According to a performance test, a newly-designed paddle-type dryer can dry Chitosan salt to a low moisture contents below 0.3%. Also the newly-designed dryer can dry air pollution materials, because the dryer can operate in a closed system. The economic efficiency of a newly-designed system and an existing system was compared in a performance test. As a result, the economic efficiency of a newly-designed system was higher than an existing system. In conclusion, it is thought that the newly-designed system has a high commercial value.

• 한국대기환경학회지
• /
• 제12권1호
• /
• pp.101-112
• /
• 1996

Dry and wet deposition is an impertant removal mechanism of the amobient aerosol in the atmospheric environment. Since the deposition flut provides adverse impacts on various encironmental media including aquatic and ecological system as well as human health, it is essential to quantitatively estimate the removal fluxes of many air pollutants. Thus, the purposes of this experimental study are to investigate seasonal deposition flux variations of the total dustfall and various inorganic elements in the local ambient air and then to finally estimate their dry deposition velocities. To perform the study, the total of 90 dustfall samples were collected from January, 1994 thru February, 1995 in 5 different cities of Korea including Seoul, Suwon, Daejon, Kwangju, and Kangrung. Each sample was analyzed by an AAS and an ICP to determine the quantities of the 11 inorganic elements, such as Zn, Cd, Cr, K, Na, Pb, Ca, Fe, Mn, Mi, and Cu. As results, deposition fluxes, soluble/insoluble fractions, and deposition velocities for each element were extensively investigated. The resulting dry deposition velocities of some elements in Suwon were estimated by ranges of 0.57 .sim. 0.87 cm/sec for Zn, 0.35 .sim. 0.45 cm/sec for Pb, 1.25 .sim. 3.52 cm/sec for Ca, 0.21 .sim. 0.48 cm/sec for Fe, 0.95 .sim. 9.31 cm/sec for Mn, and 2.08 cm/sec for Cu.

• Asian-Australasian Journal of Animal Sciences
• /
• 제16권8호
• /
• pp.1126-1130
• /
• 2003

The conditions of measurement for the determination of bulk density were evaluated to assess the bulkiness of 8 kinds of forage. The bulkiness of the forages was determined with 4 different sizes of forage samples with 7 different pressure application under air-dry and wet conditions. The dry bulk density (DBD) curvilinearly regressed with the pressure applied. The particle size of the samples and kinds of forage used in the present study did not affect changes in values of DBD determined under pressures over $20g/cm^2$ up to $200g/cm^2$. The values of the wet bulk density (WBD) increased as an increment of particle size, but were not always regressed on the particle size of the 8 kinds of forage. The DBD determined on 8 mm particles showed a higher correlation coefficient with neutral detergent fiber (NDF) contents. The DBD may be a useful tool for the assessment of NDF in forage, when it is determined under condition of a pressure of $100g/cm^2$ or over with a particle size of 8 mm. The WBD may not be utilized for the direct measurement of the physical characteristics of forage, but may be required a thorough consideration on water solubility of forages. Further studies are needed to clarify the DBD contribution to the prediction of forage intake by ruminants.